RGN-ACRO-SACRO-S

English Manual FCC ID: RGN-ACRO-S This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment。 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Revised wording (obsolete) 1.0 2.0 Sept–25-2007 Updated company template (current) 2.0 3.0 Jan-31-2012 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 3.0 INSOPACK. CO., LTD. December 17, 2012 To: SIEMIC, INC. 775 Montague Expressway, Milpitas, CA 95035 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, __ INSOPACK. CO., LTD.__hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): FCC ID: RGN-ACRO-S Product name: ACRO-S Model: ACRO-S We affirm that between SIEMIC and _ INSOPACK. CO., LTD._ _, any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Client’s signature : Client’s name / title : Jeong Hyun Cho Adress : 101/508, Digital Empire Building, Sin-dong, Yeongtong-gu, Suwon, Kyeonggi-do, Korea. 486-1 Tel. : +82 316958400 Fax : +82 316958406 Email : [email protected]

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 (obsolete) 1.0 2.0 August – 11 - 2008 Updated company template & Added text box (current) 2.0 3.0 Jan-31-2012 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 3.0 INSOPACK. CO., LTD. December 17, 2012 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: RGN-ACRO-S We hereby request confidential treatment of information accompanying this application as outlined below: - Block diagram - Schematic - Operating description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Client’s signature : Client’s name / title : Jeong Hyun Cho Adress : 101/508, Digital Empire Building, Sin-dong, Yeongtong-gu, Suwon, Kyeonggi-do, Korea. 486-1 Tel. : +82 316958400 Fax : +82 316958406 Email : [email protected]

Full View Top View Bottom View Front View Left View Rear View Right View

Label Location

Top View Bottom View ANTENNA Top View Top View Bottom View Bottom View

Shenzhen Certification Technology Service Co., Ltd 2F, Building B, East Area of Nanchang Second Industrial Zone, Gushu 2nd Road, Bao'an District, Shenzhen 518126, P.R. China. FCC ID: RGN-ACRO-S Page 1 of 41 TEST REPORT FCC ID: RGN-ACRO-S Applicant : INSOPACK. CO.,LTD. Address : 101/508, Digital Empire Building, Sin-dong, Yeongtong-gu, Suwon, Kyeonggi-do, Korea. 486-1 Equipment under Test (EUT): Name : ACRO-S Model : ACRO-S Standards : FCC PART 15, SUBPART C : 2011 (Section 15.249) Report No. : STE121217794 Date of Test : December 14-17, 2012 Date of Issue : December 18, 2012 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above Authorized Signature (Mark Zhu) General Manager The manufacture should ensure that all the products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of Shenzhen Certification Technology Service Co., Ltd. Or test done by Shenzhen Certification Technology Service Co., Ltd. Approvals in connection with, distribution or use of the product described in this report must be approved by Shenzhen Certification Technology Service Co., Ltd. Approvals in writing. Report No.: STE121217794 FCCID: RGN-ACRO-S Page 2 of 41 TABLE OF CONTENT Description Page 1 General Information--------------------------------------------------------------------------------------3 1.1 Description of Device (EUT)---------------------------------------------------------------------3 1.2 Accessories of device (EUT)---------------------------------------------------------------------4 1.3 Description of Test Facility-----------------------------------------------------------------------4 2 EMC Equipment List-----------------------------------------------------------------------------------5 2.1 Assistant equipment used for test----------------------------------------------------------------5 2.2 Block Diagram--------------------------------------------------------------------------------------5 2.3 Test mode--------------------------------------------------------------------------------------------5 2.4 Test Conditions-------------------------------------------------------------------------------------6 2.5 Measurement Uncertainty (95% confidence levels, k=2)-------------------------------------6 2.6 Test Equipment-------------------------------------------------------------------------------------7 3 Test Procedure-------------------------------------------------------------------------------------------8 4 Summary of Measurement---------------------------------------------------------------------------9 5 POWER LINE CONDUCTED EMISSION-------------------------------------------------------10 5.1 Conducted Emission Limits(15.209&249)-------------------------------------------------10 5.2 Test Setup-----------------------------------------------------------------------------------------10 5.3 Test Procedure-----------------------------------------------------------------------------------11 5.4 Test Results---------------------------------------------------------------------------------------11 6 Radiation Emission----------------------------------------------------------------------------------14 6.1 Radiation Emission Limits(15.209&249 (a))----------------------------------------------14 6.2 Test Setup-----------------------------------------------------------------------------------------15 6.3 Test Procedure-----------------------------------------------------------------------------------16 6.4 Test Equipment Setting For emission test.-----------------------------------------------17 6.5 Test Condition------------------------------------------------------------------------------------17 6.6 Test Result----------------------------------------------------------------------------------------17 7 Occupied bandwidth---------------------------------------------------------------------------------23 7.1 Test limit-------------------------------------------------------------------------------------------23 7.2 Method of measurement-----------------------------------------------------------------------23 7.3 Test Setup-----------------------------------------------------------------------------------------23 7.4 Test Results---------------------------------------------------------------------------------------23 8 Band Edge Check-------------------------------------------------------------------------------------26 8.1 Test limit-------------------------------------------------------------------------------------------26 8.2 Test Procedure-----------------------------------------------------------------------------------26 8.3 Test Setup-----------------------------------------------------------------------------------------26 8.4 Test Result----------------------------------------------------------------------------------------26 9 Antenna Requirement-------------------------------------------------------------------------------31 9.1 Standard Requirement-------------------------------------------------------------------------31 9.2 Antenna Connected Construction-----------------------------------------------------------31 9.3 Result-----------------------------------------------------------------------------------------------31 10 Photographs of Test Setup------------------------------------------------------------------------32 11 Photographs of EUT---------------------------------------------------------------------------------35 Report No.: STE121217794 FCCID: RGN-ACRO-S Page 3 of 41 1 General Information 1.1 Description of Device (EUT) Trade Name : N/A EUT : ACRO-S Model No. : ACRO-S Type of Antenna : Integral Antenna Antenna Specification : 3.62 dBi Operation Frequency : 2403-2478MHz Channel number : 76 Modulation type : GF…

Text truncated - open the document above for the full version.

Photographs-Radiated Emission Test Setup in Chamber Below 1G Above 1G Photographs-Conducted Emission Test Setup