RV7-SC6000Dual Radio Concurrent AP/CB

Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Industry Canada statement This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Caution: The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems. High power radars are allocated as primary users (meaning they have priority) of 5250-5350 MHz and 5650-5850 MHz and these radars could cause interference and/or damage to LE-LAN devices. This device has been designed to operate with an antenna having a maximum gain of 8 dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2 Page 3 Page 4

Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13

FCC ID: RV7-SC6000 Report No.: RF990806C19 Operational Description This device is Dual Radio Concurrent AP/CB, which operates in 5GHz band the maximum data rate could be up to 300Mbps which OFDM technique. If the signal to noise radio is too poor which could not support 300Mbps, the 11Mbps data rate with DSSS technique will be applied. The transmitter of the EUT is powered by PoE. The antenna is Patch antennas with MMCX antenna connector. For more detailed instruction, please take a look at the user’s manual. FCC 15.407(c) states: The device shall automatically discontinue transmission in case of either absence of information to transmit or operational failure. These provisions are not intended to preclude the transmission of control or signaling information or the use of repetitive codes used by certain digital technologies to complete frame or burst intervals. Applicants shall include in their application for equipment authorization a description of how this requirement is met” Data transmission is always initiated by software, which is then pass down through the MAC, through the digital and analog baseband, and finally to the RF chip. Several special packets (ACKs, CTS, PSPoll, etc...) are initiated by the MAC. There are the only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only while one of the aforementioned packets are being transmitted.

Report No.: SA990806C19 Report Format Version 3.0.1. 1 RF EXPOSURE REPORT REPORT NO.: SA990806C19 MODEL NO.: SC6000 FCC ID: RV7-SC6000 ACCORDING: FCC Guidelines for Human Exposure IEEE C95.1 APPLICANT: Trilliant Networks, Inc. ADDRESS: 1100 Island Drive Redwood City California United States 95065 ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. TEST LOCATION: No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. Report No.: SA990806C19 Report Format Version 3.0.1. 2 1. RF EXPOSURE LIMIT LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) FREQUENCY RANGE (MHz) ELECTRIC FIELD STRENGTH (V/m) MAGNETIC FIELD STRENGTH (A/m) POWER DENSITY (mW/cm 2 ) AVERAGE TIME (minutes) LIMITS FOR GENERAL POPULATION / UNCONTROLLED EXPOSURE 300-1500 ... ... F/1500 30 1500-100,000 ... ... 1.0 30 F = Frequency in MHz 2. MPE CALCULATION FORMULA Pd = (Pout*G) / (4*pi*r2) where Pd = power density in mW/cm2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm 3. CLASSIFICATION The antenna of this product, under normal use condition, is at least 20cm away from the body of the user. So, this device is classified as Mobile Device. 4. CALCULATION RESULT OF MAXIMUM CONDUCTED POWER FREQUENCY BAND (MHz) MAX POWER (dBm) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/ cm 2 ) LIMIT (mW/cm 2 ) 5180-5240 5.6 15 20 0.023 1.00 5745-5825 17.8 15 20 0.379 1.00

Report No.: RF990806C19 1 Report Format Version 3.0.1 FCC TEST REPORT (15.247) REPORT NO.: RF990806C19 MODEL NO.: SC6000 FCC ID: RV7-SC6000 RECEIVED: Aug. 06, 2010 TESTED: Aug. 10 ~ Sep. 06, 2010 ISSUED: Sep. 09, 2010 APPLICANT: Trilliant Networks, Inc. ADDRESS: 1100 Island Drive Redwood City California United States 95065 ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. TEST LOCATION: No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This test report consists of 39 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF or any government agency. The test results in the report only apply to the tested sample. Report No.: RF990806C19 2 Report Format Version 3.0.1 TABLE OF CONTENTS 1. CERTIFICATION ......................................................................................................4 2. SUMMARY OF TEST RESULTS..............................................................................5 2.1 MEASUREMENT UNCERTAINTY ............................................................................5 3. GENERAL INFORMATION ......................................................................................6 3.1 GENERAL DESCRIPTION OF EUT.........................................................................6 3.2 DESCRIPTION OF TEST MODES...........................................................................7 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST......................................................7 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL...........................8 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ........................................10 3.4 DESCRIPTION OF SUPPORT UNITS...................................................................10 4. TEST TYPES AND RESULTS (FOR 5.0GHz BAND)............................................. 11 4.1 RADIATED EMISSION MEASUREMENT .............................................................. 11 4.1.1 LIMITS OF RADIATED EMISSION MEASUREMENT ........................................... 11 4.1.2 TEST INSTRUMENTS ...........................................................................................12 4.1.3 TEST PROCEDURES ............................................................................................13 4.1.4 DEVIATION FROM TEST STANDARD ..................................................................13 4.1.5 TEST SETUP .........................................................................................................14 4.1.6 EUT OPERATING CONDITIONS...........................................................................14 4.1.7 TEST RESULTS .....................................................................................................15 4.2 CONDUCTED EMISSION MEASUREMENT .........................................................19 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT ......................................19 4.2.2 T EST INSTRUMENTS ..........................................................................................19 4.2.3 TEST PROCEDURES ............................................................................................20 4.2.4 DEVIATION FROM TEST STANDARD ..................................................................20 4.2.5 TEST SETUP .........................................................................................................21 4.2.6 EUT OPERATING CONDITIONS...........................................................................21 4.2.7 TEST RESULTS .....................................................................................................22 4.3 6dB BANDWIDTH MEASUREMENT .....................................................................24 4.3.1 LIMITS OF 6dB BANDWIDTH MEASUREMENT...................................................24 4.3.2 TEST INSTRUMENTS ...........................................................................................24 4.3.3 TEST PROCEDURE ..............................................................................................24 4.3.4 DEVIATION FROM TEST STANDARD ..................................................................25 4.3.5 TEST SETUP .........................................................................................................25 4.3.6 EUT OPERATING CONDITIONS...........................................................................25 4.3.7 TEST RESULTS .....................................................................................................26 4.4 MAXIMUM OUTPUT POWER................................................................................27 4.4.1 LIMITS OF MAXIMUM OUTPUT POWER MEASUREMENT ................................27 4.4.2 INSTRUMENTS .....................................................................................................27 4.4.3 TEST PROCEDURES ............................................................................................27 4.4.4 DEVIATION FROM TEST STANDARD ..................................................................28 4.4.5 TEST SETUP .........................................................................................................28 4.4.6 EUT OPERATING CONDITIONS...........................................................................28 4.4.7 TEST RESULTS .....................................................................................................28 4.5 POWER SPECTRAL DENSITY MEASUREMENT ................................................29 4.5.1 LIMITS OF POWER SPECTRAL DENSITY MEASUREMENT ..............................29 4.5.2 TEST INSTRUMENTS ...................................................................................…

Text truncated - open the document above for the full version.

Report No.: RF990806C19-1 1 Report Format Version 3.0.1 FCC TEST REPORT (15.407) REPORT NO.: RF990806C19-1 MODEL NO.: SC6000 FCC ID: RV7-SC6000 RECEIVED: Aug. 06, 2010 TESTED: Aug. 10 ~ Sep. 06, 2010 ISSUED: Sep. 09, 2010 APPLICANT: Trilliant Networks, Inc. ADDRESS: 1100 Island Drive Redwood City California United States 95065 ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. TEST LOCATION: No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This test report consists of 45 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF or any government agency. The test results in the report only apply to the tested sample. Report No.: RF990806C19-1 2 Report Format Version 3.0.1 TABLE OF CONTENTS 1. CERTIFICATION.......................................................................................................... 4 2. SUMMARY OF TEST RESULTS ................................................................................. 5 2.1 MEASUREMENT UNCERTAINTY............................................................................... 5 3. GENERAL INFORMATION .......................................................................................... 6 3.1 GENERAL DESCRIPTION OF EUT ............................................................................ 6 3.2 DESCRIPTION OF TEST MODES .............................................................................. 7 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST ......................................................... 7 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL .............................. 8 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ........................................... 10 3.4 DESCRIPTION OF SUPPORT UNITS ...................................................................... 10 4. TEST TYPES AND RESULTS ................................................................................... 11 4.1 RADIATED EMISSION MEASUREMENT ................................................................. 11 4.1.1 LIMITS OF RADIATED EMISSION MEASUREMENT............................................... 11 4.1.2 LIMITS OF UNWANTED EMISSION OUT OF THE RESTRICTED BANDS ............. 11 4.1.3 TEST INSTRUMENTS............................................................................................... 12 4.1.4 TEST PROCEDURES ............................................................................................... 13 4.1.5 DEVIATION FROM TEST STANDARD ..................................................................... 13 4.1.6 TEST SETUP............................................................................................................. 14 4.1.7 EUT OPERATING CONDITION................................................................................. 14 4.1.8 TEST RESULTS ........................................................................................................ 15 4.2 CONDUCTED EMISSION MEASUREMENT ............................................................ 19 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT.......................................... 19 4.2.2 TEST INSTRUMENTS............................................................................................... 19 4.2.3 TEST PROCEDURES ............................................................................................... 20 4.2.4 DEVIATION FROM TEST STANDARD ..................................................................... 20 4.2.5 TEST SETUP............................................................................................................. 21 4.2.6 EUT OPERATING CONDITIONS .............................................................................. 21 4.2.7 TEST RESULTS ........................................................................................................ 22 4.3 MAXIMUM CONDUCTED OUTPUT POWER MEASUREMENT .............................. 24 4.3.1 LIMITS OF MAXIMUM CONDUCTED OUTPUT POWER MEASUREMENT............ 24 4.3.2 TEST INSTRUMENTS............................................................................................... 24 4.3.3 TEST PROCEDURE.................................................................................................. 25 4.3.4 DEVIATION FROM TEST STANDARD ..................................................................... 25 4.3.5 TEST SETUP............................................................................................................. 25 4.3.6 EUT OPERATING CONDITIONS .............................................................................. 25 4.3.7 TEST RESULTS ........................................................................................................ 26 4.4 PEAK POWER EXCURSION MEASUREMENT ....................................................... 28 4.4.1 LIMITS OF PEAK POWER EXCURSION MEASUREMENT..................................... 28 4.4.2 TEST INSTRUMENTS............................................................................................... 28 4.4.3 TEST PROCEDURE.................................................................................................. 28 4.4.4 DEVIATION FROM TEST STANDARD ..................................................................... 29 4.4.5 TEST SETUP............................................................................................................. 29 4.4.6 EUT OPERATING CONDITIONS .............................................................................. 29 4.4.7 TEST RESULTS ........................................................................................................ 30 4.5 PEAK POWER SPECTRAL DENSITY MEASUREMENT .....................…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST 2 RADIATED EMISSION TEST