SY9TPMSX7TIRE PRESSURE MONITORING SYSTEM

Caution: The user is cautioned that changes or modifications not expres sly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation i s subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, includin g interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with t he limits for a Class B d igital device, pursuant to Part 15 of the FCC Rules. These limi ts are designed to provide reasonable protection against harmful inter ference i n a residential installation. This equipment generates, uses and ca n radiate radio frequency energy and, if not installed and used in accordance w ith the instructions, may cause harmful interference to radio communica tions. However, there is no guarantee that interference will not occur in a par ticular installation. If this equipment does cause harmful interference to radio or t elevision reception, which can be determined by turning the equipment off and on, th e user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet o n a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

External Photo

Internal Photo

SGS-CSTC Standards Technical Services Co., Ltd. Guangzhou Branch 198 Kezhu Road, Scientech Park, Guangzhou Economic & Technological Development District, Guangzhou, China 510663 Telephone: +86 (0) 20 82155555 Fax: +86 (0) 20 82075059 Email: [email protected] Report No.: GZEM141200692601 Page: 1 of 15 FCC ID: SY9TPMSX7 Authorized Signature: Jerry Chan Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. An y unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only. 1 Cover Page TEST REPORT Application No.: GZEM1412006926CR Applicant: GUANGDONG LFF TECHNOLOGY CO., LTD Manufacturer: Same as the applicant. FCC ID: SY9TPMSX7 Product Description: TIRE PRESSURE MONITORING SYSTEM Model No.: TPMS-X7, TPMS-V10 ♣ ♣ Please refer to section 3 of this report for further details. Trade Mark: SPY Standards: CFR 47 FCC PART 15 SUBPART B:2014 Date of Receipt: 2015-01-05 Date of Test: 2015-03-03 to 2015-04-21 Date of Issue: 2015-08-28 Test Result : Pass* * In the configuration tested, the EUT complied with the standards specified above. SGS-CSTC Standards Technical Services Co., Ltd. Guangzhou Branch Report No.: GZEM141200692601 Page: 2 of 15 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only. 2 Version Revision Record Version Chapter Date Modifier Remark 00 2015-08-28 Original Authorized for issue by: Tested By 2015-03-03 to 2015-04-21 (Terry Lai) /Project Engineer Date Prepared By 2015-04-27 (June Chen) /Clerk Date Checked By 2015-04-27 (Kobe Jian) /Reviewer Date SGS-CSTC Standards Technical Services Co., Ltd. Guangzhou Branch Report No.: GZEM141200692601 Page: 3 of 15 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspxand,for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only. 3 Test Summary Electromagnetic Interference (EMI) Test Test Requirement Test Method Class / Severity Result Radiated Emission (30 MHz to 1 GHz) FCC PART 15 SUBPART B:2014 ANSI C63.4:2009 Class…

Text truncated - open the document above for the full version.

Test Setup Photo 1.1 RADIATED EMISSIONS, 30MHZ TO 1GHZ TEST SETUP 1.2 RADIATED EMISSIONS ABOVE 1 GHZ TEST SETUP