SYW-RGBWAGREMRemote Controller

Remote Controller An instruction manual Warranty instructions NOTE The one-year warranty of our products is only applicable to all operations that conform to the instructions.The warranty does not include the following: 1. Any change, amendment, deletion or scribbled purchase labels or instructions. 2. Failure due to damage, misuse. 3. Because of the natural environment rather than the inherent causes of the product (such as lightning, flood, etc.).The bad phenomena of fire, etc. 4. The product has been opened or disassembled. 5. Adverse consequences arising from use, maintenance or custody do not conform to product specifications(e.g. damp, corrosive). 6. Any other matter caused by product defect, appearance distortion, appearance damage or external forcePhysical injury. 1. Do not use in humid, high temperature environment. 2. Please don't use this product in bed. Product Parameters Model No:LVSL24-12/REM power supply: DC 3V(1*3V SizeCR2025 Battery) Product size: L86 xW40 xH7mm Working environment: indoor Working temperature: - 10 C - 45 °C (140 F - 113 F) Humidity: <80% RH FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Feit Electric Company * the applicant must designate a contact located in the United States for purposes of acting as the applicant’s agent for service of process, regardless of whether the applicant is a domestic or foreign entity. An applicant located in the United States may designate itself as the agent for service of process. U.S. Agent Designation for Service of Process - Certification Attestation Letter 10/20/2023 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA ATTN.: Reviewing Engineer FCC ID: SYW-RGBWAGREM FRN of applicant: 0024691990 Per section 2.911(d)(7) of the FCC rules, Feit Electric Company certifies that the equipment for which authorization is sought is designated to the following U.S. agent* for service of process: Company Name: Feit Electric Company FCC Registration Number(FRN): 0024691990 Physical U.S. Company Address: 4901 Gregg Road, Pico Rivera, California 90660, United States Contact Person: Aaron Feit Agent Email Address: [email protected] The above contact person accepts the obligation for service of process. The applicant accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Applicant Signed: Signed: Printed name: Aaron Feit Title: President Company Name: Feit Electric Company Date: 10/20/2023 Agent Signed (if different to Applicant): Signed: Printed name: Aaron Feit Title: President Company Name: Feit Electric Company Date: 10/20/2023

Page 1 of 3 Test Model No.: FERGBWAG/REM Page 2 of 3 Page 3 of 3

Page 1 of 3 Test Model No.: FERGBWAG/REM Page 2 of 3 Page 3 of 3

FCC ID: SYW-RGBWAGREM RF Exposure evaluation According to 447498 D04 Interim General RF Exposure Guidance v01 eirp = pt x gt = (EXd) 2 /30 where: pt = transmitter output power in watts, gt = numeric gain of the transmitting antenna (unitless), E = electric field strength in V/m, --- 10 ((dBuV/m)/20) /10 6 d = measurement distance in meters (m)---3m Sopt = (EXd) 2 /30 x gt Frequency(MHz) Field Strength (dBuv/m) antenna gain(dBi) numeric gain calc. Pt (mW) erp(mW) limit (mW) min. distance (cm) 433.925 81.16 0.9 1.23 0.04 0.03 23.17 0.50 WORSE CASE 0.03mW<23.17mW Then SAR evaluation is not required

A n t enn a c o m p o nen t s t 频率 范围 F re qu en cy r ange 天线增益(Antenna Gain) 输入阻抗Input Impedanc 0.9 d B 板 载 天 线 ： ( 4 33 .92 5 MH z ) i e 5 0 ( Q ) 极化方式Polarization垂直极化Vertical Polarization 半功率波束(3dB)HPW 1 8 0 ° H - p l an e 1 2 0 ° E - p l ane 1 T e c h n i ca l S u m mar y T h i s r e p o r t s u m m ar i z es t h e e l e c t r i c a l r e s u l t s o f t h e p r o p o se d an t e n n a t o s u pp o r t t h e 4 33 M H z 天 线 p r o g ra m . 2 G e ne r a l D e sc r i p t i o n 2 . 1 C o m p onen t s / P a r t r e v i s i ons V S W R : V o l t a g e S t a n d i n g W a v e R a t e . 3 M ec h an i c a l D es cr i p t i on 4 E l ec t r i c a l P e r f o r mance 4 . 1 S e t - u p 4 . 1 . 1 V S W R V S WR m ea s u r e m e n t s ( S 11 ) w ere p e r f o r m e d u s i n g an A g i l e n t 8 7 5 3 D N e t w o r k A n a l y z e r an d t h e p r e v i o u s l y d e s c r i b e d t e s t f i x t u r e . C o a x i a l c h o k e s w e r e u s e d t o m i t i g a t e s u r f a ce cu r ren t s o n t h e o u t s i d e o f t h e ca b l i n g . T h e t e s t i n g w a s p e r f o rme d i n f r ee s p ace . 4 . 1 . 2 G a i n & R a d i a t i on P a t t e r ns T h e g a i n o f t h e a n t e nn a w a s m e a s u r e d i n t h e L x c ' s a ne c h o i c c h am b er . C o a x i a l c h o k e s o n t h e f e e d ca b l e w e r e u s e d t o m i t i g a t e s u r f a ce c u r r e n t s . T h e c h a m b e r p r o v i d e s l e ss t h a n - 30 d B r e f l ec t i v i t y f r om 800 MH z t h r ou g h 3 G H z an d a n 18 ” d i ame t er s p h er i ca l q u i t e z one . T h e m e a s u r e m e n t r e s u l t s a r e c a l i b r a t e d u s i n g b o t h d i p o l e a n d l e a k y w a v e h o r n s t a n d a r d s . F i l e N a m e : P a D a t e : 2 02 3 - 8 - 2 8 T E S T : L a n g u a g e : E n g l i s h A — 1 —

Global United Technology Services Co., Ltd. Report No.: GTS2023090222F01 Authorized Signature: Robinson Luo Laboratory Manager This results shown in this test report refer only to the sample(s) tested, this test report cannot be reproduced, except in full, without prior written permission of the company. The report would be invalid without specific stamp of test institute and the signatures of compiler and approver. Page 1 of 22 TEST REPORT Applicant: Feit Electric Company Address of Applicant: 4901 Gregg Road, Pico Rivera, California 90660, United States Manufacturer: SIGNCOMPLEX LIMITED Address of Manufacturer: No.70 Hexiang West Road, Heshan Industrial Park, Heshan, Guangdong, China Equipment Under Test (EUT) Product Name: Remote Controller Model No.: FERGBWAG/REM Trade Mark: Feit Electric FCC ID: SYW-RGBWAGREM Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.231 Date of sample receipt: September 21, 2023 Date of Test: September 22, 2023-October 07, 2023 Date of report issued: October 07, 2023 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No.: GTS2023090222F01 Global United Technology Services Co., Ltd. No.123-128, Tower A, Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 2 of 22 2 Version Version No. Date Description 01 October 07, 2023 Original Prepared By: Date: October 07, 2023 Project Engineer Check By: Date: October 07, 2023 Reviewer Report No.: GTS2023090222F01 Global United Technology Services Co., Ltd. No.123-128, Tower A, Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 3 of 22 3 Contents Page 1 COVER PAGE .......................................................................................................................................... 1 2 VERSION .................................................................................................................................................. 2 3 CONTENTS .............................................................................................................................................. 3 4 TEST SUMMARY ..................................................................................................................................... 4 4.1 MEASUREMENT UNCERTAINTY ............................................................................................................ 4 5 GENERAL INFORMATION ...................................................................................................................... 5 5.1 GENERAL DESCRIPTION OF EUT ......................................................................................................... 5 5.2 TEST MODE ........................................................................................................................................ 6 5.3 DESCRIPTION OF SUPPORT UNITS ....................................................................................................... 6 5.4 TEST FACILITY .................................................................................................................................... 6 5.5 TEST LOCATION ................................................................................................................................. 6 5.6 OTHER INFORMATION REQUESTED BY THE CUSTOMER ......................................................................... 6 5.7 ADDITIONAL INSTRUCTIONS ................................................................................................................. 6 6 TEST INSTRUMENTS LIST ..................................................................................................................... 7 7 TEST RESULTS AND MEASUREMENT DATA ...................................................................................... 9 7.1 ANTENNA REQUIREMENT ..................................................................................................................... 9 7.2 RADIATED EMISSION METHOD ........................................................................................................... 10 7.2.1 Field Strength of The Fundamental Signal ................................................................................ 12 7.2.2 Spurious Emissions ................................................................................................................... 15 7.3 20DB OCCUPY BANDWIDTH .............................................................................................................. 19 7.4 DEACTIVATION TESTING .................................................................................................................... 20 8 TEST SETUP PHOTO ............................................................................................................................ 22 9 EUT CONSTRUCTIONAL DETAILS ..................................................................................................... 22 Report No.: GTS2023090222F01 Global United Technology Services Co., Ltd. No.123-128, Tower A, Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 4 of 22 4 Test Summary Test Item Section in CFR 47 Result Antenna Requirement 15.203 Pass Conduction Emission 15.207 N/A Field strength of the Fundamental Signal 15.231 (b) Pass Spurious Emissions 15.231 (b)/15.209 Pass 20dB Bandwidth 15.231 (c) Pass Deactivation Testing 15.231 (a)(2) Pass Pass: The EUT complies with the essential requirements in the standard. N/A: Not applicable. 4.1 Measurement Uncertainty Test Item Frequency Range Measurement Uncertainty Notes Radiated Emission 30MHz-200MHz 3.8039dB (1) Radiated Emissio…

Text truncated - open the document above for the full version.

Page 1 of 1 Test Model No.: FERGBWAG/REM Radiated Emission