TJJ-IL001LED REMOTE

Thank you for purchasing the Remote GoLite™. For added security, use GoLite™ to light the interior of your vehicle while approaching at night. GoLite is also great for illuminating the inside of your vehicle for any purpose, roadside repair or anywhere light is needed. If you have questions, comments or need assistance, call our technical support team at 800-835-0129. CONTENTS: 1 – GoLite (batteries not included), 1 – Remote (includes battery), 1 – Suction Cup, 1 – Visor Clip, 1 – Vibration Pad OPERATION: 1. Slide GoLite battery cover open and insert 4 AA batteries (not included). Replace battery cover. 2. Remote control includes a 12V 23A battery. For future replacement of battery, remove four screws on back of devise. 3. Slide on/off/remote switch located on light to the preferred position.  “ ○ ” symbol = Light is always off.  “ ─ “ symbol = Light is always on.  “ “ symbol = Light is activated on and off by remote control. 4. Place GoLite in the desired location. CAUTION: Do not place GoLite in any location that would impair visibility while driving or come in contact with airbags should they be deployed. Check state and local laws for regulations that may apply.  Built in hook allows for hanging from rear view mirror. Note: When hanging GoLite from the mirror, the front of the GoLite may come in contact with the rear of the mirror, causing a rattling noise. Use the included Vibration Pad and adhere to the GoLite or back of the mirror at the location where the GoLite contacts the mirror.  Suction cup allows for placement on any flat window surface. Clean window prior to attachment.  Visor clip allows for placement on passenger side sunvisor. CAUTION: To prevent damage to the light and personal injury, remove light prior to flipping sunvisor to the “down” position. 5. Remote Operation  Slide GoLite on/off/remote switch to the “ “ position. The red LED light on the end of GoLite will illuminate. For continuous remote operation, leave switch in this position at all times.  Push the on/off button located on the remote control to activate the light. Activation can be achieved from up to 100 ft. (in some instances, weather and other obstacles may interfere with the transmission, causing the activation distance to be less than 100 ft.)  Push remote button a second time to turn light off (GoLite will continue to be in the “remote” status and can be activated by the remote control devise at any time). GoLight will automatically turn off in 60 seconds if the light is not manually turned off. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help. HOPKINS MANUFACTURING CORPORATION 428 PEYTON STREET ● P.O. BOX 1157 ● EMPORIA, KS 66801-1157 Phone: (620) 342-7320 ● www.HopkinsMfg.com ● www.GoGearMobile.com

SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page 1 of 2 APPENDIX 1 PHOTOGRAPHS OF EUT SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd. Page 2 of 2 EUT front view EUT front viewEUT front view EUT front view B BB Back view ack viewack view ack view

FCC ID: TJJ-IL001

SGS-CSTC Standards Technical Services（ （（ （Shanghai） ）） ） Co., Ltd. Page 1 of 4 APPENDIX 2 PHOTOGRAPHS OF EUT SGS-CSTC Standards Technical Services（ （（ （Shanghai） ）） ） Co., Ltd. Page 2 of 4 Internal InternalInternal Internal of Transmitter of Transmitter of Transmitter of Transmitter Open EUT Open EUTOpen EUT Open EUT Antenna SGS-CSTC Standards Technical Services（ （（ （Shanghai） ）） ） Co., Ltd. Page 3 of 4 Internal InternalInternal Internal of of of of PCB Front Side PCB Front SidePCB Front Side PCB Front Side SGS-CSTC Standards Technical Services（ （（ （Shanghai） ）） ） Co., Ltd. Page 4 of 4 Internal InternalInternal Internal of of of of PCB Back Side PCB Back SidePCB Back Side PCB Back Side

SGS-CSTC Standards Technical Services（ （（ （Shanghai） ）） ） Co., Ltd. FCC ID: TJJ-IL001 588 West Jindu Road,Songjiang District,Shanghai,China Telephone: +86 (0) 21 6191 5666 Fax: +86 (0) 21 6191 5655 [email protected] Report No.: SHEM120800118401 Page: 1 of 21 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e- document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to thesample(s) tested and such sample(s) are retained for 90 days only Member of the SGS Group (SGS SA) TEST REPORT Application No. : SHEM1208001184RF Applicant: Hopkins Manufacturing Corporation FCC ID: TJJ-IL001 Fundamental Frequency : 433.92MHz Equipment Under Test (EUT): Name: LED Remote Model No.: AUTOLED Standards: FCC 47 CFR PART 15 SUBPART C Date of Receipt: Aug. 17, 2012 Date of Test: Aug. 23, 2012 to Sep 2, 2012 Date of Issue: Sep 9, 2012 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Jim Xu Neil Zhang E&E Section Head E&E Project Engineer SGS-CSTC(Shanghai) Co., Ltd. SGS-CSTC(Shanghai) Co., Ltd. SGS-CSTC Standards Technical Services（ （（ （Shanghai） ）） ） Co., Ltd. FCC ID: TJJ-IL001 Report No.: SHEM120800118401 Page: 2 of 21 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e- document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to thesample(s) tested and such sample(s) are retained for 90 days only 2 Test Summary TEST ITEM FCC REFERANCE Test Method RESULT Powerline Conductived Emissions 15.207 ANSI C63.10: 2009 N/A 20dB Bandwidth 15.231(c) ANSI C63.10: 2009 Pass Limit of Transmission 15.231(a)(1) ANSI C63.10: 2009 Pass Radiated Emissions FCC Part15 209(a) and FCC Part15 205 ANSI C63.10: 2009 Pass SGS-CSTC Standards Technical Services（ （（ （Shanghai） ）） ） Co., Ltd. FCC ID: TJJ-IL001 Report No.: SHEM120800118401 Page: 3 of 21 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e- document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to thesample(s) tested and such sample(s) are retained for 90 days only 3 Contents Page 1 COVER PAGE ........................................................................................................................................... 1 2 TEST SUMMARY .................................................................................................................................................... 2 3 CONTENTS .............................................................................................................................................................. 3 4 GENERAL INFORMATION .................................................................................................................................... 4 4.1 CLIENT INFORMATION ....................................................................................................................................... 4 4.2 DETAILS OF E.U.T. ...............................…

Text truncated - open the document above for the full version.

SGS-CSTC Standards Technical Services (Shanghai)Co., Ltd. Page 1 of 3 APPENDIX 3 PHOTOGRAPHS OF EUT TEST SETUP SGS-CSTC Standards Technical Services (Shanghai)Co., Ltd. Page 2 of 3 RADIATED EMISSION TEST SETUP 30M-1G Above 1G SGS-CSTC Standards Technical Services (Shanghai)Co., Ltd. Page 3 of 3 Near Photo