UHBSX-940BLUETOOTH STEREO HEADSET

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

深圳市冠测技术服务有限公司 Shenzhen Certification Technology Service Co., Ltd TEL: 86-755-86375552 FAX: 86-755-26736857 Test Lab Attestation Letter This attestation is to confirm that the below listed device was tested at our Test Facilities located at: Test Lab Name: Shenzhen Certification Technology Service Co., Ltd Test Lab Address: 2F, Building B, East Area of Nanchang Second Industrial Zone, Gushu 2nd Road, Bao'an District, shenzhen 518126, China Test Lab Registration Number: 197647 Date of Test: 2012-5-30 Test Report Number: BST12050252Y-1E-3 Applicant Name: Shenzhen Shuaixian Electronic Equipment Co., Ltd. FCC ID: UHBSX-940 Name of Engineer(s) Performing Test: Eric Li Company Name of Engineer(s) Performing Test: Shenzhen Certification Technology Service Co., Ltd TEST LABORATORY: Signature of Authorized Representative of the Test Laboratory: Full Contact Name: Mark Zhu Position/Title: General Manager

External Photo

FCC Certification Label FCC ID: UHBSX-940 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Label Location on EUT EUT View/ FCC ID Label Location

Internal Photo Antenna

FCC PART 15.249 EMI MEASUREMENT AND TEST REPORT For Shenzhen Shuaixian Electronic Equipment Co., Ltd. No.10 Lane 3, Longxing Rd., Dakang Long Village, Henggang Town, Longgang Dist., Shenzhen, China FCC ID: UHBSX-940 June 13, 2012 This Report Concerns: Original Report Equipment Type: Bluetooth Stereo Headset Test Engineer: Eric Li Report No.: BST12050252Y-1E-3 Receive EUT Date/Test Date: May 27, 2012/ May 28 – June 5, 2012 Reviewed By: Christina Deng Prepared By: Shenzhen BST Technology Co.,Ltd. 3F,Weames Technology Building, No. 10 Kefa Road, Science Park, Nanshan District,Shenzhen,Guangdong,China Tel: 0755-267477513 Fax: 0755-267477513 ext.826 Note: The test report is specially limited to the above company and this particular sample only. It may not be duplicated without prior written consent of Shenzhen BST Technology Co.,Ltd. This report must not be used by the client to claim product certification,approval,or endorsement by NVLAP, NIST or any agency of the US Government. Shenzhen Shuaixian Electronic Equipment Co., Ltd. FCC ID: UHBSX-940 BST FCC ID REPORT: BST12050252Y-1E-3 Page 2/23 TABLE OF CONTENTS 1. GENERAL INFORMATION ....................................................................................................3 1.1. Report information ............................................................................................................3 1.2. Measurement Uncertainty .................................................................................................3 2. PRODUCT DESCRIPTION ......................................................................................................4 2.1. EUT Description ...............................................................................................................4 2.2. Block Diagram of EUT Configuration..............................................................................4 2.3. Support Equipment List ....................................................................................................5 2.4. Test Conditions .................................................................................................................5 3. FCC ID LABEL...........................................................................................................................6 4. TEST RESULTS SUMMARY ...................................................................................................7 Modifications ................................................................................................................................7 5. TEST EQUIPMENT USED .......................................................................................................8 6. ANTENNA REQUIREMENT ...................................................................................................9 6.1. Standard Applicable..........................................................................................................9 6.2. Antenna Connected Construction .....................................................................................9 6.3. Result ................................................................................................................................9 7. CONDUCTED POWER LINE TEST .....................................................................................10 7.1. Test Equipment ...............................................................................................................10 7.2. Test Procedure ................................................................................................................10 7.3. Test Setup........................................................................................................................10 7.4. Conducted Power line Emission Limits..........................................................................10 7.5. Conducted Power Line Test Result.................................................................................11 8. RADIATED EMISSION TEST ...............................................................................................13 8.1. Test Equipment ...............................................................................................................13 8.2. Test Procedure ................................................................................................................13 8.3. Radiated Test Setup ........................................................................................................13 8.4. Radiated Emission Limit.................................................................................................15 8.5. Radiated Emission Test Result .......................................................................................16 9. BAND EDGE .............................................................................................................................18 9.1. Test Equipment ...............................................................................................................18 9.2. Test Procedure ................................................................................................................18 9.3. Band Edge FCC 15.249(d) Limit ....................................................................................18 9.4. Band Edge Test Result ....................................................................................................19 Shenzhen Shuaixian Electronic Equipment Co., Ltd. FCC ID: UHBSX-940 BST FCC ID REPORT: BST12050252Y-1E-3 Page 3/23 1. GENERAL INFORMATION 1.1. Report information 1.1.1.This report is not a certificate of quality; it only applies to the sample of the specific product/equipment given at the time of its testing. The results are not used to indicate or imply that they are application to the similar items. In addition, such results must not be used to indicate or imply that BST approves recommends or endorses the manufacture, supplier or use of such product/equipment, or that BST i…

Text truncated - open the document above for the full version.

Radiated emissions test Conducted emissions test