VHC-AAI-BH1410-00ARC AUREM Bluetooth Earbuds

P/N: 95-08-BH1410US-02 Material: 128g C2S 折页：上、下对折（Logo 面朝外） 折页成品尺寸：260* 125mm 公差: +/- 1mm “L” mark for left USB Charge Quick
Start
Guide Contents
of
the
Packaging 1.ARC
Aurem
wireless
earbuds
x
2(L&R) 2.USB
to
mirco
USB
cable 3.ARC
Earhook
for
ARC
Aurem
earbuds
x
2(L&R) 4.Carrying
Charging
Case 5.Earcushion
x
2(Large
and
Small
size) Identifications Power Button “R” mark for right Manual Please visit our website WWW.ARCSTORE.ME to download the full user manual, if any Warnings/Caution/General Information Please check about warning information of the product container in separate sheets or check in our full manual before initial usage of the product. Warranty Please register warranty service at our website WWW.ARCSTORE.ME in 7 days after purchase Hotline Please get your support service at our Hotline : 1-844-ARC-7222 Copyright © 2014 ARC All rights reserved. Get Ready To Use 1. ARC Aurem two pieces earbuds have been paired during manufacturing. 2. Press and hold Power button of L earbud for 5 seconds,LED ring will turn from Blue/Red to fast flashing Blue. 3. Turn on the Bluetooth device 4. Select “ARC Aurem” in the Bluetooth device. 5. Paired automaticall (Enter “0000” if password required) 6. Press and hold Power button of R earbud for 2 seconds, 7. Play music at the Bluetooth device Phone 1. Make sure earbuds and cell are paired 2. Dial at cell and talk with earbuds 3. Accept incoming call by pressing Power button at L earbud 4. Refuse incoming call, press Power button for 2 seconds Remark: Talk feature will only be activated on L earbuds. FCC ID: VHC-AAI-BH1410-00 BC LED ring will turn from Blue/Red to flashing Red. 8. Adjust volume level on the Bluetooth device Reset 1. Turn the R earbud off 2. Press Power button for 12 seconds to clear old memory and reset 3. LED ring will flash between RED and BLUE three times 4. Repeat the above procedures on L earbud. 5. Start the processes of Pair processes Pair (If not getting the earbuds start to work) 1. In case paring is needed, do the following procedures. 2. Press and hold Power button of L earbud 5 seconds, LED ring will turn from Blue/Red to fast flashing Blue. Do the same for R earbud. 3. Fast press Power button of L earbud and LED ring turns to Red. Slow press Power button twice of R earbud and LED ring turns toBlue/Red. Both LED rings will flash slowly in Red when they are paired. 4. Press Power button of L earbud for 2 seconds to turn it off. Turn it on again by pressing Power button for 5 seconds until LED ring flashes fast in Blue. 5. Turn on Bluetooth device and choose “ARC Aurem” for pairing. 6. LED rings flash slowly in Blue at L earbud ,and LED rings flash slowly in Red 7. LED rings flash slowly in Blue at both L & R earbuds when getting music to both L & R earbuds. at R earbud when pairing with Bluetooth device is completed. 8. Adjust volume level on the Bluetooth device “The rating plate is located at the bottom enclosure of the apparatus.” “ Battery shall not be exposed to excessive heat such as sunshine, fire or the like” Caution Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. “ Warning for lithium battery” ity This device complies with part 15 of the FCC Rules.

INTERTEK TESTING SERVICES External Photos FCC ID: VHC-AAI-BH1410-00 external photos - 1 of 2 INTERTEK TESTING SERVICES External Photos FCC ID: VHC-AAI-BH1410-00 external photos - 2 of 2

MODEL NO:Aurem FCC ID:VHC-AAI-BH1410-00 L MODEL NO:Aurem FCC ID:VHC-AAI-BH1410-00 L 11.03 mm 5.02 mm 1.52 mm 1.33 mm Bh1410 丝印图纸 塑胶晒细纹 黑色 TOL UNLESS OTHERWISE STATED 10.1~50 100.1~ 50.1~100 ANGULAR SHEET 1 OF 1 SCALE : 1:1 MODEL : PART NO. DWG.NO.: CHECKED BY : APPR0VED BY :DATE : DATE : DESCRIPTION: AAi Acoustic Arc International Ltd. DRAWN BY : FINISH : MATERIAL: DATE : QTY. 1 UNIT:mm DO NOT SCALE DRAWING ±1/4° ±0.15 ±0.30 ±0.22 0~10±0.08 CHG. BY A0 DESCRIPTION / REVISIONAPPR. BYDATE A4 A1 REVISION 贺建成 2014/10/06 第一次发出 BH1410 BH1410黑色配灰色 比例：1：1

INTERTEK TESTING SERVICES Internal photos FCC ID: VHC-AAI-BH1410-00 internal photos - 1 of 3 INTERTEK TESTING SERVICES Internal photos FCC ID: VHC-AAI-BH1410-00 internal photos - 2 of 3 INTERTEK TESTING SERVICES Internal photos FCC ID: VHC-AAI-BH1410-00 internal photos - 3 of 3

Analysis Report The Equipment Under Test (EUT) is a Bluetooth Stereo Earbuds. The EUT is using adaptive frequency hopping for Bluetooth module. The Bluetooth can support Bluetooth 4.0 BLE and Bluetooth 3.0. The Bluetooth portion operates in frequency range from 2402MHz to 2480MHz The EUT is powered by 3.7 VDC Li-ion rechargeable battery. The Mirco-USB port is for charging internal rechargeable battery of EUT only. The left earbud and the right earbud are identical in RF circuit. The only differences between the left earbud and the right earbud are audio signal output due to software setting. 2.4GHz Bluetooth Module: Modulation Type: GFSK Antenna Type: Integral, Internal Frequency Range for Bluetooth 3.0: 2402MHz - 2480MHz, 1MHz channel spacing, 79 channels Nominal field strength is 103.9dB μV/m @ 3m Production Tolerance of field strength is 100.0 dB μV/m to 104.0 dBμV/m Antenna gain is 0dBi 2.4GHz Bluetooth Module: Modulation Type: GFSK Antenna Type: Integral, Internal Frequency Range for Bluetooth 4.0(BLE):2402MHz -2480MHz, 2MHz channel spacing, 40 channels. Nominal field strength is 103.9dB μV/m @ 3m Production Tolerance of field strength is 100.0 dB μV/m to 104.0 dBμV/m Antenna gain is 0dBi Based on the Maximum allowed field strength of production tolerance was 104.0dBμV/m at 3m in frequency 2.4GHz, thus; The EIRP = [(FS*D) ^2*1000 / 30] = 7.54mW Conducted power = Radiated Power (EIRP) – Antenna Gain So; Conducted Power = 7.54mW The SAR Exclusion Threshold Level: = 3.0 * (min. test separation distance, mm) / sqrt(freq. in GHz) = 3.0 * 5 / sqrt (2.48) mW = 9.53 mW Since the above conducted output power is well below the SAR Exclusion threshold level, so the EUT is considered to comply with SAR requirement without testing.

lntertek Valued Quality. Delivercd, lssuing Laboratory: lntertek Testing Services Hong Kong Limited HKAS has accreditêd this laboratory (HOKLAS 005 - TEST) under HOKLqS for specifìc laboratory activities as l¡sted ¡n tho HOKLqS directory of accredited laboratories. Report No.: 141 00530HKG-001 TEST REPORT Acoustic Arc lnternational Ltd. Application For Certification (Original Grant) (FCC lD: VHG-AAI-BHl410-00) Transceiver Prepared and Checked by: Assistant Engineer lntertek's standard Terms end Conditions can be obtained at our wobslte http:/ ilww.¡ntedok.conúterms/. This report shall not be reproduced, except in full. Thls report ¡s for the €xclusivs use of lnterlek's Client and ls pfovided pursuant lo the agreernent betwesn lntsrtek and ¡ts Clisnt. lntertek's respons¡bility and liability sre lim¡ted to the terro and condltions of th€ agre€mnt. lntert€k sssums no liablllty lo any perty, other than to ths Client in sccordanæ wilh the agreemnt, for any loss, expense or damge occaslon€d by ths use ol thls r€porl. Only the Client ls authorized to permit copying or distribution of thls report and lhen only ln ¡ts enürety. Any uss of ths lnt€rtek name or ons of its mrks for tho sale or advert¡s€rent of the tosted mter¡al, product or sery¡cs must f¡rst be approved ln wr¡tlng by lntertek. The obseruations End test r€sults ln th¡s r€port are rslsvant only lo the sample tested. Th¡s r€port by itself do€s not ¡mply that the mterlal, product, or sêru¡co ls or has ever boon undor an lnterlek cort¡llcation program. lntertek Testing Services Hong Kong Ltd. 2/F., Garment Centr€, 576 Castle P€ak Road, Kowloon, Hong Kong. Tel: (852) 2173 8888 Fax: (852) 2785 5487 Webs¡te: www.hk.intert€k-etlsemko.com Approved by: Supervisor Date: November 27,2014 Issuing Laboratory: Intertek Testing Services Hong Kong Limited HKAS has accredited this laboratory (HOKLAS 005 – TEST) under HOKLAS for specific laboratory activities as listed in the HOKLAS directory of accredited laboratories. Report No.: 14100530HKG-001 i FCC ID: VHC-AAI-BH1410-00 Intertek Testing Services Hong Kong Ltd. 2/F., Garment Centre, 576 Castle Peak Road, Kowloon, Hong Kong. Tel: (852) 2173 8888 Fax: (852) 2785 5487 Website: www.hk.intertek-etlsemko.com GENERAL INFORMATION Grantee: Acoustic Arc International Ltd. Grantee Address: Unit 311B, 3/F., IC Development Centre, No. 6 Science Park West Avenue, Shatin, N.T., Hong Kong. Contact Person: George Chan Tel: (852) 2607 4015 Fax: (852) 2607 4016 e-mail: [email protected] Manufacturer: ShengHai Electronics (Shenzhen) Ltd. Manufacturer Address: Block 17&18, Hui Ming Ying Industry, YanChuan, SongGang, Baoan County, Shenzhen, China 518105. Brand Name: ARC Tested Model: BH1410US Additional Model: Aurem, Aurem2, Aurem3, Aurem4, Parvus, Parvus2, Parvus3, Parvus4, Auris, Auris2, Auris3, Auris4 Type of EUT: Transceiver Description of EUT: ARC AUREM Bluetooth Earbuds Serial Number: N/A FCC ID: VHC-AAI-BH1410-00 Date of Sample Submitted: October 15, 2014 Date of Test: October 15, 2014 to November 25, 2014 Report No.: 14100530HKG-001 Report Date: November 27, 2014 Environmental Conditions: Temperature: +10 to 40°C Humidity: 10 to 90% Issuing Laboratory: Intertek Testing Services Hong Kong Limited HKAS has accredited this laboratory (HOKLAS 005 – TEST) under HOKLAS for specific laboratory activities as listed in the HOKLAS directory of accredited laboratories. Report No.: 14100530HKG-001 ii FCC ID: VHC-AAI-BH1410-00 Intertek Testing Services Hong Kong Ltd. 2/F., Garment Centre, 576 Castle Peak Road, Kowloon, Hong Kong. Tel: (852) 2173 8888 Fax: (852) 2785 5487 Website: www.hk.intertek-etlsemko.com SUMMARY OF TEST RESULT TEST SPECIFICATION REFERENCE RESULTS Radiated Emission Radiated Emission on the Bandedge 15.249 Pass Radiated Emission in Restricted Bands 15.205 Pass The equipment under test is found to be complying with the following standards: FCC Part 15, October 1, 2012 Edition Note: 1. The EUT uses a permanently attached antenna which, in accordance to section 15.203, is considered sufficient to comply with the pervisions of this section. 2. Pursuant to FCC part 15 Section 15.215(c), the 20 dB bandwidth of the emission was contained within the frequency band designated (mentioned as above) which the EUT operated. The effects, if any, from frequency sweeping, frequency hopping, other modulation techniques and frequency stability over excepted variations in temperature and supply voltage were considered. Issuing Laboratory: Intertek Testing Services Hong Kong Limited HKAS has accredited this laboratory (HOKLAS 005 – TEST) under HOKLAS for specific laboratory activities as listed in the HOKLAS directory of accredited laboratories. Report No.: 14100530HKG-001 iii FCC ID: VHC-AAI-BH1410-00 Intertek Testing Services Hong Kong Ltd. 2/F., Garment Centre, 576 Castle Peak Road, Kowloon, Hong Kong. Tel: (852) 2173 8888 Fax: (852) 2785 5487 Website: www.hk.intertek-etlsemko.com Table of Contents 1.0 General Description....................................................................................... 1 1.1 Product Description ...................................................................................... 1 1.2 Related Submittal(s) Grants .......................................................................... 1 1.3 Test Methodology ......................................................................................... 2 1.4 Test Facility .................................................................................................. 2 2.0 System Test Configuration ............................................................................ 3 2.1 Justification................................................................................................... 3 2.2 EUT Exercising Software .............................................................................. 4 2.3 Special Accessories...................................................................................... 4 2.4 Measurement Uncertai…

Text truncated - open the document above for the full version.

INTERTEK TESTING SERVICES The Worst Case Configuration Photographs FCC ID:VHC-AAI-BH1410-00 config photos (radiated emission) - 1 of 1 Front Back