VS9HF-1BT Gamepad for PS3

HF-1 WIRELESS CONTROLLER FOR PS3™ ERGONOMIC FPS CONTROLLER MODEL G302A This product is not designed, manufactured, sponsored or endorsed by Sony Computer Entertainment Inc. or any of its divisions. PS3™ is a trademark of Sony Computer Entertainment Inc. Specification & appearance are subject to change without prior notice. Copyright © 2009, 2010 GBB Group. All Rights Reserved. 06 | PAIRING ASSIGNING PORTS | 07 assigning ports To assign the HF-1 to a different port, follow the instructions below: Controller assigned to port 1. Controller assigned to port 7. pairing your controller The HF-1 must be paired to your PS3™ to use it wirelessly. To enable pairing, connect your controller to the PS3™ via a USB cable and pairing will happen automatically. Once paired, one or two LEDs within the crescent of the controller will light depending on which port the controller has been assigned to. 1. Press X on Accessory Settings.2. Press X on Reassign Controllers.3. Scroll to assign the controller to your desired port. 08 | OPERATIONOPERATION | 09 02 flip switch The Flip switch swaps the functions assigned to the L1 & L2 and R1 & R2 buttons. The HF-1 will go into sleep mode if not used for 10 minutes. To wake up the controller, press the Home button. operating your controller To power on your controller, press and hold the home button for 2 seconds until a red LED appears in the crescent. To power off your controller, press and hold the home button for 1 second. 01 turbo function Pressing an action button assigned with turbo will simulate the button being pressed rapidly e.g. “boost firepower”. To enable turbo function: While pressing the Turbo button, press & release the action button you wish to turbo. To switch turbo off, repeat the procedure above. NOTE: More than one button can be assigned the turbo function at any one time. To clear all turbo functions: Press & hold the Turbo button ONLY for 12 seconds.

FCC ID: VS9HF‐1

FCC ID: VS9HF‐1

FCC ID: VS9HF-1 Report No.: STS100807F2 INTERNAL PHOTO OF SAMPLE - 1 INTERNAL PHOTO OF SAMPLE - 2 FCC ID: VS9HF-1 Report No.: STS100807F2 Internal of Bluetooth module-1 Internal of Bluetooth module-2

HF-1 Controller for PS3 Operation Principle August 12, 2010 The HF-1 controller has two microcontrollers on it, MTB0125B and BC417. The MTB0125B is an 8-bit MCU that interprets keystrokes, controls the LED indicators and motor, provides USB connectivity and communicates with the wireless module. There are four LED indicators on the controller that displays the status of the controller. When the controller is connected to PS3 with a USB cable, it can be used as a wired controller. Furthermore, the pairing is done when connected via USB. The BC417 is a single-chip solution integrating radio, baseband, and microcontroller. The data rate is at 3Mbps. The non-removable antenna is an embedded PCB antenna matching is done by using lumped inductors and capacitors. The radio system uses 2.4GHz (the frequency range is 2402 - 2480MHz) FHSS, which consists of 79 channels and the channel spacing is 1MHz. The controller can be powered by USB bus or 2 AA-size batteries and output voltage is regulated to 3.3V. The total current consumption of controller is about 80mA when connected wirelessly. It will enter sleep mode if no button is pressed afte r 10 minutes.Its modulation type is FHSS, and the crystal frquency is 12MHz, the antenna type is internal.

FCC 47 CFR PART 15 SUBPART C TEST REPORT For Applicant : Good Better Best Ltd. Address : 11 Willow Way London N3 2PL，London，United Kingdom Product Name : HF-1 Controller for PS3 Model Name : HF-1 Brand Name : Gioteck FCC ID : VS9HF-1 Report No. : STS100807F2 Date of Issue : August. 20, 2010 Issued by :Shenzhen Super Test Service Technology Co., Ltd. Address : No.5, Langshan 2nd Rd., North Hi-Tech Industrial park, Nanshan, Shenzhen, Guangdong, China Tel : 86-755-2795 8522 Fax : 86-755-2795 8022 The report consists 35 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by STS. The test results in the report only apply to the tested sample. The test report shall be invalid without all the signatures of testing engineers, reviewer and approver. FCC ID: VS9HF-1 Report No.: STS100807F2 Page 2 of 35 TABLE OF CONTENTS 1．VERIFICATION OF CONFORMITY .............................................................................................................. 3 2. GENERAL INFORMATION ............................................................................................................................ 4 2.1 Product Information ...................................................................................................................................... 4 2.2 Objective ...................................................................................................................................................... 5 2.3 Test Standards and Results .......................................................................................................................... 5 2.4 Environmental Conditions............................................................................................................................. 5 3. TEST FACILITY.............................................................................................................................................. 6 3.1TEST FACILITY............................................................................................................................................. 6 3.2 GENERAL TEST PROCEDURES ................................................................................................................ 6 3.3 FCC PART 15.205 RESTRICTED BANDS OF OPERATIONS..................................................................... 7 4. SETUP OF EQUIPMENT UNDER TEST ....................................................................................................... 8 4.1 SUPPORT EQUIPMENT.............................................................................................................................. 8 4.2 TEST EQUIPMENT LIST ............................................................................................................................. 9 5. 47 CFR Part 15C 15.249 Requirements....................................................................................................... 10 5.1 Spurious Emission Test .............................................................................................................................. 10 5.1.1 Requirement............................................................................................................................................ 10 5.1.2 Test Description ........................................................................................................................................11 5.1.3 Test Description ....................................................................................................................................... 12 5.1.4 Test Result............................................................................................................................................... 13 5.2 Band Edge ................................................................................................................................................. 22 5.2.1 Requirement............................................................................................................................................ 22 5.2.2 Test Description ....................................................................................................................................... 22 5.2.3Test Result................................................................................................................................................ 22 5.3 LINE CONDUCTED EMISSION TEST ....................................................................................................... 24 5.3.1. LIMITS OF LINE CONDUCTED EMISSION TEST ................................................................................ 24 5.3.2. BLOCK DIAGRAM OF TEST SETUP..................................................................................................... 24 5.3.3. PRELIMINARY PROCEDURE OF LINE CONDUCTED EMISSION TEST ............................................ 25 5.3.4. FINAL PROCEDURE OF LINE CONDUCTED EMISSION TEST .......................................................... 25 5.3.5. TEST RESULT OF LINE CONDUCTED EMISSION TEST .................................................................... 26 APPENDIX 1 .................................................................................................................................................... 28 PHOTOGRAPHS OF TEST SETUP................................................................................................................. 28 APPENDIX 2 .................................................................................................................................................... 30 PHOTOGRAPHS OF EUT ............................................................................................................................... 30 FCC ID: VS9HF-1 Report No.: STS100807F2 Page 3…

Text truncated - open the document above for the full version.

FCC ID: VS9HF-1 Report No.: STS100807F2 CE TEST SETUP RE TEST SETUP