VVG53631638TXWireless Indoor/Outdoor Thermometer

IN MAX MIN OUT MAX MIN CH1 CH2 CH3 R 2. Receiver: INSTRUCTION MANUAL MODEL 536, 31638 WIRELESS THERMOMETER IN OUT And then. FEATURES: IN OUT CH1 Place 2 AAA batteries into the battery compartment, the display will show. A. MODETo switch or B. CHANNEL: Press CHANNEL key once, display shows. IN OUT CH3 IN OUT IN OUT IN OUT Press CHANNEL key to choose the preferred channels from 1-3. C. MAX/MIN: To show indoor/ outdoor maximum/minimum temperature press MAX/MIN key. Hold it for 2 seconds, to clean ther ecordo f m aximum and minimum temperature. D. RESETPressR ESETk e y o n the back, to reset the unit. E. Temperature trend: Temperature is falling. The unit is searching and showing outdoor temperature for channels from 1-3 automatically and consecutively. If there's no outdoor sensor in the channel, the outdoor temperature will show blank Press CHANNEL key 3 more times, display shows. ,, ,, 1. Batteries required: Receiver: 2 - AAA Transmitter: 2 - AAA F. Low Battery Indication: IN OUT IN OUT Low battery for receiver Low battery for transmitter IN OUT G. Data Receiving Indication 3. Transmitter: (Back View) TXRESET1 2 3 AAA 1.5V AAA 1.5V A.TX: Press this key, to manually send signals to receiver for testing. B.RESET: To reset the trabsmitter. C.1 2 3: channels from 1-3. If switched on 1, the receiver will show CH1 for outdoor temperature. A maximum 3 transmitters could be used to monitor outdoor temperatures. The TX6360 comes with only one transmitter. Additional transmitters can be purchased from Maverick Industries, Inc. for $7.50/ea plus $6.25 shipping and handling. Mail checks and request for TX6360 TRANSMITTER to: Maverick Customer Service 94 Mayfield Ave. Edison NJ 08837 Use a small Phillips head screw driver to unscrew the battery compartment and insert 2 AAA batteries. FCC STATEMENT 1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the users a uthorityto o peratethee quipment.

POWER SUPPLY DC 3V MCU CRYSTAL 32.768kHz TRANSMIT MODULE433MHz TEMPERATURE SENSOR 536 & 31638(TX) BLOCK DIAGRAM KAYPAD

ID label & location info. label location FCC ID: VVG53631638TX

536&31638 Operation Description Frequency: 433.9MHz±100kHz Modulation Type: ASK Turn on the switch to select your desired position, open the battery compartment and insert 2 AAA batteries, then MCU will reset itself, MCU will collect data of temperature sensor ( collect data one time per 55s ), Upon receipt of signal, the MCU will calculate and code it , then it will transmit signals modulated on 433.9MHz RF wave.(transmit one time per 55s)

55 44 33 22 11 D D C C B B A A LD536 & C31637 00 发射机 12 Thursday, February 01, 2007 <Gtwei> <A4> Title: Size: Rev: Date: Sheet of Design:Check:Appro: 深圳市三福达电子有限公司 Part No: SEG8 C3 P42 SEG13 C0 C0 C2 SEG11 P40 P44 SEG13 SEG2 P30 SEG2 SEG3 SEG4 SEG5 P44 C2 P43 P30 P33 SEG6 SEG7 C1 SEG4 P43GND SEG3 SEG10 P40 C3 C1 P32 SEG9 SEG7 SEG9 SEG8SEG6 SEG5 SEG10 P32 P42 SEG1 P31P33 SEG1 SEG11 P41 SEG12 SEG12 P31 VCC VCC VCC VCC C1 20P BT13V 12 C2 20P RT 51K R101 1M R104 510R U1 SG8LP128 1 2 3 4 5 6 7 8 9 10 11 12 13 14 1516171819202122232425 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40414243444546474849505152 S7 S6 S5 S4 S3 S2 S1 S0 TEST RESET LXIN LOUT VDD SND GNDP30P31P32P33P40P41P42P43P44C3 C2 C1 C0 S31 S30 S29 S28 S27 S26 S25 S24 S23 S22 S21 S20S19S18S17S16S15S14S13S12S11S10 S9S8 Q2 PNP R2810K R21K C101 104 Q1 H9014 1 23 R3 510K JP1 RESET + C3100U LCD1 LCD 1 2 3 4 6 7 8 9 10 11 12 13 14 15 16 5 17 COM0 COM1 COM2 COM3 SEG29 SEG28 SEG27 SEG26 SEG25 SEG24 SEG23 SEG22 SEG21 SEG20 SEG19 SEG30 SEG18 R7 27K R250R C4 104 R4 510K R5100R TX1 D1LED Y132.768KHz C/F1 JP2HEADER 3/SM 123 R30 27K R29 50K R260R R23 33K R21 0R R22 6.8K SW1SS-13D07 1234 R6 82K R1 110K RF-OUT

Page 1 of 28 FCC ID: VVG53631638TX ACCURATE TECHNOLOGY CO. LTD REPORT NO. ATE20072882 APPLICATION CERTIFICATION On Behalf of Shenzhen San Fu Da Electronics Co., Ltd. Wireless Indoor/Outdoor Thermometer Model No.: 536, 31638 FCC ID: VVG53631638TX Prepared for : Shenzhen San Fu Da Electronics Co., Ltd. Address : 6/F., Block B, Huali Industrial Building, District 28, Baoan Shenzhen, China Prepared by : ACCURATE TECHNOLOGY CO. LTD Address : F1, Bldg. A, Changyuan New Material Port, Keyuan Rd. Science & Industry Park, Nanshan, Shenzhen, Guangdong P.R. China Tel: (0755) 26503290 Fax: (0755) 26503396 Report Number : ATE20072882 Date of Test : November 27, 2007 Date of Report : November 29, 2007 Page 2 of 28 FCC ID: VVG53631638TX ACCURATE TECHNOLOGY CO. LTD REPORT NO. ATE20072882 TABLE OF CONTENTS Description Page Test Report Certification 1. GENERAL INFORMATION .......................................................................................................... 4 1.1. Description of Device (EUT)....................................................................................................................4 1.2. Description of Test Facility ......................................................................................................................4 1.3. Measurement Uncertainty.........................................................................................................................4 2. MEASURING DEVICE AND TEST EQUIPMENT ..................................................................... 5 3. THE FIELD STRENGTH OF RADIATION EMISSION ............................................................ 6 3.1. Block Diagram of Test Setup....................................................................................................................6 3.2. The Field Strength of Radiation Emission Measurement Limits..............................................................6 3.3. Configuration of EUT on Measurement ...................................................................................................7 3.4. Operating Condition of EUT ....................................................................................................................7 3.5. Test Procedure ..........................................................................................................................................7 3.6. The Field Strength of Radiation Emission Measurement Results ............................................................8 4. 20DB OCCUPIED BANDWIDTH ................................................................................................ 10 4.1. Block Diagram of Test Setup..................................................................................................................10 4.2. The Bandwidth of Emission Limit According To FCC Part 15 Section 15.231(c) ................................10 4.3. EUT Configuration on Measurement .....................................................................................................11 4.4. Operating Condition of EUT ..................................................................................................................11 4.5. Test Procedure ........................................................................................................................................11 4.6. Measurement Result ...............................................................................................................................12 5. DURATION TIME AND SILENT PERIOD MEASUREMENT............................................... 13 5.1. Block Diagram of Test Setup..................................................................................................................13 5.2. Duration Time and silent period measurement according to FCC Part 15 Section 15.231(e) ................13 5.3. EUT Configuration on Measurement .....................................................................................................14 5.4. Operating Condition of EUT ..................................................................................................................14 5.5. Test Procedure ........................................................................................................................................14 5.6. Measurement Result ...............................................................................................................................15 6. AVERAGE FACTOR MEASUREMENT .................................................................................... 16 6.1. Block Diagram of Test Setup..................................................................................................................16 6.2. Average factor Measurement according to ANSI 63.4: 2003.................................................................16 6.3. EUT Configuration on Measurement .....................................................................................................17 6.4. Operating Condition of EUT ..................................................................................................................17 6.5. Test Procedure ........................................................................................................................................17 6.6. Measurement Result ...............................................................................................................................18 APPENDIX I ( TEST CURVES) (9pages) Page 3 of 28 FCC ID: VVG53631638TX ACCURATE TECHNOLOGY CO. LTD REPORT NO. ATE20072882 Test Report Certification Applicant : Shenzhen San Fu Da Electronics Co., Ltd. Manufacturer : Shenzhen San Fu Da Electronics Co., Ltd. EUT Description : Wireless Indoor/Outdoor Thermometer (A) MODEL NO.: 536, 31638 (B) SERIAL NO.: N/A (C) POWER SUPPLY: DC 3.0V (AAA Batteries ̄2) Measurement Procedure Used: FCC Rules and Regulations Part 15 Subpart C Section 15.231: 2007 & ANSI 63.4: 2003 The device described above…

Text truncated - open the document above for the full version.