VZPNFC-002HF RFID Module

User's manual 1. INTRODUCTION The EUT-002 is a smallest module in the market and highly integrated transmission module for contactless communication at RFID 13.56 MHz (HF) applications. Its simplified interface, ultra low power consumption, standard RF output port and superior performance, make it easy to integrate any device with EUT/RFID technology. The EUT-002 is a highly integrated transmission module for contactless communication at 13.56 MHz. The embedded firmware handles the ISO 14443A and MIFARE reader protocol as well as the basic FeliCa Reader protocol and the complete EUT IP-1 protocol. 1.1 Module and EUT Features ■ Module profile and Footprint 20(mm)x20(mm)x 3.2(mm) ■ EUT profile and Footprint 90(mm)x60(mm)x 8(mm) ■ Internal oscillator to connect 27.12 MHz crystal ■ Supports ISO/IEC 14443A/Mifare ■ Supports Mifare Classic encryption in reader/writer mode ■ Supports Mifare higher transfer speed communication at 212 kbit/s and 424 kbit/s ■ Supports contactless communication according to the FeliCa scheme at 212 KBaud and 424 KBaud ■ Integrated RF interface for EUT IP-1 up to 424 Kbaud ■ Ultra low power consumption ■ 2.5 - 3.6 V power supply ■ Easy Connection to Flex antenna ■ Supported High Speed Serial UART (similar to RS232 with 0 and PVDD voltage levels) host interface 1.2 Operating modes: The EUT-002 supports 2 different operating modes • Reader/writer mode for ISO14443A Mifare and FeliCa cards • EUT Mode (EUT IP-1 mode) The Analog circuitry handles the modulation and demodulation of the analog signals according to the reader /writer mode and EUT mode communication scheme. The RF level detector detects the presence of an external RF field at 13.56 MHz. The mode detector detects a MIFARE, FeliCa or EUT coding of an incoming signal in order to prepare the internal receiver to demodulate signals that are sent to the EUT-002 Module. The integrated contactless UART interface and the firmware handle the protocol requirements for the communication schemes including the RF based protocols as well as the protocols for host communication. The microcontroller with its embedded firmware allows autonomous management of communication both on the RF interface and with the host. Various host interfaces are implemented to fulfil different customer requirements. 1.2.1 Reader/Writer Operating mode The EUT-002 can act as a reader / writer for ISO14443A/MIFARE® or FeliCa cards. In the reader/ writer mode the EUT-002 EUT enables communication to a passive ISO14443A/MIFARE or FeliCa card. The EUT-002’s firmware and contactless UART handle the ISO 14443A/MIFARE and FeliCa protocol. 1.2.2 EUT MODE EUT communication differentiates between an active and a passive communication. Active EUT Mode means both the initiator and the target are using their own RF field for the communication. Passive EUT Mode means that the target answers to an initiator command in a load modulation scheme. The initiator is active i.e. generating the RF field. initiator: generates RF field @ 13.56 MHz and starts the EUT communication Target: responds to initiator commands either using load modulation scheme (RF field continuously generated by Initiator) or using modulation of self generated RF field (no RF field generated by initiator) 2.Mechanical Characteristics 2.1 Dimensions 2.2 -X Pinning Diagram EUT-002 Pin Assignment (Top view) 2.3 -X Pin Description Port Pin I/O Description RF_Tx1 1 O Transmitter 1: delivers the modulated 13.56 MHz energy carrier RF_GND 2 PWR Transmitter Ground RF_Tx2 3 O Transmitter 2: delivers the modulated 13.56 MHz energy carrier RF_Rx 4 I Receiver Input: Input pin for the reception signal, which is the load modulated 13.56 MHz energy carrier from the antenna circuit USB_D- 5 IO USB D- USB_D+ 6 IO USB D+ USB_5V 7 PWR USB power supply. USB_GND 8 PWR Module substrate ground IRQ 9 IO Interrupt request: Output to signal an interrupt event to the host UART_Rx 10 IO Serial UART Rx (similar to RS232 with 0 and PVDD voltage levels) UART_Tx 11 IO Serial UART Tx (similar to RS232 with 0 and PVDD voltage levels) H_REQ 12 IO Request or acknowledge line from the host SCK 13 IO Serial interface clock. In test mode this signal is used as input and output test signal DVdd+3.3V 14 PWR Digital Power Supply PVdd 15 PWR Pad power supply GND 16 PWR Module substrate ground 2.4 Absolute maximum ratings Symbol Parameter Conditions Min Typ Max Unit USB_5V USB Supply Voltage (USB mode) 4.2 5 5.25 V Supply Voltage (non USB mode) VBUS = DVDD; Gnd = 0 V 2.5 3.3 3.6 V DVdd_3.3V Supply Voltage DVDD Gnd = 0 V 2.5 3.3 3.6 V PVDD Supply Voltage for host interface Gnd = 0 V1.6 3.6 V IUSB_5V Maximum load current (USB mode) measured on VBUS180 mA Maximum Inrush current limitation At power up (curlimoff =0) 130 mA IDVDD Transmitter Supply Current During RF Transmission, DV DD= 3 V 60 130 mA Ptotusb continuous total power dissipation in USB mode T amb = -30 to +85 °C 0.6 W Ptot continuous total power dissipation in non USB mode T amb = -30 to +85 °C 0.2 W Tamb operating ambient temperature -30 +85 °C 3.EUT Mechanical Characteristics 3.1 EUT(Component-U1)-MAX3232 Pin Description RS-232 Serial Protocol(+12V~-12V) to UART TTL Protocol(+3V~-3V) Port Pin I/O Description C1+ 1 PWR Positive Terminal of Voltage-Doubler Charge-Pump Capacitor U+ 2 PWR +5.5V Generated by the Charge Pump C1- 3 PWR Negative Terminal of Voltage-Doubler Charge-Pump Capacitor C2+ 4 PWR Positive Terminal of Voltage-Doubler Charge-Pump Capacitor C2- 5 PWR Negative Terminal of Voltage-Doubler Charge-Pump Capacitor U- 6 PWR -5.5V Generated by the Charge Pump T2OUT 7 IO RS-232 Transmitter Outputs R2IN 8 IO RS-232 Receiver Inputs R2OUT 9 IO TTL/CMOS Receiver Outputs T2IN 10 IO TTL/CMOS Transmitter Inputs T1IN 11 IO TTL/CMOS Transmitter Inputs R1OUT 12 IO TTL/CMOS Receiver Outputs R1IN 13 IO RS-232 Receiver Inputs T1OUT 14 IO RS-232 Transmitter Outputs GND 15 PWR Ground VDD 16 PWR Power Supply 3.2 EUT(Component-U2)-XX1117 Pin Description Power 5V to 3.3v LDO Port Pin I/O Des…

Text truncated - open the document above for the full version.

FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B1 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255 APPENDIX B. Photographs of EUT FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B2 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255 FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B3 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255 FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B4 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255

FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B4 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255 1

PRODUCT CODE：jogtek POWER：3.3V MODEL：NFC-002 FCC ID：VZPNFC-002 MANUFACTURED：SEP 2009 MADE IN TAIWAN

FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B1 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255 APPENDIX B. Photographs of EUT FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B2 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255 FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B3 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255 FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B4 OF B4 TEL : 886-2-2696-2468 ISSUED DATE : Nov. 20, 2009 FAX : 886-2-2696-2255

FCC TEST REPORT Report No.: FR9O1322 SPORTON International Inc. Report Format Version: b FCC RADIO TEST REPORT according to 47 CFR FCC Part 15 Subpart C § 15.225 Equipment : HF RFID Module Model No. : NFC-002 Brand Name : jogtek Filing Type : New Application Applicant : Jogtek Corp. 7F., No. 300, Yangguang St., Neihu District, Taipei 114, Taiwan FCC ID : VZPNFC-002 Manufacturer : Jogtek Corp. 7F., No. 300, Yangguang St., Neihu District, Taipei 114, Taiwan Received Date : Nov. 03, 2009 Final Test Date : Nov. 16, 2009 Statement The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. The measurements and test results shown in this test report were made in accordance with the procedures and found in compliance with the limit given in ANSI C63.4-2003 and 47 CFR FCC Part 15 Subpart C. The test equipment used to perform the test is calibrated and traceable to NML/ROC. SPORTON International Inc. 6F, No. 106, Sec. 1, Hsin Tai Wu Rd., Hsi Chih, Taipei Hsien, Taiwan, R.O.C. FCC TEST REPORT Report No.: FR9O1322 SPORTON International Inc. Page No. : i of ii TEL : 886-2-2696-2468 Issued Date : Dec. 15, 2009 FAX : 886-2-2696-2255 FCC ID : VZPNFC-002 Table of Contents 1 SUMMARY OF THE TEST RESULT ...................................................................................................................... 2 2 GENERAL INFORMATION..................................................................................................................................... 3 2.1 Product Details ........................................................................................................................................................................................ 3 2.2 Table for Test Modes .............................................................................................................................................................................. 3 2.3 Table for Testing Locations ..................................................................................................................................................................... 3 2.4 Table for Supporting Units....................................................................................................................................................................... 3 2.5 EUT Operation during Test ..................................................................................................................................................................... 4 2.6 Test Configurations ................................................................................................................................................................................. 4 3 TEST RESULT ........................................................................................................................................................ 6 3.1 AC Power Line Conducted Emissions Measurement.............................................................................................................................. 6 3.2 Field Strength of Fundamental Emissions and Mask Measurement ....................................................................................................... 9 3.3 20dB Spectrum Bandwidth Measurement............................................................................................................................................. 12 3.4 Radiated Emissions Measurement........................................................................................................................................................ 14 3.5 Frequency Stability Measurement......................................................................................................................................................... 23 3.6 Antenna Requirements.......................................................................................................................................................................... 25 4 LIST OF MEASURING EQUIPMENTS ................................................................................................................. 26 5 TEST LOCATION.................................................................................................................................................. 28 6 TAF CERTIFICATE OF ACCREDITATION .......................................................................................................... 29 APPENDIX A. TEST PHOTOS ........................................................................................................................ A1 ~ A5 APPENDIX B. PHOTOGRAPHS OF EUT ....................................................................................................... B1 ~ B4 FCC TEST REPORT Report No.: FR9O1322 SPORTON International Inc. Page No. : ii of ii TEL : 886-2-2696-2468 Issued Date : Dec. 15, 2009 FAX : 886-2-2696-2255 FCC ID : VZPNFC-002 History of This Test Report Original Issue Date: Dec. 15, 2009 Report No.: FR9O1322 ■ No additional attachment. □ Additional attachment were issued as following record: Attachment No. Issue Date Description 15.205(a) 15.209(a) 47 CFR FCC Part 15 Subpart C Further, this requirement does not apply to intentional radiators that must be professionally installed. FCC TEST REPORT Report No.: FR9O1322 SPORTON International Inc. Page No. : 1 of 29 TEL : 886-2-2696-2468 Issued Date : Dec. 15, 2009 FAX : 886-2-2696-2255 FCC ID : VZPNFC-002 CERTIFICATE OF COMPLIANCE according to 47 CFR FCC Part 15 Subpart C § 15.225 Equipment : HF RFID Module Model No. : NFC-002 Brand Name : jogtek Applicant : Jogtek Corp. 7F., No. 300, Yangguang St., Neihu District, Taipei 114, Taiwan Sporton International as requested by the applicant to evaluate the EMC performance of the product sample received on Nov. 03, 2009 would like to declare that the tested sample has been …

Text truncated - open the document above for the full version.

FCC TEST REPORT Report No.: FR9O1322 Page No. : A1 of A5 FCC ID : VZPNFC-002 Appendix A. Test Photos FCC TEST REPORT Report No.: FR9O1322 Page No. : A2 of A5 FCC ID : VZPNFC-002 1 Photographs of Radiated Emissions Test Configuration For radiated emissions 9kHz~30MHz FRONT VIEW REAR VIEW FCC TEST REPORT Report No.: FR9O1322 Page No. : A3 of A5 FCC ID : VZPNFC-002 FRONT VIEW REAR VIEW FCC TEST REPORT Report No.: FR9O1322 Page No. : A4 of A5 FCC ID : VZPNFC-002 For radiated emissions 30MHz~1GHz FRONT VIEW REAR VIEW FCC TEST REPORT Report No.: FR9O1322 Page No. : A5 of A5 FCC ID : VZPNFC-002 FRONT VIEW REAR VIEW