WUACCM660165-196WIRED OPTICAL MOUSE

FCC warning statement This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection ag ainst har mful interference in a residential installation. This equipment generates, uses and can ra diate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular insta llation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interf erence by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experien ced radio/TV technician for help WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (current) 1.0 1.0 Nov-14-2006 Revised wording (current) 1.0 2.0 Sept–25-2007 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 2.0 PAWAS Trading Gmbh Date:2010-11-25 To: SIEMIC, INC. 2206 Ringwood Avenue, San Jose, CA 95131 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, PAWAS Trading Gmbh hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): Product: WIRED OPTICAL MOUSE (M/N: KM1033C) We affirm that between SIEMIC and PAWAS Trading Gmbh, any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities.

General Appearance of the EUT

FCC ID Label Location On EUT

1 1 2 2 3 3 4 4 DD CC BB AA Title NumberRevisionSize A4 Date:2010-5-17Sheet of File:E:\本地磁盘 (J)\..\KM1036NC.schDrawn By: C2 C4 12 X1 D1 SW1 SW3 SW2 A B C WH R1 1 2 3 4 5 6 7 89 10 11 12 13 14 15 16 U1 VDD 1 C 2 D 3 VSS 4 J1 C5 C3 C1R2 PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.cn

Dongguan EMTEK Co., Ltd. Report No. ：KAD101109014E Page 1 of 21 FCC TEST REPORT For WIRED OPTICAL MOUSE MODEL No.: KM1033C, CCM660165, CCM660196 BRAND NAME: N/A FCC ID: WUACCM660165-196 REPORT NO: KAD101109014E ISSUE DATE: November 25, 2010 Prepared for PAWAS Trading Gmbh Nordstrasse 223, CH-8037 Zurich, Switzerland Prepared by DONGGUAN EMTEK CO., LTD. No.281, Guantai Road, Nancheng District, Dongguan, Guangdong, China TEL: 86-769-22807078 FAX: 86-769-22807079 Dongguan EMTEK Co., Ltd. Report No. ：KAD101109014E Page 2 of 21 TABLE OF CONTENTS 1. GENERAL INFORMATION ............................................................................................................... 4 1.1 Description of Device (EUT)........................................................................................................................... 4 1.2 Description of Support Device ........................................................................................................................ 5 1.3 Test Facility ..................................................................................................................................................... 5 1.4 Measurement Uncertainty ................................................................................................................................ 6 2. POWER LINE CONDUCTED MEASUREMENT ............................................................................ 7 2.1 Test Equipment ................................................................................................................................................ 7 2.2 Block Diagram of Test Setup........................................................................................................................... 7 2.3 Power Line Conducted Emission Measurement Limits................................................................................... 8 2.4 Configuration of EUT on Measurement .......................................................................................................... 8 2.5 Operating Condition of EUT ........................................................................................................................... 8 2.6 Test Procedure ................................................................................................................................................. 8 2.7 Power Line Conducted Emission Measurement Results ................................................................................. 8 3. RADIATED EMISSION MEASUREMENT .................................................................................... 11 3.1 Test Equipment .............................................................................................................................................. 11 3.2 Block Diagram of Test Setup......................................................................................................................... 12 3.3 Radiated Emission Limit ............................................................................................................................... 13 3.4 EUT Configuration on Measurement ............................................................................................................ 13 3.5 Operating Condition of EUT ......................................................................................................................... 13 3.6 Test Procedure ............................................................................................................................................... 13 3.7 Radiated Emission Measurement Results ...................................................................................................... 14 4. PHOTOGRAPHS ................................................................................................................................ 17 4.1 Photo of Power Line Conducted Emission Measurement ............................................................................. 17 4.2 Photo of Radiated Emission Measurement .................................................................................................... 17 4.3 Photos of EUT ............................................................................................................................................... 18 Dongguan EMTEK Co., Ltd. Report No. ：KAD101109014E Page 3 of 21 TEST REPOTR DESCRIPTION Applicant : PAWAS TRADING GMBH Manufacturer : PAWAS TRADING GMBH EUT : WIRED OPTICAL MOUSE FCC ID No. : WUACCM660165-196 Test Voltage : DC 5V (PC Input: AC 120V 60Hz) File Number : KAD101109014E Date of Test : November 09, 2010 to November 25, 2010 Measurement Procedure Used: FCC Rules and Regulations Part 15 Subpart B Class B October 2009 & FCC / ANSI C63.4- 2009 The device described above is tested by Dongguan EMTEK Co., Ltd. to determine the maximum emission levels emanating from the device. The maximum emission levels are compared to the FCC Part 15 Subpart Class B limits both radiated and conducted emissions. The measurement results are contained in this test report and Dongguan EMTEK Co., Ltd. is assumed full responsibility for the accuracy and completeness of these measurements. Also, this report shows that the Equipment Under Test (EUT) is to be technically compliant with the FCC requirements. This report applies to above tested sample only. This report shall not be reproduced in part without written approval of Dongguan EMTEK Co., Ltd. Approved By Nicol Lee / Q.A. Manager DONGGUAN EMTEK CO., LTD. Dongguan EMTEK Co., Ltd. Report No. ：KAD101109014E Page 4 of 21 1. GENERAL INFORMATION 1.1 Description of Device (EUT) EUT : WIRED OPTICAL MOUSE Model Number : KM1033C, CCM660165, CCM660196 (Note: These models are the same except model number, all models use the same FCC ID Number. So we prepare KM1033C for EMC test. ) FCC ID Number : WUACCM660165-196 Trade Mark : N/A Power Supply : DC 5V (PC Input: AC 120V 60Hz) Applicant : PAWAS TRADING GMBH Address : No…

Text truncated - open the document above for the full version.

Radiated Emission Setup Photos Conducted Emission Setup Photos