X5B-PL9956TDDRCE RF coordinator

©2013 Konami Digital Entertainment Instruction Booklet ddrclassroomedition.com The manufacturer of this product (“Manufacturer”) hereby warrants to the original purchaser that the product (and all components) will be free from defects in materials and/or workmanship for a period of one (1) year, beginning from the date of purchase (the “Warranty Period”). If a defect covered by this warranty occurs during the Warranty Period, the Manufacturer may repair or replace (in its option), at no charge to the purchaser, any part that Manufacturer determines to be defective, or the entire product if necessary. To obtain warranty services during the Warranty Period the purchasers must contact Manufacturer at the address/contact below. Purchaser should be prepared to provide information regarding the where and when the product was purchased, and product serial numbers. This warranty shall not apply if the product has been damaged by abuse, misuse, negligence, accident, modifi cation, tampering or by any causes unrelated to defective materials and/or workmanship. Repair or replacement of parts, or the product, as provided under this warranty is the Manufacturer’s exclusive prerogative and within the Manufacturer’s sole discretion. ANY APPLICABLE IMPLIED WARRANTIES, INCLUDING WARRANTIES OR MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY LIMITED TO THE LENGTH OF TIME SPECIFIED IN THE WARRANTY, BEGINNING FROM THE DATE OF PURCHASE AND ARE SUBJECT TO THE CONDITIONS SET FORTH IN THIS WARRANTY. IN NO EVENT SHALL MANUFACTURER BE ACCOUNTABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE BREACH OF ANY EXPRESS OR IMPLIED WARRANTIES. NOTE: This warranty gives you specifi c legal rights. YOU MAY HAVE DIFFERENT OR ADDITIONAL LEGAL RIGHTS, INCLUDING LONGER WARRANTY PERIODS, WHICH VARY FROM JURISDICTION TO JURISDICTION. Some jurisdictions do not allow limitations on the length of warranty periods, and thus the above limitations may not apply to you depending on your location. In addition, consumers have legal rights under applicable national and state legislation governing the sale of consumer goods Such rights are not affected by any warranties set forth herein. Contact Information: Konami Digital Entertainment [email protected] Attention: Customer Service 1-855-705-1332 2381 Rosecrans Avenue, Suite 200 El Segundo, CA 90245 Konami may, at its sole discretion, forward all warranty claims to Performance Designed Products, LLC. DanceDanceRevolution Classroom Edition Product Warranty Information 2001 NOTES TABLE OF CONTENTS A HEALTHY REVOLUTION ........................01 PARENTAL CONSENT ..............................02 GETTING STARTED .................................04 GAME CONTROLS ...................................08 HOW TO PLAY ........................................09 GAME MODES .........................................11 ADMINISTRATION MODE .........................13 HARDWARE ...........................................15 FAQS .....................................................16 TROUBLESHOOTING ...............................17 CREDITS ................................................18 NOTES ...................................................19 LIMITED WARRANTY ..............................21 A HEALTHY REVOLUTION Active gaming is a concept used to describe the combination of a physical activity with a technology driven game. Players must use their body in order to play the game. DanceDanceRevolution ® : Classroom Edition is active gaming at its fi nest, and, helping students stay active and fi t by fusing an interactive video game with real physical dancing and popular, high-energy music. Recognized by industry experts, school administrators, and doctors, DanceDanceRevolution ® : Classroom Edition is an innovative and fun solution to promoting a healthy lifestyle and fi ghting child obesity. However, there are more than just physical fi tness benefi ts, as the title also promotes team-building skills. In DanceDanceRevolution ® : Classroom Edition, students are randomly placed in different teams, fostering social interaction and teamwork. You are provided with data tracked during the game, allowing you to monitor users’ scores, body mass index (BMI), calories burned, and step counts. In addition, the DanceDanceRevolution ® : Classroom Edition website, www.ddrclassroomedition.com, allows parents, students, and other teachers access to collected data and the accompanying reports. In order to use the website feature, your school administrators need to have Internet access for the school. Note that only students who have completed the parental consent form can have their information uploaded to the website. Konami has taken the DanceDanceRevolution ® experience and morphed it into the world’s most advanced interactive dance and fi tness platform available. Get ready for a healthy revolution! 0219 PARENTAL CONSENT Each student in your class must have the following parental consent form signed in order for their information and progress to be part of the DanceDanceRevolution ® : Classroom Edition website. After everyone has returned a signed consent form and they are all properly stored at your school location, you can use the website to access a variety of reports for your class. With the consent process complete, select the check button in Administration mode to have your student’s information sent to the 100% secure website. FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of t…

Text truncated - open the document above for the full version.

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Revised wording (obsolete) 1.0 2.0 Sept–25-2007 Updated company template (current) 2.0 3.0 Jan-31-2012 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 3.0 Performance Designed Products, LLC 2013-9-2 To: SIEMIC, INC. 775 Montague Expressway, Milpitas, CA 95035 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, Performance Designed Products, LLC hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): FCC ID: X5B-PL9956T DDRCE RF coordinator, PL-9956T We affirm that between SIEMIC and Performance Designed Products, LLC , any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Signature Tom Roberts/Chief Technical Officer E-mail: [email protected] Phone: 1-323-234-9911 Fax: 1-323-234-9922 Address 14144 Ventura Blvd, Suite 200 Sherman. Oaks CA USA 91423.

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 (obsolete) 1.0 2.0 August – 11 - 2008 Updated company template & Added text box (current) 2.0 3.0 Jan-31-2012 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 3.0 Performance Designed Products, LLC 2013-9-2 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: X5B-PL9956T We hereby request confidential treatment of information accompanying this application as outlined below: - Block Diagram - Schematics - Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Signature Tom Roberts/Chief Technical Officer E-mail: [email protected] Phone: 1-323-234-9911 Fax: 1-323-234-9922 Address 14144 Ventura Blvd, Suite 200 Sherman. Oaks CA USA 91423.

Performance Designed Products, LLC 2013-09-2 To: Federal Communications Commission 7435 Oakland Mills Road Columbia, MD FCC ID: X5B-PL9956T To Whom It May Concern: This letter is to ascertain that Performance Designed Products, LLC FCC ID: X5B-PL9956T DDRCE RF coordinator, PL-9956T has been the units used for conducting FCC compliance testing, the DoC part will be tested by FCC recognized test lab. If you have any question or concerns, pls. contact us. Sincerely, Signature Tom Roberts/Chief Technical Officer E-mail: [email protected] Phone: 1-323-234-9911 Fax: 1-323-234-9922 Address 14144 Ventura Blvd, Suite 200 Sherman. Oaks CA USA 91423.

Label Location Proposed Label Location on EUT

Model No.: PL-9956R Model No.: PL-9956T

7 Antennas Transmit Module 6 Receive Modules

TRF No：FCC 15.249/A TRF No：RSS-210/A Page 1 of 32 Report No.: ES130802021E Shenzhen EMTEK Co.,Ltd. Building 69, Majialong Industry Zone, Nanshan District, Shenzhen,Guangdong,China www.emtek.com.cn Tel: +86-755-2695 4280 Fax: +86-755-2695 4282 Access to the World ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT INTENTIONAL RADIATOR CERTIFICATION TO FCC PART 15 SUBPART C AND CANADIAN RSS 210 ISSUE 8 REQUIREMENTS OF DDRCE RF coordinator MODEL No.: PL-9956T FCC ID: X5B-PL9956T IC:8814A-PL9956T Tr a d e m ark : N / A REPORT NO.: ES130802021E ISSUE DATE: August 28, 2013 Prepared for PERFORMANCE DESIGNED PRODUCTS, LLC. 14144 Ventura Blvd Suite 200 Sherman Oaks CA USA 91423. Prepared by SHENZHEN EMTEK CO., LTD Bldg 69, Majialong Industry Zone, Nanshan District, Shenzhen, Guangdong, China TEL: 86-755-26954280 FAX: 86-755-26954282 TRF No：FCC 15.249/A TRF No：RSS-210/A Page 2 of 32 Report No.: ES130802021E Shenzhen EMTEK Co.,Ltd. Building 69, Majialong Industry Zone, Nanshan District, Shenzhen,Guangdong,China www.emtek.com.cn Tel: +86-755-2695 4280 Fax: +86-755-2695 4282 Access to the World VERIFICATION OF COMPLIANCE Applicant: PERFORMANCE DESIGNED PRODUCTS, LLC. 14144 Ventura Blvd Suite 200 Sherman Oaks CA USA 91423. Manufacturer: PERFORMANCE DESIGNED PRODUCTS, LLC. 14144 Ventura Blvd Suite 200 Sherman Oaks CA USA 91423. Product Description: DDRCE RF coordinator Model Number: PL-9956T Serial Number: N/A File Number: ES130802021E Date of Test: August 14, 2013 We hereby certify that: The above equipment was tested by SHENZHEN EMTEK CO., LTD. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.4 (2009) and the energy emitted by the sample EUT tested as described in this report is in compliance with conducted and radiated emission limits of FCC Rules Part 15.249 and Canadian RSS 210 ISSUE 8 REQUIREMENTS The test results of this report relate only to the tested sample identified in this report. Date of Test : August 14, 2013 Prepared by : Jack.Li/Editor Reviewer : June xie/Supervisor Approve & Authorized Signer : Lisa Wang/Manager TRF No：FCC 15.249/A TRF No：RSS-210/A Page 3 of 32 Report No.: ES130802021E Shenzhen EMTEK Co.,Ltd. Building 69, Majialong Industry Zone, Nanshan District, Shenzhen,Guangdong,China www.emtek.com.cn Tel: +86-755-2695 4280 Fax: +86-755-2695 4282 Access to the World Ta b l e o f C o n t e n t s 1. GENERAL INFORMATION.......................................................................................................... 5 1.1 P RODUCT DESCRIPTION............................................................................................................... 5 1.2 R ELATED SUBMITTAL(S) / GRANT (S) ........................................................................................... 5 1.3 T EST METHODOLOGY.................................................................................................................. 5 1.4 S PECIAL ACCESSORIES................................................................................................................. 5 1.5 E QUIPMENT MODIFICATIONS........................................................................................................ 5 1.6 T EST FACILITY............................................................................................................................. 6 2. SYSTEM TEST CONFIGURATION ............................................................................................ 7 2.1 EUT CONFIGURATION.................................................................................................................. 7 2.2 EUT EXERCISE............................................................................................................................ 7 2.3 T EST PROCEDURE......................................................................................................................... 7 2.4 DESCRIPTION OF TEST MODES....................................................................................................... 8 3. SUMMARY OF TEST RESULTS .................................................................................................. 9 3.1 CONFIGURATION OF TESTED SYSTEM ................................................................................ 9 3.2 DESCRIPTION OF SUPPORT UNITS ........................................................................................ 9 4. CONDUCTED EMISSIONS TEST ............................................................................................. 10 4.1. MEASUREMENT PROCEDURE: ...................................................................................................... 10 4.2. TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ............................................................... 10 4.3. MEASUREMENT EQUIPMENT USED: ............................................................................................. 10 4.4. CONDUCTED EMISSION LIMIT...................................................................................................... 10 4.5. MEASUREMENT RESULT: ..............................................................................................................11 5. RADIATED EMISSION TEST .................................................................................................... 12 5.1 M EASUREMENT PROCEDURE...................................................................................................... 12 5.2 T EST SET-UP (BLOCK DIAGRAM OF CONFIGURATION).............................................................. 13 5.3 M EASUREMENT EQUIPMENT USED:............................................................................................ 14 5.4 R ADIATED EMISSION LIMIT........................................................................................................ 14 5.5 M EASUREMENT RESULT.................................................................................................…

Text truncated - open the document above for the full version.

Conducted Measurement Photo Radiated Emission Test