XJJCHANGCHENG3RC Toy Transmitter

FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

CHANGCHENG PLASTIC FACTORY Tel: 86-754-85860054 Fax: 86-754-85864054 Add: South Port Section Chenglai Road, Chenghai Zone, Shantou City, Guangdong, P.R.CHINA Authorization Letter December 5, 2012 Federal Communication Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Dear Sir/Madam We, the undersigned, hereby authorize Mr Wilson Loke of SGS IECC Limited to act on our behalf in all matter relating to FCC equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by SGS IECC Limited on our behalf shall have the same effect as acts of our own. This authorization is valid for the FCC Certification with FCC ID: XJJCHANGCHENG3 and expires on December 5, 2013 CHANGCHENG PLASTIC FACTORY

CHANGCHENG PLASTIC FACTORY Tel: 86-754-85860054 Fax: 86-754-85864054 Add: South Port Section Chenglai Road, Chenghai Zone, Shantou City, Guangdong, P.R.CHINA Attention: Application Examiner RE: Request for Long Term Confidentiality Applicant: CHANGCHENG PLASTIC FACTORY FCC ID: XJJCHANGCHENG3 To whom it may concern, Permanent Confidentiality Request in hereby submitted by CHANGCHENG PLASTIC FACTORY, to withhold permanently from public review certain portions of application for equipment certification for referenced FCC identifiers. This request for confidentially is made pursuant to 47 CFR 0.457(d) of the FCC Rules. In particular, the following sections of application are to be kept permanently confidential: - Circuit Diagram - Block Diagram - Operation Description Date: Jan 7, 2013 CHANGCHENG PLASTIC FACTORY

FCC ID: CHANGCHENG3 INTERNAL PHOTO FCC ID: CHANGCHENG3 FCC ID: CHANGCHENG3 FCC ID: CHANGCHENG3 FCC ID: CHANGCHENG3 FCC ID: CHANGCHENG3 FCC ID: CHANGCHENG3

Address: Units 303-305, 3/F., 31 Lok Yip Road, On Lok Tsuen, Fanling, N.T., Hong Kong Report No.: 58268 Page: 1 of 20 Telephone: +852 23052570 Fax: +852 27564480 Email: [email protected] Authorized Signature: Stephen C.N. Wong Technical Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS IECC Limited or testing done by SGS IECC Limited in connection with, distribution or use of the product described in this report must be approved by SGS IECC Limited in writing. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. FCC ID: XJJCHANGCHENG3 Member of the SGS Group (SGS SA) FCC Test Report Application No.: 58268 Applicant: CHANGCHENG PLASTIC FACTORY Address: South Port Section Chenglai Road Chenghai Zone, Shantou City, Guangdong China Product Information: Product Description: 2.4G R/C Car Model: 2206, 2209, 2115, 2116, 2161, 2162, 2163, 2165, 2166, 2167, 2168, 2169, 2171, 2172, 2173, 2175, 2176, 2177, 2178, 2179 ♣ ♣ Please refer to section 2 of this report which indicates which item was actually tested and which were electrically identical. Product Class : Low Power Communication Device – Transmitter (2.4 GHz) FCC ID: XJJCHANGCHENG3 Requirement: CFR 47 FCC PART 15 SUBPART C, 2011 - Intentional Radiators. Date of Receipt: December 13, 2012 Date of Test: December 20, 2012 to December 27, 2012 Date of Issue: December 28, 2012 Test Result : PASS* * In the configuration tested, the EUT complied with the requirements for the relevant clauses of Federal Communications Commission Rules as specified above. Report No.: 58268 Page: 2 of 20 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. FCC ID: XJJCHANGCHENG3 Member of the SGS Group (SGS SA) 2 Test Summary Test Test Requirement Test Method Result Conducted Emission (150KHz to 30MHz) FCC PART 15, SUBPART C: 2011 ANSI C63.4:2009 N/A 1) Radiated Emission (9kMHz to 1GHz) FCC PART 15, SUBPART C: 2011 ANSI C63.4:2009 PASS Radiated Emission above 1 GHz FCC PART 15, SUBPART C: 2011 ANSI C63.4:2009 PASS Band edge / 20 dB Bandwidth FCC PART 15, SUBPART C: 2011 ANSI C63.4:2009 Marker-Detla measurement PASS Remark : 1) Please refer to section 6.1 of this report for explanation ♣ Item no.: 2206, 2209, 2115, 2116, 2161, 2162, 2163, 2165, 2166, 2167, 2168, 2168, 2171, 2172, 2173, 2175, 2176, 2177, 2178, 2179 According to the confirmation from the applicant, the above models are identical in all electrical aspects in relating to the circuit design, PCB layout, electrical components used, internal wiring and function. The differences are only the color and decorations. Therefore only the model 2206 was tested in this report. Report No.: 58268 Page: 3 of 20 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transa…

Text truncated - open the document above for the full version.

FCC ID: XJJCHANGCHENG3 TEST SET CONFIGURATION