XQWUHFBPPR601Wireless Microphone

Passport® UHF Wireless Systems UHF Wireless Receiver Module UHF Wireless Handheld Microphone UHF Wireless Belt-pack Transmitter Deluxe Headset Microphone Deluxe Lavaliere Microphone IMPORTANT SAFET Y INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles and the point where they exit from the apparatus. 11) Only use attachments/accessories specified by the manufacturer. 12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury f rom tip - over. 13) Unplug this apparatus during lightning storms or when unused for long periods of time. 14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 15) To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug from the AC receptacle. 16) The mains plug of the power supply cord shall remain readily operable. 17) WARNING – To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. 18) Do not expose this equipment to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the equipment. 19) Maintain at least 6 inches (15.25 cm) of unobstructed air space behind the unit to allow for proper ventilation and cooling of the unit. 20) CAUTION – For rack mounted power amplifiers, keep all wiring and materials away from the sides of the unit and allow the unit to cool down for 2 minutes before pulling from a rack enclosure. 21) Amplifiers and loudspeaker systems, and ear/headphones (if equipped) are capable of producing very high sound pressure levels which may cause temporary or permanent hearing damage. Use care when setting and adjusting volume levels during use. 22) FCC Part 15 Compliance Statement (for digital products, as applicable) - Part 15.21: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. 2 3) WARNING – To maintain product safety, products with internal or external (battery pack) batteries: •Batteries and/or the product in which they are installed, shall not be exposed to excessive heat such as sunshine, fire or the like. •There may be a danger of explosion if the battery is incorrectly connected/replaced. Replace only with the same or equivalent type battery specified in the instructions or on the product. 24) CAUTION – Unplug unit and allow it to cool before touching/ replacing vacuum tubes. Thank you for selecting the Fender Passport UHF Wireless System. Fender’s Passport® brand of products are known for their portability, ease of use, innovative design, exceptional quality and value. We think you will find the same qualities in your new Passport UHF Wireless System. Before operating the Passport UHF Wireless System, please read this instruction manual thoroughly and familiarize yourself with the features and operation of your new system components. Systems The Passport UHF Wireless Handheld System Contains a handheld UHF wireless microphone (transmitter) and custom- designed multi-channel UHF docking receiver. The Passport UHF Wireless Executive System Contains a UHF belt-pack transmitter, a deluxe lavaliere microphone, a deluxe headset microphone, an instrument cable, and a custom-designed multi- channel UHF docking receiver. An additional transmitter may be purchased separately to compliment either system. Consult your Fender dealer for details and options. Setting Up Unpacking Your Passport Wireless system (or accessory) was packed with care at the factory. The shipping carton was designed to protect it during initial shipment. Please retain this carton in the unlikely event that you need to return your Passport Wireless for servicing. Remove the Docking Receiver and the transmitter (either Handheld or Belt- pack) from their respective packaging and check that nothing is missing and/or damaged from shipping. Pre-Installation The Passport Wireless Systems and accessories are custom designed to work with “wireless ready” Passport Sound Systems. “Wireless Ready” Passport Sou…

Text truncated - open the document above for the full version.

Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Transmitter Front View Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Transmitter Rear View Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Transmitter Front Orthogonal View Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Transmitter Rear Orthogonal View Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Transmitter Top View

Label Location – UHF WRLS BP Label will be placed on rear as shown. This statement will be placed in User’s Manual: This device complies with part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Internal view of Transmitter Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Internal view of PCB Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Component view of PCB Company: Fender Musical Instruments Corp. Model: UHF WRLS BP Date: January 7, 2010 Photo Description: Solder side view of PCB

Date: December 24, 2009 Applicant: Fender Musical Instruments Corp. 8860 E. Chaparral Road, Suite 100 Scottsdale, AZ 85250-2618 Attention of: Larry Clauss, Sr. Project Engineer - Compliance (480) 367-5203; FAX (480) 948-9155 [email protected] Equipment: UHF WRLS BP FCC ID: XQWUHFBPPR601 FCC Rules: Radio Frequency Radiation Exposure Limits 47 CFR 1.1307 RF Exposure Statement 1. Standard Applicable According to 1.1307 (b)(1), systems operating under the provisions of this section shall be operated in a manner that ensure that the public is not exposed to radio frequency energy level in excess of the Commission’s guideline. This is a portable device. 2. Measurement Result: This is a portable device and the max peak conducted output power is 13.0 dBm (20 mW) with a 100% duty cycle. Using the formula 60/f GHz = mW to determine the SAR threshold a limit of 96.5 mW was determined. Calculation 60 / 0.62185 = 96.5 mW A SAR measurement is not necessary.

Compliance Testing 3356 N. San Marcos Place, Suite 107 Chandler, Arizona 85225-7176 (866) 311-3268 phone, (480) 926-3598 fax p09c0010, d09c0013 Rev.1.0 Date: December 24, 2009 Applicant: Fender Musical Instruments Corp. 8860 E. Chaparral Road, Suite 100 Scottsdale, AZ 85250-2618 Attention of: Larry Clauss, Sr. Project Engineer - Compliance (480) 367-5203; FAX (480) 948-9155 [email protected] Equipment: UHF WRLS BP FCC ID: XQWUHFBPPR601 FCC Rules: Part 74H Gentlemen: Enclosed please find your copy of the Engineering Test Report for which you are subject to the restrictions as listed on the attached summary. Once a Telecommunication Certification Body (TCB) issues a Grant the Federal Communication Commission (FCC) has 30 days to review the application and request added information. It is your decision whether or not to market the equipment subject to a possible recall before the end of the 30 days. If your equipment is still retained by us, it will be returned to you 30 days after approval is achieved. Our invoice for services has been directed to your Accounts Payable Department. For any additional information please contact us. Thank you. Sincerely yours, John Erhard: Engineering Manager Compliance Testing 3356 N. San Marcos Place, Suite 107 Chandler, Arizona 85225-7176 (866) 311-3268 phone, (480) 926-3598 fax p09c0010, d09c0013 Rev.1.0 Summary of Restrictions 1. All submissions to the FCC are subject to their Examiner's interpretation. 2. Please allow from 60 to 90 days before hearing from the FCC with regard to any submission. 3. The FCC can set aside any action; modify or set aside any action, within 30 days. (FCC Rule 1.108, 1.113). 4. Under Rule 2.803, if device is not type accepted/certificated then it must not be sold, leased, offered for sale, imported, shipped or distributed or advertised for sale. 5. FCC can revoke its certificates at any time if the equipment does not meet or continue to meet their Rules. (Rule Parts 2.927, 2.939). 6. FCC can request a sample at any time (2.936). Compliance Testing 3356 N. San Marcos Place, Suite 107 Chandler, Arizona 85225-7176 (866) 311-3268 phone, (480) 926-3598 fax p09c0010, d09c0013 Rev.1.0 Date: December 24, 2009 Federal Communications Commission Via: Electronic Filing Attention: Authorization & Evaluation Division Applicant: Fender Musical Instruments Corp. Equipment: UHF WRLS BP FCC ID: XQWUHFBPPR601 FCC Rules: Part 74H Dear Gentleman: On behalf of the Applicant, enclosed please find Application Form 731, Engineering Test Report and all pertinent documentation, the whole for approval of the referenced equipment as shown. We trust the same is in order. Should you need any further information, kindly contact the writer who is authorized to act as agent. Best regards, John Erhard: Engineering Manager Compliance Testing 3356 N. San Marcos Place, Suite 107 Chandler, Arizona 85225-7176 (866) 311-3268 phone, (480) 926-3598 fax p09c0010, d09c0013 Rev.1.0 Test Report for Model: UHF WRLS BP to Federal Communications Commission Rule Part(s) Date of report: December 24, 2009 On the Behalf of the Applicant: Fender Musical Instruments Corp. At the Request of: Fender Musical Instruments Corp. 8860 E. Chaparral Road, Suite 100 Scottsdale, AZ 85250-2618 Attention of: Larry Clauss, Sr. Project Engineer - Compliance (480) 367-5203; FAX (480) 948-9155 [email protected] Reviewed by: John Erhard: Engineering Manager Compliance Testing 3356 N. San Marcos Place, Suite 107 Chandler, Arizona 85225-7176 (866) 311-3268 phone, (480) 926-3598 fax p09c0010, d09c0013 Rev.1.0 Test Report Revision history Revision Date Revised By Reason for revision 1.0 December 24, 2009 J Erhard Original Document Compliance Testing 3356 N. San Marcos Place, Suite 107 Chandler, Arizona 85225-7176 (866) 311-3268 phone, (480) 926-3598 fax p09c0010, d09c0013 Rev.1.0 List of Exhibits (FCC Certification (Transmitters) - Revised 9/28/98) Applicant: Fender Musical Instruments Corp. FCC ID: XQWUHFBPPR601 By Applicant: 1. Letter of Authorization 2. Confidentiality Request: 0.457 And 0.459 3. Identification Drawings, 2.1033(c)(11) Label Location of Label Compliance Statement Location of Compliance Statement 4. Photographs, 2.1033(c)(12) 5. Documentation: 2.1033(c) (3) User Manual (9) Tune Up Info (10) Schematic Diagram (10) Circuit Description Block Diagram Parts List Active Devices 6. MPE/SAR Report By Compliance Testing: A. Testimonial & Statement of Certification Compliance Testing 3356 N. San Marcos Place, Suite 107 Chandler, Arizona 85225-7176 (866) 311-3268 phone, (480) 926-3598 fax p09c0010, d09c0013 Rev.1.0 The Applicant has been cautioned as to the following: 15.21 Information to the User. The users manual or instruction manual for an intentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 15.27(a) Special Accessories. Equipment marketed to a consumer must be capable of complying with the necessary regulations in the configuration in which the equipment is marketed. Where special accessories, such as shielded cables and/or special connectors are required to enable an unintentional or intentional radiator to comply with the emission limits in this part, the equipment must be marketed with, i.e. shipped and sold with, those special accessories. However, in lieu of shipping or packaging the special accessories with the unintentional or intentional radiator, the responsible party may employ other methods of ensuring that the special accessories are provided to the consumer, without additional charge. Information detailing any alternative method used to supply the special accessories for a grant of equipment authorization or retained in the verification records, as appropriate. The party responsible for the equipment, as detailed in § 2.909 of this chapter, shall ensure that these special accessories are provided with the equipment. The instructio…

Text truncated - open the document above for the full version.

Page 1 of 1 Test Setup Photos: Fender Musical Instruments Corp – UHF WRLS BP