XRB6379RE49TXATOM RACERS

fold 27 fold 38 fold 49 5 10 fold 6 1 XC6379 IS01EXC.ai 3 x 3 05/09/11; REVISED 5/26/11 EB Excalibur, Inc., Miami, [email protected]© 2011 EB Excalibur, Inc.Distributed in the United Kingdom by:EB Brands UK, Worcester WR4 9FAMade in ChinaActual product may differ slightly from photograph. XC6379IS01EXC Atomic Racer Layout Atomic Racer Radio Control CarXC6379 ©2011 EB Excalibur Use a screwdriver to detach the car from thebattery cover and pedestal.Note: To open atomic case, simply press release button and liftdome cover off. Insert two AA batteries (not included) and replace door.[NOTE: Battery + / - orientation indicated on controller.]Twist dome cover counterclockwise to open.Slide battery cover/attached car off of controller. Place antenna into hole at the top of controller. Turn clockwise to secure the antenna to controller. DO NOT OVER-TIGHTEN. Pull tip of antenna to extend. To charge the car, open the cover at the bottom of the controller. Align metal nodes on controller with the nodeson the car and place car onto the controller. The chargingindicator light will come on when the car is charging. After a full charge (approximately 2-3 minutes) the light willturn off. ChargingNodes To drive the car, push and hold the forward or reversebutton on the remote. Use the left and right arrows for steering. The operating light will come on when the car is in use. When the operating ligh t becomes faint, it is time to change the controller batteries. Make sure the antenna is fully extended while in use. If the car begins to veer right or left when moving forwardor reverse, the alignment can be adjusted using the directional guide located on the bottom of the car.For best results, only operate the car on smooth, dry surfaces. Radio waves control this toy and can easily be interrupted. Avoid using near phones, electrical lines, radios, or other wireless devices. Battery Cautions• Do not mix old and new batteries.• Do not mix alkaline & standard or rechargeable batteries.• Install batteries so that the polarity (+ and -) matches the diagrams in the battery compartment.• Use only batteries of the same type and equivalency.• Remove exhausted batteries from the unit.• Do not short circuit battery terminals.• Non-rechargeable batteries are not to be recharged• Rechargeable batteries must be removed before recharging and only under adult supervision• Do not dispose of batteries in fire; or product may explode or leak• If this product will not be used for an extended period of time, remove the batteries from the product• Clean the battery contacts and also those of the product prior to battery installation• As always, dispose of batteries in an eco-friendly manner The device complies with Part 15 of the FCC Rules. Operation issubject to the following two conditions: (1) this device may notcause harmful interference, and (2) this device must accept anyinterference received, including interference that may causeundesired operation.Changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operatethe product.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communica-tions. However, there is no guarantee that interference will not occurin a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the transmitting equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio technician for help. WARNINGCHOKING HAZARD - Small Parts.Not for children under 3 years.

Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID: (XRB6379RE49TX). Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: Exhibit Type: Block Diagram, Schematics and Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely,

FCC ID 49MHz FCC ID Back side of 49MHz Remote Control Bottom side of 49MHz RC car Sketch showing FCC ID position

Sample Label FCC ID: XRB6379RE49TX This is to certify that the label shown above will be the production label to be used on production units of model 6379. FCC ID number: XRB6379RE49TX Example: FCC ID: XXX123 (XXX - Grantee Code) (123 - Equipment Product Code)

International Electrical Certification Centre Ltd. Technical Services in Electrical Product Testing, International Certification & Information FCC – Test Report No. 55627-1 Date: 2011-08-16 Page 2 of 15 Address : Units 602-605, 6/F., 31 Lok Yip Rd., On Lok Tsuen, Fanling, N.T., Hong Kong. Tel : (852) 2305 2570 E-mail : [email protected] 嶺樂樂路316樓602-605 Fax : (852) 2756 4480 Home Page : http://www.iecc.com.hk IECC a wholly-owned subsidiary of SGS Hong Kong Limited TABLE OF CONTENTS 1. Laboratory Report Cover 2. Table of Contents 3. Test Location and Summary of Test Results 4. Test Equipment List 5. Radiated Emission Test Setup 6. Conducted Emission Test Setup 7. Test Procedure 8. Test Results 9-13. Measurement Data 14-15. Photo of sample International Electrical Certification Centre Ltd. Technical Services in Electrical Product Testing, International Certification & Information FCC – Test Report No. 55627-1 Date: 2011-08-16 Page 3 of 15 Address : Units 602-605, 6/F., 31 Lok Yip Rd., On Lok Tsuen, Fanling, N.T., Hong Kong. Tel : (852) 2305 2570 E-mail : [email protected] 嶺樂樂路316樓602-605 Fax : (852) 2756 4480 Home Page : http://www.iecc.com.hk IECC a wholly-owned subsidiary of SGS Hong Kong Limited Test Location International Electrical Certification Centre Ltd. Units 602-605, 31 Lok Yip Road, On Lok Tsuen, Fanling, N.T., Hong Kong Tel : +852 23052570 Fax : +852 27564480 Email : [email protected] Summary of Test Results Radiated Emission: Test result: O.K. Test data: See attached data sheet Conducted Emission: Test result: O.K. Test data: See attached data sheet Measurement of Emissions within Band Edges Test result: O.K. Test data: See attached data sheet International Electrical Certification Centre Ltd. Technical Services in Electrical Product Testing, International Certification & Information FCC – Test Report No. 55627-1 Date: 2011-08-16 Page 4 of 15 Address : Units 602-605, 6/F., 31 Lok Yip Rd., On Lok Tsuen, Fanling, N.T., Hong Kong. Tel : (852) 2305 2570 E-mail : [email protected] 嶺樂樂路316樓602-605 Fax : (852) 2756 4480 Home Page : http://www.iecc.com.hk IECC a wholly-owned subsidiary of SGS Hong Kong Limited TEST EQUIPMENT LIST Equipment Manufacturer Model Serial No. Last Calibration Date Next Calibration Date Test Receiver Rohde & Schwarz ESCS 30 100388 11/11/2010 10/11/2011 Antenna Schaffner CBL6111C 2791 30/09/2010 29/09/2012 Antenna Mast System Schwarzbeck AM9104 -- -- -- Turntable with Controller Drehtisch DT312 -- -- -- Spectrum Analyzer with Q. Peak Advantest R3132 140101852 09/08/2011 08/08/2012 International Electrical Certification Centre Ltd. Technical Services in Electrical Product Testing, International Certification & Information FCC – Test Report No. 55627-1 Date: 2011-08-16 Page 5 of 15 Address : Units 602-605, 6/F., 31 Lok Yip Rd., On Lok Tsuen, Fanling, N.T., Hong Kong. Tel : (852) 2305 2570 E-mail : [email protected] 嶺樂樂路316樓602-605 Fax : (852) 2756 4480 Home Page : http://www.iecc.com.hk IECC a wholly-owned subsidiary of SGS Hong Kong Limited Radiated Emission Test Setup (3 m diatance) (> 30MHz) 3 m Antenna Antenna mask h = 1 m - 4 m Mains 0.8 m Filter Filter Mains Ground Plane Field Strength Meter EUT (on turntable) International Electrical Certification Centre Ltd. Technical Services in Electrical Product Testing, International Certification & Information FCC – Test Report No. 55627-1 Date: 2011-08-16 Page 6 of 15 Address : Units 602-605, 6/F., 31 Lok Yip Rd., On Lok Tsuen, Fanling, N.T., Hong Kong. Tel : (852) 2305 2570 E-mail : [email protected] 嶺樂樂路316樓602-605 Fax : (852) 2756 4480 Home Page : http://www.iecc.com.hk IECC a wholly-owned subsidiary of SGS Hong Kong Limited Conducted Emission Test Setup International Electrical Certification Centre Ltd. Technical Services in Electrical Product Testing, International Certification & Information FCC – Test Report No. 55627-1 Date: 2011-08-16 Page 7 of 15 Address : Units 602-605, 6/F., 31 Lok Yip Rd., On Lok Tsuen, Fanling, N.T., Hong Kong. Tel : (852) 2305 2570 E-mail : [email protected] 嶺樂樂路316樓602-605 Fax : (852) 2756 4480 Home Page : http://www.iecc.com.hk IECC a wholly-owned subsidiary of SGS Hong Kong Limited Test Procedure Radiated Emission : The EUT was tested according to ANSI 63.4-2003 for the requirements of FCC Part 15 Subpart C Section 15.209 and 15.235. During the test, the sample was placed on a turn table and operated with new batteries. The table is 0.8 meter above the reference ground plane on the Open Aera Test Site and can rotate 360 degrees to determine the position of the maximum emission level. A broad-band antenna for the frequency range 30 - 1000 MHz, connected with 10 meters coaxial cable to the test receiver was used for measurement. The antenna is capable of measuring both horizontal and vertical polarizations. The antenna was raised from 1 to 4 meters to find out the maximum emission level from the EUT. An initial pre-scan was performed to find out the maximum emission level of the sample placed at 3 orthogonal planes. Final measurement (30 MHz –1000 MHz) was then performed to record the data for the emissions under worst-case condition for combination of the antenna orientation / height and turn table position. Note : 1. Fundamental emission for this pulse modulated device was measured with the peak detector function of the test receiver and was properly adjusted for the duty cycle correction factor as pulse desensitization to calculate the average emission value. 2. The Open Aera Test Site located at IECC was placed on file with the FCC Pursuant to Section 2.948 of the FCC Rules (FCC Registration No. : 97774). Conducted Emission : Not Applicable International Electrical Certification Centre Ltd. Technical Services in Electrical Product Testing, International Certification & Information FCC – Test Report No. 55627-1 Date: 2011-08-16 Page 8 of 15 Address : Units 602-605, 6/F., 31 Lok Yip Rd., On Lok Tsuen, Fanling, N.T., Hong Kong. Tel : (852) 2305 2570 E-mail : [email protected] 嶺樂樂路316樓602-60…

Text truncated - open the document above for the full version.