XZU9734IEEE 802.11p communication module

Kapsch TrafficCom AG User Manual OMR WAVE-UNIT This device is based on the IEEE WAVE Standards 1000005542-Bed-02 1000005542-Bed-02 Document number 1000005542 Document type Bed Document version 02 Document status released Date of release 2010-04-21 Valid from Software version - Created by: Batko Manfred Checked by: Povolny Robert Approved by: Komarica Anto Disclaimer and Limitation of Liability The products described in this manual are provided “as is” and without any warranties of any kind, either express or implied. Kapsch TrafficCom disclaims all warranties, express or implied, including, but not limited to, warranties of title, legality or non-infringement or misappropriation of any intellectual property rights of third parties or implied warranties of merchantability or fitness for a particular purpose. Under no circumstances will Kapsch TrafficCom (including its affiliates, licensors, contractors, suppliers, assignees, subsidiaries, and the respective officers, directors, employees, shareholders, agents and representatives of each of them) be liable for any expenses, fees, claims, damages or losses in any way relating to or arising out of the products described in this manual. Applicable law may not allow certain warranty exclusions, so one or more of the above disclaimers may not apply to you. Copyright  Kapsch TrafficCom AG 2010 Duplication as well as utilization of contents of this documentation are illegal without our explicit consent. User Manual | OMR-WAVE-UNIT Page 3 of 15 1000005542-Bed-02 Table of Contents Page Information about this document 5 Text conventions ............................................................................................. 5 Important text elements ................................................................................... 5 Abbreviations ................................................................................................... 6 Warning to users in the United States 7 Regulatory Information 8 Software Licenses 9 Safety Instructions 9 Environmental Information 9 Visual Inspection 9 Maintenance Instructions 9 General Information 10 Definitions ...................................................................................................... 10 Ordering Information 10 Installation 11 Reading OBUs 12 Product Specifications 13 Conformity 14 Standards ...................................................................................................... 14 List of tables Table 1 Abbreviations and definitions ............................................................. 6 Table 2 Article numbers for accessories ....................................................... 10 Table 3 Standards ......................................................................................... 14 User Manual | OMR-WAVE-UNIT Page 5 of 15 1000005542-Bed-02 Information about this document This document is for professionals setting up and maintaining the equipment. Professionals are persons, who have basic knowledge of software installation and computer equipment. This User Manual shall be carefully read before installation. Text conventions Visual aids and standard text formats in this manual help the reader to locate and identify information easily. Typographical formats: Style Used for bold Accentuations italics Labelling and cross-references CAPITAL LETTERS Acronyms Note: Contains additional information on the topic. Important text elements This manual contains specific Caution and Warning statements. These shall be interpreted as follows: Attention: This warning indicates that the device may be affected by Electrostatic Discharge. Appropriate precautions must be made to avoid damage to the device. Caution: Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. Warning: Indicates a hazardous situation which, if not avoided, could result in death or serious injury. Audience Preparations Table 1 Text formats and their meaning Attention Caution Warning Page 6 of 15 User Manual | OMR WAVE-UNIT 1000005542-Bed-02 Abbreviations DSRC Dedicated Short Range Communication OBU Onboard Unit (adjustable by user) RF Radio Frequency WAVE Wireless Access in Vehicular Environments Table 1 Abbreviations and definitions Warning to users in the United States Page 7 of 15 1000005542-Bed-02 Warning to users in the United States The hardware referred to in this document allows selection of frequency bands and transmit power levels that may not comply with the regulatory body that governs spectrum policy where the hardware is being used. This equipment is certified under 47 CFR Part 90M as a portable RSU. However, portable or hand-held RSUs are permitted to operate where they do not interfere with a site-licensed operation. There might be also local restrictions referred in 47 CFR Part §90.371, 47 CFR Part §90.383, 47 CFR Part §90.375. Local Regulations Local Restrictions Page 8 of 15 User Manual | OMR WAVE-UNIT 1000005542-Bed-02 Regulatory Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made to this equipment not expressly approved by Kapsch may void the FCC authorization to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful …

Text truncated - open the document above for the full version.

*GZQ00700* 00OMR-WAVE-UNIT 34027060000 Kapsch TrafficCom AG Input: 5V DC 500mA FCC ID: XZU9734

Kapsch TrafficCom AG Kapsch TrafficCom AG | A -1120 Wien, Am Europlatz 2 | Tel.+43 (0)50 811 0 | Fax +43 (0)50 811 2109 | http://www.kapschtraffic.com | http://www.kapsch.net | Registered at Commercial Court in Vienna FN 223805a | VAT: ATU 54300000 RF Exposure Info OMR-WAVE-UNIT Kapsch TrafficCom AG Project: OMR-WAVE-UNIT Page 2 of 2 Issued: 12.02.2009 20100302_RF_Exposure 1. Average Power Calculation 100mW 5mW 300μs 10ms Peak Power Time Average Power = 7,8mW Worst Case Power Profile The diagram shows one cycle of the worst case power profile running the OMR-WAVE-UNIT with the user application. The profile can be repeated several times, but this does not affect the average value. It shows that the transmitted peak power is 100mW for maximum 300μs. The rest of the time the unit transmits not more than 5mW. The average power for the whole transmission is less than 7,8mW.

Bluetooth Qualification Test Facility (BQTF) FCC listed A2LA Accredited IC recognized # 3462B CETECOM Inc. 411 Dixon Landing Road  Milpitas, CA 95035  U.S.A. Phone: + 1 (408) 586 6200  Fax: + 1 (408) 586 6299  E-mail: [email protected]  http://www.cetecom.com CETECOM Inc. is a Delaware Corporation with Corporation number: 2113686 Board of Directors: Dr. Harald Ansorge, Dr. Klaus Matkey, Hans Peter May V2.0 2009-10-30 The BLUETOOTH trademarks are owned by Bluetooth SIG, Inc., U.S.A. and licensed to CETECOM Inc. © Copyright by CETECOM FCC Test Report FOR: Model Name: OMR-WAVE-UNIT FCC ID: XZU9734 47 CFR Part 90M TEST REPORT #: EMC_CETE4_012_90M_Rev1 DATE: 2010-02-22 Test Report #: EMC_ CETE4_012_90M_Rev1 Date of Report : 2010-02-22 Page 2 of 36 1 TABLE OF CONTENTS 1 TABLE OF CONTENTS _________________________________________________________ 2 2 Assessment _____________________________________________________________________ 3 3 Administrative Data _____________________________________________________________ 4 3.1 Identification of the Testing Laboratory Issuing the EMC Test Report _____________________ 4 3.2 Identification of the Client __________________________________________________________ 4 3.3 Identification of the Manufacturer ___________________________________________________ 4 4 Equipment under Test (EUT) ______________________________________________________ 5 4.1 Specification of the Equipment under Test ____________________________________________ 5 4.2 Identification of the Equipment Under Test (EUT) _____________________________________ 5 4.3 Identification of Accessory equipment ________________________________________________ 5 5 Subject Of Investigation __________________________________________________________ 6 6 Measurements __________________________________________________________________ 7 6.1 Radiated Measurement Procedure ___________________________________________________ 7 6.2 Maximum Peak Output Power ______________________________________________________ 8 6.2.1 Limits _________________________________________________________________________________ 8 6.2.2 Test Conditions: _________________________________________________________________________ 8 6.2.3 Test Result: _____________________________________________________________________________ 8 6.3 Modulation Characteristics ________________________________________________________ 16 6.4 Occupied Bandwidth _____________________________________________________________ 17 6.4.1 Test Result: ____________________________________________________________________________ 17 6.4.2 Test Data/plots: _________________________________________________________________________ 18 6.5 Transmit Spectrum Mask _________________________________________________________ 21 6.6 Frequency Tolerance _____________________________________________________________ 24 6.6.1 Limits: ________________________________________________________________________________ 24 6.6.2 Results: _______________________________________________________________________________ 24 6.7 Transmitter Spurious Emissions- Conducted _________________________________________ 25 6.7.1 Limits ________________________________________________________________________________ 25 6.7.2 Test data/ plots: _________________________________________________________________________ 25 6.8 Transmitter Spurious Emissions- Radiated ___________________________________________ 28 6.8.1 Test Result: ____________________________________________________________________________ 28 7 Test Equipment and Ancillaries used for tests ________________________________________ 33 8 BLOCK DIAGRAMS ___________________________________________________________ 34 9 Revision History _______________________________________________________________ 36 Test Report #: EMC_ CETE4_012_90M_Rev1 Date of Report : 2010-02-22 Page 3 of 36 2 Assessment The following is in compliance with the applicable criteria specified in FCC rules Parts 90M of Title 47 of the Code of Federal Regulations. Company Description Model # KAPSCH TrafficCom AG Wireless Radio OMR-WAVE-UNIT Responsible for Testing Laboratory: 2010-02-22 Compliance Heiko Strehlow (Director) Date Section Name Signature Responsible for the Report: 2010-02-22 Compliance Marc Douat (Test Lab Manager) Date Section Name Signature The test results of this test report relate exclusively to the test item specified in Section3. CETECOM Inc. USA does not assume responsibility for any conclusions and generalizations drawn from the test results with regard to other specimens or samples of the type of the equipment represented by the test item. The test report may only be reproduced or published in full. Reproduction or publication of extracts from the report requires the prior written approval of the CETECOM Inc USA. Test Report #: EMC_ CETE4_012_90M_Rev1 Date of Report : 2010-02-22 Page 4 of 36 3 Administrative Data 3.1 Identification of the Testing Laboratory Issuing the EMC Test Report Company Name: CETECOM Inc. Department: Compliance Address: 411 Dixon Landing Road Milpitas, CA 95035 U.S.A. Telephone: +1 (408) 586 6200 Fax: +1 (408) 586 6299 Responsible Test Lab Manager: Heiko Strehlow Responsible Project Leader: Marc Douat 3.2 Identification of the Client Applicant’s Name: Kapsch TrafficCom AG Street Address: Am Europlatz 2 City/Zip Code 1120 Wien Country Austria Contact Person: Herbert Diemling Phone No. +43508117857 Fax: +43508112209 e-mail: [email protected] 3.3 Identification of the Manufacturer Manufacturer’s Name: Same as above Manufacturers Address: City/Zip Code Country Test Report #: EMC_ CETE4_012_90M_Rev1 Date of Report : 2010-02-22 Page 5 of 36 4 Equipment under Test (EUT) 4.1 Specification of the Equipment under Test Marketing Name: OMR-WAVE-UNIT Model No: OMR-WAVE-UNIT Product Type: Wireless Radio Hardware Revision : Rev201 Software Revision : 1.0 FCC-ID: XZU9734 Frequency: 5860 MHz – 5920 MHz Type(s) of Modulation: OFDM Number of c…

Text truncated - open the document above for the full version.