Y2A-MK-100Mini-Kiosk

MK-100 User's Manual Mini Kiosk http://www.poslab.com.tw Dec 2010 V2.0 1 Table of Contents 1.Standard Package ........................................................................ 4 2. Optional Devices ........................................................................... 5 3. General Guide .............................................................................. 6 4. Getting Start ................................................................................. 7 5. Install “Active Sync4.5 ................................................................... 18 2 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 3 1.Standard Package Take out the terminal carefully and the following items will be found. a. MK-100 b. Power adaptor (MK100 only accepts 5v adaptor) 4 2. Optional Devices POE Adaptor Magnetic Card Reader Wall Mount Kit 5 3. General Guide 6 4. Getting Start Install USB driver After the PC find the new hardware, follow the steps as the pictures indicate. 7 Select “No, not this time” for search for software? 8 Select “ Install from a list or specific location” for the USB driver. 9 Select “Include this location in this search” 1 0 Browse the CD’s folder “PCHK6410 USB Driver” 11 1 2 Installation complete. 1 3 Set up your Partnership. Select “YES” for the partnership. 1 4 Click “Next” 1 5 1 6 1 7 5. Install “Active Sync4.5” Run Active Sync4.5, Select “Next” 1 8 Select “I accept the terms in the license agreement” 1 9 Click “Next” to continue next step. 2 0 Click “Next” to continue next step. 2 1 Click “Install” to continue next step. 2 2 2 3 Installation Complete 2 4

Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 93 of 120 External Photos Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 94 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 95 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 96 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 97 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 98 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 99 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 100 of 120

Label and Location

Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 102 of 120 Internal Photos Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 103 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 104 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 105 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 106 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 107 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 108 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 109 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 110 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 111 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 112 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 113 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 114 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 115 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 116 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 117 of 120 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 118 of 120

MPE Prediction FCC Rule: 15.247(b)(5) Systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy levels in excess of the Commission’s guidelines. See §1.1307(b)(1) of this Chapter. LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) Frequency Range (MHz) Electric Field Strength (V/m) Magnetic Field Strength (A/m) Power Density (mW/cm2) Average time (minutes) (A)Limits For Occupational / Control Exposures 30-300 61.4 0.613 1.0 6 300-1500 ... ... F/300 6 1500-100,000 ... ... 5 6 (B)Limits For General Population / Uncontrolled Exposure 30-300 27.5 0.073 0.2 30 300-1500 ... ... F/1500 30 1500-100,000 ... ... 1.0 30 F = Frequency in MHz Prediction of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01 PG S = -------------- 4πR² where: S = power density P = power input to the antenna G = power gain of the antenna in the direction of interest relative to an isotropic radiator R = distance to the center of radiation of the antenna Maximum peak output power at antenna input terminal: 23.46 (dBm) Maximum peak output power at antenna input terminal: 221.8196 (mW) Antenna gain(maximal): 2 (dBi) Prediction distance: 20 (cm) Prediction frequency: 2412 (MHz) MPE limit for uncontrolled exposure at prediction frequency: 1.0 (mW/cm²) Power density at prediction frequency: 0.0697 (mW/cm²) The manual instruct the user to install and operate the device in a minimum distance of 20 cm between antenna and the users body.

of Applicant: Poslab Technology Corporation Address: 1F, No.94, Dacheng Rd., YangMei City, Taoyuan County 326, Taiwan (R.O.C.) Tested and Prepared by Worldwide Testing Services (Taiwan) Co., Ltd. FCC Registration No.: 930600 Industry Canada filed test laboratory Reg. No. IC 5679A-1 A2LA Accredited No.: 2732.01 Report No.: W6M21011-10996-C-1 6F, NO. 58, LANE 188, RUEY-KUANG RD., NEIHU TAIPEI 114, TAIWAN, R.O.C. TEL: 886-2-66068877 FAX: 886-2-66068879 E-mail: [email protected] FCC PART 15 SUBPART C TEST REPORT for Mini-Kiosk Model No.: MK-100 FCC ID: Y2A-MK-100 Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Page 1 of 30 TABLE OF CONTENTS 1 GENERAL INFORMATION ................................................................................................... 2 1.1 NOTES................................................................................................................................... 2 1.2 TESTING LABORATORY......................................................................................................... 3 1.2.1 Location .......................................................................................................................3 1.2.2 Details of accreditation status ..................................................................................... 3 1.3 DETAILS OF APPROVAL HOLDER............................................................................................ 3 1.4 APPLICATION DETAILS.......................................................................................................... 4 1.5 G ENERAL INFORMATION OF TEST ITEM................................................................................. 4 1.6 T EST STANDARDS.................................................................................................................. 5 2 TECHNICAL TEST ..................................................................................................................6 2.1 SUMMARY OF TEST RESULTS................................................................................................. 6 2.2 T EST ENVIRONMENT............................................................................................................. 6 2.3 TEST EQUIPMENT LIST.......................................................................................................... 7 2.4 GENERAL TEST PROCEDURE................................................................................................. 9 3 TEST RESULTS (ENCLOSURE) ......................................................................................... 11 3.1 P EAK OUTPUT POWER (TRANSMITTER) ............................................................................... 12 3.2 EQUIVALENT ISOTROPIC RADIATED POWER......................................................................... 14 3.3 RF EXPOSURE COMPLIANCE REQUIREMENTS..................................................................... 14 3.4 TRANSMITTER RADIATED EMISSIONS IN RESTRICTED BANDS............................................. 15 3.5 S PURIOUS EMISSIONS (TX) .................................................................................................. 16 3.6 R ADIATED EMISSION ON THE BAND EDGE........................................................................... 25 3.7 MINIMUM 6 dB BANDWIDTH............................................................................................... 26 3.8 PEAK POWER SPECTRAL DENSITY...................................................................................... 27 3.9 R ADIATED EMISSION FROM DIGITAL PART......................................................................... 28 3.10 POWER LINE CONDUCTED EMISSION.................................................................................. 29 APPENDIX Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Page 2 of 30 1 General Information 1.1 Notes The purpose of conformity testing is to increase the probability of adherence to the essential requirements or conformity specifications, as appropriate. The complexity of the technical specifications, however, means that full and thorough testing is impractical for both technical and economic reasons. Furthermore, there is no guarantee that a test sample which has passed all the relevant tests conforms to a specification. Neither is there any guarantee that such a test sample will interwork with other genuinely open systems. The existence of the tests nevertheless provides the confidence that the test sample possesses the qualities as maintained and that is performance generally conforms to representative cases of communications equipment. The test results of this test report relate exclusively to the item tested as specified in 1.5. The test report may only be reproduced or published in full. Reproduction or publication of extracts from the report requires the prior written approval of the Worldwide Testing Services(Taiwan) Co., Ltd. Specific Conditions: Usage of the hereunder tested device in combination with other integrated or external antennas requires at least additional output power measurements, spurious emission measurements, conducted emission measurements (AC supply lines) and radio frequency exposure evaluations for each individual configuration performed, for certification by FCC. The test sample is able to work according IEEE 802.11 b/g/n. This report is related to FCC Part 15 C (DSSS and OFDM device). Tester: December 02, 2010 Robert Ren Date WTS-Lab. Name Signature Technical responsibility for area of testing: December 02, 2010 Chang Tse-Ming Date WTS Name Signature Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Page 3 of 30 1.2 Testing laboratory 1.2.1 Location OATS No.5-1, Shuang Sing Village, LiShuei Rd., Wanli Township, Taipei County 207, Taiwan (R.O.C.) Company Worldwide Testing Services(Taiwan) Co., Ltd…

Text truncated - open the document above for the full version.

Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 119 of 120 Set Up Photo of Radiated Emission RF Registration number: W6M21011-10996-C-1 FCC ID: Y2A-MK-100 Worldwide Testing Services(Taiwan) Co., Ltd. Appendix Page 120 of 120 Set Up Photo of Conducted Emission