YBO-SSRC02Wireless Hand Held Transmitter

EASY INSTALLATION: 1. Plug the power strip into a 3-wire indoor outlet. 2. Green indicator light is lit when the power strip is powered on and have proper grounding. BATTERY INFORMATION AND REPLACEMENT: 1. On the bottom of the remote use your finger to slide out the battery holder. 2. Remove the used battery and insert a new 23A 12V battery. 3. Slide the battery holder back inside so that it sets in place. 4. Dispose of old battery properly. WARNING: Keep batteries away from children and pets. Follow the battery manufacturer’s safety and usage instructions. • Remove battery if product is to be left unused for a long time. • Clean the battery contacts prior to battery installation. • Do not dispose of batteries in fire. Batteries may explode or leak. Remote Control 1. Press: “ON” button on the transmitter, the power strip is power ON continuously. 2. Press “OFF” button on the transmitter, the power strip is power ON now. 3. Operate range: up to 80 feet. CAUTION • Risk of Fire. • DO NOT PLUG IN MORE THAN THE RATED LOAD. • This is a Radio Frequency (RF) Device. Therefore the range of the transmitter is affected by obstructions, walls and other electronic devices. ATTENTION: INSTRUCTIONS FOR PROPER USE • USE WITHIN THE ELECTRICAL RATING MARKED ON THE PRODUCT • RATED 125 VOLTS • Inspect periodically WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Notice: Functional Range may be adversely affected by one or more of the following factors: Orientation of the transmitter or receiver, weather, radio frequency interference, low transmitter battery and obstructions between the transmitter and receiver. Green LED indicator Transmitter Power strip (receiver)

K e y b o a r d m a t r i x M i c r o c o m p u t e r C o d i n g 3 1 5 M H Z M o d u l a t e T r a n s m i t 1 2 V D C P o w e r S u p p l y C r y s t a l 9 . 8 4 3 7 5 M H Z

SSRC02 March 28,2013

FCC ID: YBO-SSRC02 Page 1 of 2 External Picture FCC ID: YBO-SSRC02 Page 2 of 2

FCC ID: YBO-SSRC02 Page 1 of 3 Internal Picture FCC ID: YBO-SSRC02 Page 2 of 3 FCC ID: YBO-SSRC02 Page 3 of 3

technical description Power on the remote hand-held switching device by the batteries (12V d.c.), the IC is working, it is an MCU who have an signal amplifier. When consumer press the “on” switch (KEY1), it give a small signal to the IC by pin 3, and it sent a large signal wave to control the transistors Q2 working in on and off stages, and the oscillator SAW(315MHz) is working, produce a special frequency wave, at last the wave is transmit out via C4，L1 and antenna. And the same process when consumer press the “off” switch (KEY2).

ABCD DCBA Title Number Revision Size B Da te: Sheet of F ile: Drawn By: 12 34 KEY1 ON 12 34 KEY2 OFF R647 C32.2pF C26.8pFL147nH C447pF 1234 SAWHDR315M R515K R44.7K R34.7K R2750 R14.7K Vin 3 GND 2 Vout 1 U2L78L05 C1 104 12 JP1BAR+ 12 JP2BAR- +12V +5V C5104Q22SC3356 Q1S8550 R00 R7 47 +12V 1234 5678 U1MCU

FCC ID: YBO-SSRC02 Page 1 of 15 Test Data FCC ID: YBO-SSRC02 Page 2 of 15 1. Fundamental & Spurious Emission & Restrict band radiated emission Horizontal 30-1000MHz 0 10 20 30 40 50 60 70 80 Level [dBμV/m] 30M50M70M100M200M 300M500M700M1G Frequency [Hz] x x x x x x x x x x MES JH130321H1_red MES JH130321H1_pre LIM FCC 15 F 3 QP Field Strength QP FCC ID: YBO-SSRC02 Page 3 of 15 Restrict band 0 10 20 30 40 50 60 70 80 Level [dBμV/m] 322M324M 326M328M330M332M335.4M Frequency [Hz] x MES JH130321H1_red MES JH130321H1_pre LIM FCC 15 F 3 QP Field Strength QP FCC ID: YBO-SSRC02 Page 4 of 15 1000-5000MHz 0 10 20 30 40 50 60 70 80 Level [dBμV/m] 1G1.5G2G2.5G3G3.5G Frequency [Hz] x x x x x MES JH130321H3_red MES JH130321H3_pre LIM FCC 15 F 3 QP Field Strength QP FCC ID: YBO-SSRC02 Page 5 of 15 Vertical 30-1000MHz 0 10 20 30 40 50 60 70 80 Level [dBμV/m] 30M50M70M100M200M 300M500M700M1G Frequency [Hz] x x x x x x x x x x x MES JH130321V2_red MES JH130321V2_pre LIM FCC 15 F 3 QP Field Strength QP FCC ID: YBO-SSRC02 Page 6 of 15 Restrict band 0 10 20 30 40 50 60 70 80 Level [dBμV/m] 322M324M 326M328M330M332M335.4M Frequency [Hz] x MES JH130321V2_red MES JH130321V2_pre LIM FCC 15 F 3 QP Field Strength QP FCC ID: YBO-SSRC02 Page 7 of 15 1000-5000MHz 0 10 20 30 40 50 60 70 80 Level [dBμV/m] 1G1.5G2G2.5G3G3.5G Frequency [Hz] x x x x MES JH130321V3_red MES JH130321V3_pre LIM FCC 15 F 3 QP Field Strength QP FCC ID: YBO-SSRC02 Page 8 of 15 2. Deactivating time R ef 87 dBμV/ mA tt 10 dB * A TDF PS DC R BW 1 0 0 kH z V BW 3 0 0 kH z 3DB C enter 3 15 MH z500 ms / S WT 5 s 1 A P VIE W -10 0 10 20 30 40 50 60 70 80 FCC ID: YBO-SSRC02 Page 9 of 15 3. Emission bandwidth R ef 87 dBμV/ mA tt 10 dB ** A TDF PS C enter 3 15 MH zSp an 3 0 0 kH z3 0 kH z / * 3DB R BW 1 0 k Hz V BW 3 0 k Hz S WT 4 0 m s DC * 1 P K VIE W -10 0 10 20 30 40 50 60 70 80 1 Ma rk e r 1 [ T 1 ] 6 0 . 9 7 dB μ V / m 3 1 5. 06 7 8 0 00 00 M H z 2 De lt a 2 [ T 1 ] - 2 0. 14 d B - 2 4. 60 0 0 0 00 00 k H z 3 De lt a 3 [ T 1 ] - 2 0. 16 d B 2 2. 20 0 0 0 00 00 k H z FCC ID: YBO-SSRC02 Page 10 of 15 4. Duty Cycle Pulse train of “on” key R ef 87 dBμV/ mA tt 10 dB * A TDF PS DC 3DB R BW 1 MH z V BW 3 MH z C enter 3 15 MH z20 m s/ S WT 2 0 0 ms 1 A P VIE W -10 0 10 20 30 40 50 60 70 80 1 Ma rk e r 1 [ T 1 ] 4 1 . 6 2 dB μ V / m 70 . 8 0 00 00 m s 2 De lt a 2 [ T 1 ] - 1 4. 02 d B 77 . 6 0 00 00 m s FCC ID: YBO-SSRC02 Page 11 of 15 Pulse train of “off” key R ef 87 dBμV/ mA tt 10 dB * A TDF PS DC R BW 1 MH z V BW 3 MH z C enter 3 15 MH z20 m s/ S WT 2 0 0 ms 3DB 1 A P VIE W -10 0 10 20 30 40 50 60 70 80 1 Ma rk e r 1 [ T 1 ] 5 8 . 7 4 dB μ V / m 20 . 0 0 00 00 m s 2 De lt a 2 [ T 1 ] - 3 0. 94 d B 1 04 . 8 0 00 00 m s Date: 1.APR.2013 17:33:34 FCC ID: YBO-SSRC02 Page 12 of 15 Dwell time of one pulse FCC ID: YBO-SSRC02 Page 13 of 15 R ef 87 dBμV/ mA tt 10 dB * A TDF PS DC R BW 1 MH z V BW 3 MH z C enter 3 15 MH z500 μs / S WT 5 ms 3DB 1 A P VIE W -10 0 10 20 30 40 50 60 70 80 1 Ma rk e r 1 [ T 1 ] 5 1 . 3 3 dB μ V / m 2 . 7 5 00 00 m s 2 De lt a 2 [ T 1 ] - 1 8. 64 d B 9 30 . 0 0 00 00 μ s FCC ID: YBO-SSRC02 Page 14 of 15 R ef 87 dBμV/ mA tt 10 dB * A TDF PS DC R BW 1 MH z V BW 3 MH z C enter 3 15 MH z3 ms/ S WT 3 0 m s 3DB 1 A P VIE W -10 0 10 20 30 40 50 60 70 80 1 Ma rk e r 1 [ T 1 ] 4 6 . 7 2 dB μ V / m 14 . 0 3 00 00 m s 2 De lt a 2 [ T 1 ] - 1 8. 70 d B 5 . 0 1 00 00 m s Date: 1.APR.2013 17:37:51 FCC ID: YBO-SSRC02 Page 15 of 15 The Duty cycle of keys was assessed as below: Duty cycle of “on” key = (5.2 + 0.93*17+2.86) / 77.6 = 0.308 Duty cycle of “off” key= (5.2 + 0.93*23+0.9) / 100 = 0.275

FCC ID: YBO-SSRC02 Page 1 of 4 Test Setup FCC ID: YBO-SSRC02 Page 2 of 4 1. Radiated Emission 30MHz-1000MHz, X axis 30MHz-1000MHz, Y axis FCC ID: YBO-SSRC02 Page 3 of 4 30MHz-1000MHz, Z axis Higher than 1GHz, X axis FCC ID: YBO-SSRC02 Page 4 of 4 Higher than 1GHz, Y axis Higher than 1GHz, Z axis