
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
Suyin Optronics Corp. Factory assembly process for RF Dongle 1. Product photos: 2. Install and Application: 6‐Pin Connection is standard USB2.0 specifications, could be applied to Microsoft Windows system the Notebook or Computer, need to refer to the motherboard of USB2.0 circuit configuration。 3. Software setup: The compatible for Win 8, Win 7, Windows XP, Windows 2000, Windows 98. Device the RF IC can Auto setting driver for Windows system. Suyin Optronics Corp. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX FCC ID: YSXRMTP-PR-01-D ". The FCC part 15.19 statement below has to also be available on the label: This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
Limited Module Approval Request Letter Subject: Limited Module Approval Date: June 7, 2012 FCC ID: YSXRMTP-PR-01-D Dear Reviewer, We, SUYIN OPTRONICS CORP would request RF Dongle approved under limited module approval authorization. The application of this module is specified to mobile host equipment. The requirements regulated in 15.212 have been fulfilled and clearly explained below. 1. The requirement of RF shielding: This module will not be offered for sale to, or use by any other company or OEM. As the manufacturer of the module and any host product into which this module will be installed, SUYIN OPTRONICS CORP retains full control over the final installation of the device into its products, and therefore can assure the compliance of the end product to the tested results. 2. The requirement of buffered inputs: Buffered data inputs stage has been integrated in chip (A7105). 3. The requirement of power supply regulation: The part number of the power regulator is (A7105). 4. The requirements of section 15.203 and 15.204(C): The requirements of antenna connector and spurious emission have been fulfilled. Please reference the exhibition Test Report. 5. The requirement of stand-alone test configuration: Please reference exhibition Test Configuration Photo for the stand-alone test configuration. 6. The requirement of labeling: The instruction on the labeling rule of the end product has been stated in the user’s manual of this module. Please also see the exhibition Label Sample. 7. The requirement of compliance on specific rule or operating requirements: The required FCC rule has been fulfilled and all the instructions for maintaining compliance has been clearly stated in the Users Manual. 8. The requirement of RF exposure: the device is simply exempted for the RF Exposure requirements due to its very low radiating power. Please do not hesitate to contact me for any questions of this request letter. Thank you. Firm Name: Sporton International Inc. Telephone: 886-3-3273456 Ext: 586 Fax: 886-3-327-0973 First Name: Wayne Hsu Last Name: Hsu Address: No. 52, Hwa Ya 1st Rd., Kwei-Shan Hsiang, Tao Yuan Hsien, Taiwan, R.O.C. Country: Taiwan R.O.C Zip/ Postal Code: 333 E - Mail: [email protected]
FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B1 OF B3 TEL : 886-3-327-3456 ISSUED DATE : May 23, 2012 FAX : 886-3-327-0973 APPENDIX B. Photographs of EUT FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B2 OF B3 TEL : 886-3-327-3456 ISSUED DATE : May 23, 2012 FAX : 886-3-327-0973 FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B3 OF B3 TEL : 886-3-327-3456 ISSUED DATE : May 23, 2012 FAX : 886-3-327-0973
1 / 1 3/19 4:1 m m PC RMTP-PR-WS1-DONGLE Carlos/2012/03/19 Sam/2012/03/19 96000689-200 2 1 D EFC 1 2 3 4 BA 3 2 1 5 CD 4 6 7 8 AB 6 5 SUYIN OPTRONICS CORP . SHEET NO. DATE SCALE UNIT MATERIAL ISSUED THE 3RD PROJECTION APPOVEDCHECK DESIGNEDPART NO.PART NAME DATE DESCRIPTION LTR Pin Define1 VBUS2 USB-3 USB+4 GND5 PWR_ON6 STATE_IR TOP BOTTOM PIN1 5.00 cbsdpef!Տ 5.00 30.00 FCC:YSXRMTP-PR-01-D MagicPad Dongle 16.00 6.00 Mbcfm!Տ
FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B1 OF B3 TEL : 886-3-327-3456 ISSUED DATE : May 23, 2012 FAX : 886-3-327-0973 APPENDIX B. Photographs of EUT FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B2 OF B3 TEL : 886-3-327-3456 ISSUED DATE : May 23, 2012 FAX : 886-3-327-0973 FCC TEST REPORT SPORTON International Inc. PAGE NUMBER : B3 OF B3 TEL : 886-3-327-3456 ISSUED DATE : May 23, 2012 FAX : 886-3-327-0973
SPORTON International Inc. Report Format Version: a FCC TEST REPORT Report No. : FR242633 FCC RADIO TEST REPORT According to 47 CFR FCC Part 15 Subpart C § 15.249 Equipment :RF Dongle Brand Name :SUYIN, ACER Model No. :MagicPad, RMTP-PR-FC1, RMTP-PR-WS1, RMTP-PR-GN1 Filin g Type :New Application Applicant Manufacturer :SUYIN OPTRONICS CORP No. 377, Fude 1 ST RD., Xizhi City, Taipei County 221,Taiwan FCC ID :YSXRMTP-PR-01-D Received Date :Mar. 16, 2012 Final Test Date :May 21, 2012 Statement The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. The measurements and test results shown in this test report were made in accordance with the procedures and found in compliance with the limit given in ANSI C63.4-2009 and 47 CFR FCC Part 15 Subpart C. The test equipment used to perform the test is calibrated and traceable to NML/ROC. SPORTON International Inc. No. 52, Hwa Ya 1 st Rd., Hwa Ya Technology Park, Kwei-Shan Hsiang, Tao Yuan Hsien, Taiwan, R.O.C. SPORTON International Inc. Page No. : i of ii TEL : 886-3-327-3456 Issued Date : Jun. 06, 2012 FAX : 886-3-327-0973 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 Table of Contents 1. SUMMARY OF THE TEST RESULT ....................................................................................................................... 2 2. GENERAL INFORMATION ...................................................................................................................................... 3 2.1. Product Details .........................................................................................................................................................................................3 2.2. Table for Test Modes ...............................................................................................................................................................................3 2.3. Table for Testing Locations ......................................................................................................................................................................3 2.4. Table for Supporting Units .......................................................................................................................................................................3 2.5. EUT Operation during Test ......................................................................................................................................................................4 2.6. Test Configurations ..................................................................................................................................................................................4 3. TEST RESULT ......................................................................................................................................................... 6 3.1. AC Power Line Conducted Emissions Measurement ..............................................................................................................................6 3.2. Field Strength of Fundamental Emissions Measurement ......................................................................................................................10 3.3. 20dB Spectrum Bandwidth Measurement .............................................................................................................................................13 3.4. Radiated Emissions Measurement ........................................................................................................................................................19 3.5. Band Edge Emissions Measurement .....................................................................................................................................................31 3.6. Antenna Requirements ..........................................................................................................................................................................33 4. LIST OF MEASURING EQUIPMENTS .................................................................................................................. 34 5. TEST LOCATION ................................................................................................................................................... 36 6. TAF CERTIFICATE OF ACCREDITATION ........................................................................................................... 37 APPENDIX A. TEST PHOTOS ........................................................................................................................ A1 ~ A7 APPENDIX B. PHOTOGRAPHS OF EUT ....................................................................................................... B1 ~ B3 SPORTON International Inc. Page No. : ii of ii TEL : 886-3-327-3456 Issued Date : Jun. 06, 2012 FAX : 886-3-327-0973 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 History of This Test Report Original Issue Date: Jun. 06, 2012 Report No.: FR242633 ■ No additional attachment. □ Additional attachment were issued as following record: Attachment No. Issue Date Description 15.205(a) 15.209(a) Further, this requirement does not apply to intentional radiators that must be professionally installed. SPORTON International Inc. Page No. : 1 of 37 TEL : 886-3-327-3456 Issued Date : Jun. 06, 2012 FAX : 886-3-327-0973 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 CERTIFICATE OF COMPLIANCE According to 47 CFR FCC Part 15 Subpart C § 15.249 Equipment :RF Dongle Brand Name :SUYIN, ACER Model No. : MagicPad, RMTP-PR-FC1, RMTP-PR-WS1, RMTP-PR-GN1 Applicant :SUYIN OPTRONICS CORP No. 377, Fude 1 ST RD., Xizhi City, Taipei County 221,Taiwan Sporton International as requested by the applicant to evaluate the EMC performance of the product sample received on Mar. 16, 2012 would like to de…
Text truncated - open the document above for the full version.
Page No. : A1 of A7 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 Appendix A. Test Photos Page No. : A2 of A7 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 1 Photographs of Conducted Emissions Test Configuration FRONT VIEW REAR VIEW Page No. : A3 of A7 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 SIDE VIEW Page No. : A4 of A7 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 2 Photographs of Radiated Emissions Test Configuration For radiated emissions 9kHz~30MHz FRONT VIEW REAR VIEW Page No. : A5 of A7 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 For radiated emissions 30MHz~1GHz FRONT VIEW REAR VIEW Page No. : A6 of A7 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 For radiated emissions above 1GHz FRONT VIEW REAR VIEW Page No. : A7 of A7 FCC ID : YSXRMTP-PR-01-D FCC TEST REPORT Report No. : FR242633 EUT take a close-up FRONT VIEW REAR VIEW
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 2.41 GHz - 2.47 GHz | - |

Media Remote
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
Media Remote
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
RF Dongle
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
RMTP
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter
RF2.4G dongle
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter