YSXRMTP-S1H1-01-DRF2.4G dongle

RMTP&RF2.4G Dongle user manual 1 2 Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instruction as documented in this manual. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 3 Introduction This is an innovative wireless Multi function Touch-Pad having all the functions of a standard wireless mouse. Combining advanced RF transceiver, an easy to use miniature Touch-Pad, built-in G-sensor and backlight keyboard, you can now easily control or edit your target by just slightly moving or touching your thumb on the Touch- Pad, just like how you operate your Laptop, PC, Media center & STB, while you are walking around the classroom, meeting room, living room etc. it is a very good assistant for normal users & lecturers, and is an essential & efficiency equipment for media center, laptop, AIO PC and digital interface TVs. Features RF 2.4G reliable wireless Wireless connection with up to 20 meter range. (Open space) Supports 1 or 2 fingers touch applications G-sensor inside Low power consumption Plug & Play Win, MAC & Linux base supported Backlight keyboard operation USB rechargeable power design Appearances USB Dongle Device 19.8mm 12mm 95mm 54mm Power switch Mini USB for power charging RF Mouse mode LED indicator Function description Power onBlue (flash 3 times) Mouse mode Touch pad area Property selection Function description Slidefinger on the touch pad area as cursor control(similar mouse’s left key) Touch icon to enable property page(similarmouse’s right key) Keyboard mode Function description To touch icon to enablekeyboard mode for typing Backlightflash when entry character Keyboard selection Zoom in/out mode Touch pad area Function description Place2 fingers on the touch pad area and slide up & down for performing zoom in/out function Scrolling mode Touch pad area Function description Place 1 fingers on icon and another finger place touch pad area to slide up & down for scrolling bar Pictures rotation mode Touch pad area Function description Place 1 fingers on the touch pad area and swipe left & right for controlling the picture rotation

Page 1 CONSTRUCTION PHOTOS OF EUT

4cm x 1.2cm

FCC LABEL LOCATION The label will be permanently affixed at a conspicuous location on the device LABEL

Page 2 Page 3

Report No.: RF990914D03-1 1 Report Format Version 3.0.1 FCC TEST REPORT REPORT NO.: RF990914D03-1 MODEL NO.: RMTP-S1H1, HWMP1 FCC ID: YSXRMTP-S1H1-01-D RECEIVED: Sep. 14, 2010 TESTED: Sep. 15 ~ 20, 2010 ISSUED: Oct. 1, 2010 APPLICANT: SUYIN OPTRONICS CORP ADDRESS: No.377, Fude 1st RD., Xizhi City, Taipei County 221, Taiwan ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB LOCATION: No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien, 244 Taiwan This test report consists of 30 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF or any government agencies. The test results in the report only apply to the tested sample. Report No.: RF990914D03-1 2 Report Format Version 3.0.1 Table of Contents 1. CERTIFICATION..........................................................................................3 2. SUMMARY OF TEST RESULTS..................................................................4 2.1 MEASUREMENT UNCERTAINTY...............................................................4 3. GENERAL INFORMATION..........................................................................5 3.1 GENERAL DESCRIPTION OF EUT............................................................5 3.2 DESCRIPTION OF TEST MODES..............................................................6 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST.........................................6 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL:.............7 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS.............................8 3.4 DESCRIPTION OF SUPPORT UNITS........................................................8 4. TEST TYPES AND RESULTS......................................................................9 4.1 CONDUCTED EMISSION MEASUREMENT..............................................9 4.1.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT............................9 4.1.2 TEST INSTRUMENTS................................................................................9 4.1.3 TEST PROCEDURES...............................................................................10 4.1.4 DEVIATION FROM TEST STANDARD.....................................................10 4.1.5 TEST SETUP............................................................................................10 4.1.6 EUT OPERATING CONDITIONS..............................................................11 4.1.7 TEST RESULTS........................................................................................12 4.2 RADIATED EMISSION MEASUREMENT.................................................14 4.2.1 LIMITS OF RADIATED EMISSION MEASUREMENT...............................14 4.2.2 TEST INSTRUMENTS..............................................................................15 4.2.3 TEST PROCEDURES...............................................................................16 4.2.4 DEVIATION FROM TEST STANDARD.....................................................16 4.2.5 TEST SETUP............................................................................................17 4.2.6 EUT OPERATING CONDITIONS..............................................................17 4.2.7 TEST RESULTS........................................................................................18 4.3 BAND EDGES MEASUREMENT..............................................................25 4.3.1 LIMITS OF BAND EDGES MEASUREMENT............................................25 4.3.2 TEST INSTRUMENTS..............................................................................25 4.3.3 TEST PROCEDURE.................................................................................25 4.3.4 DEVIATION FROM TEST STANDARD.....................................................25 4.3.5 EUT OPERATING CONDITION................................................................25 4.3.6 TEST RESULTS........................................................................................25 5. PHOTOGRAPHS OF THE TEST CONFIGURATION.................................28 6. INFORMATION ON THE TESTING LABORATORIES...............................29 7. APPENDIX A – MODIFICATIONS RECORDERS FOR ENGINEERING CHANGES TO THE EUT BY THE LAB......................................................30 Report No.: RF990914D03-1 3 Report Format Version 3.0.1 1. CERTIFICATION PRODUCT: RF2.4G dongle MODEL NO.: RMTP-S1H1 (BRAND NAME: SUYIN) HWMP1 (BRAND NAME: HAWKING) APPLICANT: SUYIN OPTRONICS CORP TESTED: Sep. 15 ~ 20, 2010 TEST ITEM: ENGINEERING SAMPLE STANDARDS: FCC Part 15, Subpart C (Section 15.249) ANSI C63.4-2003 The above equipment (Model: RMTP-S1H1) has been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE: Oct. 1, 2010 ( Annie Chang / Senior Specialist ) TECHNICAL ACCEPTANCE : , DATE: Oct. 1, 2010 Responsible for RF ( Jamison Chan / Supervisor ) APPROVED BY : , DATE: Oct. 1, 2010 ( Ken Liu / Manager ) Report No.: RF990914D03-1 4 Report Format Version 3.0.1 2. SUMMARY OF TEST RESULTS The EUT has been tested according to the following specifications: APPLIED STANDARD: FCC Part 15, Subpart C (Section 15.249) STANDARD SECTION TEST TYPE AND LIMIT RESULT REMARK 15.207 Conducted Emission Test PASS Minimum passing margin is –11.08dB at 0.597MHz 15.209 15.249 15.249 (d) Radiated Emission Test Band Edge Measurement Limit: 50dB less than the peak value of fundamental frequency or meet radiated emission limit in section 12.209 PASS Minimum passing margin is –5.3dB at 67.31MHz …

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST 2 RADIATED EMISSION TEST