ZF9RCS-S22ASENSOR1-Way Transmitter

Shenzhen Sailwider Electronics Co., Ltd. Tel: +86-755-82828526/82933134 Fax: +86-755-82933109 Email: [email protected] 1 1-way Transmitting System for Energy Data Specification 1. General Information The 1-way transmitting system for Energy Data consists of one transmitter and 1-3pcs sensor clamp(s). The sensor clamp detects the current data and the transmitter sends such data to the display unit via 433.92MHz transmission so that the display unit can monitor the energy consumption. 2. Structure Shenzhen Sailwider Electronics Co., Ltd. Tel: +86-755-82828526/82933134 Fax: +86-755-82933109 Email: [email protected] 2 3. Installation 1) If it is the first time to use the transmitter, please pull out the clear plastic tab from the back of the transmitter, as per below photo. The tab is an insulation sheet, once it is pulled out, the built-in batteries will make the transmitter start to work immediately. 2) The transmitter already has one fixed sensor clamp on it which is ok for single phase. If it is to be used for 3-phase, then two more sensor clamps are required. Please attach the DC plug of each sensor clamp into the DC sockets on the bottom of the Transmitter. 3) For single phase, fix the sensor clamp around the null line (green color, also called zero line) or the live line (red color) of the monitored object, just as below photo is showing (Don’t fix the clamp around the ground wire). Make sure to let the line pass through the clamp. Shenzhen Sailwider Electronics Co., Ltd. Tel: +86-755-82828526/82933134 Fax: +86-755-82933109 Email: [email protected] 3 4) For 3-phase, fix the 3pcs of sensor clamps around the lines of Phase-A (yellow color), Phase-B (green color) and Phase-C (red color). Don’t fix the clamps around the ground wire and neutral wire. 4. Function Instructions 1) Pairing: Use a slim stick to push into the pairing hole of the transmitter (as shown in below photo) and hold it there for about 3 seconds until the LED indicator flashes quickly. The Transmitter is now starting to pair with the Display Unit. If the display unit is also in pairing mode, it will receive the pairing data from the Shenzhen Sailwider Electronics Co., Ltd. Tel: +86-755-82828526/82933134 Fax: +86-755-82933109 Email: [email protected] 4 transmitter and complete the successful pairing and the antenna icon on the Display Unit’s LCD stops flashing and stays on the top right corner of the LCD screen. If the pairing fails in 30 seconds, the pairing will stop automatically. Please restart the pairing again. Try to put the transmitter near to the Display Unit during pairing. After pairing, put the transmitter in a dry place near the monitored object or stick the transmitter on the wall near the monitored object by using the wall sticker as below photo: 2) Data Transmission After successfully pairing, the transmitter will start to send the data collected by the sensor clamp to the Display Unit so that the data can be viewed on the Display Unit’s LCD screen. 5. External antenna information: Model: ATL-V0433S Trade mark: Richtek Manufacturer: Antele Communication Technology Co., Ltd. Warning statement: Any operation or use of this product in any manner not expressly specified within this manual is expressly forbidden and voids the users right to operate the device. This includes, but is not limited to, any modification of the device hardware or software, and use with non-approved antennas Shenzhen Sailwider Electronics Co., Ltd. Tel: +86-755-82828526/82933134 Fax: +86-755-82933109 Email: [email protected] 5 6. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions： (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.

Shenzhen Sailwider Electronics Co., Ltd. 2012-03-31 Nemko Canada Inc 303 River Road Ottawa, Ontario, Canada K1V 1H2 Attn: Director of Certification Authority to Act as Agent On our behalf, I appoint China Certification & Inspection Services Co., Ltd.; 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China； Bruce.Zhang , to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the Federal Communications Commission’s regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, as specified by Nemko Canada Inc, still resides with Shenzhen Sailwider Electronics Co., Ltd. Unit Y-Z, 25th Floor, Bldg. A, Fortune Plaza, No.7002 Shennan Road, Futian District, Shenzhen 518040, China. Dated this 2012-03-31 By: Hongbo Li Signature Printed Title: General Manager On behalf of : Shenzhen Sailwider Electronics Co., Ltd. Telephone: 0755-82828526

Label Location

Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 30 of 35 RCS-J34A Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 31 of 35 Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 32 of 35 RCS-S22Asensor Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 33 of 35 Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 34 of 35 RCS-S36A Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 35 of 35 ------End------

China Certification & Inspection Services Co., Ltd. Report No: CCIS12030003601 Authorized Signature: Stephen Guo Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the CCIS product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of CCIS International Electrical Approvals or testing done by CCIS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by CCIS International Electrical Approvals in writing. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 1 Cover Page FCC REPORT Applicant: Shenzhen Sailwider Electronics Co., Ltd. Address of Applicant: Unit Y-Z, 25th Floor, Bldg. A, Fortune Plaza, No.7002 Shennan Road, Futian District, Shenzhen 518040, China Equipment Under Test (EUT) Product Name: 1-Way Transmitter Model No.: RCS-S22Asensor, RCS-J34A, RCS-S36A Trade mark: Sailwider Electronics FCC ID: ZF9RCS-S22ASENSOR Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.231:2010 Date of sample receipt: Mar. 19, 2012 Date of Test: Mar. 21-28, 2012 Date of report issue: Apr.17, 2012 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 2 of 35 2 Version Version No. Date Description 00 Apr.17, 2012 Original Prepared By: Date: Apr.17, 2012 Project Engineer Check By: Date: Apr.17, 2012 Reviewer Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 3 of 35 3 Contents Page 1 COVER PAGE......................................................................................................................................................... 1 2 VERSION.................................................................................................................................................................. 2 3 CONTENTS.............................................................................................................................................................. 3 4 TEST SUMMARY.................................................................................................................................................... 4 5 GENERAL INFORMATION................................................................................................................................... 5 5.1 CLIENT INFORMATION....................................................................................................................................... 5 5.2 GENERAL DESCRIPTION OF E.U.T................................................................................................................... 5 5.3 TEST MODE....................................................................................................................................................... 5 5.4 IDENTIFICATION OF ACCESSORY EQUIPMENT.................................................................................................. 6 5.5 TEST FACILITY................................................................................................................................................... 6 5.6 TEST LOCATION................................................................................................................................................ 6 5.7 OTHER INFORMATION REQUESTED BY THE CUSTOMER.................................................................................. 6 5.8 TEST INSTRUMENTS LIST.................................................................................................................................. 7 6 TEST RESULTS AND MEASUREMENT DATA................................................................................................ 8 6.1 ANTENNA REQUIREMENT:................................................................................................................................. 8 6.2 RADIATED EMISSION......................................................................................................................................... 9 6.2.1 Field Strength Of The Fundamental Signal......................................................................................... 11 6.2.2 Spurious Emissions................................................................................................................................. 13 6.3 20 DB BANDWIDTH......................................................................................................................................... 16 6.4 DWELL TIME:................................................................................................................................................... 18 6.5 SILENT PERIOD:.......................................................................................................................................…

Text truncated - open the document above for the full version.

Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 22 of 35 7 Photographs-test setup photo Model No.: RCS-J34A Radiated Emission(below 1G) Radiated Emission(above 1G) Report No: CCIS12030003601 China Certification & Inspection Services Co., Ltd. Project No.: CCIS120300036RF 1st Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Page 23 of 35 Model No.: RCS-S22Asensor Radiated Emission(below 1G) Radiated Emission(above 1G)