2A839-PEM105Remote Control

P button Up Stop Down Technical data • Power : 3V (CR2032) • Frequency : 433.92MHz • Working current : ≤ 20MA • Operating temperature : - 20 °C~+60 °C • Distance : ≥ 100m (open space) -20°C 60°C Working temperature Warning PEM 105 Remote Control Manual Bracket Product introduction • The remote contorl shall not be affected by moisture or impact, so as to avoid affecting its life. • In the process of use, when you find that the remote control distance is obviously close or not sensitive, please check whether the battery needs to be replaced. • Press any button for more than 10 seconds, and the transmitter will stop sending wireless ignals. • Please properly dispose of the used battery according to the instructions. FCC STATEMENT: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, -Connect the equipment into an outlet on a circuit different from that if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The user that changes or modifications not expressly approved by the party responsible for compliance could void the user`s authority to operate the equipment.

Page 1 of 4 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. PHOTOGRAPHSOFTHEEUTEXTERNALCONSTRUCTIONALDETAILS Photo1 Photo2 Page 2 of 4 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo3 Photo4 Page 3 of 4 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo5 Photo6 Page 4 of 4 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo7

REMOTE CONTROL PEM105 INPUT: 3V Made in China ZHEJIANG GENERAL LIGHT CURTAIN CO.,LTD. XIN TANG TOU INDUSTRIAL ZONE, XIN TANG TOU VILLAGE, XIN JIE TOWN, XIAO SHAN DISTRICT,HANGZHOU CITY, ZHE JIANG PROVINCE, CHINA FCC ID2A839-PEM105 2*3cm

Page 1 of 6 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. PHOTOGRAPHSOFTHEEUTINTERNALCONSTRUCTIONALDETAILS Photo1 Photo2 Page 2 of 6 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo3 Photo4 Page 3 of 6 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo5 Photo6 Page 4 of 6 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo7 Photo8 Page 5 of 6 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo9 Photo10 Page 6 of 6 ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. Photo11 Photo12 433.92MHz ANT

"ShanghaiATBLTechnologyCo.,Ltd."herebycertifiesthataccordingtoactualtestingconditions.Thetestresultsorobservationsare providedinaccordancewithmeasuredvalue,withouttakingriskscausedbyuncertaintyintoaccount.Withoutexplicitstipulationinspecial agreements,standardsorregulations,ATBLshallnotassumeanyresponsibility.Thetestresultsorobservationsareapplicableonlytotested sample.Clientshallberesponsibleforrepresentativenessofthesampleandauthenticityofthematerial.Thisreportwillbevoidwithout authorizedsignatureorspecialsealfortestingreport.Donotcopiedwithoutauthorization. Tel:+86(0)21-51298625Web:www.atbl-lab.comEmail:[email protected] ReportNo.:SHATBL2210011W01 Applicant: ZhejiangGeneralLightCurtainCo.,LTD. Address: XinTangTouVillage,XinJieTown,XiaoShanDistrict, HangZhouCity,ZheJiangProvince,China ProductName:RemoteControl BrandName: ModelName:PEM105 SeriesModel:N/A FCCID:2A839-PEM105 TestStandard: FCCPart15.231 RADIOTESTREPORT Page2of31 ReportNo.:SHATBL2210011W01 ShanghaiATBLTechnologyCo.,Ltd.Number:SHATBL-W-05Releasedate:2022-03-01VersionNo.A/1 GENERALDESCRIPTION Applicant’sName....................: ZhejiangGeneralLightCurtainCo.,LTD. Address......................................: XinTangTouVillage,XinJieTown,XiaoShanDistrict, HangZhouCity,ZheJiangProvince,China Manufacture'sName .............. : ZhejiangGeneralLightCurtainCo.,LTD. Address ...................................... : XinTangTouVillage,XinJieTown,XiaoShanDistrict, HangZhouCity,ZheJiangProvince,China ProductDescription ProductName ........................... : RemoteControl BrandName ............................... : ModelName .............................. : PEM105 SeriesModel...............................: N/A TestStandards........................: FCCPart15.231 TestProcedure .......................... : ANSIC63.10-2013 ThisdevicedescribedabovehasbeentestedbyATBL,thetestresultsshowthattheequipmentunder test(EUT)isincompliancewiththeFCCrequirements.Anditisapplicableonlytothetestedsample identifiedinthereport. Thisreportshallnotbereproducedexceptinfull,withoutthewrittenapprovalofATBL,thisdocument maybealteredorrevisedbyATBL,personalonly,andshallbenotedintherevisionofthedocument. Dateofreceiptoftestitem ........................ : 2022.10.18 Date(s)ofperformanceoftests...............: 2022.11.23-2022.11.24 DateofIssue..............................................: 2022.11.23 TestResult..................................................:Pass TestingEngineer: (ChrisXu/JackSuo) TechnicalManager: (GhostLi) AuthorizedSignatory: (TerryYang) Page3of31 ReportNo.:SHATBL2210011W01 ShanghaiATBLTechnologyCo.,Ltd.Number:SHATBL-W-05Releasedate:2022-03-01VersionNo.A/1 TableofContents 1.SUMMARYOFTESTRESULTS..............................................................................................6 2.GENERALINFORMATION.......................................................................................................7 2.1GENERALDESCRIPTIONOFTHEEUT..........................................................................7 2.2DESCRIPTIONOFTHETESTMODES............................................................................8 2.3BLOCKDIAGRAMSHOWINGTHECONFIGURATIONOFSYSTEMTESTED.............8 2.4DESCRIPTIONOFNECESSARYACCESSORIESANDSUPPORTUNITS..................9 2.5LABORATORYINFORMATION.........................................................................................9 2.6MEASUREMENTUNCERTAINTY.....................................................................................9 2.7EQUIPMENTSLIST.........................................................................................................10 3.EMCEMISSIONTEST............................................................................................................12 3.1CONDUCTEDEMISSIONMEASUREMENT..................................................................12 3.2TESTPROCEDURE........................................................................................................12 3.3TESTSETUP...................................................................................................................13 3.4EUTOPERATINGCONDITIONS....................................................................................13 3.5TESTRESULTS................................................................................................................13 4.RADIATEDEMISSIONMEASUREMENT..............................................................................14 4.1RADIATEDEMISSIONLIMITS........................................................................................14 4.2TESTPROCEDURE........................................................................................................16 4.3TESTSETUP...................................................................................................................17 4.4EUTOPERATINGCONDITIONS....................................................................................17 4.5FIELDSTRENGTHCALCULATION................................................................................18 5.BANDWIDTHTEST................................................................................................................24 5.1LIMIT................................................................................................................................24 5.2TESTSETUP...................................................................................................................24 5.3EUTOPERATIONCONDITIONS....................................................................................24 5.4TESTRESULTS...............................................................................................................25 6.DUTYCYCLE..........................................................................................................................26 6.1TESTPROCEDURE........................................................................................................26 6.2TESTSETUP........................................................…

Text truncated - open the document above for the full version.

ReportNo.:SHATBL2210011 "ShanghaiATBLTechnologyCo.,Ltd."herebycertifiesthatthetestresultsdescribedinthecompany'sstandardtestsitetest reportandthestructureofthetestequipmentarerecordedindetailbasedontheactualtestsituation.Thetestresultsofthis reportareonlyapplicabletotheabove-mentionedtestedprototypesandtheequipmentdescribedinthereport.Thisreportis notallowedtobecopiedwithoutthewrittenconsentofShanghaiATBLTechnologyCo., Ltd.;ShanghaiATBLTechnologyCo.,Ltd. Building8,No.160Bashengroad,WaigaoqiaoFreeTradeZone,PudongNewArea,Shanghai Tel:+86(0)21-51298625Web:www.atbl-lab.com OTATESTREPORT ............: .............: ReportPreparedby ClientInformation: Applicant...............................:Zhejiang General Light Curtain Co.,LTD. Addressadd.............................:Xin Tang Tou Village, Xin Jie Town, Xiao Shan District, Hang Zhou City, Zhe Jiang Province, China oduct Description...............:PCB antenna Product Name..........................: P CB antenna Model Name.............................: P EM Date of Test...................................18 Nov. 2022 Date of Issue................................18 Nov. 2022 : (qiyaozhao) ReportApprovedby: (leoLi) AuthorizedSignatory: (Terryyang) Page2of7ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. RevisionHistory Rev.IssueDateReportNo.EffectPageContents 00 18Nov.2022 SHATBL2210011ALLInitialIssue Page3of7ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. 1. Samplephoto Page4of7ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. 2.Testlayout Page5of7ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. 3.ResultsSummary（2D/3DRadiationPattern/Efficiency） Frequency(MHz)Gain(dB)Efficiency(dB)Efficiency(%) 400-4.303-8.51714.067 405-4.367-8.65513.627 410-4.162-8.62713.718 415-3.893-8.69213.512 420-3.536-9.01112.556 425-3.788-9.19912.025 430-4.148-9.37711.541 433-4.886-9.63810.868 435-5.182-9.70310.707 440-5.311-9.66110.810 445-5.724-9.82010.422 450-6.012-9.99610.0075 Overview Page6of7ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. 2/3D方向图带壳 Page7of7ReportNo.:SHATBL2210011 ShanghaiATBLTechnologyCo.,Ltd. 4. SWR

APPENDIX-PHOTOSOFTEST RadiatedEmissionsfor9kHz~30MHzRadiatedEmissionsfor30MHz~1GHz RadiatedEmissionsfor1GHz~5GHz N/A ※※※※※ENDOFTHEREPORT※※※※※