2AAPLCQL1412-BiBun Bluetooth Speaker

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/ TV technician for help. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, Human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Revised wording (obsolete) 1.0 2.0 Sept–25-2007 Updated company template (current) 2.0 3.0 Jan-31-2012 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 3.0 Sure Wave(Hong Kong) Limited Mar 10, 2014 To: SIEMIC, INC. 775 Montague Expressway, Milpitas, CA 95035 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, Sure Wave(Hong Kong) Limited hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): Product name: iBun Bluetooth Speaker Model No.: CQL1412-B, UG-M6 FCC ID: 2AAPLCQL1412-B We affirm that between SIEMIC and Sure Wave(Hong Kong) Limited, any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Client’s signature Client’s name / title : Emma Lee/ Senior Sales Executive Contact address: A-703, Building 2, TianAn Cyber Park, Huangge North Road, Longgang District, Shenzhen, 518172, China Contact telephone: 86-755-22157741 Email: [email protected]

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] FCC Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 (obsolete) 1.0 2.0 August – 11 - 2008 Updated company template & Added text box (current) 2.0 3.0 Jan-31-2012 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 3.0 Sure Wave(Hong Kong) Limited FCC Confidentiality Request Letter Mar 10,2014 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: 2AAPLCQL1412-B We hereby request confidential treatment of information accompanying this application as outlined below: - Block Diagram - Schematics - Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s signature Client’s name / title : Emma Lee/ Senior Sales Executive Contact address: A-703, Building 2, TianAn Cyber Park, Huangge North Road, Longgang District, Shenzhen, 518172, China Contact telephone: 86-755-22157741 Email: [email protected]

Sure Wave(Hong Kong) Limited Date: Mar 10, 2014 To: SIEMIC, INC. 775 Montague Expressway, Milpitas, CA 95035 USA Statement FCC ID: 2AAPLCQL1412-B Model number: CQL1412-B, UG-M6 We hereby state that these models are identical in interior structure, electrical circuits and components, and just model number is different for the marketing requirement. Your assistance on this matter is highly appreciated. Sincerely, Client’s signature Client’s name / title : Emma Lee/ Senior Sales Executive Contact address: A-703, Building 2, TianAn Cyber Park, Huangge North Road, Longgang District, Shenzhen, 518172, China Contact telephone: 86-755-22157741 Email: [email protected]

External Photos

Label and label location

Internal Photos Antenna

FCC ID : 2AAPLCQL1412-B 1. RF EXPOSURE 1.1. The Requirement System operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy levels in excess of the Commission’s guidelines. See Section 15.247(b)(4) and Section 1.1307(b)(1) 1.2. Limit For Maximum Permissible Exposure (MPE) Limits for General Population/ Uncontrolled Exposure F = frequency in MHz, * Plane-wave equivalent power density 1.3. MPE Calculation Method Predication of MPE limit at a given distance Equation from page 18 of OET Bulletin 65, Edition 97-01 S=PG/4πR² Where: S=power density P=power input to antenna G=power gain of the antenna in the direction of interest relative to an isotropic radiator Frequency Range (MHz) Electric Field Strength (E) (V/m) Magnetic Field Strength (H) (A/m) Power Density (S) ( 2 mW/cm) Averaging Time 2 E, 2 H or S (minutes) 0.3-1.34 614 1.63 (100)* 30 1.34-30 824/f 2.19/f (180/f)* 30 30-300 27.5 0.073 0.2 30 300-1500 f/1500 30 1500-100,000 1.0 30 R=distance to the center of radiation of the antenna From the peak EUT RF output power, the minimum mobile separation distance, d=0.2m, as well as the gain of the BT antenna is 0 dBi, the RF power density can be obtained. 1.4. TEST RESULTS Maximum measured transmitter power For Bluetooth V2.1+EDR GFSK mode Test Frequency （MHz） Minimum Separation Distance (cm) Output Power (dBm) Output Power (mW) Antenna Gain (Numeric) Power Density Limit (mW/cm 2 ) Power Density At 20 cm (mW/cm 2 ) Test Results 2402 20.00 2.31 1.702 1.000 1.000 0.0003 Pass 2441 20.00 1.65 1.462 1.000 1.000 0.0003 Pass 2480 20.00 -1.02 0.791 1.000 1.000 0.0002 Pass ∏/4-DQPSK Mode Test Frequency （MHz） Minimum Separation Distance (cm) Output Power (dBm) Output Power (mW) Antenna Gain (Numeric) Power Density Limit (mW/cm 2 ) Power Density At 20 cm (mW/cm 2 ) Test Results 2402 20.00 1.98 1.578 1.000 1.000 0.0003 Pass 2441 20.00 1.23 1.327 1.000 1.000 0.0003 Pass 2480 20.00 -0.45 0.902 1.000 1.000 0.0002 Pass 8DPSK Mode Test Frequency （MHz） Minimum Separation Distance (cm) Output Power (dBm) Output Power (mW) Antenna Gain (Numeric) Power Density Limit (mW/cm 2 ) Power Density At 20 cm (mW/cm 2 ) Test Results 2402 20.00 2.11 1.626 1.000 1.000 0.0003 Pass 2441 20.00 1.42 1.387 1.000 1.000 0.0003 Pass 2480 20.00 -0.24 0.946 1.000 1.000 0.0002 Pass The measurement results comply with the FCC Limit per 47 CFR 2.1091 for the uncontrolled RF Exposure. 1.5. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, Human proximity to the antenna shall not be less than 20cm(8 inches) during normal operation. Proposed RF exposure safety information to include in User’s Manual.

Report No.: ATE20140163 Page 1 of 92 FCC ID: 2AAPLCQL1412-B ACCURATE TECHNOLOGY CO. LTD APPLICATION CERTIFICATION On Behalf of Sure Wave(Hong Kong) Limited iBun Bluetooth Speaker Model No.: CQL1412-B, UG-M6 FCC ID: 2AAPLCQL1412-B Prepared for : Sure Wave(Hong Kong) Limited Address : A-703, Building 2, TianAn Cyber Park, Huangge North Road, Longgang District, Shenzhen, 518172, China Prepared by : ACCURATE TECHNOLOGY CO., LTD Address : F1, Bldg. A, Chan Yuan New Material Port, Keyuan Rd. Science & Industry Park, Nan Shan, Shenzhen, Guangdong P.R. China Tel: (0755) 26503290 Fax: (0755) 26503396 Report Number : ATE20140163 Date of Test : Feb 24, 2014-Mar 06, 2014 Date of Report : Mar 06, 2014 Report No.: ATE20140163 Page 2 of 92 FCC ID: 2AAPLCQL1412-B ACCURATE TECHNOLOGY CO. LTD TABLE OF CONTENTS Description Page Test Report Certification 1. GENERAL INFORMATION .......................................................................................................... 5 1.1. Description of Device (EUT)....................................................................................................................5 1.2. Description of Test Facility ......................................................................................................................6 1.3. Measurement Uncertainty.........................................................................................................................6 2. MEASURING DEVICE AND TEST EQUIPMENT ..................................................................... 7 3. OPERATION OF EUT DURING TESTING ................................................................................. 8 3.1. Operating Mode ........................................................................................................................................8 3.2. Configuration and peripherals ..................................................................................................................8 4. TEST PROCEDURES AND RESULTS ......................................................................................... 9 5. 20DB BANDWIDTH TEST............................................................................................................ 10 5.1. Block Diagram of Test Setup..................................................................................................................10 5.2. The Requirement For Section 15.247(a)(1) ............................................................................................10 5.3. EUT Configuration on Measurement .....................................................................................................10 5.4. Operating Condition of EUT ..................................................................................................................10 5.5. Test Procedure ........................................................................................................................................11 5.6. Test Result ..............................................................................................................................................11 6. CARRIER FREQUENCY SEPARATION TEST........................................................................ 16 6.1. Block Diagram of Test Setup..................................................................................................................16 6.2. The Requirement For Section 15.247(a)(1) ............................................................................................16 6.3. EUT Configuration on Measurement .....................................................................................................16 6.4. Operating Condition of EUT ..................................................................................................................16 6.5. Test Procedure ........................................................................................................................................17 6.6. Test Result ..............................................................................................................................................17 7. NUMBER OF HOPPING FREQUENCY TEST ......................................................................... 23 7.1. Block Diagram of Test Setup..................................................................................................................23 7.2. The Requirement For Section 15.247(a)(1)(iii) ......................................................................................23 7.3. EUT Configuration on Measurement .....................................................................................................23 7.4. Operating Condition of EUT ..................................................................................................................23 7.5. Test Procedure ........................................................................................................................................24 7.6. Test Result ..............................................................................................................................................24 8. DWELL TIME TEST ..................................................................................................................... 26 8.1. Block Diagram of Test Setup..................................................................................................................26 8.2. The Requirement For Section 15.247(a)(1)(iii) ......................................................................................26 8.3. EUT Configuration on Measurement .....................................................................................................26 8.4. Operating Condition of EUT ..................................................................................................................26 8.5. Test Procedure ....................................................................................................…

Text truncated - open the document above for the full version.