2AAUQAAHZT11thermostats

Installation Manual Orion EMS September 13, 2012 Page 2 of 50 66 8003 002-8 Copyrights The information in this document is subject to change at the sole discretion of VingCard Elsafe AS without notice. Any use, operation or repair in contravention of this document is at your own risk. VingCard Elsafe AS does not assume any responsibility for incidental or consequential damages arising from the use of this manual. All information and drawings in this document are the property of VingCard Elsafe AS. Unauthorized use and reproduction is prohibited. VingCard is a registered trademark of VingCard Elsafe AS. September 13, 2012 Page 3 of 50 66 8003 002-8 Table of contents 1. GENERAL........................................................................................................................................................... 4 2. SOFTWARE INSTALLATION................................................................................................................................. 5 2.2 Installing an Orion EMS client ..................................................................................................................... 5 2.2.1 Starting an Orion EMS client................................................................................................................. 5 3. COMPONENT INFORMATION................................................................................................................................ 6 3.1 Thermostat controller ................................................................................................................................... 6 3.1.1 Thermostat controller dimensions .......................................................................................................... 6 3.2 Thermostat ................................................................................................................................................... 7 3.2.1 Thermostat buttons ................................................................................................................................ 7 3.2.2 Thermostat display ................................................................................................................................ 8 3.2.3 Thermostat dimensions.......................................................................................................................... 9 3.3 Parameters / specifications ......................................................................................................................... 10 3.4 Motion sensor ............................................................................................................................................ 12 3.4.1 Motion sensor dimensions ................................................................................................................... 13 3.4.2 Motion sensor specifications................................................................................................................ 13 4. DEVICE INSTALLATION AND COMMISSIONING................................................................................................... 16 4.1 Inputs / outputs .......................................................................................................................................... 16 4.1.1 RS-485 interface.................................................................................................................................. 17 4.1.2 Configuration with thermostat controller ............................................................................................. 18 4.1.3 Configuration without thermostat controller......................................................................................... 19 4.2 Installing a thermostat controller ................................................................................................................ 20 4.2.1 Mounting a thermostat controller ......................................................................................................... 20 4.3 Installing a thermostat ................................................................................................................................ 21 4.3.1 Mounting a thermostat......................................................................................................................... 21 4.3.1.1 Thermostat placement ................................................................................................................... 22 4.3.1.2 Thermostat battery exchange......................................................................................................... 22 4.3.2 Wiring a thermostat ............................................................................................................................. 22 4.3.2.1 Recommended wire specification.................................................................................................. 22 4.3.2.2 Connecting a thermostat................................................................................................................ 22 4.3.2.3 Line to low voltage conversion ..................................................................................................... 23 4.3.2.4 Connecting a wired door switch .................................................................................................... 23 4.4 Installing a motion sensor...........................................................................................................................24 4.4.1 Motion sensor placement ..................................................................................................................... 25 4.5 Commissioning the system ......................................................................................................................... 26 4.5.1 Commissioning when thermostat controller is used.............................................................................. 26 4.5.1…

Text truncated - open the document above for the full version.

Computime Limited 9/F, Tower One, Lippo Centre, 89 Queensway, Hong Kong DATE :2013-8-21 Nemko Canada Inc 303 River Road Ottawa, Ontario, Canada K1V 1H2 Attn: Director of Certification Authority to Act as Agent On our behalf, I appoint Hans.Hu of Global United Technology Services Co., Ltd. 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District Shenzhen Guangdong to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the Federal Communications Commission’s regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, as specified by Nemko Canada Inc, still resides with Computime Limited and 9/F, Tower One, Lippo Centre, 89 Queensway, Hong Kong Dated this / Day of 8/21/2013 / Agency agreement expiration date: 8/21/2014 By: stanley ye Signature Printed Title: manager On behalf of : Computime Limited Telephone: (86) 755 8473 6036-380

Computime Limited 9/F, Tower One, Lippo Centre, 89 Queensway, Hong Kong 2013-8-21 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 F CC ID: 2AAUQAAHZT11 Product Name: thermostats Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential:  Schematics  Block diagram  Operational Description These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated this 8/21/2013 By: stanley ye Signature Printed Title: manager On behalf of : Computime Limited Telephone: (86) 755 8473 6036-380

AAHZT11 label Material:72826T Size:42x30mm Model :AAHZT11 Input:24VAC Switching:3×0.5A FCC ID:2AAUQAAHZT11 This equipment complies with part 15 of FCC RF Rules. Operation is subject to the following two conditions: 1)This device may not cause interference and 2)This device may accept any interference, including Interference that may cause undesired operation of the device.

Label location

FCC ID:2AAUQAAHZT11 RF Exposure evaluation According to 447498 D01 General RF Exposure Guidance v05r01 The 1-g and 10-g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances ≤ 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)] • [√f(GHz)] ≤ 3.0 for 1-g SAR and ≤ 7.5 for 10-g extremity SAR, where • f(GHz) is the RF channel transmit frequency in GHz • Power and distance are rounded to the nearest mW and mm before calculation • The result is rounded to one decimal place for comparison eirp = pt x gt = (EXd) 2 /30 where: pt = transmitter output power in watts, gt = numeric gain of the transmitting antenna (unitless), E = electric field strength in V/m, --- 10 ((dBuV/m)/20) /10 6 d = measurement distance in meters (m)---3m So pt = (EXd) 2 /30 x gt Field strength = 97.56dBuV/m @3m Ant gain =0dBi ;so Ant numeric gain=1 So pt={ [10 (97.56/20) /10 6 x3] 2 /30x1 }x1000 mW = 1.71mW So ( 1.71mW/5mm)x √2.48GHz = 0.539 <3 Then SAR evaluation is not required

Global United Technology Services Co., Ltd. Report No.: GTSE13070113401 Authorized Signature: Robinson Lo Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the GTS product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of GTS International Electrical Approvals or testing done by GTS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by GTS International Electrical Approvals in writing. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” Page FCC REPORT Applicant: Computime Limited Address of Applicant: 9/F, Tower One, Lippo Centre, 89 Queensway, Hong Kong Equipment Under Test (EUT) Product Name: thermostats Model No.: AAHZT11, AAHZT12 FCC ID: 2AAUQAAHZT11 Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.249:2012 Date of sample receipt: July 18, 2013 Date of Test: July 18-August 15, 2013 Date of report issued: August 16, 2013 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No.: GTSE13070113401 Global United Technology Services Co., Ltd. Project No.: GTSE130701134RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 2 of 30 2 Version Version No. Date Description 00 August 16, 2013 Original Prepared By: Date: August 16, 2013 Project Engineer Check By: Date: August 16, 2013 Reviewer Report No.: GTSE13070113401 Global United Technology Services Co., Ltd. Project No.: GTSE130701134RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 3 of 30 3 Contents Page 1 COVER PAGE ............................................................................................................................................ 1 2 VERSION .................................................................................................................................................. 2 3 CONTENTS .............................................................................................................................................. 3 4 TEST SUMMARY ..................................................................................................................................... 4 5 GENERAL INFORMATION ...................................................................................................................... 5 5.1 CLIENT INFORMATION ......................................................................................................................... 5 5.2 GENERAL DESCRIPTION OF EUT ......................................................................................................... 5 5.3 TEST MODE ........................................................................................................................................ 7 5.4 DESCRIPTION OF SUPPORT UNITS ....................................................................................................... 7 5.5 TEST FACILITY .................................................................................................................................... 7 5.6 TEST LOCATION ................................................................................................................................. 7 5.7 OTHER INFORMATION REQUESTED BY THE CUSTOMER ......................................................................... 7 6 TEST INSTRUMENTS LIST ..................................................................................................................... 8 7 TEST RESULTS AND MEASUREMENT DATA ...................................................................................... 9 7.1 ANTENNA REQUIREMENT: .................................................................................................................... 9 7.2 CONDUCTED EMISSIONS ................................................................................................................... 10 7.3 RADIATED EMISSION METHOD ........................................................................................................... 13 7.3.1 Field Strength of The Fundamental Signal ................................................................................ 15 7.3.2 Spurious emissions .................................................................................................................... 16 7.3.3 Bandedge emissions.................................................................................................................. 20 7.4 20DB OCCUPY BANDWIDTH .............................................................................................................. 21 8 TEST SETUP PHOTO ............................................................................................................................ 23 9 EUT CONSTRUCTIONAL DETAILS ..................................................................................................... 25 Report No.: GTSE13070113401…

Text truncated - open the document above for the full version.

Radiated Emission