2ASK3CT-6164TPA-1008 PALM SIZED HIGH PERFORMANCE DRONE

WARNING: Never leave product charging unattended for extended periods of time. Always disconnect PA-1008 from charger immediately after the PA-1008 is fully charged. Please refer to enclosed safety instructions. INSTRUCTION BOOKLET Colors and styles may vary slightly. PACKAGE CONTAINS: 2.4G Wireless ControllerInstruction BookletSpare PartsUSB Charging CordPA-1008 Made in China C008S-FRN-V 1.0 PALM SIZED HIGH PERFORMANCE DRONE PA-1008 CT- 6164 14 Voyage Aeronautics™ is the registered trademark of Amax Group USA, LLC. AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024 © 2020 All Rights Reserved. visit us at www.amaxbrands.com CHOKING HAZARD - Small parts. Not suitable for children under 3 years. WARNING! FCC Part 15 C Notice CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC/ IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Cet équipement est conforme aux limites d'exposition aux radiations FCC/IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps. Conforms to safety requirements of RED 2014/53/EU and FCC. WEEE Directive & Product Disposal At the end of its serviceable life, this product should not be treated as household or general waste. It should be handed over to the applicable collection point for the recycling of electrical and electronics equipment, or returned to the supplier for disposal. Internal/Supplied Batteries This symbol on the battery indicates that the battery is to be collected separately. This battery is designed for separate collection at an appropriate collection point. This Regulation require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life it should not be disposed of with other household waste. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that the battery should be collected and not be disposed of with other household waste. The toy is only to be connected to Class II equipment bearing the symbol. Costco France 1 avenue de Bréhat 91140 Villebon-sur-Yvette, France 01 80 45 01 10 www.costco.fr Thank you for purchasing the 2.4 G Indoor /Outdoor PA-1008. Please read this instruction booklet as it contains valuable information on how to properly fly and care for your PA-1008. FEATURES • Air Pressure Sensor Locks Flight Altitude • Built In 6 Axis Gyroscopic Chip Keeps the PA-1008 Extremely Stable in All Conditions • T (Training ) Mode Helps Beginner Pilots Learn How to Fly • Automatically Start and Lands with The Push of A Button • Different Speed Settings for Slow to High Speed Flying REMOTE CONTROL BATTERY INSTALLATION 1. Unscrew and remove the battery cover from the back of the remote control. 2. Install 2 “AAA” alkaline batteries into the battery compartment as shown in the diagram A1. 3. Replace the battery cover and secure it. CHARGING THE PA-1008 1. Before playing, you need to charge the PA-1008 battery first. Connect the charging socket of USB charging cord to the charging plug on the battery side. (See diagram A) Caution: The USB plug fits the charging socket only in one way. Do not force it. 2. Connect the PA-1008 charging cord to your computer’s USB port (see diagram B). Caution: Only use this charging cord with a computer USB port! Do not attempt to use other USB charging devices. 3. The red LED on the USB plug lights up when charging is complete (See diagram C). Note: If the red LED lights up, either the charging is complete or the USB plug is not properly connected. 4. The average charging time is approximately 35-40 minutes. The PA-1008 operates for about 5 minutes per charge. Low battery indication: the PA-1008 ‘s LED lights will begin to flash to notify you that the battery is running low. 45 seconds after the LED lights start flashing y…

Text truncated - open the document above for the full version.

AMAX INDUSTRIAL GROUP CHINA CO., LTD Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 Subject: Request for Confidentiality FCC ID: 2ASK3CT-6164T To Whom It May Concern: Pursuant to the provisions of Sections 0.457 and 0.459 of the Commission’s rules (47 CFR §§ 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. Schematic Diagram Block Diagram Theory of Operation Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards Company Name: AMAX INDUSTRIAL GROUP CHINA CO., LTD Contact Name: Nancy Chen Title of Person:QA Manager Address: OFFICE NO.3 10/F WITTY COMMERCIAL BUILDING 1A-1L TUNG CHOI STREET MONGKOK KOWLOON HONG KONG Date:2020/5/13

AMAX INDUSTRIAL GROUP CHINA CO., LTD Address: OFFICE NO.3 10/F WITTY COMMERCIAL BUILDING 1A-1L TUNG CHOI STREET MONGKOK KOWLOON HONG KONG Confirmation Letter We, AMAX INDUSTRIAL GROUP CHINA CO., LTD FCC ID: 2ASK3CT-6164T The product: PA-1008 PALM SIZED HIGH PERFORMANCE DRONE And model No.: CT-6164 1422628/SC-6129/SC-6130/SC-6131 have the same technical construction including circuit diagram, PCB Layout, components and component layout, all electrical construction and mechanical construction with CT-6164.The difference lies only the model number and color. (Signature) _____________

Appendix I External Photographs Page 2 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. View of EUT-1 View of EUT-2 Page 3 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. View of EUT-3 View of EUT-4

13MM 0.9MM FCC ID: 2ASK3CT- 6164T

Appendix II Internal Photographs Page 2 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-1 Internal View of EUT-2 Page 3 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-3 Internal View of EUT-4 Antenna

The results reported herein have been performed in accordance with the laboratory’s terms of accreditation. This report shall not be reproduced except in full without the written approval of the Laboratory. The results in this report apply to the test sample(s) mentioned above at the time of the testing period only and are not to be used to indicate applicability to other similar products. This report does not imply that the product(s) has met the criteria for certification. CFR 47 FCC PART 15 SUBPART C TEST REPORT For PA-1008 PALM SIZED HIGH PERFORMANCE DRONE MODEL NUMBER: CT-6164,1422628, SC-6129, SC-6130, SC-6131 FCC ID: 2ASK3CT-6164T REPORT NUMBER: 4789436323-6 ISSUE DATE: May 13, 2020 Prepared for AMAX INDUSTRIAL GROUP CHINA CO.,LTD OFFICE NO.3 10/F WITTY COMMERCIAL BUILDING 1A-1L TUNG CHOI STREET MONGKOK KOWLOON HONG KONG Prepared by UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch Building 10, Innovation Technology Park, No. 1, Li Bin Road, Song Shan Lake Hi- Tech Development Zone Dongguan, 523808, People’s Republic of China Tel: +86 769 22038881 Fax: +86 769 33244054 Website: www.ul.com REPORT NO.: 4789436323-6 Page 2 of 50 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO.: 10-SL-F0058 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Revision History Rev. Issue Date Revisions Revised By V0 05/13/2020 Initial Issue REPORT NO.: 4789436323-6 Page 3 of 50 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO.: 10-SL-F0058 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Summary of Test Results Clause Test Items FCC Rules Test Results 1 20dB Bandwidth and 99% Occupied Bandwidth CFR 47 FCC §15.215 (c) Pass 2 Radiated Emission CFR 47 FCC §15.249 (a)(d)(e) CFR 47 FCC §15.205 and §15.209 Pass 3 Conducted Emission Test For AC Power Port RSS-GEN Clause 8.8 Not Applicable （Note 3） 4 Antenna Requirement CFR 47 FCC §15.203 Pass Note: 1. This test report is only published to and used by the applicant, and it is not for evidence purpose in China. 2. The measurement result for the sample received is <Pass> according to < CFR 47 FCC PART 15 SUBPART C, ISED RSS-210 Issue 10 and ISED RSS-GEN Issue 5 > when <Accuracy Method> decision rule is applied. 3. The EUT only employ battery power for operation and which do not operate from the AC power lines. REPORT NO.: 4789436323-6 Page 4 of 50 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO.: 10-SL-F0058 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. TABLE OF CONTENTS 1. ATTESTATION OF TEST RESULTS .................................................................................... 5 2. TEST METHODOLOGY ........................................................................................................ 6 3. FACILITIES AND ACCREDITATION .................................................................................... 6 4. CALIBRATION AND UNCERTAINTY .................................................................................. 7 4.1. MEASURING INSTRUMENT CALIBRATION ................................................................ 7 4.2. MEASUREMENT UNCERTAINTY ................................................................................. 7 5. EQUIPMENT UNDER TEST ................................................................................................. 8 5.1. DESCRIPTION OF EUT ................................................................................................. 8 5.2. MAXIMUM FIELD STRENGTH ...................................................................................... 8 5.3. CHANNEL LIST .............................................................................................................. 8 5.4. DESCRIPTION OF AVAILABLE ANTENNAS ................................................................ 8 5.5. TEST CHANNEL CONFIGURATION ............................................................................. 8 5.6. THE WORSE CASE POWER SETTING PARAMETER ................................................. 9 5.7. TEST ENVIRONMENT ................................................................................................... 9 5.8. DESCRIPTION OF TEST SETUP ................................................................................ 10 5.9. MEASURING INSTRUMENT AND SOFTWARE USED .............................................. 11 6. ANTENNA PORT TEST RESULTS .................................................................................... 12 6.1. ON TIME AND DUTY CYCLE ...................................................................................... 12 6.2. 20 dB BANDWIDTH AND 99% OCCUPIED BANDWIDTH .......................................... 14 7. RADIATED TEST RESULTS .............................................................................................. 18 7.1. LIMITS AND PROCEDURE ......................................................................................... 18 7.2. RESTRICTED BANDEDGE AND FIELD STRENGTH OF INTENTIONAL EMISSIONS 25 7.3. SPURIOUS EMISSIONS (1~3GHz) ............................................................................. 31 7.4. SPURIOUS EMISSIONS (3~18GHz) ........................................................................... 37 7.5. SPURIOUS EMISSIONS (18~26GHz) ......................................................................... 43 7.6. SPURIOUS EMISSIONS BELOW 30MHz ................................................................... 45 7.7. SPURIOUS EMISSIONS BELOW 1GHz AND ABOVE 30MHz ................................... 48 8. ANTENNA REQUIREMENTS ............................................................................................. 50 …

Text truncated - open the document above for the full version.

Appendix II Setup Photographs RADIATED RF MEASUREMENT SETUP (30MHz ~ 1 GHz) RADIATED RF MEASUREMENT SETUP (Below 30MHz) RADIATED RF MEASUREMENT SETUP (Above 1G – X axis) RADIATED RF MEASUREMENT SETUP (Above 1G – Y axis) RADIATED RF MEASUREMENT SETUP (Above 1G – Z axis)