2ASK3CT-6176TSHIFT24/Power Craze 2.0 High Speed Buggy

Colors and styles may slightly vary. SAFETY WARNINGS!s Improper use of batteries may lead to overheating, breakage or leaking. - Do not mix old and new batteries. - Do not mix different battery brands. - Install batteries with correct polarity. The flat side (negative terminal) of the battery should rest against the spring. - Remove dead batteries immediately. - Avoid liquids, which can short circuit the batteries. - The truck or remote will become unresponsive when batteries are low, at which point you should replace all batteries with new ones. - Remove the batteries if you will not use the truck for a long time. s Avoid using near furniture or glass to prevent damage to these objects. s Do not play on roads. s Do not play in crowded areas to avoid injury or damage. Choose a safe location away from traffic. s Do not use truck during a storm or when lightning or thunder are present. s Do not use in a wet , sandy or muddy environment as truck may become damaged. s Do not modify or attempt to replace the built-in original antenna on the remote or truck. Doing so will damage the set and affect operation.s$ONOTPULLONANYWIRESTHATAREPARTOFTHETRUCK3UCHA CTIONMAYCAUSETHEWIRESTOBREAKANDTHETRUCK to malfunction.s+EEPFINGERS HAIRANDCLOTHESAWAYFROMTHETRUCKSSPINNI NGTIRES&AILURETODOSOMAYRESULTIN physical injury.s.EVERAIMTHETRUCKATOTHERPEOPLEs$ONOTTHROWTHETRUCKORPURPOSELYHITITWITHANYOBJECTs3TORETRUCKINACOOLENVIRONMENT AWAYFROMHIGH TEMPERATU RESOURCESSUCHASFIRES STOVES RADIATORS ETC s4HISTRUCKHASNOUSER SERVICEABLEPARTS$ONOTATTEMPTTO MODIFYCOMPONENTSORCIRCUITBOARD s4HISTOYISONLYTOBECONNECTEDTOEQUIPMENTBEARINGEITHE ROFTHEFOLLOWINGSYMBOLSOR 2%#(!2'%!",%"!44%294HIS3()&4© uses an internal Lithium Ion rechargeable battery and is not replaceable. If the battery no longer stays charged, dispose of it properly according to local disposal requirements.#!54)/.)FTHERECHARGEABLEBATTERYLEAKSFLUID AVOIDCONTACT WITHEYESANDDISPOSEOFTHE3()&4© . FCC Part 15 C NoticeCAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:s2EORIENTORRELOCATETHERECEIVINGANTENNAs)NCREASETHESEPARATIONBETWEENTHEEQUIPMENTANDRECEIVERs#ONNECTTHEEQUIPMENTINTOANOUTLETONACIRCUITDIFFERENT from that to which the receiver is connected.s Consult the dealer or experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation. INSTRUCTION MANUAL This product is manufactured by Amax Group12645 Memorial Drive Suite F1 #388 Houston, TX 77024SHIFT™2.0 is the registered trademark of Amax Group © 2020 All rights reserved. Visit us at www.amaxbrands.com Conforms to safety requirements of ASTM, FCC and CPSIA. Made in China CT-6176 # !53 6 ® III 4HANKYOUFORPURCHASINGTHE3()&4© With proper care, your new 3()&4© will provide you with many hours of enjoyment. Please read this instruction manual completely before using the product for the first time, and then keep this manual in a handy place for future reference. Costco Wholesale Australia Pty Ltd 17-21 Parramatta Road Lidcombe NSW 2141 Australia www.costco.com.au Limited 90-Day Warranty NORTH AMERICA AMAX Group USA warrants to the original consumer that this product is free from any electrical or mechanical defects for a period of 90 DAYS from the date of purchase. If any such defect is discovered within the warranty period, AMAX Group USA will repair or replace the unit free of charge upon receipt of the unit, shipped postage prepaid and insured to our warranty center ALONG WITH THE ORIGINAL RECEIPT evidencing that the product was purchased from an approved AMAX retail partner and that the product is still within the 90 day warranty period. The warranty covers normal consumer use and does not cover damage that occurs in shipment or failure that results from alterations, accident, misuse, abuse, neglect, wear and tear, inadequate maintenance, commercial use or unreasonable use of the unit. Removal of any parts/components voids all warranties. This warranty does not cover cost of repairs made or attempted outside by third-party individuals or companies. Any applicable implied warranties, including warranties of merchantability and fitness, are hereby limited to 90 DAYS from the date of purchase. Consequential or incidental damages resulting from a breach of any applicable express or implied warranties are hereby excluded. Some states do not allow limitations on the duration of implied warranties and do not allow exclusion of incidental or consequential damages, so the above limitations and exclusions in these instances may not apply. REPAIR/REPLACE PRODUCTIf your product begins to malfunction or stop working, immediately contact our warranty center (contact details listed below).…

Text truncated - open the document above for the full version.

AMAX INDUSTRIAL GROUP CHINA CO., LTD Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 Subject: Request for Confidentiality FCC ID: 2ASK3CT-6176T To Whom It May Concern: Pursuant to the provisions of Sections 0.457 and 0.459 of the Commission’s rules (47 CFR §§ 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. Schematic Diagram Block Diagram Theory of Operation Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards Company Name: AMAX INDUSTRIAL GROUP CHINA CO., LTD Contact Name: Nancy Chen Title of Person：QA Manager Address: OFFICE NO.3 10/F WITTY COMMERCIAL BUILDING 1A-1L TUNG CHOI STREET MONGKOK KOWLOON HONG KONG Date:5/14/2020

Appendix I External Photographs Page 2 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. View of EUT-1 View of EUT-2 Page 3 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. View of EUT-3 View of EUT-4

Amax Industrial Group China Co. Limited 852.3962.5160 Model Number: CT- 6176 F08B01D05/2020 Shenzhen, China 63.3mm 15.5mm FCC ID: 2ASK3CT- 6176T This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Appendix II Internal Photographs Page 2 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-1 Internal View of EUT-2 Page 3 of 3 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Internal View of EUT-3 Antenna

The results reported herein have been performed in accordance with the laboratory’s terms of accreditation. This report shall not be reproduced except in full without the written approval of the Laboratory. The results in this report apply to the test sample(s) mentioned above at the time of the testing period only and are not to be used to indicate applicability to other similar products. This report does not imply that the product(s) has met the criteria for certification. CFR 47 FCC PART 15 SUBPART C TEST REPORT For SHIFT24/Power Craze 2.0 High Speed Buggy MODEL NUMBER: CT-6176/1422642/VL-6036/VL-6037/VL-6038 FCC ID: 2ASK3CT-6176T REPORT NUMBER: 4789461925-4 ISSUE DATE: May 15, 2020 Prepared for AMAX INDUSTRIAL GROUP CHINA CO.,LTD OFFICE NO.3 10/F WITTY COMMERCIAL BUILDING 1A-1L TUNG CHOI STREET MONGKOK KOWLOON HONG KONG Prepared by UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch Building 10, Innovation Technology Park, No. 1, Li Bin Road, Song Shan Lake Hi- Tech Development Zone Dongguan, 523808, People’s Republic of China Tel: +86 769 22038881 Fax: +86 769 33244054 Website: www.ul.com REPORT NO.: 4789461925-4 Page 2 of 50 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO.: 10-SL-F0058 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Revision History Rev. Issue Date Revisions Revised By V0 05/15/2020 Initial Issue REPORT NO.: 4789461925-4 Page 3 of 50 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO.: 10-SL-F0058 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. Summary of Test Results Clause Test Items FCC/ISED Rules Test Results 1 20dB Bandwidth and 99% Occupied Bandwidth CFR 47 FCC §15.215 (c) ISED RSS-Gen Clause 6.7 Pass 2 Radiated Emission CFR 47 FCC §15.249 (a)(d)(e) CFR 47 FCC §15.205 and §15.209 Pass 3 Antenna Requirement CFR 47 FCC §15.203 Pass Note 1: This test report is only published to and used by the applicant, and it is not for evidence purpose in China. Note 2: The measurement result for the sample received is <Pass> according to < CFR 47 FCC PART 15 SUBPART C, ISED RSS-210 Issue 10 and ISED RSS-GEN Issue 5 > when <Accuracy Method> decision rule is applied. REPORT NO.: 4789461925-4 Page 4 of 50 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO.: 10-SL-F0058 This report shall not be reproduced except in full, without the written approval of UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch. TABLE OF CONTENTS 1. ATTESTATION OF TEST RESULTS ................................................................................. 5 2. TEST METHODOLOGY ..................................................................................................... 6 3. FACILITIES AND ACCREDITATION ................................................................................. 6 4. CALIBRATION AND UNCERTAINTY ................................................................................ 7 4.1. MEASURING INSTRUMENT CALIBRATION .............................................................. 7 4.2. MEASUREMENT UNCERTAINTY ............................................................................... 7 5. EQUIPMENT UNDER TEST ............................................................................................... 8 5.1. DESCRIPTION OF EUT .............................................................................................. 8 5.2. MAXIMUM FIELD STRENGTH .................................................................................... 8 5.3. CHANNEL LIST ........................................................................................................... 8 5.4. DESCRIPTION OF AVAILABLE ANTENNAS .............................................................. 8 5.5. TEST CHANNEL CONFIGURATION ........................................................................... 8 5.6. THE WORSE CASE POWER SETTING PARAMETER ............................................... 9 5.7. TEST ENVIRONMENT ................................................................................................ 9 5.8. DESCRIPTION OF TEST SETUP ...............................................................................10 5.9. MEASURING INSTRUMENT AND SOFTWARE USED ..............................................11 6. ANTENNA PORT TEST RESULTS ...................................................................................12 6.1. ON TIME AND DUTY CYCLE .....................................................................................12 6.2. 20 dB BANDWIDTH AND 99% OCCUPIED BANDWIDTH .........................................14 7. RADIATED TEST RESULTS .............................................................................................18 7.1. LIMITS AND PROCEDURE ........................................................................................18 7.2. RESTRICTED BANDEDGE AND FIELD STRENGTH OF INTENTIONAL EMISSIONS 25 7.3. SPURIOUS EMISSIONS (1~3GHz) ............................................................................31 7.4. SPURIOUS EMISSIONS (3~18GHz) ..........................................................................37 7.5. SPURIOUS EMISSIONS (18~26GHz) ........................................................................43 7.6. SPURIOUS EMISSIONS BELOW 30MHz ..................................................................45 7.7. SPURIOUS EMISSIONS BELOW 1GHz AND ABOVE 30MHz ...................................48 8. ANTENNA REQUIREMENTS ............................................................................................50 REPORT NO.: 4789461925-4 Page 5 of 50 UL Verification Services (Guangzhou) Co., Ltd, Song Shan Lake Branch FORM NO.: 10-SL-F0058 This report shall not be reproduced except in full, without the written approval of UL V…

Text truncated - open the document above for the full version.

Appendix II Setup Photographs RADIATED RF MEASUREMENT SETUP (30MHz ~ 1 GHz) RADIATED RF MEASUREMENT SETUP (Below 30MHz) RADIATED RF MEASUREMENT SETUP (Above 1G – X axis) RADIATED RF MEASUREMENT SETUP (Above 1G – Y axis) RADIATED RF MEASUREMENT SETUP (Above 1G – Z axis)