2AVTM-TT2001Heyday Wireless Bluetooth Earbuds

Wireless Earbuds Included Wireless Earbuds Micro USB Charging Cable Pairing Power ON using ON/OFF switch. Rapid flashing white light, followed by a chime Use Bluetooth settings on your phone to pair with HEYDAY EARBUD 01 Slow flashing white light - pairing successful Indicators Red/White Alternating - Bluetooth pairing Slow Flashing White - Paired Slow Flashing Red - Battery low Red - Charging White - Charging complete Ascending Tones - Powering on Descending Tones - Powering off Three Rapid Tones - Ready to pair Two Rapid High Tones - Paired Two Rapid Low Tones - Low battery Two Ascending Tones - Max. Volume Two Descending Tones - Min. Volume Phone call function Press the ON/OFF switch to answer the incoming call, press the ON/OFF switch again to hang up after the call Press the + button to increase the volume Press the – button to decrease the volume The music will pause when a call comes in and will resume playing after the call has ended Charging Full charge requires approximately 2-3 hours Charging is complete when solid white light turns on Plug micro end of charging cable into earbuds Plug USB end of charging cable into a DC 5V USB power supply Troubleshooting and tips If the earbuds are not working correctly, turn them on/off to reset If the earbuds won’t turn on, recharge the battery and try again If the earbuds won’t charge, make sure the supply works, is 5V >1A, and not damaged If the earbuds make no sound adjust the volume If the earbuds make no sound or do not show as an available device, make sure they are not paired to another device, if so, unpair the device and re-pair the desired device This device does not have a pairing code. If prompted for one make sure you are connecting to the correct device. If you are, “forget“ the device and re-pair. If you are still prompted enter 0000 NOTE: The unit will power off after 2 minutes of no use. Need some help? Can’t get it to pair? Have a question or comment? call us at: 877-698-4883 or: 877-MyTgtTech online at: TargetTechSupport.com Safety Do not use near any water source Do not modify or repair this device Do not use in high temperatures or extreme weather Do not use chemical detergents to clean your device, use a soft dry cloth Keep 5-10 inches between microphone and mouth when using the phone call function FCC ID: 2AVTM-TT2001 Model: TT2001 Input: 5V Max 1A Made in China FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause interference to radio communications. How ever, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ● Reorient or relocate the receiving antenna. ● Increase the separation between the equipment and receiver. ● Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. ● Consult the dealer or an experienced radio/TV technician for help. Target Corp.Mpls.MN,55403 Phone:1-612-304-6073 Left charge port increase volume / hold-next track hold on / off play / pause / answer/end calls decrease volume / hold-last track / mute call Right heyday R

RadiationPatternRadiationPattern 2DGainPattern(2441MHZ)2DGainPattern(2441MHZ)

1 External Photo FCC ID: 2AVTM-TT2001 View of The Product View of The Product

FCC ID:2AVTM-TT2001 08-20 BC 1 视角 日期 产品料号 图纸编号 页次 版本 单位 客户代码 绘图 批准 线控移印图 产品型号 审核 1/1 BT345 2019/7/23 mm 01-A Silkscreen cool gray 9c Made in China Model:TT2001

1 Internal Photo FCC ID: 2AVTM-TT2001 Inner View of the EUT Inner Circuit Top View Antenna 2 Inner Circuit Bottom View

RF Exposure Test Requirement: FCC 47CFR 15.247(i) Test Date: 2020-07-24 Mode of Operation: Tx mode Requirements: In 15.247(i), an equipment shall be operated in a manner that ensures that the public is not exposed to radio frequency energy levels in excess of the limits in §§ 1.1310 and 2.1093 of this chapter. Applications to the Commission for construction permits, licenses to transmit or renewals thereof, equipment authorizations or modifications in existing facilities must contain a statement confirming compliance with the limits unless the facility, operation, or transmitter is categorically excluded, as discussed below. Technical information showing the basis for this statement must be submitted to the Commission upon request. According to KDB447498 D01 General RF Exposure Guidance v06, unless specifically required by the published RF exposure KDB procedures, standalone 1-g head or body and 10-g extremity SAR evaluation for general population exposure conditions, by measurement or numerical simulation, is not required when the corresponding SAR Exclusion Threshold condition. Test Results: RF Exposure Evaluation The Maximum tune-up power = -1.739dBm (0.67mW) SAR Test Exclusion Thresholds=0.21≤ 3.0 for 1-g SAR, The test separation distances is ≤5 mm The power tune up tolerance is -3.439±1.70dBm Max. duty factor is 100%

Test Report Date : 2020-07-30 Page 1 of 74 No. : HMD20070008 The Hong Kong Standards and Testing Centre Limited 10 Dai Wang Street, Taipo Industrial Estate, Tai Po, N.T., Hong Kong Tel: +852 2666 1888 Fax: +852 2664 4353 Email: [email protected] Website: www.stc.group This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Limited. For Conditions of Issuance of this test report, please refer to “Conditions of Issuance of Test Reports” section or Website. Applicant : TT Innovation Technology (HK) Co., Ltd. Unit 506A, Harbour Crystal Centre,100 Granville Road, Tsim Sha Tsui, Kowloon, Hong Kong Supplier / Manufacturer : Dongguan Fulun Electronics Co., Ltd. 4-8 Building B Xinbosheng Industrial Park No.5 Xinyuan South Road Keyuan City Tangxia Dongguan China Description of Sample(s) : Submitted sample(s) said to be Product: Heyday Wireless Bluetooth Earbuds Brand Name: heyday Model No.: TT2001 FCC ID: 2AVTM-TT2001 Date Samples Received : 2020-07-20 Date Tested : 2020-07-20 to 2020-07-24 Investigation Requested : Perform Electro Magnetic Interference measurement in accordance with FCC 47CFR [Codes of Federal Regulations] Part 15 and ANSI C63.10:2013 for FCC Certification. Conclusions : The submitted product COMPLIED with the requirements of Federal Communications Commission [FCC] Rules and Regulations Part 15. The tests were performed in accordance with the standards described above and on Section 2.2 in this Test Report. Remarks : Bluetooth FHSS (GFSK / /4-DQPSK) _______________________________ LEUNG Kwun Hang, Joey Authorized Signatory Test Report Date : 2020-07-30 Page 2 of 74 No. : HMD20070008 The Hong Kong Standards and Testing Centre Limited 10 Dai Wang Street, Taipo Industrial Estate, Tai Po, N.T., Hong Kong Tel: +852 2666 1888 Fax: +852 2664 4353 Email: [email protected] Website: www.stc.group This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Limited. For Conditions of Issuance of this test report, please refer to “Conditions of Issuance of Test Reports” section or Website. CONTENT: Cover Page 1 of 74 Content Page 2 of 74 1.0 General Details 1.1 Test Laboratory Page 3 of 74 1.2 Equipment Under Test [EUT] Page 3 of 74 Description of EUT operation 1.3 Date of Order Page 3 of 74 1.4 Submitted Sample(s) Page 3 of 74 1.5 Test Duration Page 3 of 74 1.6 Country of Origin Page 3 of 74 1.7 RF Module Details Page 4 of 74 1.8 Antenna Details Page 4 of 74 1.9 Channel List Page 4 of 74 2.0 Technical Details 2.1 Investigations Requested Page 5 of 74 2.2 Test Standards and Results Summary Page 5 of 74 2.3 Table for Test Modes Page 6 of 74 3.0 Test Results 3.1 Emission Page 7-70 of 74 Appendix A List of Measurement Equipment Page 71 of 74 Appendix B Photograph(s) of Product Page 72-74 of 74 Test Report Date : 2020-07-30 Page 3 of 74 No. : HMD20070008 The Hong Kong Standards and Testing Centre Limited 10 Dai Wang Street, Taipo Industrial Estate, Tai Po, N.T., Hong Kong Tel: +852 2666 1888 Fax: +852 2664 4353 Email: [email protected] Website: www.stc.group This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Limited. For Conditions of Issuance of this test report, please refer to “Conditions of Issuance of Test Reports” section or Website. 1.0 General Details 1.1 Test Laboratory The Hong Kong Standards and Testing Centre Ltd. EMC Laboratory 10 Dai Wang Street, Taipo Industrial Estate, New Territories, Hong Kong Telephone: 852 2666 1888 Fax: 852 2664 4353 1.2 Equipment Under Test [EUT] Description of Sample(s) Product: Heyday Wireless Bluetooth Earbuds Manufacturer: Dongguan Fulun Electronics Co., Ltd. 4-8 Building B Xinbosheng Industrial Park No.5 Xinyuan South Road Keyuan City Tangxia Dongguan China Brand Name: heyday Model Number: TT2001 Rating: 5Vd.c.(power by USB port) / 3.7Vd.c (Li-ion rechargeable battery x1) 1.2.1 Description of EUT Operation The Equipment Under Test (EUT) is a Heyday Wireless Bluetooth Earbuds. The transmission signal is digital modulated with channel frequency range 2402-2480MHz. The R.F. signal was modulated by IC; the type of modulation used was frequency hopping spread spectrum Modulation. 1.3 Date of Order 2020-07-20 1.4 Submitted Sample(s): 1 Sample 1.5 Test Duration 2020-07-20 to 2020-07-24 1.6 Country of Origin China Test Report Date : 2020-07-30 Page 4 of 74 No. : HMD20070008 The Hong Kong Standards and Testing Centre Limited 10 Dai Wang Street, Taipo Industrial Estate, Tai Po, N.T., Hong Kong Tel: +852 2666 1888 Fax: +852 2664 4353 Email: [email protected] Website: www.stc.group This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Limited. For Conditions of Issuance of this test report, please refer to “Conditions of Issuance of Test Reports” section or Website. 1.7 RF Module Details Module Model Number: AC6936D Module FCC ID: N/A Module Transmission Type: Bluetooth V4.2 EDR Modulation: FHSS (GFSK / /4-DQPSK) Data Rates: 1MBps: GFSK 2 MBps: /4-DQPSK Frequency Range: 2400-2483.5MHz Carrier Frequencies: 2402MHz – 2480MHz Module Specification (specification provided by manufacturer) 1.8 Antenna Details Antenna Type: PCB antenna Antenna Gain: 0dBi 1.9 Channel List Channel Frequency (MHz) Channel Frequency (MHz) 0 2402 42 2444 1 2403 43 2445 2 2404 44 2446 3 2405 45 2447 4 2406 46 2448 5 2407 47 2449 6 2408 48 2450 7 2409 ... ... 8 2410 67 2469 9 2411 68 2470 ... ... 69 2471 33 2435 70 2472 34 2436 71 2473 35 2437 72 2474 36 2438 73 2475 37 2439 74 2476 38 2440 75 2477 39 2441 76 2478 40 2442 77 2479 41 2443 78 2480 Test Report Date : 2020-07-30 Page 5 of 74 No. : HMD20070008 The Hong Kong Standards and Testing Centre Limited 10 Dai Wang Street, Taipo Industrial Estate, Tai Po, N.T., Hong Kong Tel: +852 2666 1888 Fax: +852 2664 4353 Email: [email protected] Website: www.stc.group This report shall not be reproduced unless …

Text truncated - open the document above for the full version.

1 Test Photo FCC ID: 2AVTM-TT2001 Measurement of Radiated Emission Test Set Up Measurement of Radiated Emission Test Set Up 2 Measurement of Radiated Emission Test Set Up Measurement of Conducted Emission Test Set Up