A7C-3100F-000WIFI OUTDOOR ACCESS POINT

Document # 3100-30-000-A01 November 28, 2011 MBW 3100 MBW 3100MBW 3100 MBW 3100 Installation Guide Installation Guide Installation Guide Installation Guide G GG GoNet oNetoNet oNet MBW 3100 Installation Guide MBW 3100 Installation GuideMBW 3100 Installation Guide MBW 3100 Installation Guide Trademarks and Licensing Agreement © 2011 GoNet Systems Ltd. All rights reserved. All information contained in this document is protected by international copyright treaties. No information may be copied or reproduced without the express written consent of GoNet Systems Ltd. GoNet Metro Broadband Wireless, GoNet MBW, WLAN Sector Base Station, WLS, GoNet WLAN Pico Base Station, WLP, GoNet Wireless Network Controller, and WNC are all trademarks of GoNet Systems Ltd. Any duplication, transmission by any method, or storage in an information retrieval system of any part of this publication for other purposes other than those stated above is strictly prohibited without the specific written permission of GoNet Systems Ltd. This includes, but is not limited to, transcription into any form of computer system for audio, text, print, or visual retrieval. All rights under federal copyright laws and international laws will be strictly enforced. All other trademarks and registered trademarks are the property of their respective owners. GoNet Systems Ltd. Email: [email protected] G GG GoNet oNetoNet oNet MBW 3100 Installation Gu MBW 3100 Installation GuMBW 3100 Installation Gu MBW 3100 Installation Guide ideide ide FCC Compliance Status The following information is for FCC compliance: This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment, this equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. To meet regulatory restrictions, the outdoor access point must be professionally installed. The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when using its antennas. Any changes or modifications not expressly approved by GoNet Systems could void the user's authority to operate the equipment. The antennas used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. G GG GoNet oNetoNet oNet MBW 3100 Installation Guide MBW 3100 Installation GuideMBW 3100 Installation Guide MBW 3100 Installation Guide Table of Contents Introduction ........................................................................................................................................ 1 Key Product Features ................................................................................................................................ 1 Organization of this Document ................................................................................................................... 2 MBW 3100 ........................................................................................................................................... 3 MBW 3100 Package Components ............................................................................................................... 3 MBW 3100 Safety Information ..................................................................................................................... 4 RF Exposure .............................................................................................................................................. 4 MBW 3100 Lightning Protector .................................................................................................................. 4 Information de sécurité pour MBW 3100 .................................................................................................... 5 Exposition aux fréquences RF ................................................................................................................... 5 Paratonnerre pour MBW 3100 .................................................................................................................. 5 Installation .......................................................................................................................................... 6 Installation Process ...................................................................................................................................... 6 Site Survey ................................................................................................................................................ 6 Assembling and Mounting the MBW 3100 ................................................................................................. 7 Mounting Adapters ..................................................................................................................................... 8 Mounting Brackets ..................................................................................................................................... 9 Mounting the MBW 3100 ......................................................................................................................... 12 Installing the Safety Cable ....................................................................................................................... 13 Assembling and Mounting the Optional Mesh Antenna ......................................................................... 14 Cable Connections ...…

Text truncated - open the document above for the full version.

Date: 25/1/2012 Federal Communications Commission Authorization and Evaluation Division Subject: Confidentiality Request regarding application for certification of FCC ID: A7C-3100F-000 Dear Sirs Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: CONF APPENDIX MBW-3100F BlkDia.pdf CONF APPENDIX MBW-3100F PartsLst.pdf CONF APPENDIX MBW-3100F Schem.pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely,

Date: 25/1/2012 To: Timco Engineering Inc. To Whom It May Concern We hereby authorize Shaike Raz of ITL to act on the behalf of GoNet Systems Ltd., regarding the FCC ID Certification process for the following application FCC ID: AC7-3100F-000 Thank you,

Date: 25/1/2012 Letter of individual Authorization to sign Form 731 To: Timco Engineering Inc. To Whom It May Concern We hereby authorize Shaike Raz of ITL as an authorized individual to sign Form 731 on behalf of GoNet Systems Ltd for the FCC ID: A7C-3100F-000 application. Thank you,

The MBW-3100 is designed to be an outdoor Wireless LAN Access Point (AP) to be installed in public wireless LAN hot spots / hot zones. A user in the vicinity of the AP, that has a laptop / PDA or cell phone with a wireless LAN NIC (Network Interface Card) can associate with the AP and be connected to the Internet. In a public WLAN (wireless LAN) installation, the MBW-3100s will be installed by large service providers or cellular operators in areas where there will be a demand for this service, such as train stations, airports, convention centers and business areas. Another option is that the MBW- 3100 will be installed in a campus (such as a university or hospital) by the "owner" of the campus. The MBW-3100 will typically be installed either outdoors to provide outdoor coverage of Campuses or city neighborhoods, or in large indoor locations such as train stations, airports etc. In outdoor installations the MBW-3100 will typically be mounted either on a pole or on an outside wall of a building. In indoor installation, the MBW-3100 will typically be mounted on wall. MBW-3100 Architecture The MBW-3100 employs a WLAN channel. A WLAN Station (STA) can associate to any one of these channels and transmit / receive data from it. The MBW-3100's channel employs a multi element (4) antenna with a beam steering algorithm to steer a directional beam in the direction of the STA from which it is receiving information / to which it is transmitting information. The beam steering is preformed digitally on the Base Band (BB) signal. In transmission the BB signal is duplicated 4 times. Each "copy" of the signals is modified digitally and transmitted to a separate RF chain. The 4 RF chains perform up – conversion and amplification separately and drives one of the 4 antenna elements. A similar performance happens in reception.

Test Report E111742.00 GoNet Systems Ltd. Page 1 of 133 FCC ACC M Ver 1.1 05Mayl 2000 DATE: 19 January 2012 I.T.L. (PRODUCT TESTING) LTD. FCC Radio Test Report for GoNet Systems Ltd Equipment under test: WiFi Outdoor Access Point MBW-3100F Written by: _____________________________ D. Shidlowsky, Documentation Approved by: _____________________________ A. Sharabi, Test Engineer Approved by: _____________________________ I. Raz, EMC Laboratory Manager This report must not be reproduced, except in full, without the written permission of I.T.L. (Product Testing) Ltd. This report relates only to items tested. Test Report E111742.00 GoNet Systems Ltd. Page 2 of 133 FCC ACC M Ver 1.1 05Mayl 2000 Measurement/Technical Report for GoNet Systems Ltd WiFi Outdoor Access Point MBW-3100F FCC ID: A7C-3100F-000 This report concerns: Original Grant: X Class I Change: Class II Change: Equipment type: Digital Transmission System Limits used: 47CFR15 Section 15.247 Measurement procedure used is ANSI C63.4-2003. Application for Certification Applicant for this device: prepared by: (different from "prepared by") Ishaishou Raz Sharon Ashkenazi ITL (Product Testing) Ltd. GoNet Systems Ltd. Kfar Bin Nun 34 HaBarzel St. D.N. Shimshon 99780 Tel-Aviv, 69710 Israel Israel e-mail [email protected] Tel: +972-3- 633-8634 Fax: +972-3- 649-3866 e-mail: [email protected] Test Report E111742.00 GoNet Systems Ltd. Page 3 of 133 FCC ACC M Ver 1.1 05Mayl 2000 TABLE OF CONTENTS 1. GENERAL INFORMATION ------------------------------------------------------------------------------- 5 1.1 Administrative Information ................................................................................. 5 1.2 List of Accreditations ......................................................................................... 6 1.3 Product Description ........................................................................................... 7 1.4 Test Methodology .............................................................................................. 7 1.5 Test Facility ....................................................................................................... 8 1.6 Measurement Uncertainty ................................................................................. 8 2. SYSTEM TEST CONFIGURATION --------------------------------------------------------------------- 9 2.1 Justification ........................................................................................................ 9 2.2 EUT Exercise Software ..................................................................................... 9 2.3 Special Accessories .......................................................................................... 9 2.4 Equipment Modifications ................................................................................... 9 2.5 Configuration of Tested System ...................................................................... 10 3. CONDUCTED AND RADIATED MEASUREMENT TEST SET-UP PHOTOS --------------11 4. CONDUCTED EMISSION DATA -----------------------------------------------------------------------13 4.1 Test Specification ............................................................................................ 13 4.2 Test Procedure ................................................................................................ 13 4.3 Measured Data ................................................................................................ 13 4.4 Test Instrumentation Used, Conducted Measurement ................................... 18 5. 6 DB MINIMUM BANDWIDTH --------------------------------------------------------------------------19 5.1 Test procedure ................................................................................................ 19 5.2 Results table .................................................................................................... 26 5.3 Test Equipment Used. ..................................................................................... 27 6. 26 DB MINIMUM BANDWIDTH-------------------------------------------------------------------------28 6.1 Test procedure ................................................................................................ 28 6.2 Results table .................................................................................................... 35 6.3 Test Equipment Used. ..................................................................................... 36 7. MAXIMUM TRANSMITTED PEAK POWER OUTPUT -------------------------------------------37 7.1 Test procedure ................................................................................................ 37 7.2 Results table .................................................................................................... 44 7.3 Test Equipment Used. ..................................................................................... 45 8. PEAK POWER OUTPUT OUT OF 2400-2483.5 MHZ BAND -----------------------------------46 8.1 Test procedure ................................................................................................ 46 8.2 Results table .................................................................................................... 89 8.3 Test Equipment Used. ..................................................................................... 90 9. BAND EDGE SPECTRUM -------------------------------------------------------------------------------91 9.1 Test procedure ................................................................................................ 91 9.2 Results table .................................................................................................... 96 9.3 Test Equipment Used. ..................................................................................... 97 10. RADIATED EMISSION, 9 KHZ – 30 MHZ -----------------------------------------------------------98 10.1 Test Specification .......................................…

Text truncated - open the document above for the full version.

Test Report E111743.00 GoNet Systems Ltd. Page 1 of 100 FCC ACC M Ver 1.1 05Mayl 2000 DATE: 19 January 2012 I.T.L. (PRODUCT TESTING) LTD. FCC Radio Test Report for GoNet Systems Ltd Equipment under test: WiFi Outdoor Access Point MBW-3100F Written by: _____________________________ D. Shidlowsky, Documentation Approved by: _____________________________ A. Sharabi, Test Engineer Approved by: _____________________________ I. Raz, EMC Laboratory Manager This report must not be reproduced, except in full, without the written permission of I.T.L. (Product Testing) Ltd. This report relates only to items tested. Test Report E111743.00 GoNet Systems Ltd. Page 2 of 100 FCC ACC M Ver 1.1 05Mayl 2000 Measurement/Technical Report for GoNet Systems Ltd WiFi Outdoor Access Point MBW-3100F FCC ID: A7C-3100F-000 This report concerns: Original Grant: X Class I Change: Class II Change: Equipment type: Digital Transmission System Limits used: 47CFR15 Section 15.247 Measurement procedure used is ANSI C63.4-2003. Application for Certification Applicant for this device: prepared by: (different from "prepared by") Ishaishou Raz Sharon Ashkenazi ITL (Product Testing) Ltd. GoNet Systems Ltd. Kfar Bin Nun 34 HaBarzel St. D.N. Shimshon 99780 Tel-Aviv, 69710 Israel Israel e-mail [email protected] Tel: +972-3- 633-8634 Fax: +972-3- 649-3866 e-mail: [email protected] Test Report E111743.00 GoNet Systems Ltd. Page 3 of 100 FCC ACC M Ver 1.1 05Mayl 2000 TABLE OF CONTENTS 1. GENERAL INFORMATION ------------------------------------------------------------------------------- 5 1.1 Administrative Information ................................................................................. 5 1.2 List of Accreditations ......................................................................................... 6 1.3 Product Description ........................................................................................... 7 1.4 Test Methodology .............................................................................................. 7 1.5 Test Facility ....................................................................................................... 8 1.6 Measurement Uncertainty ................................................................................. 8 2. SYSTEM TEST CONFIGURATION --------------------------------------------------------------------- 9 2.1 Justification ........................................................................................................ 9 2.2 EUT Exercise Software ..................................................................................... 9 2.3 Special Accessories .......................................................................................... 9 2.4 Equipment Modifications ................................................................................... 9 2.5 Configuration of Tested System ...................................................................... 10 3. CONDUCTED AND RADIATED MEASUREMENT TEST SET-UP PHOTOS --------------11 4. CONDUCTED EMISSION DATA -----------------------------------------------------------------------13 4.1 Test Specification ............................................................................................ 13 4.2 Test Procedure ................................................................................................ 13 4.3 Measured Data ................................................................................................ 13 4.4 Test Instrumentation Used, Conducted Measurement ................................... 18 5. 6 DB MINIMUM BANDWIDTH --------------------------------------------------------------------------19 5.1 Test procedure ................................................................................................ 19 5.2 Results table .................................................................................................... 23 5.3 Test Equipment Used. ..................................................................................... 24 6. 26 DB MINIMUM BANDWIDTH-------------------------------------------------------------------------25 6.1 Test procedure ................................................................................................ 25 6.2 Results table .................................................................................................... 29 6.3 Test Equipment Used. ..................................................................................... 30 7. MAXIMUM TRANSMITTED PEAK POWER OUTPUT -------------------------------------------31 7.1 Test procedure ................................................................................................ 31 7.2 Results table .................................................................................................... 35 7.3 Test Equipment Used. ..................................................................................... 36 8. PEAK POWER OUTPUT OUT OF 5725-5850 MHZ BAND -------------------------------------37 8.1 Test procedure ................................................................................................ 37 8.2 Results table .................................................................................................... 62 8.3 Test Equipment Used. ..................................................................................... 63 9. BAND EDGE SPECTRUM -------------------------------------------------------------------------------64 9.1 Test procedure ................................................................................................ 64 9.2 Results table .................................................................................................... 67 9.3 Test Equipment Used. ..................................................................................... 68 10. RADIATED EMISSION, 9 KHZ – 30 MHZ -----------------------------------------------------------69 10.1 Test Specification .......................................…

Text truncated - open the document above for the full version.