B4SR1000Remote Control

Set Up and Operating Instructions for Remote Control Model R1000 Install batteries: Open the battery compartment on the back of the remote and insert 2 AAA alkaline batteries (not supplied). Observe polarity. Operation Press the Firefly button to bring up the on-screen menu and then follow the prompts. Select help from the on-screen menu for more information. F.C.C. CAUTION - THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. This equipment generates and uses radio frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturers instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for remote control security devices in accordance with the specifications in Sub-Part B of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the interference by one or more of the following measures. o Reorient the antenna of the radio/TV experiencing the interference. o Relocate the product with respect to the radio/TV. o Move the product away from the radio/TV. o Plug the product into an outlet on a different electrical circuit from the radio/TV experiencing the interference. If necessary, consult your local dealer for additional suggestions. NOTE: NO CHANGES OR MODIFICATIONS MAY BE MADE TO THE UNITS. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. R1000-10/03 SnapStream Media, Inc. www.snapstream/com/firefly

MCU (EM78P447S) Block Diagram for SNAPSTREAM RF REMOTE (R1000) Key Matrix 433.92MHzTransmitter 433.92MHz

RF Remote Control Use with Firefly Receiver Model R1000-1. Use 2 AAA alkaline batteries. Model OR12A (Snapstream) Remote Control rating label 2: 1 10/20/03 SnapStream Media, Inc. www.snapstream/com/firefly with Wireless PC control FCC ID: B4SR1000 Made in China Model R1000

1 2 34 ABCD 4 3 2 1 D CBA Title Number Revision Size A4 Date: 22-Jan-2003 Sheet of File: A:\M_RF433_.SCH Drawn By: TR1H10 R1 10K R310K R2 150R C61P C55P6 C2 * C322PC14P7 L2 8MM L318T L1 3.5T SAW1 433MHz RF INPUT +3V C41P RF 433MHz Tx 90MMAntenna PCB TRACE DCBA 12345678 ABCD 8 7 6 5 4 3 2 1 PICO ELECTRONICS Ltd., Eastfield Industrial Estate, Glenrothes, Fife, KY7 4NZ, SCOTLAND SHEET No. DATEDATE REVISION DATE FIRST DRAWN FILEDRNAPPD. DO NOT SCALE DRAWING TITLE: REV. Error : PICO.WMF File Not Found D:\BACKUP\OR12A\S11941.SCH 11 of A PRINT DATE 17:34:33 9-Oct-2003 30/9/02 30/09/02 30/09/02 LED1RED R51K VSS C747UF25V D3 Y1 4MHZ R41M VSS VSS 2 x AAA BATTERIES BATT1BATT2 +3V NOTES:-1/ ALL UNSPECIFIED DIODES 1N4148 OR EQUIVALENT.2/ ALL UNSPECIFIED DAUGHTER BOARD CAPACITORS ARE SMD TYPE.3/ ALL UNSPECIFIED DAUGHTER BOARD RESISTORS ARE SMD TYPE.4/ ALL UNSPECIFIED RESISTORS ARE 0.125W 5%.5/ ALL UNSPECIFIED CAPACITORS ARE AXIAL MLC TYPE."*" DENOTES COMPONENT NOT INSTALLED SIGNAL KEY11MAXIMIZE KEY12 Info KEY18A KEY26CH- KEY31D KEY34RTKEY3UP KEY7PHOTOS KEY9Fireflg KEY1BKEY6HOUSE KEY33CH+ KEY171 RF DAUGHTER BOARD SHOWN FOR REFERENCE ONLY 433MHz DAUGHTER BOARD KEY303KEY24Close TCC 1 VDD 2 NC 3 INT 5 P50 6 P51 7 P52 8 P53 9 P60 10 P61 11 P62 12 P63 13 P64 14 VCC 4 RES 28 P65 15 P66 16 P67 17 P70 18 P71 19 P72 20 P73 21 P74 22 P75 23 P76 24 P77 25 OSCO 26 OSCI 27 U1 EM78P447S R6100K C61NF VSS KEY4PLAYKEY22REC KEY237 KEY28STOP KEY298 KEY10PREV KEY56KEY366 KEY37MOUSE KEY39ENT KEY43C KEY45MUTE KEY422 KEY41NEXT TR1H10 R1 10K R310K R2 100R C6* C55P6 C2 100P C322PC15P6 L26MM L318T L1 2.5T SAW1 433MHz C41P VSS KEY35FWD KEY19MUSIC KEY25VIDEOKEY32OptionKEY38TVKEY44DVD KEY20VOL-KEY13VOL+KEY8BACKKEY20 KEY14LFKEY21MENUKEY27ENTKEY40DNKEY46OK KEY15REWKEY47PAUSE KEY487KEY163

Test Report No. R-10116-3 FCC ID: B4SR1000 APPLICANT X-10 USA, Inc. 19823, 58 th Place S. Kent, WA 98032 MANUFACTURER X-10 Electronics Shenzhen Co. Ltd. X-10 Building Labour Industrial District Shenzhen, Xixiang, Bao An Guang Dong, China, 518102 TEST SPECIFICATION: FCC Rules and Regulations Part 15, Subpart C, Para. 15.231 TEST PROCEDURE: ANSI C63.4:2001 TEST SAMPLE DESCRIPTION BRANDNAME: X-10 USA Model Number: R1000 TYPE: Pulsed Transmitter POWER REQUIREMENTS: 2 “AAA” Batteries FREQUENCY OF OPERATION: 433.92 MHz TESTS PERFORMED Para. 15.231(b), Radiated Emissions, Fundamental and Harmonics Para. 15.231(b), Radiated Emissions, Spurious Case Para. 15.35, Duty Cycle Determination Para. 15.231(c), Occupied Bandwidth REPORT OF MEASUREMENTS Applicant: X-10 (USA), Inc. Brand Name: Snapstream ‘Firefly’ Device: Pulsed Transmitter FCC ID: B4SR1000 Test Report No. R-10116-3 FCC ID: B4SR1000 Power Requirements: 2 “AAA” Batteries Applicable Rule Section: Part 15, Subpart C, Section 15.231 Test Report No. R-10116-3 FCC ID: B4SR1000 REPORT OF MEASUREMENTS (continued) TEST RESULTS 15.231 (a): This device is used as a remote control transmitter. 15.231 (a)(1) & The transmitter is manually operated and ceases transmission within 5 15.231(a)(2): seconds after deactivation. 15.231 (a)(3): The transmitter does not perform periodic transmissions. 15.231 (b): The fundamental field strength did not exceed 10,958 μV/M (Average) at a test distance of 3 meters. In addition, the requirements of section 15.35 for averaging pulsed emissions and for limiting peak emissions were met. The field strength of harmonic and spurious emissions did not exceed 1,095 μV/M (AVERAGE). DETERMINATION OF FIELD STRENGTH LIMITS The field strength limits shown below are found in Section 15.231. Frequency Limit F1 = 260 3750 = L1 Fo = 433.92 Lo F2 = 470 12500 = L2 Test Report No. R-10116-3 FCC ID: B4SR1000 REPORT OF MEASUREMENTS (continued) The formula below was utilized to determine the limits: Limit = L1 + [(Fo-F1)(L2-L1)/(F2-F1)] Solving yields: Fundamental Limit = 10,997 μV/M (AVERAGE) @ 3 Meters Harmonic Limit = 1,099 μV/M (AVERAGE) @ 3 Meters DUTY CYCLE DETERMINATION The unit’s RF output was directly coupled to the input of the spectrum analyzer. The analyzer was set for a frequency span of 0Hz. The sweep time was then adjusted in order to display one full pulse train. The transmitter on time was then summed and compared to the time for one full cycle in order to obtain the duty cycle. Transmitter On Time = 17.6 milliseconds (maximum) Transmitter Cycle Time = 41.3 milliseconds Transmitter Duty Cycle = 42.6 % See separate e-file for plots named dutycycle.pdf for additional information. Test Report No. R-10116-3 FCC ID: B4SR1000 SPECTRUM ANALYZER DESENSITIZATION CONSIDERATIONS Due to the nature of the emissions being measured, care was taken to ensure that the resolution bandwidth of the spectrum analyzer was adequate to provide accurate measurements. The following formula was utilized: Setting pulse desensitization equal to zero and utilizing the minimum observed pulse width of 650 μs yields a minimum required bandwidth of 1,026 Hz. FCC specified bandwidths of 100kHz and 1MHz were utilized below and above 1GHz, respectively. GENERAL NOTES All readings were taken utilizing a peak detector function at a test distance of 3 meters. The duty cycle was applied to the peak readings in order to determine the average value of the emissions. The frequency range was scanned from 30 MHz to 4.3392 GHz. All emissions not reported were more than 20 dB below the specified limit. Test Report No. R-10116-3 FCC ID: B4SR1000 EQUIPMENT LIST FCC Part 15, Subpart C, Paragraph 15.231 EN Type Manufacturer Description Model No. Cal Date Due Date 067 Open Area Test Site Retlif 3 Meter RNY 10/01/2003 10/01/2006 128 Double Ridged Guide Electro-Mechanics 1 GHz - 18 GHz 3105 06/13/2003 06/13/2004 133 Broadband Pre-Amplifier Electro-Metrics 10 kHz - 1 GHz, 26dB BPA-1000 06/12/2003 06/12/2004 141 Spectrum Analyzer Hewlett Packard 100 Hz - 40 GHz 8566B 07/23/2003 01/23/2004 141A Graphics Plotter Hewlett Packard N/A 7470A 03/05/2003 03/05/2004 141B Quasi-Peak Adaptor Hewlett Packard 100 Hz - 1 GHz 85650A 07/23/2003 01/23/2004 206B 6.0 dB Attenuator Texscan 0 - 1.0 GHz FP-50 - 6 dB 06/12/2003 06/12/2004 543 Preamplifier Hewlett Packard 1.0 GHz - 26.5 GHz 8449B 07/24/2003 07/24/2004 617 Interference Analyzer Electro-Metrics 10 kHz - 1 GHz EMC-30 09/30/2003 09/30/2004 767 Biconilog EMCO 26 - 2000 MHz 3142B 09/04/2003 09/04/2004 Test Report No. R-9132-1 FCC ID: B4SR1000 FCC 15.231(b) RADIATED EMISSIONS, FUNDAMENTAL & SPURIOUS CASE (See separate e-file named Refundharm & REspur.pdf) FCC 15.231(c) OCCUPIED BANDWIDTH (See separate e-file named occbw.pdf) Test Report No. R-10116-3 FCC ID: B4SR1000 FCC 15.231(c) DUTY CYCLE (See separate e-file named dutycycle.pdf) Test Report No. R-10116-3 FCC ID: B4SR1000 Test Setup Photograph

Retlif Testing Laboratories R Test Report No. R-10116-3 FCC ID: B4SR1000 Test Setup Photograph