BBP-WLKIB01Wireless LAN Module

User Manual Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host product according the interface specification (installation procedure). User Manual The following information must be indicated on the host device of this module; [for FCC] Contains Transmitter Module FCC ID: BBP-WLKIB01 or Contains FCC ID: BBP-WLKIB01 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [for IC] Contains Transmitter Module IC: 144D-WLKIB01 or Contains IC: 144D-WLKIB01 The following statements must be described on the user manual of the host device of this module; [for FCC] FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body in normal use position. [for IC] This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body in normal use position. Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le dispositif rayonnant et le corps en utilisation normale.

front internal back LBWA1ZZWL6 Photos 2013/10/7 Since this is covered with the soldered metal shielding case, the RF section cannot be opened easily. Model: R-WL6

front internal back LBWA1ZZWL6 Photos 2013/10/7 Since this is covered with the soldered metal shielding case, the RF section cannot be opened easily. Model: R-WL6

UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 Applicant: Ricoh Company, Ltd. T ype of Equipm ent : W ireless LA N M odule Model No. : R-WL6 FCC ID: BBP-W LK IB01 Ricoh C ompany, Ltd. declares that M odel : W ireless LAN M odule complies with FCC radiation exposure requirement specified in the FCC Rules 2.1091. RF Exposure Calculations: The following information provides the minimum separation distance for the highest gain antenna provided with the “R-W L6“ as calculated from FCC Part 1, §1.1310, TABLE 1 (B) Limits for General Population / Uncontrolled Exposure. This calculation is based on the highest EIRP possible from the system, considering maximum power and antenna gain, and considering a 1.0mW/cm^2 uncontrolled exposure limit. The Friis formula used was: S = (P * G) / (4* π * r 2 ) Where P = 168.27 mW (M aximum peak output power) G = 0.76 Numerical Antenna gain; equal -1.20 dBi r =20.0 cm For: R-W L6S = 0.02539 mW/cm 2 No. : 10055965S-A RF Ex posure / SAR Statement

Test report No. : 10055965S-A Page : 2 of 63 Issued date : November 22, 2013 Revised date : December 4, 2013 FCC ID : BBP-WLKIB01 UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 REVISION HISTORY Original Test Report No.: 10055965S-A Revision Test report No. Date Page revised Contents - (Original) 10055965S-A November 22, 2013 - - 1 10055965S-A December 4, 2013 4, 24-29 P4: Correction of Antenna connector type P24-29: Addition of Remarks to data Test report No. : 10055965S-A Page : 3 of 63 Issued date : November 22, 2013 FCC ID : BBP-WLKIB01 UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 Contents Page SECTION 1: Customer information ..................................................................................... 4 SECTION 2: Equipment under test (E.U.T.) ....................................................................... 4 SECTION 3: Test specification, procedures & results ......................................................... 5 SECTION 4: Operation of E.U.T. during testing ................................................................. 8 SECTION 5: Conducted emission ........................................................................................ 9 SECTION 6: 6dB bandwidth & Occupied bandwidth (99%) ........................................... 10 SECTION 7: Maximum peak conducted output power..................................................... 10 SECTION 8: Out of band emissions (Antenna port conducted) ....................................... 10 SECTION 9: Peak power density........................................................................................ 10 SECTION 10: Radiated emission........................................................................................ 11 Contents of APPENDIXES ................................................................................................... 13 APPENDIX 1: Data of Radio tests ...................................................................................... 14 APPENDIX 2: Test instruments ......................................................................................... 60 APPENDIX 3: Photographs of test setup ........................................................................... 61 Test report No. : 10055965S-A Page : 4 of 63 Issued date : November 22, 2013 Revised date : December 4, 2013 FCC ID : BBP-WLKIB01 UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 SECTION 1: Customer information Company Name : Ricoh Company, Ltd. Address : 810 Shimoimaizumi, Ebina-shi, Kanagawa-ken, 243-0460 Japan Telephone Number : +81- 46- 292- 2564 Facsimile Number : +81- 3- 6673- 4430 Contact Person : Seiji Nakamura SECTION 2: Equipment under test (E.U.T.) 2.1 Identification of E.U.T. Type of Equipment : Wireless LAN Module Model Number : R-WL6 Serial Number : Refer to Section 4.2 Rating : DC 3.6V (VBAT), DC 3.0V (PAVDD) Country of Mass-production : China Condition of EUT : Engineering prototype (Not for Sale: This sample is equivalent to mass-produced items.) Receipt Date of Sample : August 26, 2013 Modification of EUT : No modification by the test lab. 2.2 Product description Model: R-WL6 (referred to as the EUT in this report) is a Wireless LAN Module. Clock frequency(ies) in the system : 26MHz, 32.768kHz <Radio part> Equipment type : Transceiver Frequency of operation : 2412-2462MHz Bandwidth : 20MHz Channel spacing : 5MHz Type of modulation : DSSS, OFDM ITU code : D1D, G1D Operation temperature range : 0 to +70 deg.C Antenna type : Print Pattern Antenna Antenna gain : -1.2dBi peak Antenna connector type : None FCC 15.31 (e) / 212 This host device provides stable voltage (DC3.6V (VBAT) and DC3.0V (PAVDD)) constantly to RF Module regardless of input voltage. Therefore, the equipment complies with the requirement. FCC 15.203 / 212 The antenna is not removable from the EUT. Therefore, the equipment complies with the antenna requirement. Test report No. : 10055965S-A Page : 5 of 63 Issued date : November 22, 2013 FCC ID : BBP-WLKIB01 UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 SECTION 3: Test specification, procedures & results 3.1 Test specification Test specification : FCC Part 15 Subpart C: 2013, final revised on September 30, 2013 and effective October 30, 2013 Title : FCC 47CFR Part15 Radio Frequency Device Subpart C Intentional Radiators Section 15.207 Conducted limits Section 15.209 Radiated emission limits, general requirements Section 15.247 Operation within the bands 902-928MHz, 2400-2483.5MHz, and 5725-5850MHz * The revision on September 30, 2013 does not affect the test specification applied to the EUT. 3.2 Procedures & Results Item Test Procedure *1) SpecificationRemarks DeviationWorst Margin Results Conducted emission ANSI C63.10:2009 FCC 15.207 - N/A 15.1dB Freq.: 0.17413MHz Detector: Average Phase: L1 Mode: Tx 2437MHz, IEEE 802.11g Complied 6dB bandwidth ANSI C63.10:2009 FCC 15.247 (a)(2) ConductedN/A * See data Complied Maximum peak conducted output power ANSI C63.10:2009 FCC 15.247 (b)(3) ConductedN/A 7.74dB (result: 22.26dBm) Mode: Tx 2437MHz, IEEE 802.11g Complied Out of band emission & Restricted band edges ANSI C63.10:2009 FCC 15.109, 15.247 (d) & 15.209 Conducted / Radiated N/A 4.2dB Freq.: 2390.000MHz Polarization: Horizontal Detection: Peak Mode: Tx 2412MHz, IEEE 802.11n HT20 Complied Power density ANSI C63.10:2009 FCC 15.247 (e) ConductedN/A * See data Complied Note: UL Japan’s EMI Work Procedures No.13-EM-W0420 and 13-EM-W0422. *1) These tests were also referred to KDB 558074 v03 r01 (FCC), "Guidance for Performing Compliance Measurements on Digital Transmission Systems (…

Text truncated - open the document above for the full version.

UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 APPENDIX 3: Photographs of test setup Conducted emission Front view Rear view Test Report No 10055965S-A 61 of 63 UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 Radiated emission Front view Rear view (below 1GHz) Rear view (above 1GHz) Test Report No 10055965S-A 62 of 63 UL Japan, Inc. Shonan EMC Lab. 1-22-3 Megumigaoka, Hiratsuka-shi, Kanagawa-ken, 259-1220 JAPAN Telephone : +81 463 50 6400 Facsimile : +81 463 50 6401 Pre-check of the worst position X-axis Y-axis Z-axis END OF REPORT Test Report No 10055965S-A 63 of 63