EJM-AP1210Wireless Gateway

Share Broadband with all your PCs ® Intel Wireless Gateway II User’s Guide user_guide_rg1210.book Page 1 Monday, April 22, 2002 2:20 PM Copyright The Intel ® Wireless Gateway II User’s Guide as well as the software described in it, is furnished under license and may only be used or copied in accordance with the terms of the license. The information in this document is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Intel Corporation. Intel assumes no responsibility or liability for any errors or inaccuracies that may appear in this document or any software that may be provided in association with this document. Except as permitted by such license, no part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means without the express written consent of Intel Corporation. Information in this document is provided in connection with Intel products. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted by this document. Except as provided in Intel's Terms and Conditions of Sale for such products, Intel assumes no liability whatsoever, and Intel disclaims any express or implied warranty, relating to sale and/or use of Intel products including liability or warranties relating to fitness for a particular purpose, merchantability, or infringement of any patent, copyright or other intellectual property right. Intel products are not intended for use in medical, life saving, or life sustaining applications. Intel may make changes to specifications and product descriptions at any time, without notice. Intel, the Intel logo, and AnyPoint are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries. *Other names and brands may be claimed as the property of others. Copyright © 2002, Intel Corporation. All rights reserved. Intel Corporation, 5200 NE Elam Young Parkway, Hillsboro, OR 97214-6497 Rev. 0.03, April 22, 2002 user_guide_rg1210.book Page 2 Monday, April 22, 2002 2:20 PM iii Contents Chapter 1 – Overview1 Decide how to set up the Intel ® WirelessGatewayII........2 FeaturesoftheIntelWirelessGatewayII.................3 Verify system and service requirements..................4 Alookatthegatewayhardware........................5 Configurationsoftwareandsettings.....................9 Accessingtheconfigurationsoftware....................9 Wheretofindmoreinformation........................12 Chapter 2 – Setting Up the Gateway on a Network13 Planning your network..............................14 Connecting the gateway to an Ethernet hub or switch ......14 Configuringthegatewayasanaccesspoint .............16 Installing wireless adapters on other PCs................20 Using Windows* XP Client Configuration Manager . . ......21 Configuring the adapter.............................22 Chapter 3 – Changing the Gateway Settings23 Opening the gateway configuration software.............24 Viewing your connection status.......................25 Viewingmorestatusdetails ..........................25 Printingyourgatewaysettings ........................25 Changing your wireless settings.......................26 Changing or disabling your encryption settings...........28 Changing your device settings........................32 Savingsettingsandrestartingyourgateway .............37 Chapter 4 – Using the Advanced Feature Set39 Accessingadvancedfeatures.........................40 Changing your gateway password.....................40 Changing your advanced wireless settings...............41 Settingyourtransferrate ............................42 Setting your operating channel........................42 user_guide_rg1210.book Page iii Monday, April 22, 2002 2:20 PM iv Contents Usingsystemtools.................................42 Establishingroutingprotocols.........................43 Refining DHCP server addressing.....................45 Assigningvirtualserversettings.......................46 Usingaccesscontrolfeatures.........................50 Changing your gateway IP address....................51 IP addressing in network adapters.....................52 UniversalPlugandPlay.............................53 Chapter 5 – Troubleshooting55 Problemsandsolutions..............................56 Ifallelsefails .....................................69 Reading the gateway indicator lights...................70 Reading settings and device status....................70 Using firmware troubleshooting tips....................71 Using the system tools on your gateway................71 Chapter 6 – Glossary75 Glossary.........................................76 Chapter 7 – Specifications82 Technicalspecifications .............................83 Chapter 8 – Regulatory Compliance Statements85 Safetycompliancestatement.........................86 Emissionscompliancestatements.....................86 RFexposurecompliancestatements...................87 Canadian compliance statements......................87 European Union compliance statements................87 Product Ecology Statements..........................89 Chapter 9 – Index91 user_guide_rg1210.book Page iv Monday, April 22, 2002 2:20 PM 1 Chapter 1 Overview This chapter provides a basic overview of the features of the Intel ® Wireless Gateway II, lists its system and service requirements, and explains where to find more information, if needed. What’s in this chapter:
Decide how to set up the Intel ® Wireless Gateway II
Features of the Intel Wireless Gateway II
A look at the gateway hardware
Configuration software and settings
Where to find more information user_guide_rg1210.book Page 1 Monday, April 22, 2002 2:20 PM Chapter 1 – Overview 2 Decide how to set up the Intel ® Wireless Gateway II There are several ways to set up your Intel ® Wireless Gateway II. The methods depend on whether you want to: •Set up a new network •Add the gateway to an existing network Over…

Text truncated - open the document above for the full version.

Page 1 ANNEX PHOTOGRAPHS OF EUT Page 2

Page 3 Page 4 Page 5 Page 6 Page 7

FCC ID: EJM-AP1210 ADT No.910418R02 Operational Description The transmitter of the EUT (Intel Wireless Gateway II) is powered by power adapter. The antenna is Dipole antenna. There is no antenna connector. Under normal use condition, the user has to keep at least 20cm separation distance between radiator and the body of the user. The other instruction, please have a look at the users manual. DSSS Information This device is Direct Sequence Spread Spectrum, the data is mixed by pseudorandom code which is an orthogonal code. The mixed data is digital modulated by BPSK and QPSK technique depends on the data rates. The CCK coding is applied for increasing the data rate, and also the processing gain will be increased. The bit rates are 1,2,5.5,11Mbps, the symbol rates are 1,1,1.375,1.375Mbps, the chip rates are always 11Mbps. So, the Chip/symbol is 11,11,8 and 8 respectively. Although is higher bit rate, the processing gain is lower than 10, but the CCK coding used in higher bit rate will provide 2.2dB coding gain.

FCC ID: EJM-AP1210 Report No.: RF910418R021Issued: May 20, 2002 FCC TEST REPORT REPORT NO.: RF910418R02 MODEL NO.: AP1210 RECEIVED: April 18, 2002 TESTED: May 6 ~ 11, 2002 APPLICANT: Intel Corporation ADDRESS: 5200 N.E. Elam Young Parkway Hillsboro, OR 97124-6497 ISSUED BY: Advance Data Technology Corporation LAB LOCATION: 47 14 th Lin, Chiapau Tsun, Linko, Taipei, Taiwan, R.O.C. This test report consists of 49 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by CNLA, NVLAP or any government agencies. The test results in the report only apply to the tested sample. 0528 ILAC MRA Lab Code: 200102-0 FCC ID: EJM-AP1210 Report No.: RF910418R022Issued: May 20, 2002 Table of Contents 1CERTIFICATION........................................................................................... 4 2SUMMARY OF TEST RESULTS .................................................................. 5 3GENERAL INFORMATION ........................................................................... 6 3.1GENERAL DESCRIPTION OF EUT ............................................................. 6 3.2DESCRIPTION OF TEST MODES ............................................................... 7 3.3GENERAL DESCRIPTION OF APPLIED STANDARDS............................... 7 3.4DESCRIPTION OF SUPPORT UNITS.......................................................... 8 4TEST TYPES AND RESULTS ...................................................................... 9 4.1CONDUCTED EMISSION MEASUREMENT................................................ 9 4.1.1LIMITS OF CONDUCTED EMISSION MEASUREMENT ...................................................... 9 4.1.2TEST INSTRUMENTS ...........................................................................................................9 4.1.3TEST PROCEDURES .......................................................................................................... 10 4.1.4TEST SETUP ....................................................................................................................... 10 4.1.5EUT OPERATING CONDITIONS......................................................................................... 11 4.1.6TEST RESULTS ................................................................................................................... 12 4.2RADIATED EMISSION MEASUREMENT................................................... 18 4.2.1LIMITS OF RADIATED EMISSION MEASUREMENT ......................................................... 18 4.2.2TEST INSTRUMENTS ......................................................................................................... 19 4.2.3TEST PROCEDURES .......................................................................................................... 20 4.2.4TEST SETUP ....................................................................................................................... 21 4.2.5EUT OPERATING CONDITIONS......................................................................................... 21 4.2.6TEST RESULTS ................................................................................................................... 22 4.36dB BANDWIDTH MEASUREMENT .......................................................... 27 4.3.1LIMITS OF 6dB BANDWIDTH MEASUREMENT ................................................................ 27 4.3.2TEST INSTRUMENTS ......................................................................................................... 27 4.3.3TEST PROCEDURE ............................................................................................................28 4.3.4TEST SETUP ....................................................................................................................... 28 4.3.5EUT OPERATING CONDITIONS......................................................................................... 28 4.3.6TEST RESULTS ................................................................................................................... 29 4.4MAXIMUM PEAK OUTPUT POWER .......................................................... 33 4.4.1LIMITS OF MAXIMUM PEAK OUTPUT POWER MEASUREMENT ................................... 33 4.4.2INSTRUMENTS.................................................................................................................... 33 4.4.3TEST PROCEDURES .......................................................................................................... 34 4.4.4TEST SETUP ....................................................................................................................... 34 4.4.5EUT OPERATING CONDITIONS......................................................................................... 34 4.4.6TEST RESULTS ................................................................................................................... 35 4.5POWER SPECTRAL DENSITY MEASUREMENT ..................................... 36 4.5.1LIMITS OF POWER SPECTRAL DENSITY MEASUREMENT............................................ 36 4.5.2TEST INSTRUMENTS ......................................................................................................... 36 4.5.3TEST PROCEDURE ............................................................................................................37 TEST SETUP..................................................................................................................................... 37 4.5.5EUT OPERATING CONDITION ........................................................................................... 37 4.5.6TEST RESULTS ................................................................................................................... 38 4.6BAND EDGES MEASUREMENT................................................................ 42 FCC ID: EJM-…

Text truncated - open the document above for the full version.

FCC ID: EJM-AP1210 Report No.: RF910418R0247Issued: May 20, 2002 5 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST FCC ID: EJM-AP1210 Report No.: RF910418R0248Issued: May 20, 2002 RADIATED EMISSION TEST