ELVAT1ECar Alarm Transmitter

CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. 128-6122 4 of 4

From: Denise Teng Sent: Wednesday, November 07, 2001 4:23 PM To: Mike Kuo; Steve Cheng; Kerwin Corpuz Subject: RE: Nutek Corporation, FCC ID:ELVAT1E, AN01T1570 CCS project no:01T0997-1 Hi Mike, Here's the answers: #1: Duty cycle 2 on Page 11 is for 100ms. #2: Page 10 - just showing 1 full cycle. Page 11 - for 100ms plot. #3: Please see attached file. Thanks! regards, -----Original Message----- From: CERTADM Sent: Wednesday, November 07, 2001 2:14 PM To: '[email protected]' Subject: Nutek Corporation, FCC ID:ELVAT1E, AN01T1570 Notice_content ------------- Question #1: Page 9 of 26 of test report, the one complete pulse is indicated 100ms. However, there is no plot to support this reading. Please explain. Question #2: Page 10 and 11 of test report, there are duty cycle plots submitted. Please explain the differences between these two plots . Question #3: Page 15 and 16 of test report, only average data are submitted. Please provide raidated emission data with peak detector. Best Regards Mike Kuo / TCB Certifier The items indicated above must be submitted before processing can continue on the above referenced application. Failure to provide the requested information within 60 days of the original e-mail date may result in application dismissal and forfeiture of the filing fee. Also, please note that partial responses increase processing time and should not be submitted. Any questions about the content of this correspondence should be directed to the e-mail address listed below the name of the sender.

PROPOSED FCC ID LABEL AND LOCATION NUTEK CORPORATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID: ELVAT1E FCC ID LABEL

Operational Description The car alarm transmitter is a low powered, hand held unit for remote controlling the car locks and other features. See the function descriptions in attached. The transmitter is powered by a 12 volt battery. It is designed to operated on a single fixed frequency at 302 MHz. See the attached block diagram and schematic. There are 3 buttons trigger the integrated circuit (IC1) which produces the digital control signals and will modulate the carrier signal. The carrier signal is generated by a LC circuit comprised of a 302 MHz and a npn transmitter (TR1). The transmitter is manually operated by the buttons pushed and will automatically deactivate instant after the button being released. This feature is incorporated by the IC1 internally. All tuning and verification are performed by the manufacture and there are no adjustments can be made by the user. No external ground is required or used with this transmitter.

ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT CERTIFICATION TO FCC PART 15 REQUIREMENTS for INTENTIONAL RADIATOR 302 MHz CAR ALARM TRANSMITTER MODEL NAME: PRO-OE3B3 TRADE NAME: NUTEK FCC ID NO: ELVAT1E REPORT NO: 01T0977-1 ISSUE DATE: SEPTEMBER 28, 2001 Prepared for NUTEK CORPORATION 5F, NO. 3, ALLEY 6, LANE 45 PAO-HSING ROAD, HSIN TIEN, TAIPEI TAIWAN R. O. C. Prepared by COMPLIANCE ENGINEERING SERVICES, INC. d.b.a. COMPLIANCE CERTIFICATION SERVICES 561F MONTEREY ROAD MORGAN HILL, CA 95037, USA TEL: (408) 463-0885 FAX: (408) 463-0888 REPORT NO: 01T0977-1 FCC ID: ELVAT1E DATE: SEPTEMBER 28, 2001 COMPLIANCE CERTIFICATION SERVICES CCS DOCUMENT NO:CCSUP4020B 561F MONTEREY RD., MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. TABLE OF CONTENTS PAGE 1. VERIFICATION OF COMPLIANCE........................................................................................3 2. Product Description.....................................................................................................................4 3. Test Facility.................................................................................................................................4 4. Measurement Standards...............................................................................................................4 5. Test Methodology........................................................................................................................4 6. Measurement Equipment Used....................................................................................................4 7. POWERLINE RFI LIMIT...........................................................................................................5 8. RADIATED EMISSION LIMITS...............................................................................................5 9. SYSTEM TEST CONFIGURATION.........................................................................................6 10. Test Procedure...........................................................................................................................7 11. Equipment Modifications...........................................................................................................8 12. TEST RESULT..........................................................................................................................9 12.1 Maximum Modulation Percentage (M%)................................................................................9 12.2 The Emissions Bandwidth.......................................................................................................9 TEST DATA • Maximum Modulation Percentage Plot • Emission Bandwidth Plot • Radiated Emission Worksheet for Peak Measurement • Radiated Emission Worksheet for Average Measurement ATTACHMENT • EUT Photographs • Proposed FCC ID Label • Schematics & Block Diagram • User Manual REPORT NO: 01T0977-1 FCC ID: ELVAT1E DATE: SEPTEMBER 28, 2001 Page 3 of 26 COMPLIANCE CERTIFICATION SERVICES CCS DOCUMENT NO:CCSUP4020B 561F MONTEREY RD., MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 1. VERIFICATION OF COMPLIANCE COMPANY NAME: NUTEK CORPORATION 5F, NO. 3, ALLEY 6, LANE 45, PAO-HSING ROAD HSIN TIEN, TAIPEI, TAIWAN R. O. C. CONTACT PERSON: RUBY HSIEH TELEPHONE NO.: 02-2918-9478 EUT DESCRIPTION: 302 MHz CAR ALARM TRANSMITTER MODEL NAME/NUMBER: PRO-OE3B3 TRADE NAME: NUTEK FCC ID: ELVAT1E DATE TESTED: SEPTEMBER 24, 2001 REPORT NUMBER: 01U0977-1 TYPE OF EQUIPMENT SECURITY EQUIPMENT (INTENTIONAL RADIATOR) EQUIPMENT TYPE 302 MHz CAR ALARM TRANSMITTER MEASUREMENT PROCEDURE ANSI C63.4 / 1992 LIMIT TYPE CERTIFICATION FCC RULE CFR 47, PART 15 The above equipment was tested by Compliance Certification Services for compliance with the requirements set forth in the FCC CFR 47, PART 15. The results of testing in this report apply to the product/system which was tested only. Other similar equipment will not necessarily produce the same results due to production tolerance and measurement uncertainties. Warning : This document reports conditions under which testing was conducted and results of tests performed. This document may not be altered or revised in any way unless done so by Compliance Certification Services and all revisions are duly noted in the revisions section. Any alteration of this document not carried out by Compliance Certification will constitute fraud and shall nullify the document. Tested By: KERWIN CORPUZ ASSOCIATE EMC ENGINEER COMPLIANCE CERTIFICATION SERVICES Approved & Released By: THU CHAN SENIOR EMC ENGINEER COMPLIANCE CERTIFICATION SERVICES REPORT NO: 01T0977-1 FCC ID: ELVAT1E DATE: SEPTEMBER 28, 2001 Page 4 of 26 COMPLIANCE CERTIFICATION SERVICES CCS DOCUMENT NO:CCSUP4020B 561F MONTEREY RD., MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 2. PRODUCT DESCRIPTION Fundamental Frequency 302 MHz Power Source 12V Alkaline Battery Model 27A Transmitting Time Periodic < 5 seconds Associated Receiver FCC ID: ELVAR5C 3. TEST FACILITY The 3/10/30 meter open area test site and conducted measurement facility used to collect the radiated data is located at 561F Monterey Road, Morgan Hill, California, U.S.A. A detailed description of the test facility was submitted to the Commission on Ma…

Text truncated - open the document above for the full version.

01T0977-1 010924C1 09/24/014:45 PM KERWIN CORPUZ NUTEK CORPORATION 302MHz CAR ALARM TX (M/N: PRO-OE3B3) EUT ONLY FCC PART 15.231(b) TX 09/24/01 Freq.ReadingAFClossPre-ampLevelLimitMarginPolAzHeightMark (MHz)(dBuV)(dB)(dB)(dB)(dBuV/m)FCC_B(dB)(H/V)(Deg)(Meter)(P/Q/A) X AXIS: OPTION button: 302.0171.0915.092.5926.6562.1194.80-32.693mV135.001.30P 302.0183.8914.852.5926.6574.6794.80-20.133mH135.001.00P LOCK button 302.0183.4914.852.5926.6574.2794.80-20.533mH270.001.00P 302.0167.7915.092.5926.6558.8194.80-35.993mV180.001.30P UNLOCK button 302.0167.2915.092.5926.6558.3194.80-36.493mV180.001.30P 302.0183.8914.852.5926.6574.6794.80-20.133mH0.001.00P Y AXIS: UNLOCK button 302.0175.0914.852.5926.6565.8794.80-28.933mH180.001.70P 302.0180.1915.092.5926.6571.2194.80-23.593mV270.001.60P LOCK button 302.0180.1915.092.5926.6571.2194.80-23.593mV270.001.60P 302.0174.4914.852.5926.6565.2794.80-29.533mH0.001.70P OPTION button 302.0175.1914.852.5926.6565.9794.80-28.833mH180.001.70P 302.0179.6915.092.5926.6570.7194.80-24.093mV315.001.60P Z AXIS: OPTION button 302.0179.7915.092.5926.6570.8194.80-23.993mV270.001.70P 302.0174.5914.852.5926.6565.3794.80-29.433mH0.001.70P LOCK button 302.0174.5914.852.5926.6565.3794.80-29.433mH180.001.70P 302.0179.8915.092.5926.6570.9194.80-23.893mV0.001.70P UNLOCK button 302.0179.1915.092.5926.6570.2194.80-24.593mV90.001.70P 302.0174.7914.852.5926.6565.5794.80-29.233mH0.001.70P Company: EUT Description: Test Configuration : Type of Test: Mode of Operation: FCC, VCCI, CISPR, CE, AUSTEL, NZ UL, CSA, TUV, BSMI, DHHS, NVLAP 561F MONTEREY ROAD, SAN JOSE, CA 95037-9001 PHONE: (408) 463-0885 FAX: (408) 463-0888 Project #: Report #: Date& Time: Test Engr: A-Site nmlkj A-Site nmlkj B-Site nmlkj B-Site nmlkj C-Site nmlkji C-Site nmlkji F-Site nmlkj F-Site nmlkj 6 Worst DataDescending for Harmonic: X axis, OPTION button with RX antenna at horizontal polarization. Y axis, UNLOCK button with RX antenna at vertical polarization 604.0549.0918.513.8728.1243.3554.80-11.453mV0.001.00P 906.0736.5921.794.9727.5135.8454.80-18.963mV90.001.00P 604.0550.4919.213.8728.1245.4554.80-9.353mH0.001.00P 906.0734.8922.544.9727.5134.9054.80-19.903mH0.001.00P TO COMPLETE RADIATED EMISSION, NEED TO SCAN ABOVE 1 GHz UP TO 10th HARMONIC Total data #: 22 V.2c

REPORT NO: 01T0977-1 FCC ID: ELVAT1E DATE: SEPTEMBER 28, 2001 Page 6 of 26 COMPLIANCE CERTIFICATION SERVICES CCS DOCUMENT NO:CCSUP4020B 561F MONTEREY RD., MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 9. SYSTEM TEST CONFIGURATION Use a block of foam and combined it with EUT wrapping rubber band around it. This way it can test X.Y, and Z axis. To activate continuous transmission, place a small plastic block between rubber band and EUT push button. Radiated Open Site Test Set-up