EMJM2A201Gen1 SS Wireless Rechargeable Mouse

- 1 - FCC Statement This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment Copyright Copyright 2002 Primax Electronics Ltd. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without the prior written permission of Primax Electronics Ltd. Trademarks Primax is a registered trademark of Primax Electronics Ltd. All other trademarks used in this documentation are the sole property of their respective owners. RISK OF EXPLOSION IF AN INCORRECT TYPE REPLACES BATTERY. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. Replace batteries at end of battery life with simiar type (at least 1300 NiMH capacity) rechargeable batteries. Both batteries must be same model and capacity. Only use rechargeable batteries. - 2 - Setting Up Your Mouse Hardware Installation Important: Before connecting your mouse or installing the software, be sure to identify the type of mouse port you are using (USB, PS/2). Refer to the diagrams below if you are having difficulty determining what kind of port your mouse uses. PS/2 Port USB Prot Connecting the PS/2 Mouse Note: Before coneect the mouse to your system, please make sure your computer is off. • Turn off your computer. • Connect the mouse cable to the PS/2 (6-pin) mouse port. • Turn on the computer. Connecting the USB Mouse Note: To use the USB mouse, you need to have Windows 98 / 2000 / ME / XP installed on your computer. • You don’t need to turn off your computer before connect your USB mouse. • Plug the rectangular USB mouse connector into the USB port (normally in the back of the PC). • Insert the software diskette into your disk drive and follow the onscreen instructions to install the device driver. - 3 - Installing Mouse Suite ™ Software To use all of the features of your new mouse, you must install the Mouse Suite ™ software on your computer. Uses the following guide to properly install the Mouse Suite ™ software. • Start Windows and insert the Mouse Suite ™ installation disk into the disk drive. • Click the Start button and then select Run. • From the Run dialog box, enter <drive>: Setup and click OK. For example, if the disk is in drive A, enter A:\Setup. • Follow the onscreen instructions. - 4 - Using the Wheel Note: This section is for wheel mouse only. Your new mouse may have a wheel that can be used in two ways: • Rotate it to use it as the wheel. • Click it to use it as the wheel button. Important: Universal Scrolling must be enabled in order to use scrolling functions in applications not compatible with Microsoft Office 97. Scrolling The wheel on your mouse can be used to scroll through most applications with a scroll bar. • To scroll with your mouse, simply rotate the wheel on your mouse forward or backward. AutoScrolling AutoScroll allows you to automatically scroll through a document without having to move the mouse or mouse wheel constantly. • To AutoScroll while in a document, click the mouse button designated as AutoScroll. An origin mark ( ) will appear at your pointer position. To start AutoScrolling, move your pointer vertically, horizontally, or diagonally away from the origin mark. AutoScroll speed increases as the pointer is moved away from the origin mark. To stop AutoScrolling, press any mouse button or rotate the wheel. Zooming In some Microsoft Office 97 compatible applications (e.g. Microsoft Word 97), additional zooming functions are available. You can use the zooming function to “zoom in” for a closer look at a page or “zoom out” to see more of a page. • To zoom in, hold the Ctrl key down and rotate the mouse wheel forward. • To zoom out, hold the Ctrl key down and rotate the mouse wheel backward. - 5 - Mouse Sutie ™ Features Mouse Suite ™ includes a lot of exciting features or functions that help you to increase your productivity with your new mouse. l To find your Mouse Control Panel, follow these steps: Click the Start button, click Settings, and click on the Control Panel. In the Control Panel, double-click on the Mouse icon. Button Functions Accessing the Buttons page allows you to customize the function of each mouse button. The default settings for your mouse buttons are as follows: • Left Button Primary Mouse Button (standard click and drag action) • Middle or Wheel Button Quick / Auto Scroll • Right Button Context Menu • Fourth Button Start Button (If have) • Fift…

Text truncated - open the document above for the full version.

Page 2

(Fig. 1) FCC ID: EMJM2A201 FCC LABEL LOCATION The label will be permanently affixed at a conspicuous location on the device. Label

Page 3 Page 4 Page 5 Page 6

FCC ID: EMJM2A201 Report No.: RF931101A01 Operational Description The transmitter of the EUT (Gen1 SS Wireless Rechargeable Mouse) is powered by 3V Batteries. The type of antenna is Loop antenna. The output power of this device is very low. Under normal use condition, the transmitter and the receiver are quite close, so high EIRP power is neither necessary nor allowed because of interference.

FCC ID: EMJM2A201 Report No.: RF931101A011Report Format Version 2.0.0 FCC TEST REPORT REPORT NO. : RF931101A01 MODEL NO. : MORFA2UO, 5187-8682 RECEIVED : Nov. 1, 2004 TESTED : Nov. 5, 2004 ISSUED: Nov. 9, 2004 APPLICANT : PRIMAX ELECTRONICS LTD. ADDRESS : No. 669, Ruey Kuang Road, Neihu, Taipei, Taiwan. R.O.C. ISSUED BY : Advance Data Technology Corporation LAB ADDRESS : No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang 244, Taipei Hsien, Taiwan, R.O.C. TEST LOCATION : No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang 244, Taipei Hsien, Taiwan, R.O.C. This test report consists of 15 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by CNLA, A2LA or any government agency. The test results in the report only apply to the tested sample. 0528 ILAC MRA No. 2177-01 FCC ID: EMJM2A201 Report No.: RF931101A012Report Format Version 2.0.0 Table of Contents 1CERTIFICATION ............................................................................................3 2SUMMARY OF TEST RESULTS....................................................................4 2.1MEASUREMENT UNCERTAINTY .................................................................4 3GENERAL INFORMATION ............................................................................5 3.1GENERAL DESCRIPTION OF EUT...............................................................5 3.2DESCRIPTION OF TEST MODES.................................................................6 3.3GENERAL DESCRIPTION OF APPLIED STANDARDS ................................6 3.4DESCRIPTION OF SUPPORT UNITS ...........................................................7 3.5CONFIGURATION OF SYSTEM UNDER TEST ............................................7 4TEST PROCEDURE AND RESULT ...............................................................8 4.1CONDUCTED EMISSION MEASUREMENT .................................................8 4.2RADIATED EMISSION MEASUREMENT ......................................................8 4.2.1LIMITS OF RADIATED EMISSION MEASUREMENT................................... 8 4.2.2TEST INSTRUMENT..................................................................................... 9 4.2.3TEST PROCEDURE ................................................................................... 10 4.2.4DEVATION FROM TEST STANDARD ........................................................ 10 4.2.5TEST SETUP ...............................................................................................11 4.2.6EUT OPERATING CONDITION ...................................................................11 4.2.7TEST RESULTS.......................................................................................... 12 5PHOTOGRAPHS OF THE TEST CONFIGURATION...................................14 6INFORMATION ON THE TESTING LABORATORIES .................................15 FCC ID: EMJM2A201 Report No.: RF931101A013Report Format Version 2.0.0 1 CERTIFICATION PRODUCT NAME :Gen1 SS Wireless Rechargeable Mouse MODEL NO. 1:MORFA2UO (Brand: PRIMAX) MODEL NO. 2:5187-8682 (Brand: HP) APPLICANT :PRIMAX ELECTRONICS LTD. TESTED :Nov. 5, 2004 TEST SAMPLE :ENGINEERING SAMPLE STANDARDS :FCC Part 15, Subpart C (15.227) ANSI C63.4-2003 The above equipment (model: MORFA2UO) has been tested by Advance Data Technology Corporation, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE:Nov. 9, 2004 ( Annie Chang ) TECHNICAL ACCEPTANCE : , DATE:Nov. 9, 2004 Responsible for EMI ( Arthur Lin ) APPROVED BY :, DATE:Nov. 9, 2004 ( Cody Chang, Deputy Manager ) FCC ID: EMJM2A201 Report No.: RF931101A014Report Format Version 2.0.0 2 SUMMARY OF TEST RESULTS After estimating all the combination of every test mode and channel, the result shown as below is the worst case. The EUT has been tested according to the following specifications: APPLIED STANDARD: FCC Part 15, Subpart C STANDARD PARAGRAPH TEST TYPERESULTREMARK 15.207Conducted Emission TestNA Power supply is 3Vdc from one battery 15.227Radiated Emission TestPASS Minimum passing margin is -10.71 dB at 705.77 MHz 2.1 MEASUREMENT UNCERTAINTY Where relevant, the following measurement uncertainty levels have been estimated for tests performed on the EUT as specified in CISPR 16-4: MEASUREMENTUNCERTAINTY Radiated emissions3.86 dB FCC ID: EMJM2A201 Report No.: RF931101A015Report Format Version 2.0.0 3 GENERAL INFORMATION 3.1 GENERAL DESCRIPTION OF EUT PRODUCT Gen1 SS Wireless Rechargeable Mouse MODEL NOMORFA2UO POWER SUPPLY 3Vdc from one battery for transmitter MODULATION TYPE FSK CARRIER FREQUENCY OF EACH CHANNEL 27.045 MHz BANDWIDTH OF EACH CHANNEL NA MAXIMUM FIELD STRENGTH 119.26 μV/m @ 3m NUMBER OF CHANNEL 1 ANTENNA TYPE Loop antenna DATA CABLE NA I/O PORTS NA NOTE: 1. The EUT is a transmitter part of Gen1 SS Wireless Rechargeable Mouse. 2. The EUT has two model names, which are identical to each other except for their brand name only for marketing differentiation as following: BRANDMODEL NO. PRIMAXMORFA2UO HP5187-8682 From above models, model no.: MORFA2UO was selected as the representative model for the test and therefore only its test data was recorded in this report. 3. For a more detailed features description, please refer to the manufacturer’s specifications or the User's Manual. FCC ID: EMJM2A201 Report No.: RF931101A016Report Format Version 2.0.0 3.2 DESCRIPTION OF TEST MODES One channel was provided to this EUT. ChannelFrequency 127.045MHz 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS The EUT is the transmitter part of a Gen1 SS Wireless Rechargeable Mouse. According to the specifications of the manu…

Text truncated - open the document above for the full version.

FCC ID: EMJM2A201 Report No.: RF931101A0114Report Format Version 2.0.0 5 PHOTOGRAPHS OF THE TEST CONFIGURATION RADIATED EMISSION TEST