EMJTNEOTVPRIMENetgear Bluetooth Remote Control

Netgear Bluetooth Remote Control User Guide FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Radiation Exposure Statement: The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available

No. 669, Ruey Kuang Road Neihu Taipei, Taiwan, R.O.C. Tel: 883-2-2798-9008 Fax: 886-2-8798-1565 October 26, 2012 DECLARATION LETTER Federal Communications Commission Authorization and Evaluation Division Subject: Declaration letter for label requirement FCC ID: EMJTNEOTVPRIME The label is permanent affixed in the battery compartment, and the EUT will be selling to market without the battery installed. The users can see the label during the battery installation process. The battery cover can be opened without any special tools. Please don’t hesitate to contact us, if you have any question(s). Thank you! Sincerely yours, ------------------------------------------------------------------- C.T. Huang Compliance Dept. / Director Phone: 886-2-2798-9008 ext.1710 Fax: 886-2-8797-1565 Email: [email protected]

No. 669, Ruey Kuang Road Neihu Taipei, Taiwan, R.O.C. Tel: 883-2-2798-9008 Fax: 886-2-8798-1565 Date: October 26, 2012 Federal Communications Commission Authorization and Evaluation Division Confidentiality Request FCC ID: EMJTNEOTVPRIME Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below: Schematics Block Diagram The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely yours, ------------------------------------------------------------------- C.T. Huang Compliance Dept. / Director Phone: 886-2-2798-9008 ext.1710 Fax: 886-2-8797-1565 Email: [email protected]

No. 669, Ruey Kuang Road Neihu Taipei, Taiwan, R.O.C. Tel: 883-2-2798-9008 Fax: 886-2-8798-1565 December 6, 2012 Date: December 6, 2012 Federal Communications Commission Authorization and Evaluation Division Subject: Short‐term confidentiality request regarding application for certification of FCC ID: EMJTNEOTVPRIME Pursuant to DA 04‐1705 of the Commission’s public notice, we request short‐term confidential treatment for the following information until Jan 20, 2013 in order to ensure sensitive business information remains confidential until the actual marketing of the device. External Photos Test setup photos User ’s Manual Internal Photos Sincerely yours, ------------------------------------------------------------------- C.T. Huang Compliance Dept. / Director Phone: 886-2-2798-9008 ext.1710 Fax: 886-2-8797-1565 Email: [email protected]

Page 1 CONSTRUCTION PHOTOS OF EUT

Page 2 Page 3 Page 4 Page 5 Page 6 Page 7

FCC ID: EMJTNEOTVPRIME Report No.: RF121011D04 Operational Description This device is a Netgear Bluetooth Remote Control. The transmitter of the EUT is powered by 1.5Vdc from battery. The antenna is Printed antenna without antenna connector. The other instruction, please have a look at the users manual.

Report No: SA121011D04 1 of 5 Report Format Version 5.0.0 RF EXPOSURE REPORT REPORT NO.: SA121011D04 MODEL NO.: Netgear NeoTV Prime FCC ID: EMJTNEOTVPRIME RECEIVED: Oct. 9, 2012 TESTED: Oct. 9 ~ 22, 2012 ISSUED: Nov. 1, 2012 APPLICANT: PRIMAX ELECTRONICS LTD. ADDRESS: No. 669, Ruey Kuang Road, Neihu, Taipei, Taiwan, R.O.C. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB LOCATION: No. 47, 14th Ling, Chia Pau Vil., Lin Kou Dist., New Taipei City, Taiwan ( R.O.C. ) This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the compliance or non-compliance to the specification. This report should not be used by the client to claim product certification, approval, or endorsement by any government agencies. Report No: SA121011D04 2 of 5 Report Format Version 5.0.0 TABLE OF CONTENTS RELEASE CONTROL RECORD .................................................................................... 3 1. CERTIFICATION .............................................................................................. 4 2. CONCLUSION ................................................................................................. 5 Report No: SA121011D04 3 of 5 Report Format Version 5.0.0 RELEASE CONTROL RECORD ISSUE NO. REASON FOR CHANGE DATE ISSUED SA121011D04 Original release Nov. 1, 2012 Report No: SA121011D04 4 of 5 Report Format Version 5.0.0 1. CERTIFICATION PRODUCT: Netgear Bluetooth Remote Control BRAND NAME: Netgear NeoTV Prime MODEL NO.: NETGEAR APPLICANT: PRIMAX ELECTRONICS LTD. TESTED: Oct. 9 ~ 22, 2012 TEST ITEM: MASS-PRODUCTION STANDARDS: FCC Part 2 (Section 2.1091) FCC OET Bulletin 65, Supplement C (01-01) IEEE C95.1 The above equipment has been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE: Nov. 1, 2012 ( Celia Chen / Senior Specialist ) APPROVED BY : , DATE: Nov. 1, 2012 ( Ken Liu / Manager ) Report No: SA121011D04 5 of 5 Report Format Version 5.0.0 2. CONCLUSION No Evaluation Required if power is below this threshold: F(GHz) mW Low 2.402 24.58 High 2.480 Maximum measured transmitter power: Pout (dBm) Pout (mW) Conducted Power -1.7 0.7 EIRP Power 0.2 1.0 *Note: The antenna is Printed antenna with 1.9dBi gain Threshold for no SAR evaluation is 24.58mW Transmitter power is 1.0mW Conclusion: No SAR evaluation required since Transmitter Pout is below FCC threshold ---END---

Report No.: RF121011D04 1 of 36 Report Format Version 5.0.0 FCC TEST REPORT REPORT NO.: RF121011D04 MODEL NO.: Netgear NeoTV Prime FCC ID: EMJTNEOTVPRIME RECEIVED: Oct. 9, 2012 TESTED: Oct. 9 ~ 22, 2012 ISSUED: Nov. 1, 2012 APPLICANT: PRIMAX ELECTRONICS LTD. ADDRESS: No. 669, Ruey Kuang Road, Neihu, Taipei, Taiwan, R.O.C. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB LOCATION: No. 47, 14th Ling, Chia Pau Vil., Lin Kou Dist., New Taipei City, Taiwan ( R.O.C. ) This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the compliance or non-compliance to the specification. This report should not be used by the client to claim product certification, approval, or endorsement by TAF or any government agencies. Report No.: RF121011D04 2 of 36 Report Format Version 5.0.0 Table of Contents RELEASE CONTROL RECORD................................................................................. 4 1. CERTIFICATION .............................................................................................. 5 2. SUMMARY OF TEST RESULTS ...................................................................... 6 2.1 MEASUREMENT UNCERTAINTY ................................................................... 6 3. GENERAL INFORMATION .............................................................................. 7 3.1 GENERAL DESCRIPTION OF EUT ................................................................. 7 3.2 DESCRIPTION OF TEST MODES ................................................................... 8 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ................... 9 3.3 DESCRIPTION OF SUPPORT UNITS ............................................................11 3.3.1 CONFIGURATION OF SYSTEM UNDER TEST .............................................11 3.4 GENERAL DESCRIPTION OF APPLIED STANDARDS ................................ 12 4. TEST TYPES AND RESULTS ........................................................................ 13 4.1 CONDUCTED EMISSION MEASUREMENT ................................................. 13 4.2 RADIATED EMISSION AND BANDEDGE MEASUREMENT ......................... 13 4.2.1 LIMITS OF RADIATED EMISSION AND BANDEDGE MEASUREMENT ...... 13 4.2.2 TEST INSTRUMENTS ................................................................................... 14 4.2.3 TEST PROCEDURES .................................................................................... 15 4.2.4 DEVIATION FROM TEST STANDARD .......................................................... 15 4.2.5 TEST SETUP ................................................................................................. 16 4.2.6 EUT OPERATING CONDITIONS ................................................................... 16 4.2.7 TEST RESULTS ............................................................................................. 17 4.3 NUMBER OF HOPPING FREQUENCY USED .............................................. 21 4.3.1 LIMIT OF HOPPING FREQUENCY USED .................................................... 21 4.3.2 TEST SETUP ................................................................................................. 21 4.3.3 TEST INSTRUMENTS ................................................................................... 21 4.3.4 TEST PROCEDURES .................................................................................... 21 4.3.5 DEVIATION FROM TEST STANDARD .......................................................... 21 4.3.6 TEST RESULTS ............................................................................................. 21 4.4 DWELL TIME ON EACH CHANNEL .............................................................. 23 4.4.1 LIMIT OF DWELL TIME USED....................................................................... 23 4.4.2 TEST SETUP ................................................................................................. 23 4.4.3 TEST INSTRUMENTS ................................................................................... 23 4.4.4 TEST PROCEDURES .................................................................................... 23 4.4.5 DEVIATION FROM TEST STANDARD .......................................................... 23 4.4.6 TEST RESULTS ............................................................................................. 24 4.5 CHANNEL BANDWIDTH................................................................................ 26 4.5.1 LIMITS OF CHANNEL BANDWIDTH ............................................................. 26 4.5.2 TEST SETUP ................................................................................................. 26 4.5.3 TEST INSTRUMENTS ................................................................................... 26 4.5.4 TEST PROCEDURE ........................…

Text truncated - open the document above for the full version.

Report No.: RF121011D04 1 of 1 Report Format Version 5.0.0 PHOTOGRAPHS OF THE TEST CONFIGURATION RADIATED EMISSION TEST