EZSDEIPKETR1Passive Keyless Entry System

Directed Passive Keyless Entry System (PKE) Keyfob Model PKETR1 © 2012 Directed, Vista, CA PKETR1 2012-07-18 3 © 2012 Directed. All rights reserved. Contents Government regulations .....................................................................................4 Warning! Safety first .........................................................................................6 Important information ........................................................................................6 System maintenance ..................................................................................6 Maximize the performance of your system ...................................................6 PKE Key Fob (PKETR1) .......................................................................................7 Using the system ...............................................................................................8 Automatic unlocking and locking of the vehicle.............................................8 Manual unlocking and locking of the vehicle ................................................8 Enabling/Disabling valet mode ..................................................................9 Sleep mode............................................................................................10 Glossary of terms ............................................................................................11 Limited lifetime consumer warranty ....................................................................12 4 © 2012 Directed. All rights reserved. Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio fre- quency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installa- tion. If this equipment does cause harmful interference to radio or television, which can be determined by turning the equipment Off and ON, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio / TV technician for help. To satisfy FCC RF exposure compliance requirements, this device should be used in hand-held, hand operated configurations only. This device is designed to be used in a person’s hands and its operating configurations do not support normal transmissions while it is carried in pockets or holsters next to a persons’ body. 5 © 2012 Directed. All rights reserved. This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interference to services authorized by IC. In addition, the user of this device must accept any radio interference that may be received, even if this interference could affect the operation of the device. Warning: The installation of this product must only be performed by technicians who are trained or certified by Directed dealers. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device. 6 © 2012 Directed. All rights reserved. Warning! Safety first The following safety warning must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. Important information Congratulations on the purchase of your state-of-the-art Passive Keyless Entry System (PKE). Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an au- thorized dealer voids the warranty. All dealers are provided with a preprinted dealer certificate to verify authorization. By carefully reading this Owner’s Guide prior to using your system, you will maximize the use of this system and its features. You can print additional or replacement copies of this manual by accessing our web site at www.xpresskit.com. System maintenance The system requires no specific maintenance. Your remote is powered by a small coin cell lightweight 3-volt lithium battery (CR2032) that lasts approxi- mately 3 years under normal use. When the battery begins to weaken, the operating range is reduced. Maximize the performance of your system Never put the key fob together with a cellphone as this may affect the range and its performance. 7 © 2012 Directed. All rights reserved. PKE Key Fob (PKETR1) 8 © 2012 Directed. All rights reserved. Using the system Automatic unlocking and locking of the vehicle Passive door unlocking The key fob LED will start flashing green once you have entered the active zone. The doors will be automatically unlocked and the starter kill (optional) will be disarmed. Note: The unlock operation may be delayed when approaching the vehicle immediately after a remote start command has been sent. Passive door locking The key fob LED will start flashing red once you have left the active zone. The doors will be automatically locked and the starter kill (optional) will be armed. The key fob LED will turn ON solid red for…

Text truncated - open the document above for the full version.

Report No.: 125441R-RFUSP41V01 Page : 1 of 4 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo

DEI Headquarters, Inc. FCC ID.: EZSDEIPKETR1 One Viper Way, Vista CA 92081 Tel : 760-598-6200 FCC ID Label

DEI Headquarters, Inc. FCC ID.: EZSDEIPKETR1 One Viper Way, Vista CA 92081 Tel : 760-598-6200 The FCC ID Label will be placed on the equipment as shown in the photograph below.

Report No.: 125441R-RFUSP41V01 Page : 2 of 4 (3) EUT Photo (4) EUT Photo Report No.: 125441R-RFUSP41V01 Page : 3 of 4 (5) EUT Photo (6) EUT Photo Report No.: 125441R-RFUSP41V01 Page : 4 of 4 (7) EUT Photo (8) EUT Photo

Report No：125441R-RFUSP41V01 Page: 1 of 28 Test Report Product Name Passive Keyless Entry System Model No. PKETR1 FCC ID. EZSDEIPKETR1 Applicant DEI Headquarters, Inc. Address One Viper Way, Vista CA 92081 Date of Receipt May 25, 2012 Issued Date June 13, 2012 Report No. 125441R-RFUSP04V01 Report Version V1.0 The test results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Report No：125441R-RFUSP41V01 Page: 2 of 28 Test Report Certification Issued Date : June 13, 2012 Report No. : 095168R-RFUSP04V01 Product Name Passive Keyless Entry System Applicant DEI Headquarters, Inc. Address One Viper Way, Vista CA 92081 Manufacturer NUTEK CORPORATION Model No. PKETR1 FCC ID. EZSDEIPKETR1 EUT Rated Voltage DC 3V (Power by Battery) EUT Test Voltage DC 3V (Power by Battery) Trade Name DIRECTED Applicable Standard FCC CFR Title 47 Part 15 Subpart C: 2010 ANSI C63.4: 2003 Test Result Complied Test results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Documented By : ( Senior Engineering Adm. Specialist / Anita Chou ) Tested By : ( Engineer / Vincent Chu ) Approved By : ( Manager / Vincent Lin) Report No：125441R-RFUSP41V01 Page: 3 of 28 TABLE OF CONTENTS Description Page 1. General Information ...................................................................................................................4 1.1. EUT Description............................................................................................................................4 1.2. Operation Description ...................................................................................................................5 1.3. Tested System Details....................................................................................................................6 1.4. Configuration of tested System .....................................................................................................6 1.5. EUT Exercise Software .................................................................................................................6 1.6. Test Facility ...................................................................................................................................7 2. Conducted Emission....................................................................................................................8 2.1. Test Equipment..............................................................................................................................8 2.2. Test Setup ......................................................................................................................................8 2.3. Limits ............................................................................................................................................9 2.4. Test Procedure ...............................................................................................................................9 2.5. Test Specification ..........................................................................................................................9 2.6. Uncertainty ....................................................................................................................................9 2.7. Test Result ...................................................................................................................................10 3. Radiated Emission ..................................................................................................................... 11 3.1. Test Equipment............................................................................................................................11 3.2. Test Setup ....................................................................................................................................12 3.3. Limits ..........................................................................................................................................13 3.4. Test Procedure .............................................................................................................................14 3.5. Test Specification ........................................................................................................................14 3.6. Uncertainty ..................................................................................................................................14 3.7. Test Result ...................................................................................................................................15 4. Transmit time.............................................................................................................................22 4.1. Test Equipment............................................................................................................................22 4.2. Test Setup ....................................................................................................................................22 4.3. Limits ..........................................................................................................................................22 4.4. Test Specification ........................................................................................................................22 4.5. Uncertainty ..................................................................................................................................22 4.6. Test Result ...................................................................................................................................23 5. O…

Text truncated - open the document above for the full version.