GLE136227R49.82-49.90 MHZ WIRELESS R/C TOY-RX

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

FCC ID: GLE136227R BLOCK DIAGRAM RECEIVER 49.860 MHz RF. AMP. DECODER AUDIO AMP. AND DETECTOR DRIVER STEERING MOTOR DRIVER DRIVING MOTOR

FCC ID: GLE136227R RadioShack ® This device complies with Part 15 of CAT. NO. 6000375 the FCC rules. Operation is subject Power: " 9.6V " battery pack or 6 AA batteries for vehicle, to the following two conditions: " 9V " battery for transmitter (1) This device may not cause Custom Manufactured in China harmful interference, and for RadioShack Corporation, (2) This device must accept any Fort Worth, Texas 76102 interference received, including interference that may cause undesired operation.

Applicant : Suncon Toys Industry Ltd. FCC ID: GLE136227R Technical Description The brief circuit description listed as follows. -Q1 and associated circuit act as Super regenerative Receiver -IC1 RX2 and associated circuit act as Decoder -Q15 to Q18, and associated circuit act as Motor #1 Driver -Q6 to Q9 and associated circuit act as Motor # 2 Driver Antenna Used : A permanent wire antenna has been used

FCC PART 15 B SUBPART B RECEIVER TEST REPORT Applicant SUNCON TOYS INDUSTRY LTD. Address 11/F, KAI TAK FACTORY BUILDING 99 KING FUK STREET SANPOKONG, KOWLOON HONG KONG FCC ID GLE136227R Product Description WIRELESS REMOTE CONTROL RECEIVER Date Sample Received 3/10/2008 Date Tested 3/12/2008 Tested By Richard Block Approved By Mario de Aranzeta Report Number 464UT8TestReport.doc Test Results PASS FAIL THE ATTACHED REPORT SHALL NOT BE REPRODUCED EXCEPT IN FULL WITHOUT THE WRITTEN APPROVAL OF TIMCO ENGINEERING, INC. 849 NW State Road 45 Newberry, Fl 32669 USA Phone: 888.472.2424 or 352.472.5500 Fax: 352.472.2030 Email: [email protected] Website: www.timcoengr.com Certificate # 0955-01 APPLICANT: SUNCON TOYS INDUSTRY LTD. FCC ID: GLE136227R REPORT: S\SUNCONGLE\464UT8\464UT8TestReport.doc Page 2 of 11 mdea 09.20.2007 TABLE OF CONTENTS GENERAL REMARKS................................................................................................. 3 REPORT SUMMARY................................................................................................... 4 TEST ENVIRONMENT ................................................................................................ 4 TEST SETUP SUMMARY ............................................................................................ 4 DUT SPECIFICATION................................................................................................. 5 TEST EQUIPMENT LIST............................................................................................. 6 TEST PROCEDURES ................................................................................................. 7 RADIATED SPURIOUS EMISSIONS............................................................................ 8 POWER LINE CONDUCTED INTERFERENCE........................................................... 10 RADIATED EMISSIONS TEST SETUP PHOTO .......................................................... 11 APPLICANT: SUNCON TOYS INDUSTRY LTD. FCC ID: GLE136227R REPORT: S\SUNCONGLE\464UT8\464UT8TestReport.doc Page 3 of 11 mdea 09.20.2007 GENERAL REMARKS The attached report shall not be reproduced except in full without the written permission of Timco Engineering Inc. The test results relate only to the items tested. Summary The device under test does: fulfill the general approval requirements as identified in this test report not fulfill the general approval requirements as identified in this test report Attestations This equipment has been tested in accordance with the standards identified in this test report. To the best of my knowledge and belief, these tests were performed using the measurement procedures described in this report. All instrumentation and accessories used to test products for compliance to the indicated standards are calibrated regularly in accordance with ISO 17025 requirements. Testing Certificate # 0955-01 I attest that the necessary measurements were made, under my supervision, at: Timco Engineering Inc. 849 NW State Road 45 Newberry, Fl 32669 Authorized Signatory Name: Mario de Aranzeta C.E.T. Compliance Engineer/ Lab. Supervisor Date: 3/12/2008 APPLICANT: SUNCON TOYS INDUSTRY LTD. FCC ID: GLE136227R REPORT: S\SUNCONGLE\464UT8\464UT8TestReport.doc Page 4 of 11 mdea 09.20.2007 REPORT SUMMARY Disclaimer The test results only relate to the item tested. Applicable Rule(s) Pt 15.109, Pt 15.107, ANSI C63.4: 2003 Related Report None TEST ENVIRONMENT Test Facility Timco Engineering, Inc. 849 NW State Road 45 Newberry, FL 32669 USA. Test Condition in the laboratory Temperature: 26ºC Relative humidity: 50% TEST SETUP SUMMARY Test Setup Diagram/ Description The DUT was placed on the turntable and setup per ANSI C63.4: 2003. A test set up photo is provided. Deviation from the standard/procedure No deviation Modification of DUT No modification APPLICANT: SUNCON TOYS INDUSTRY LTD. FCC ID: GLE136227R REPORT: S\SUNCONGLE\464UT8\464UT8TestReport.doc Page 5 of 11 mdea 09.20.2007 DUT SPECIFICATION DUT Description WIRELESS REMOTE CONTROL RECEIVER FCC ID GLE136227R 110–120Vac/50– 60Hz DC Power DUT Power Source Battery Operated Exclusively Prototype Pre-Production Test Item Production Fixed Mobile Type of Equipment Portable Laboratory Test Conditions Temperature: 26ºC Humidity: 55% Modifications to DUT: No Yes (explanation below) APPLICANT: SUNCON TOYS INDUSTRY LTD. FCC ID: GLE136227R REPORT: S\SUNCONGLE\464UT8\464UT8TestReport.doc Page 6 of 11 mdea 09.20.2007 TEST EQUIPMENT LIST Device Manufacturer Model Serial Number Cal/Char Date Due Date 3/10-Meter OATS TEI N/A N/A Listed 3/20/07 3/19/10 3-Meter OATS TEI N/A N/A Listed 1/11/06 1/10/09 3-Meter Semi- Anechoic Chamber Panashield N/A N/A Listed 5/11/07 5/10/10 Antenna: Biconnical Eaton 94455-1 1057 CAL 1/15/2008 1/15/10 Antenna: Biconnical Eaton 94455-1 1096 CAL 10/11/06 10/11/08 Antenna: Biconnical Electro- Metrics BIA-25 1171 CAL 7/18/07 7/18/09 Analyzer Blue Tower Quasi-Peak Adapter HP 85650A 2811A01279 CAL 5/17/07 5/17/09 Analyzer Blue Tower RF Preselector HP 85685A 2926A00983 CAL 5/17/07 5/17/09 Analyzer Blue Tower Spectrum Analyzer HP 8568B 2928A04729 2848A18049 CAL 5/17/07 5/17/09 LISN Electro- Metrics ANS-25/2 2604 CAL 10/5/06 10/5/08 LISN Electro- Metrics EM-7820 2682 CAL 7/23/07 7/23/09 Antenna: Log- Periodic Eaton 96005 1243 CAL 12/13/07 12/13/09 APPLICANT: SUNCON TOYS INDUSTRY LTD. FCC ID: GLE136227R REPORT: S\SUNCONGLE\464UT8\464UT8TestReport.doc Page 7 of 11 mdea 09.20.2007 TEST PROCEDURES Power line conducted Emission: The test procedure used was ANSI C63.4-2003. The spectrum was scanned from 0.15 to 30 MHz. Radiation Interference: The test procedure used was ANSI C63.4-2003 using a spectrum analyzer with a preselector. The bandwidth of the spectrum analyzer was 100 kHz with an appropriate sweep speed. The analyzer was calibrated in dB above a microvolt at the output of the antenna. The video bandwidth was always greater than or equal to the RBW. The frequency was scanned from 30 MHz to 1.0 GHz. When an emiss…

Text truncated - open the document above for the full version.