H52PT-6010USB EXPANSION PCI CARD

1 PURETEK INDUSTRIAL CO., LTD FCC I D : H52PT-6010 Installation Guide USB Expansion PCI CARD 2 FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Shielded interface cables must be used in order to comply with emission limits. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. 3 4 5 6 7 8 9

FCC ID : H52PT-6010FRONT SIDE OF EUT Number 1 9N1001-01.JPG FCC ID : H52PT-6010REAR SIDE OF EUT Number 2 9N1001-02.JPG

EXHIBIT A. FCC ID LABEL FCC ID:H52PT-6010 The next page shows the location of FCC ID on EUT. The following statement will be placed in the User’s Manual. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC ID LOCATION

FCC TEST REPORTReport No. : F9N1001 SPORTON International Inc. FCC ID: H52PT-6010 TEL : 886-2-2696-2468Page No.: 1 of 22 FAX : 886-2-2696-2255Issued Date : Nov. 18, 1999 FCC TEST REPORT for CISPR PUB. 22 Class B Equipment: USB EXPANSION PCI CARD Model No.: PT-6010 FCC ID: H52PT-6010 Filing Type: Original Grant Applicant: PURETEK INDUSTRIAL CO., LTD. 4F, NO. 12, LANE 235, PAO-CHIAO RD., HSINTIEN CITY, TAIPEI, TAIWAN, R.O.C.
The test result refers exclusively to the test presented test model / sample.
Without the written authorization of the test lab., the Test Report may not be copied.
Certificate or Test Report must not be used by the applicant to claim the product in this test report endorsement by NVLAP or any agency of U.S. government. SPORTON International Inc. 6F, No.106, Sec. 1, Hsin Tai Wu Rd., Hsi Chih, Taipei Hsien, Taiwan, R.O.C. FCC TEST REPORTReport No. : F9N1001 SPORTON International Inc. FCC ID: H52PT-6010 TEL : 886-2-2696-2468Page No.: 2 of 22 FAX : 886-2-2696-2255Issued Date : Nov. 18, 1999 Table of Contents CERTIFICATE OF COMPLIANCE ....................................................................................................................... 3 1. General Description of Equipment under Test ............................................................................................ 4 1.1. Applicant .................................................................................................................................................................................... 4 1.2. Manufacturer .............................................................................................................................................................................. 4 1.3. Basic Description of Equipment under Test ................................................................................................................................ 4 1.4. Feature of Equipment under Test ............................................................................................................................................... 4 2. Test Configuration of Equipment under Test .............................................................................................. 5 2.1. Test Manner ............................................................................................................................................................................... 5 2.2. Description of Test System ......................................................................................................................................................... 5 Connection Diagram of Test System .................................................................................................................................................. 7 3. Test Software .................................................................................................................................................. 8 4. General Information of Test ........................................................................................................................... 9 4.1. Test Facility ................................................................................................................................................................................ 9 4.2. Standard for Methods of Measurement....................................................................................................................................... 9 4.3. Test in Compliance with.............................................................................................................................................................. 9 4.4. Frequency Range Investigated ................................................................................................................................................... 9 4.5. Test Distance ............................................................................................................................................................................. 9 5. Test of Conducted Powerline ...................................................................................................................... 10 5.1. Major Measuring Instruments ................................................................................................................................................... 10 5.2. Test Procedures ....................................................................................................................................................................... 11 5.3. Typical Test Setup Layout of Conducted Powerline .................................................................................................................. 12 5.4. Test Result of AC Powerline Conducted Emission.................................................................................................................... 13 5.5. Photographs of Counducted Powerline Test Configuration ....................................................................................................... 14 6. Test of Radiated Emission ........................................................................................................................... 16 6.1. Major Measuring Instruments ................................................................................................................................................... 16 6.2. Test Procedures ....................................................................................................................................................................... 17 6.3. Typical Test Setup Layout of Radiated Emission ...................................................................................................................... 18 6.4. Test Result of Radiated Emission ............................................................................................................................................. 19 6.5. P…

Text truncated - open the document above for the full version.