JA7MFD-1001Mini Finder

Sends radio signal through walls and doors Loud 85-decible alarm Locates keys up to 60 feet away MINI KEY FINDER TRANSMITTER ACTIVATES A LOUD ALARM ON KEYCHAIN TO LOCATE KEYS UP TO 60 FEET AWAY INSTRUCTIONS Activating Key Ring Receiver (fob without button) 1. Attach key ring rec eiver to keys. 2. Press and hold key ri ng tra nsmitt er for f iv e seconds. 3. If key ring receiver is in range (6 0 feet), it will emit an audible beep. If no beep is heard, change lo cation and repeat step 2. 4. To stop beeping, pres s key ri ng transmitt er. Changing the Batte ries Important: The rec eiver and transmitt er in clude a protec tive t ab in side the batt ery cover to pres erve batt ery life of included CR2032 batt eries. Remove before first use. Key Ring 1. Unscrew batt ery cover with screwdriver. 2. Slide in button cell batt ery (CR2032) into its holder. 3. Replace cover and se curely screw into place. L ow Battery Warning The receiver beeps three times per minute to remi nd you to change the batt ery. FCC INFORMA T ION This equipment has been tes ted and found to co mply wi th the limits for a Cl ass B Digital Device, pursuant to Par t 15 of the FCC Rules. These limits are designed to provide reasonable protec tion against harmful in terfer ence in a residential installation. Thi s equipment generates , uses, and can radiate radio frequency energy and, if not installed and used in accordance wi th the inst ructions, may cause harmful in terfer ence to radio communications. However, there is no guarantee that in terference will not occu r in a particula r installa tion. The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or operating to conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

V 22 SUPER STAR TECHNOLOGY CO., LTD NO.7, LANE 306, TAI-LIN RD., SEC.2 TAI-SHAN HSIANG, TAIPEI HSIEN, TAIWAN. R.O.C. TEL: 886-2-2609-6580 FAX; 886-2-2609-6341 FCC ID: JA7MFD-1001 Device Name: Mini Finder Model No.: MFD-1001 Date: 10/5/2011 Federal Communications Commission Dear Sir: Pursuant to Section 0.457 and 0.459 of the Commission’s Rules, the Applicant hereby requests confidential treatment of information accompanying this Application as outlined below: Schematics Block Diagram Operational Descriptions The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application. By: By: MIKE LIN (Signature) (Printed) Title : MANAGER Applicant : SUPER STAR TECHNOLOGY CO., LTD Address : NO.5, LANE 306, TAI-LIN RD., SEC.2, TAI-SHAN HSIANG, TAIPEI HSIEN, TAIWAN. R.O.C Tel : 886-2- 2609-6580 Fax: 886-2- 2609-6341

FCC ID: JA7MFD-1001 Sheet A1 of A1 Sheets ETC Report No. : 11-09-MAS-278-01 ANNEX A: EXTERNAL CONSTRUCTION PHOTOS OF EUT 1. Outside view 1 of EUT 2. Outside view 2 of EUT

MFD-1001 Tested To Comply With FCC Standards FOR HOME OR OFFICE USE 11208 MODEL NO.:MFD-1001 FCCID :JA7MFD-1001 MADE IN TAIWAN 9.00 mm 19.00 mm

FCC ID: JA7MFD-1001 Sheet B1 of B2 Sheets ETC Report No. : 11-09-MAS-278-01 ANNEX B: INTERNAL CONSTRUCTION PHOTOS OF EUT 1. Inside View 1 of EUT 2. Front view of PCB FCC ID: JA7MFD-1001 Sheet B2 of B2 Sheets ETC Report No. : 11-09-MAS-278-01 3. Rear view of PCB

FCC ID: JA7MFD-1001 Sheet 1 of 22 Sheets ETC Report No.: 11-09-MAS-278-01 Rev. No 1.0 CONFORMANCE TEST REPORT FOR FCC 47 CFR, Part 15 Subpart C Report No.: 11-09-MAS-278-01 Client: SUPER STAR TECHNOLOGY CO., LTD. Product: Mini Finder Model: MFD-1001 FCC ID: JA7MFD-1001 Manufacturer/supplier: SUPER STAR TECHNOLOGY CO., LTD. Date test item received: 2011/09/22 Date test campaign completed: 2011/09/29 Date of issue: 2011/09/29 The test result onl y corresponds to the tested sample. It is not permitted to copy this report, in part or in full, without the permission of the test laboratory. Total number of pages of this test report: 22 pages Total number of pages of photos: External photos 1 pages Internal photos 2 pages Setup photos 2 pages Test Engineer Checked By Approved By Perry Lin James Cheng Winpo Tsai ELECTRONICS TESTING CENTER, TAIWAN NO.8, LANE 29, WENMING RD., LESHAN TSUEN, GUISHAN SHIANG, TAOYUAN COUNTY, TAIWAN 33383, R.O.C. TEL: (03) 3276170~4 INT: +886-3-3276170~4 FAX: (03) 3276188 INT: +886-3-3276188 FCC ID: JA7MFD-1001 Sheet 2 of 22 Sheets ETC Report No.: 11-09-MAS-278-01 Rev. No 1.0 Client : SUPER STAR TECHNOLOGY CO., LTD. Address : NO 5, Lane 306, Sec. 2, Tai-Lin Rd., Tai-Shan Shiang, Taipei Hsien,Taiwan , R.O.C. Manufacturer : SUPER STAR TECHNOLOGY CO., LTD. Address : NO 5, Lane 306, Sec. 2, Tai-Lin Rd., Tai-Shan Shiang, Taipei Hsien,Taiwan , R.O.C. EUT : Mini Finder Trade name : Mini Key Find Model No. : MFD-1001 Power Source : DC 3V（Battery） Regulations applied : FCC 47 CFR, Part 15 Subpart C The testing described in this report has been carried out to the best of our knowledge and ability, and our responsibility is limited to the exercise of reasonable care. This certification is not intended to believe the sellers from their legal and/or contractual obligations. The compliance test is only certified for the test equipment and the results of the testing report relate only to the item tested. The compliance test of this report was conducted in accordance with the appropriate standards. It’s not intention to assure the quality and performance of the product. This report shall not be reproduced except in full, without the approval of ETC. This report must not be used by the client to claim product endorsement by NVLAP or any agency of the U.S. Government. Laboratory Introduction: Electronics Testing Center, Taiwan is recognized, filed and mutual recognition arrangement as following: 1 ISO9001: TüV Product Service 2 ISO/IEC 17025: BSMI, CNLA, NCC, NVLAP, CCIBLAC, UL, Compliance 3 Filing: FCC, Industry Canada, VCCI 4 MRA: Australia, Hong Kong, New Zealand, Singapore, USA, Japan, Korea, China, APLAC through TAF 5 FCC Registration Number: 90588, 91094, 91095 h Industry Canada Site Regisitation number: IC 2949A NVLAP Lab Code 200133-0 FCC ID: JA7MFD-1001 Sheet 3 of 22 Sheets ETC Report No.: 11-09-MAS-278-01 Rev. No 1.0 Table of Contents Page 1. GENERAL INFORMATION ...................................................................................................................................... 4 1.1 PRODUCT DESCRIPTION.................................................................................................................................................. 4 1.2 CHARACTERISTICS OF DEVICE:....................................................................................................................................... 4 1.3 TEST METHODOLOGY..................................................................................................................................................... 4 1.4 TEST FACILITY............................................................................................................................................................... 4 2. DEFINITION AND LIMITS ....................................................................................................................................... 5 2.1 DEFINITION.................................................................................................................................................................... 5 2.2 RESTRICTED BANDS OF OPERATION...............................................................................................................................5 2.3 LIMITATION.................................................................................................................................................................... 6 2.4 LABELING REQUIREMENT............................................................................................................................................... 7 2.5 USER INFORMATION....................................................................................................................................................... 7 3. RADIATED EMISSION MEASUREMENT ............................................................................................................. 8 3.1 APPLICABLE STANDARD................................................................................................................................................. 8 3.2 MEASUREMENT PROCEDURE.......................................................................................................................................... 8 3.3 TEST DATA................................................................................................................................................................... 10 3.4 FIELD STRENGTH CALCULATION.................................................................................................................................. 12 3.5 RADIATED TEST EQUIPMENT........................................................................................................................................ 12 3.6 MEASURING INSTRUMENT SETUP................................................................................................................................. 17 4. BANDWIDTH OF EMISSION...................................…

Text truncated - open the document above for the full version.

FCC ID: JA7MFD-1001 Sheet 1 of 2 Sheets ETC Report No. : 11-09-MAS-278-01 Photos of Radiation Measuring Setup x-axis FCC ID: JA7MFD-1001 Sheet 2 of 2 Sheets ETC Report No. : 11-09-MAS-278-01 y-axis z-axis