KUJCE10317CEILING FAN REMOTE CONTROLLER (TRANSMITTER)

CEILINGFAN REMOTECONTROLLER OPERATIONAND INSTALLATIONINSTRUCTIONS (Pleasekeep this instructionpamphlet.) IMPORTANTPOINTSTO REMEMBER: 1.Read and save these instructions. 2.Please note that all fixed wiring appliancesshouldbe installedby a qualifiedelectrician. 3.The supplyto the remotecontrolreceivershouldbe connectedthrougha mains switch,i.e. existingwall switch. 4.Disconnectfrom power supplyat wall switch before workingon remotecontrolreceiveror ceilingfan. 5.Install receiverinto the ceilingfan canopyof the fan to ensure proper protection. 6.This unit is to be used for the controlof ceilingfan and in aAC 110/120V 60Hz power supplyonly. 7.Do not install in damp locationsor immersein water. (For indoor use only.) 8.Do not pull on or cut leads shorter. 9.Do not drop or bump the unit. 10. PLEASENOTE:The batterywill weakenwith age and shouldbe replacedbefore leakingtakes place as this will damagethe transmitter.Disposeof used batteryproperly,keep the batteryout of reach of children. 11. CAUTION:To reducethe risk of fire or injury, do not use this productin conjunctionwith any variable (rheostat)wall control. INSTALLATIONIN STRUCTIONS 1.Ceilingfan must be set at HIGH speed and light kit (If any) at ON positionby pressingthe “Light Switch ” after installation. 2.Once the connectionhas been made, the receiverinserts into the drop rod hangingbracket.The canopy comes up to cover the receiverand bracket. IMPORTANT YOU MUSTSET CEILINGFAN MANUALSWITCHTO HIGH SPEEDAND LIGHTKIT (IF ANY) TO ON POSITIONBEFOREOPERATINGREMOTECONTROL. CAUTION:INCORRECTWIRE CONNECTIONWOULDDAMAGETHIS RECEIVER. CODESWITCH 1.CODESWITCH:Codes are set by pushingdip switchesup or down. It is imperativethat the code used for both transmitterand receiveris exactlythe same, otherwiseremotecontrollerwill not work. Please note the code switch will enable you to operatea secondremotecontrollerindependently.For example,if you have two ceilingfans with 2 remotecontrolunits, set 2 differentcodes for each set of transmitter/receivers.This means you can operateeach ceilingfan independently. 2.Your remotecontrolis ready for use after batteryinstallation. FUNCTIONSOF TRANSMITTERFAN LIGHT FAN : Turn on the fan at high ,med,lowspeed,orfan off. LIGHT:Press and releaseimmediatelyto turn on or off the light. Press and hold to dim or brightenlights to the desired level and release. Ceiling Fan Remote Control Wiring Connection Installationof Transmitter Wall MountHolderwith two screws. TR219A CAUTION: To assure continued FCC compliance: FCC IDKUJCE1031 7 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. IC This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. French: Cet appareil radio est conforme au CNR‐210 d’Industrie Canada. L’utilisation de ce dispositif est autorisée seulement aux deux conditions suivantes : (1) il ne doit pas produire de brouillage, et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif. Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non contrôlé.

Chungear Industrial Co., Ltd. Ceiling Fan Remote Controller (Transmitter) FCC ID : KUJCE10317 EUT External Photos Photo 1 General Appearance (Front & Side View) Photo 2 General Appearance (Back & Side View)

Chungear Industrial Co., Ltd. Ceiling Fan Remote Controller (Transmitter) FCC ID : KUJCE10317 ID Label Location z Label Placement Location (Back View of EUT) TR221A z ID Label Format This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ID Label Placement Location

FCC ID: KUJCE10317 Page 1 of 23 AUDIX Technology Corporation Report No.: EM-F150006 TEST REPORT FOR CERTIFICATION On Behalf of Chungear Industrial Co., Ltd Ceiling Fan Remote Controller (Transmitter) Model No.: TR219A FCC ID: KUJCE10317 Prepared for : Chungear Industrial Co., Ltd 106 Kanho Rd., Taichung, Taiwan Prepared By : AUDIX Technology Corporation EMC Department No. 53-11, Dingfu, Linkou Dist., New Taipei City 244, Taiwan Tel : (02) 2609-9301, 2609-2133 Fax : (02) 2609-9303 File Number C1M1412309 Report Number EM-F150006 Date of Test 2014. 12. 30 ~ 2015. 01. 05 Date of Report 2015. 01. 06 FCC ID: KUJCE10317 Page 2 of 23 AUDIX Technology Corporation Report No.: EM-F150006 TABLE OF CONTENTS Description Page TEST REPORT CERTIFICATION ........................................................................................................ 3 1. DESCRIPTION OF VERSION ....................................................................................................... 4 2. GENERAL INFORMATION .......................................................................................................... 5 2.1. Description of Device (EUT) .................................................................................................................. 5 2.2. Description of Test Facility ..................................................................................................................... 6 2.3. Measurement Uncertainty ....................................................................................................................... 6 3. CONDUCTED EMISSION MEASUREMET ................................................................................ 7 4. RADIATED EMISSION MEASUREMENT ................................................................................. 8 4.1. Test Equipment ....................................................................................................................................... 8 4.2. Test Setup ................................................................................................................................................ 8 4.3. Radiation Emission Limits (§15.209) ................................................................................................... 10 4.4. Operating Condition of EUT ................................................................................................................. 10 4.5. Test Procedure ....................................................................................................................................... 10 4.6. Radiated Emission Noise Measurement Results ................................................................................... 11 5. FUNDAMENTAL MEASUREMENT .......................................................................................... 12 5.1. Test Equipment ..................................................................................................................................... 12 5.2. Test Setup .............................................................................................................................................. 12 5.3. Radiation Emission Limits (§15.231) ................................................................................................... 13 5.4. Operating Condition of EUT ................................................................................................................. 13 5.5. Test Procedure ....................................................................................................................................... 13 5.6. Fundamental Measurement Results ...................................................................................................... 14 6. EMISSION BANDWIDTH MEASUREMENT ........................................................................... 15 6.1. Test Equipment ..................................................................................................................................... 15 6.2. Block Diagram of Test Setup ................................................................................................................ 15 6.3. Specification Limits (§15.231-(c)) ........................................................................................................ 15 6.4. Emission Bandwidth Measurement Results .......................................................................................... 15 7. PERIODIC OPERATED MEASUREMENT .............................................................................. 17 7.1. Test Equipment ..................................................................................................................................... 17 7.2. Block Diagram of Test Setup ................................................................................................................ 17 7.3. Specification Limits [§15.231-(a)-(1)] .................................................................................................. 17 7.4. Periodic Operated Measurement Results .............................................................................................. 17 8. DEVIATION TO TEST SPECIFICATIONS............................................................................... 19 9. PHOTOGRAPHS............................................................................................................................ 20 9.1. Photos of Radiated Measurement at Semi-Anechoic Chamber (30~1000MHz) .................................. 20 9.2. Photos of Radiated Measurement at Semi-Anechoic Chamber (Above 1GHz) ................................. 21 9.3. Photo of Section RF Near Field Measurement...................................................................................... 23 FCC ID: KUJCE10317 Page 3 of 23 AUDIX Technology Corporation Report No.: EM-F150006 TEST REPORT CERTIFICATION Applicant Chungear Industrial Co., Ltd Manufacturer #1 Chungear Industrial Co., Ltd Manufacturer #2 Satelli…

Text truncated - open the document above for the full version.

FCC ID: KUJCE10317 Page 20 of 23 AUDIX Technology Corporation Report No.: EM-F150006 9. PHOTOGRAPHS 9.1. Photos of Radiated Measurement at Semi-Anechoic Chamber (30~1000MHz) EUT on Stand EUT on Side FCC ID: KUJCE10317 Page 21 of 23 AUDIX Technology Corporation Report No.: EM-F150006 EUT on Lying 9.2. Photos of Radiated Measurement at Semi-Anechoic Chamber (Above 1GHz) EUT on Stand FCC ID: KUJCE10317 Page 22 of 23 AUDIX Technology Corporation Report No.: EM-F150006 EUT on Side EUT on Lying FCC ID: KUJCE10317 Page 23 of 23 AUDIX Technology Corporation Report No.: EM-F150006 9.3. Photo of Section RF Near Field Measurement