KUJCE9101Fan/Light Remote Control Transmitter

FCC ID. KUJCE9101 Page 1 of 3 FCC ID. KUJCE9101 Page 2of 3 FCC ID. KUJCE9101 FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. CAUTION: To assure continued FCC compliance: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. Page 3of 3

Page 11 Chungear Industrial Co., Ltd. Fan/Light Remote Controller (Transmitter) FCC ID. : KUJCE9101 Block Diagram [ NOTE] : (1). These but t ons are norm a l l y open (i .e. spri ng l o aded t o rem a i n open and onl y cl ose when pushi ng) (2 ). Th ere is n o latch i n g circu it to lo ck o n tran sm itter after in itial b u tto n is p u s h e d .

Page 6 Chungear Industrial Co., Ltd. Fan/Light Remote Controller (Transmitter) FCC ID. : KUJCE9101 Photographs Photos 1 General Appearance (Front View) Photos 2 General Appearance (Front & Side View)

Page 4 Chungear Industrial Co., Ltd. Fan/Light Remote Controller (Transmitter) FCC ID. : KUJCE9101 Label Drawing z Label Placement Location (Back Side of EUT) FCC ID：KUJCE9101 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC LABEL

Page 7 Chungear Industrial Co., Ltd. Fan/Light Remote Controller (Transmitter) FCC ID. : KUJCE9101 Photos 3 Internal View (Removed Case Covers) Photos 4 PCB View (Solder Side) Page 8 Chungear Industrial Co., Ltd. Fan/Light Remote Controller (Transmitter) FCC ID. : KUJCE9101 Photos 5 PCB View (Component Side)

FCC ID. KUJCE9101 Page 2of 3

Page 12 Chungear Industrial Co., Ltd. Fan/Light Remote Controller (Transmitter) FCC ID. : KUJCE9101 Schematics Diagram

FCC ID.KUJCE9101 Page 1 of 24 APPLICATION FOR CERTIFICATION On Behalf of Chungear Industrial Co., Ltd. Fan/Light Remote Controller (Transmitter) Model : E01BT-1(BCF-0049X2) FCC ID：KUJCE9101 Prepared for : Chungear Industrial Co., Ltd. 106 Kanho Rd., Taichung, Taiwan, R.O.C. Prepared by : Audix Corporation Technical Division EMC Department No. 53-11, Tin-Fu Tsun, Lin-Kou Hsiang, Taipei Hsien 24443, Taiwan, R.O.C. Tel : (02) 2609-9301, 2609-2133 Fax : (02) 2609-9303 File Number ： ATM-G91666 Report Number ： TTEMC-F91119 Date of Test ： Jul. 18 ~ 31, 2002 Date of Report ： Jun. 10, 2003 Audix Corporation Report No.: TTEMC-F91119 FCC ID.KUJCE9101 Page 2 of 24 TABLE OF CONTENTS Description Page TEST REPORT CERTIFICATION........................................................................................................3 1. GENERAL INFORMATION.............................................................................................................4 1.1. Description of Device (EUT)..................................................................................................................4 1.2. Description of Test Facility.....................................................................................................................5 1.3. Measurement Uncertainty.......................................................................................................................5 2. POWERLINE CONDUCTED TEST.................................................................................................6 3. RADIATED EMISSION TEST..........................................................................................................7 3.1. Test Equipment.......................................................................................................................................7 3.2. Test Setup................................................................................................................................................7 3.3. Radiation Limit (§15.231).......................................................................................................................8 3.4. EUT’s Configuration during Compliance Measurement........................................................................8 3.5. Operating Condition of EUT...................................................................................................................9 3.6. Test Procedure.........................................................................................................................................9 3.7. Test Results.............................................................................................................................................9 3.8. Radiated Emission Noise Measurement Results...................................................................................10 4. EMISSION BANDWIDTH TEST....................................................................................................16 4.1. Test Equipment.....................................................................................................................................16 4.2. Block Diagram of Test Setup................................................................................................................16 4.3. Specification Limits (§15.231-(c))........................................................................................................16 4.4. EUT’s Configuration during Compliance Measurement......................................................................16 4.5. Emission Bandwidth Measurement Results..........................................................................................16 5. PERIODIC OPERATED TEST........................................................................................................18 5.1. Test Equipment.....................................................................................................................................18 5.2. Block Diagram of Test Setup................................................................................................................18 5.3. Specification Limits [§15.231-(a)-(1)]..................................................................................................18 5.4. EUT’s Configuration during Compliance Measurement......................................................................18 5.5. Periodic Operated Measurement Results..............................................................................................18 6. DEVIATION TO TEST SPECIFICATIONS...................................................................................20 7. PHOTOGRAPHS..............................................................................................................................21 7.1. Photos of Radiated Measurement at Semi-Anechoic Chamber (30~1000MHz)..........................................21 7.2. Photos of Radiated Measurement at Semi-Anechoic Chamber (1~3GHz)...........................................22 7.3. Photos of Emission Bandwidth Measurement......................................................................................24 7.4. Photos of Periodic Operated Measurement........................................................................................... 24 Audix Corporation Report No.: TTEMC-F91119 FCC ID.KUJCE9101 Page 3 of 24 TEST REPORT CERTIFICATION Applicant ： Chungear Industrial Co., Ltd. Manufacturer ： Chungear Industrial Co., Ltd. EUT Description ： Fan/Light Remote Controller (Transmitter) FCC ID ： KUJCE9101 (A) MODEL NO. ： E01BT-1(BCF-0049X2) (B) SERIAL NO. ： N/A (C) POWER SUPPLY：DC 9V Measurement Procedure Used: FCC RULES AND REGULATIONS PART 15 SUBPART C, MAY 2002 AND ANSI C63.4/1992 The device described above was tested by AUDIX CORPORATION to determine the maximum emission levels emanating from the device. The maximum emission levels were compared to the FCC Part 15 subpart C limits both radiated and conducted em…

Text truncated - open the document above for the full version.

FCC ID.KUJCE9101 Page 21 of 24 7. PHOTOGRAPHS 7.1. Photos of Radiated Measurement at Semi-Anechoic Chamber (30~1000MHz) EUT on Stand EUT on Side Audix Corporation Report No.: TTEMC-F91119 FCC ID.KUJCE9101 Page 22 of 24 EUT on Lie 7.2. Photos of Radiated Measurement at Semi-Anechoic Chamber (1~3GHz) EUT on Stand Audix Corporation Report No.: TTEMC-F91119 FCC ID.KUJCE9101 Page 23 of 24 EUT on Side EUT on Lie Audix Corporation Report No.: TTEMC-F91119 FCC ID.KUJCE9101 Page 24 of 24 7.3. Photos of Emission Bandwidth Measurement 7.4. Photos of Periodic Operated Measurement Audix Corporation Report No.: TTEMC-F91119