
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
802.11b/g MIMO XR TM Wireless LAN CardBus Card User’s Manual REGULATORY STATEMENTS FCC Certification The United States Federal Communication Commission (FCC) and the Canadian Department of Communications have established certain rules governing the use of electronic equipment. Part15, Class B This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interface, and 2) This device must accept any interface received, including interface that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Radiation Exposure Statement: This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C. Table of Contents INTRODUCTION ...................................................................................................1 WIRELESS NETWORK OPTIONS...............................................................................1 The Peer-to-Peer Network .........................................................................1 The Access Point Network ........................................................................2 INSTALLATION ....................................................................................................3 INSTALL THE DRIVER & UTILITY............................................................................3 HARDWARE INSTALLATION.....................................................................................7 Installation Verification .............................................................................8 UTILITY CONFIGURATION...............................................................................9 ACCESSING THE CONFIGURATION UTILITY..............................................................9 PROFILE TAB........................................................................................................10 LINK STATUS........................................................................................................15 SITE SURVEY........................................................................................................15 STATISTICS...........................................................................................................17 ADVANCED..........................................................................................................17 ABOUT.................................................................................................................18 UNINSTALLATION.............................................................................................20 - 1 - INTRODUCTION The 802.11g MIMO XR TM Wireless LAN CardBus Card is a device that allows you connect your computer to a wireless local area network (LAN). A wireless LAN allows your system to use wireless Radio Frequency (RF) technology to transmit and receive data without physically attaching to the network. The Wireless protocols that come with this product ensure data security and isolation from interference generated by other radio frequencies. This card also allows you to take full advantage of your computer’s mobility with access to real-time information and online services anytime and anywhere. In addition, this device eliminates the bother of pulling cable through walls and under furniture. It even allows you to place your system in locations where cabling is impossible. Modifying and augmenting networks has never been so easy. Wireless Network Options The Peer-to-Peer Network This network installation lets you set a small wireless workgroup easily and quickly. Equipped with wireless PC Cards or wireless PCI, you can share files and printers between each PC and laptop. - 2 - You can also use one computer as an Internet Server to connect to a wired global network and share files and information with other computers via a wireless LAN. The Access Point Network The network installation allows you to share files, printers, and Internet access much more conveniently. With Wireless LAN Cards, you can connect wireless LAN to a wired global network via an Access Point. - 3 - INSTALLATION Install the Driver & Utility 1. Exit all Windows programs. Insert the CD-ROM into the CD-ROM drive of your computer. If the CD-ROM is not …
Text truncated - open the document above for the full version.
SPORTON International Inc. PAGE NUMBER : A1 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : Jul. 20, 2006 FAX : 886-2-2696-2255 APPENDIX A. Photographs of EUT SPORTON International Inc. PAGE NUMBER : A2 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : Jul. 20, 2006 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A3 OF A3 TEL : 886-2-2696-2468 ISSUED DATE : Jul. 20, 2006 FAX : 886-2-2696-2255
SPORTON International Inc. PAGE NUMBER : A1 OF A4 TEL : 886-2-2696-2468 ISSUED DATE : Jul. 20, 2006 FAX : 886-2-2696-2255 APPENDIX A. Photographs of EUT SPORTON International Inc. PAGE NUMBER : A2 OF A4 TEL : 886-2-2696-2468 ISSUED DATE : Jul. 20, 2006 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A3 OF A4 TEL : 886-2-2696-2468 ISSUED DATE : Jul. 20, 2006 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : A4 OF A4 TEL : 886-2-2696-2468 ISSUED DATE : Jul. 20, 2006 FAX : 886-2-2696-2255
©2006 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 01 FCC SAR Test Report Test Report No ﹕ FA671123-1-2-01 Specific Absorption Rate (SAR) Test Report for AboCom Systems, Inc. on the 802.11g MIMO XR TM Wireless LAN CardBus Card Report No. : FA671123-1-2-01 Trade Name : AboCom Model Name : WCB5202 FCC ID : MQ4WCB5202 Date of Testing : Jul. 25, 2006 Date of Report : Jul. 27, 2006 Date of Review : Jul. 27, 2006 The test results refer exclusively to the presented test model / sample only. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. Report Version: Rev. 01. SPORTON International Inc. 6F, No.106, Sec. 1, Hsin Tai Wu Rd., Hsi Chih, Taipei Hsien, Taiwan, R.O.C. 1190 ILAC MRA ©2006 SPORTON International Inc. SAR Testing Lab This report shall not be reproduced except in full, without the written approval of Sporton. Rev. 01 Tel:886-22696-2468 Fax:886-2-2696-2255 FCC SAR Test Report Test Report No ﹕ FA671123-1-2-01 Table of Contents 1. Statement of Compliance ............................................................................................................................................................ 1 2. Administration Data..................................................................................................................................................................... 2 2.1 Testing Laboratory ........................................................................................................................................................... 2 2.2 Detail of Applicant............................................................................................................................................................ 2 2.3 Detail of Manufacturer ..................................................................................................................................................... 2 2.4 Application Detail............................................................................................................................................................. 2 3. Scope ............................................................................................................................................................................................ 3 3.1 Description of Device Under Test (DUT).......................................................................................................................... 3 3.2 Product Photo.................................................................................................................................................................. 4 3.3 Applied Standards: .......................................................................................................................................................... 5 3.4 Device Category and SAR Limits .................................................................................................................................... 5 3.5 Test Conditons................................................................................................................................................................. 5 3.5.1 Ambient Condition:............................................................................................................................................ 5 3.5.2 Test Configuration: ............................................................................................................................................ 5 4. Specific Absorption Rate (SAR) ................................................................................................................................................. 6 4.1 Introduction...................................................................................................................................................................... 6 4.2 SAR Definition ................................................................................................................................................................. 6 5. SAR Measurement Setup ............................................................................................................................................................ 7 5.1 DASY4 E-Field Probe System ..................................................................................................... .................................... 8 5.1.1 ET3DV6 E-Field Probe Specification................................................................................................................. 9 5.1.2 ET3DV6 E-Field Probe Calibration.................................................................................................................... 9 5.2 DATA Acquisition Electronics (DAE) .............................................................................................................................. 10 5.3 Robot..............................................................................................................................................................................11 5.4 Measurement Server ......................................................................................................................................................11 5.5 SAM Twin Phantom ........................................................................................................................................................11 5.6 Data Storage and Evaluation ......................................................................................................................................... 13 5.6.1 Data Storage ................................................................................................................................................... 13 5.6.2 Data Evaluation .......................................................................................…
Text truncated - open the document above for the full version.
SPORTON International Inc. No. 52, Hwa Ya 1st Rd., Kwei-Shan Hsiang, TaoYuan Hsien, Taiwan, R.O.C. Ph: 886-3-327-3456 / FAX: 886-3-327-0973 / www.sporton.com.tw Report Format Version: RF-15.247-2006-6-16-e FCC RADIO TEST REPORT Applicant’s company AboCom Systems, Inc. Applicant Address No. 77, Youyi Rd., Jhunan Township, Miaoli County 350, Taiwan, R.O.C. FCC ID MQ4WCB5202 Manufacturer’s company AboCom Systems, Inc. Manufacturer Address No. 77, Youyi Rd., Jhunan Township, Miaoli County 350, Taiwan, R.O.C. Product Name 802.11g MIMO XRTM Wireless LAN CardBus Card Brand Name AboCom Model Name WCB5202 Test Rule 47 CFR FCC Part 15 Subpart C § 15.247 Test Freq. Range 2400 ~ 2483.5MHz Receive Date Jul. 11, 2006 Final Test Date Jul. 18, 2006 Submission Type Original Equipment Statement Test result included is only for the 802.11b/g part of the product. The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. The measurements and test results shown in this test report were made in accordance with the procedures and found in compliance with the limit given in ANSI C63.4-2003 and 47 CFR FCC Part 15 Subpart C. The test equipment used to perform the test is calibrated and traceable to NML/ROC. Report No.: FR671123 Report Format Version: RF-15.247-2006-2-17-d Page No. : i of ii FCC ID: MQ4WCB5202 Issued Date : Jul. 19, 2006 Table of Contents 1. CERTIFICATE OF COMPLIANCE ......................................................................................................................... 1 2. SUMMARY OF THE TEST RESULT .......................................................................................................................... 2 3. GENERAL INFORMATION .................................................................................................................................. 3 3.1. Product Details....................................................................................................................................................................................3 3.2. Accessories .........................................................................................................................................................................................3 3.3. Table for Filed Antenna.......................................................................................................................................................................3 3.4. Table for Carrier Frequencies .............................................................................................................................................................3 3.5. Table for Test Modes ...........................................................................................................................................................................4 3.6. Table for Testing Locations..................................................................................................................................................................5 3.7. Table for Supporting Units ...................................................................................................................................................................5 3.8. Table for Parameters of Test Software Setting .....................................................................................................................................5 3.9. Test Configurations .............................................................................................................................................................................6 4. TEST RESULT ..................................................................................................................................................... 8 4.1. AC Power Line Conducted Emissions Measurement...........................................................................................................................8 4.2. Maximum Peak Output Power Measurement ...................................................................................................................................12 4.3. Power Spectral Density Measurement ..............................................................................................................................................14 4.4. 6dB Spectrum Bandwidth Measurement ..........................................................................................................................................19 4.5. Radiated Emissions Measurement ....................................................................................................................................................24 4.6. Band Edge Emissions Measurement .................................................................................................................................................42 4.7. Antenna Requirements .....................................................................................................................................................................49 5. LIST OF MEASURING EQUIPMENTS ................................................................................................................... 50 6. SPORTON COMPANY PROFILE ........................................................................................................................ 52 6.1. Test Location.....................................................................................................................................................................................52 APPENDIX A. PHOTOGRAPHS OF EUT.......................................................................................................... A1 ~ A5 APPENDIX B. TEST PHOTOS.......................................................................................................................... B1 ~ B7 Report No.: FR6…
Text truncated - open the document above for the full version.
No. 52, Hwa Ya 1st Rd., Hwa Ya Technology Park · Tao Yuan · Taiwan
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 2.41 GHz - 2.46 GHz | 89.00 mW |

802.11b/g/n Module
Equipment Class
DTS - Digital Transmission System
2T2R 802.11b/g/n/ac Module
Equipment Class
DTS - Digital Transmission System
11ac WiFi Extender Smart Plug / 11ac WiFi Extender
Equipment Class
NII - Unlicensed National Information Infrastructure TX
IP Camera
Equipment Class
DTS - Digital Transmission System
Android TV Dongle
Equipment Class
JBC - Part 15 Class B Computing Device/Personal Computer