MQDMILWT-349Walkie Talkie

TO REPLACE THE BATTERY FOR LCD WATCH AND WALKIE TALKIE: 1. REMOVE THE SCREW ON THE BATTERY DOOR WITH A SCREW DRIVER (SEE FIG. 2) 2. OPEN THE BATTERY DOOR. 3. BATTERY FOR LCD WATCH: INSERT A FRESH NEW ALKALINE BATTERY (1.5V AG-3 BUTTON CELL BAATTERY) WITH THE POSITION (+) SIDE UP INTO THE BATTERY COMPARTMENT. (SEE FIGURE 2) 4. BATTERY FOR WALKIE TALKIE:INSERT A FRESH NEW ALKALINE BATTERY (12V) INTO BATTERY COMPARTMENT ACCORDING TO CORRECT POLARITY. (SEE FIGURE 2) 5. REPLACE THE BATTERY DOOR AND THE SCREW. READING THE WATCH DISPLAY TIME: - NORMALLY DISPLAY SHOW THE NORMAL TIME. - TO READ THE MONTH AND DATE, PRESS THE `SET’ BUTTON ONE TIME AFTER 2 SECOND, DISPLAY GO BACK TO NORMAL TIME. - TO READ THE SECOND, PRESS THE `SET’ BUTTON 2 TIMES, IF RETURN TO NORMAL TIME, PRESS SET BUTTON ONE TIME AGAIN. BATTERY POWER OF LCD WATCH: TO MOVE THE LCD WATCH STABLE OPERATION, WE STRONGLY RECOMMEND THE EXCLUSIVE USE OF ALKALINE BATTERY. (OPERATED BY ONE PC OF 1.5V AG-3 BUTTON CELL BATTERY) TIME AND DATE SETTING MONTH SETTING: 1. PRESS `MODE’ BUTTON ONE TIME, DISPLAY SHOW MONTH AND DATE. 2. PRESS `MODE’ BUTTON TWO TIMES TO ENTER MONTH MODE, THEN DEPRESS `SET’ BUTTON TO SET THE DATE. DATE SETTING: 3. PRESS `MODE’ BUTTON 3 TIMES TO ENTER DATE MODE, THEN DEPRESS `SET’ BUTTON TO SET THE MONTH. HOUR SETTING: 4. PRESS `MODE’ BUTTON 4 TIMES TO ENTER HOUR MODE, THEN DEPRESS `SET’ BUTTON TO SET HOUR. (‘A’ MEANS AM, ‘P’ MEANS PM) MINUTE SETTING: 5. PRESS ‘MODE’ BUTTON 5 TIMES TO ENTER MINUTE MODE, THEN DEPRESS ’SET’ BUTTON TO SET MINUTE. AFTER FINISH SETTING, PRESS ‘MODE’ BUTTON ONE MODE TIME GO BACK TO NORMAL TIME. WALKIE TALKIE OPERATION 1. TURN THE ‘ON/OFF’ VOLUME BUTTON TO ‘ON’ POSTION. 2. ADJUST THE VOLUME LEVEL AS DESIRED WITH THE CONTROL. 3. PLUG THE EARPHONE SET INTO THE EARPHONE JACK. (SEE FIGURE 1). 4. MOVE THE MIC CLOSE TO YOUR MOUTH, AND PRESS THE ‘PUSH TO TALK’ BUTTON TO TRANSMIT YOUR VOICE. 5. RELEASE THE ‘PUSH TO TALK’ BUTTON FOR RECEIVING VOICE FROM THE EARPHONE SET. 6. ROTATE THE ANTENNA AS DESIRED THE BEST RECEIVING FREQUENCY. 7. TURN ‘ON/OFF’ VOLUME BUTTON TO ‘OFF’ POSTION AFTER USE. WARING: 1. SUGGEST TO CHANGE THE BATTERY BY ADULT. 2. SMALL PARTS NOT FOR CHILDREN UNDER 3 YEARS AGE. 3. DO NOT TOUCH OR MODIFY THE INTERNAL COMPONENTS OTHER THEN REPLACE THE BATTERY. 4. DO NOT MIX OLD AND NEW BATTERIES. 5. DO NOT MIX ALKALINE, STANDARD (CARBON ZINC), OR RECHARGEABLE (NICKEL- CADMIUM) BATTERIES. REMARK: MODIFICATIONS NOT AUTHORIZED BY THE MANUFACTURER MAY VOID USERS AUTHORITY TO OPERATE THIS DEVICE. NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH LIMITS FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THESE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES: - REORIENT OR RELOCATE THE RECEIVING ANTENNA. - INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER. - CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED. - CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP.

FCC ID: MQDMILWT-349 PHOTOGRAPH OF THE PRODUCT FRONT VIEW OF THE PRODUCT REAR VIEW OF THE PRODUCT

FCC ID: MQDMILWT-349 LABEL LOCATION BOTTOM VIEW OF THE DEVICE WITH FCC ID LABEL

FCC ID: MQDMILWT-349 PHOTOGRAPH OF THE PRODUCT INNER CIRCUIT TOP VIEW INNER CIRCUIT BOTTOM VIEW

FCC ID: MQDMILWT-349 Circuit Description The 49.86MHz crystal oscillator drives the base of Q1 the final/buffer amplifier. The modulation provided by Mic. The output of Q1 has the matching network consisting of L1 and C1 that limit the harmonic content and effect the proper coupling of the antenna to the output stage. Antenna, Ground and Power Source The antenna consists of a 7cm long telescoping chrome over brass tubing. There is no external ground connection. The ground is only that of the printed circuit board. Electric current is supplied by a 12 Volt (“23L, EL12, VR22” size battery x 1) and 1.5 Volt (“AG3” button cell x 1) primary battery

Date: 2002-01-18 TEST REPORT Page 1 of 19 No.: HM106717 FCC PART 15 SUBPART C CERTIFICATION REPORT FOR LOW POWER TRANSMITTER TEST REPORT No.:HM106717 Equipment Under Test [EUT]:4 Transistor Walkie Talkie Model Number:MIL WT-349 Applicant:Million Industrial Ltd. FCC ID :MQDMILWT-349 Date: 2002-01-18 TEST REPORT Page 2 of 19 No.: HM106717 CONTENT: Cover Page 1 of 19 Content Page 2-3 of 19 Conclusion Page 4 of 19 1.0General Details 1.1Test Laboratory Page 5 of 19 1.2Applicant Details Page 5 of 19 Applicant HKSTC Code Number for Applicant Manufacturer 1.3Equipment Under Test [EUT] Page 6 of 19 Description of EUT operation 1.4Date of Order Page 6 of 19 1.5Submitted Sample Page 6 of 19 1.6Test Duration Page 6 of 19 1.7Country of Origin Page 6 of 19 1.8 Additional Information of EUT Page 7 of 19 2.0Technical Details 2.1Investigations Requested Page 8 of 19 2.2Test Standards and Results Summary Page 8 of 19 3.0Test Results 3.1Emission Page 9-14 of 19 3.2Bandwidth Measurement Page 15-17 of 19 Date: 2002-01-18 TEST REPORT Page 3 of 19 No.: HM106717 Appendix A List of Measurement Equipment Page 18 of 19 Appendix B Photographs Page 19 of 19 Date: 2002-01-18 TEST REPORT Page 4 of 19 No.: HM106717 CONCLUSION The submitted product was deemed to have COMPLIED with the requirements of Federal Communications Commission [FCC] Rules and Regulations Part 15. The tests were performed in accordance with the standards described above and on Section 2.2 in this Test Report. Verify byPatrick Wong for Chief Executive Date: 2002-01-18 TEST REPORT Page 5 of 19 No.: HM106717 1.0General Details 1.1Test Laboratory The Hong Kong Standards and Testing Centre Ltd. EMC Laboratory 10 Dai Wang Street, Taipo Industrial Estate New Territories, Hong Kong Telephone:852 2666 1888 Fax:852 2664 4353 1.2Applicant Details Applicant MILLION INDUSTRIAL LTD. Flat A, 9/Fl., Rodeo Centre, 73-79 Larch Street, Tai Kok Tsui, Kowloon, Hong Kong. Telephone:852 2396 2098 Fax:852 2392 8192 HKSTC Code Number for ApplicantMII001 Manufacturer MILLION INDUSTRIAL LTD. Flat A, 9/Fl., Rodeo Centre, 73-79 Larch Street, Tai Kok Tsui, Kowloon, Hong Kong. Telephone:852 2396 2098 Fax:852 2392 8192 Date: 2002-01-18 TEST REPORT Page 6 of 19 No.: HM106717 1.3Equipment Under Test [EUT] Description of Sample Product:4 Transistor Walkie Talkie Manufacturer:Million Industrial Ltd. Brand Name:MILLION Model Number:MIL WT-349 Input Voltage:12Vd.c. (“23L, EL12, VR22” size battery x 1) 1.5Vd.c. (“AG3” button cell x 1) 1.3.1Description of EUT Operation The Equipment Under Test (EUT) is an Tiger Electronics Inc., 49.86MHz Walkie Talkie. The transmitter is a 4 button transmitter. The EUT continues to transmit while button is being pressed. It is voice transmission, Modulation by Mic. and tape is frequency modulation. 1.4Date of Order 2002-01-10 1.5Submitted Sample(s): 1 Samples per model 1.6Test Duration 2002-01-19 1.7Country of Origin China Date: 2002-01-18 TEST REPORT Page 7 of 19 No.: HM106717 1.8Additional Information of EUT SubmittedNot Available User Manual Part List Circuit Diagram Printed Circuit Board [PCB] Layout Rating Label Block diagram FCC ID Label Date: 2002-01-18 TEST REPORT Page 8 of 19 No.: HM106717 2.0Technical Details 2.1Investigations Requested Perform ElectroMagnetic Interference measurement in accordance with FCC 47CFR [Codes of Federal Regulations] Part 15 and ANSI C63.4:2000 for FCC Certification. 2.2Test Standards and Results Summary Tables EMISSION Results Summary Test ConditionTest RequirementTest MethodClass /Test Result SeverityPassFailedN/A Field Strength of Fundamental Emissions & Spurious Emissions FCC 47CFR 15.235ANSI C63.4:2000N/A Radiated Emissions, 30MHz to 1GHz FCC 47CFR 15.209ANSI C63.4:2000Class B Conducted Emissions on AC, 0.45MHz to 30MHz FCC 47CFR 15.207ANSI C63.4:2000Class B Note: N/A - Not Applicable Date: 2002-01-18 TEST REPORT Page 9 of 19 No.: HM106717 3.0Test Results 3.1Emission 3.1.1Radiated Emissions Test Requirement:FCC 47CFR 15.235 Test Method:ANSI C63.4:2000 Test Date:2002-01-19 Mode of Operation:On mode Test Method: The sample was placed 0.8m above the ground plane on the OATS *. Measurements in both horizontal and vertical polarities were performed. During the test, each emission was maximized by: having the EUT continuously working, investigate all operating modes, rotated about all 3 axis (X, Y & Z) to obtain worst position, manipulating interconnecting cables, rotating turntable, varying antenna height from 1m to 4m in both horizontal and vertical polarizations. The emissions worst-case are shown in Test Results of the following pages. *:OATS [Open Area Test Site] located at HKSTC with a metal ground plane on filed with the FCC pursuant to section 2.948 of the FCC rules, with Registration Number: 90657. Test Setup: Date: 2002-01-18 TEST REPORT Page 10 of 19 No.: HM106717 Limits for Field Strength of Fundamental Emissions [FCC 47CFR 15.235]: Frequency Range of Fundamental Field Strength of Fundamental Emission [Peak] Field Strength of Fundamental Emission [Average] [MHz] [μV/m][μV/m] 49.82-49.90100,00010,000 Results: Field Strength of Fundamental Emissions Peak Value Frequency Level @3m Correction Factor Field Strength Field Strength Limit ** @3m Antenna Polarity MHz dBμV dB/m dBμV/mμV/mμV/m 49.8642.915.057.9785.2100,000Horizontal According to FCC 47CFR15.35, the limit on the radio frequency emissions as measured using instrumentation with a peak detector function, corresponding to 20dB above the maximum permitted average limit for the frequency being investigated unless a different peak emission limit is otherwise specified in the rules. Remarks: *:Linear interpolations Correction Factor included Antenna Factor and Cable Attenuation. Calculated measurement uncertainty=30MHz to 300MHz±3.7dB 300MHz to 1GHz+3.0dB / -2.7dB Date: 2002-01-18 TEST REPORT Page 11 of 19 No.: HM106717 Results: Field Strength of Fundamental Emissions Average Value * FrequencyLevel @3m Correction Factor Field Strength Field Strength Limit ** …

Text truncated - open the document above for the full version.

FCC ID: MQDMILWT-349 TEST SET UP PHOTOGRAPH OF THE PRODUCT MEASUREMENT OF RADIATED EMISSION TEST SET UP