MSQAM2LWireless Mouse

FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT This equipment h as been tested a nd found to compl y with the limits for a Class B digital device, Pursuant to Part 15 the FCC rules. These limits are designed to provide reasonable prot ection against harmful interferenc e in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may c ause harmful interfe rence to radio communications. Howev er, there is no guarantee that interfe rence will not occu r in a particular installation. If t his equipment does cause harmful interference will not occur in a particular installation. If t his equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by o ne or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules. Operat ion is subject to the following two conditio ns : (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING: You are cautioned that changes or modific at ions not expressly approved by the party responsible for compliance could void your authorit y to operate the equipment. Industr y Canada State ment: This device complies with RSS-210 of t he Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-210 d'I ndustrie Canada applicable aux app areils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit p as produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de p rovoquer un fonctionnement indésirable. 低功率電波輻射性電機管理辦法: 第十二條 經 型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或 變更設計之特性及功能。 第 十四條 低 功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善 至無干擾時方得繼續使用。 前 項合法通信，指依電信法規定作業之無線電通信。 低 功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 Connection 安 裝接收器 Please plug dongle int o PC USB port, the keyboard & mouse ar e al ready pre-binding without any setup proces s. 請將接收器插入 到電腦 USB port，鍵盤和滑鼠即 可工作不需要任 何安裝程序。 The funct ion ke ys in below col umns wil l only be supported in AIO system and Android System 下列框框中 的功能鍵僅能使用於華碩的AIO電腦 系 統 與Andriod系統

Page 1 CONSTRUCTION PHOTOS OF EUT

REV: C MG1231-FCC(253)-X4 ASUS/BLACK MG-1231 MG-1231 10/18-’12 10/18-’12 10/18-’12 253-01231L- SCALE: 1 : 1 DWG NO.: NOTES NOTES NOTES MODEL NO. MODEL NO.: REMARKPART NO. MAT.: TOL: UNIT: MM Q'TYSIZE: A4 SPEC: APPROVEDCHECKEDDESIGNED NAME: FINISH: REV LTRREV . DIMENSIONDATEDESIGNAPPROVE B C TAMMY T. S. AERY SPEC. ID LABEL NOTES: F C C I D : I C : C M I I T I D : X X X X X X X X X X M S Q A M 2 L 3 5 6 8 A - A M 2 L XXXXXXXX xxxxxxxxxxxxxx 1. MATERIAL: PET; THICKNESS: 0.125mm ADHESIVE: 3 M 467 OR EQUIVALENT 2. COLOR: A. BACKGROUND: Black B. TEXT, SYMBOL : White 3. FINISHED: ADHESIVE 4. LABEL VENDOR HAS TO BE APPRD. BY UL/CSA 5. THIS PRODUCT/COMPONENT MUST COMPLY WITH CHICONY SPECIFICATION "ISO 361" I n p u t R a t i n g : 3 V 3 0 m A D e s i g n b y A S U S A s s e m b l e d i n C h i n a A S U S T e k C o m p u t e r I n c . A l l r i g h t r e s e r v e d . S / N : W i r e l e s s M o u s e M o d e l N o . : A M 2 L 無線滑鼠 型號 無線鼠標 型號 AA AA LINE [ PRINTING COLOR: WHITE BACKGROUND COLOR: BLACK TEXT & SYMBOLS COLOR: WHITE

FCC LABEL LOCATION Label

Page 2 Page 3 Page 4 Page 5 Page 6 Page 7

FCC ID: MSQAM2L Report No.: RF120924D25-1 Operational Description The transmitter of the EUT (Wireless Mouse) is powered by 3.0Vdc from batteries. The type of antenna is Printed antenna. The output power of this device is very low. Under normal use condition, the transmitter and the receiver are quite close, so high EIRP power is neither necessary nor allowed because of interference.

Report No.: RF120924D25-1 1 of 22 Report Format Version 5.0.0 FCC TEST REPORT REPORT NO.: RF120924D25-1 MODEL NO.: AM2L FCC ID: MSQAM2L RECEIVED: Sep. 24, 2012 TESTED: Oct. 15, 2012 ISSUED: Oct. 22, 2012 APPLICANT: ASUSTeK COMPUTER INC. ADDRESS: 4F, No.150, LI-TE RD., PEITOU, TAIPEI, TAIWAN, R.O.C ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB LOCATION: No. 47, 14th Ling, Chia Pau Vil., Lin Kou Dist., New Taipei City, Taiwan, R.O.C. This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the com pliance or non-compliance to the specification. This report should not be used by the client to claim product certification, approval, or endorsement by TAF or any government agencies. Report No.: RF120924D25-1 2 of 22 Report Format Version 5.0.0 Table of Contents RELEASE CONTROL RECORD ................................................................................. 3 1. CERTIFICATION ............................................................................................... 4 2. SUMMARY OF TEST RESULTS ...................................................................... 5 2.1 MEASUREMENT UNCERTAINTY .................................................................... 5 3. GENERAL INFORMATION ............................................................................... 6 3.1 GENERAL DESCRIPTION OF EUT ................................................................. 6 3.2 DESCRIPTION OF TEST MODES ................................................................... 7 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL .................... 8 3.3 DESCRIPTION OF SUPPORT UNITS ............................................................. 9 3.3.1 CONFIGURATION OF SYSTEM UNDER TEST ............................................... 9 3.4 GENERAL DESCRIPTION OF APPLIED STANDARDS ................................. 10 4. TEST TYPES AND RESULTS ......................................................................... 11 4.1 CONDUCTED EMISSION MEASUREMENT ................................................... 11 4.2 RADIATED EMISSION AND BAND EDGE MEASUREMENT ......................... 11 4.2.1 LIMITS OF RADIATED EMISSION AND BAND EDGE MEASUREMENT ....... 11 4.2.2 TEST INSTRUMENTS .................................................................................... 12 4.2.3 TEST PROCEDURES .................................................................................... 13 4.2.4 DEVIATION FROM TEST STANDARD ........................................................... 13 4.2.5 TEST SETUP .................................................................................................. 14 4.2.6 EUT OPERATING CONDITIONS ................................................................... 14 4.2.7 TEST RESULTS ............................................................................................. 15 5. PHOTOGRAPHS OF THE TEST CONFIGURATION ..................................... 20 6. INFORMATION ON THE TESTING LABORATORIES .................................... 21 7. APPENDIX A – MODIFICATION RECORDERS FOR ENGINEERING CHANGES TO THE EUT BY THE LAB .......................................................... 22 Report No.: RF120924D25-1 3 of 22 Report Format Version 5.0.0 RELEASE CONTROL RECORD ISSUE NO. REASON FOR CHANGE DATE ISSUED RF120924D25-1 Original release Oct. 22, 2012 Report No.: RF120924D25-1 4 of 22 Report Format Version 5.0.0 1. CERTIFICATION PRODUCT: Wireless Mouse BRAND: ASUS MODEL NO.: AM2L APPLICANT: ASUSTeK COMPUTER INC. TESTED: Oct. 15, 2012 TEST SAMPLE: MASS-PRODUCTION STANDARDS: FCC Part 15, Subpart C (Section 15.249) ANSI C63.10-2009 The above equipment has been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE:Oct. 22, 2012 ( Annie Chang / Supervisor ) APPROVED BY : , DATE:Oct. 22, 2012 ( Ken Liu / Manager ) Report No.: RF120924D25-1 5 of 22 Report Format Version 5.0.0 2. SUMMARY OF TEST RESULTS The EUT has been tested according to the following specifications: APPLIED STANDARD: FCC Part 15, Subpart C (Section 15.249) STANDARD PARAGRAPH TEST TYPE RESULTREMARK 15.207 Conducted Emission Test N/A Power supply is 3.0Vdc from batteries 15.209 15.249 15.249 (d) Radiated Emission Test Band Edge Measurement Limit: 50dB less than the peak value of fundamental frequency or meet radiated emission limit in section 15.209 PASS Meet the requirement of limit. Minimum passing margin is -12.2dB at 2390.00MHz. 2.1 MEASUREMENT UNCERTAINTY Where relevant, the following measurement uncertainty…

Text truncated - open the document above for the full version.

Report No.: RF120924D25-1 1 of 1 Report Format Version 5.0.0 PHOTOGRAPHS OF THE TEST CONFIGURATION RADIATED EMISSION TEST