
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
Userβs Manual This light device has been tested and found to comply with the limits for Consumer RF Lighting Device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. 1 Use only on 120V/60Hz. 2 Never disassemble or modify-any changes could void the userβ authority to operate this device. 3 Not for use in totally enclosed recessed fixtures. 4 Risk of electric shock-do not use with where directly exposed to water. 5 This device is not intended for use with emergency exit fixtures or emergency exit lights. 6 This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45-30MHz. 7 To prevent burns, do not touch the bulb during operation or immediately after switching off. 8 Not for use with dimmers, electronic timer or photocell devices or occupancy sensor.
F IGURE 1 E NERGY S AVING L AMP (M/N: JLS 32W) G ENERAL A PPEARANCE F IGURE 2 E NERGY S AVING L AMP (M/N: JLS 36W) G ENERAL A PPEARANCE F IGURE 3 E NERGY S AVING L AMP (M/N: JLS 40W) G ENERAL A PPEARANCE
Label Drawing JOINLUCK FCC ID: N6AFJEE0215
Label Location Information Refer to the below red arrow: (For example) JOINLUCK FCC ID: N6AFJEE0215
F IGURE 1 E NERGY S AVING L AMP (M/N: JLS 32W) C OVER R EMOVED F IGURE 2 E NERGY S AVING L AMP (M/N: JLS 32W) M AIN B OARD (C OMPONENT S IDE ) F IGURE 3 E NERGY S AVING L AMP (M/N: JLS 32W) M AIN B OARD (S OLDERED S IDE ) F IGURE 4 E NERGY S AVING L AMP (M/N: JLS 36W) C OVER R EMOVED F IGURE 5 E NERGY S AVING L AMP (M/N: JLS 36W) M AIN B OARD (C OMPONENT S IDE ) F IGURE 6 E NERGY S AVING L AMP (M/N: JLS 36W) M AIN B OARD (S OLDERED S IDE ) F IGURE 7 E NERGY S AVING L AMP (M/N: JLS 40W) C OVER R EMOVED F IGURE 8 E NERGY S AVING L AMP (M/N: JLS 40W) M AIN B OARD (C OMPONENT S IDE ) F IGURE 9 E NERGY S AVING L AMP (M/N: JLS 40W) M AIN B OARD (S OLDERED S IDE )
Schematics
Test Set-Up Photos 1. Conducted Emission Test (M/N: JLS 32W) (M/N: JLS 36W) (M/N: JLS 40W) 2. Field strength Test (M/N: JLS 32W) (M/N: JLS 36W) (M/N: JLS 40W)
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 18 | 0.035 MHz - 0.045 MHz | - |

ENERGY SAVING LAMP
Equipment Class
8CC - Part 18 Consumer Device
ENERGY SAVING LAMP
Equipment Class
8CC - Part 18 Consumer Device
ENERGY SAVING LAMP
Equipment Class
8CC - Part 18 Consumer Device
ENERGY SAVING LAMP
Equipment Class
8CC - Part 18 Consumer Device
ENERGY SAVING LAMP
Equipment Class
8CC - Part 18 Consumer Device