NHPDSLR2000N802.11n WLAN ADSL2+ Router

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2 Page 3

DSLR-2000N CAMEO 6451DS2000N*xAv Louise x: v: # A /FCC E /ETSI 2009.9.22 :Arial Louise Lin FCC ID: NHPDSLR2000N US:CAMDL01BDSLR2000N "See Caution in Manual" Power Input: 12V 1A MADE IN CHINA 0560 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference and (2)this device must accept any interference received, including interference that may cause undesired operation. MAC: XXXXXXXXXXXX/#

FCC ID: NHPDSLR2000N Label Location

Page 4 Page 5 Page 6 Page 7

FCC ID: NHPDSLR2000N Report No.: RF990126L04 OPERATIONAL DESCRIPTION This device is a 802.11n WLAN ADSL2+ Router, which operates in the 2.4GHz frequency spectrum with throughput of up to 300Mbps which OFDM technique will be applied. If the signal to noise ratio is too poor which could not support 300Mbps, the 11Mbps data rate with DSSS technique will be applied. The transmitter of the EUT is powered by an AC adapter. The antenna is dipole antenna with UFL antenna connector. For more detailed instruction, please take a look at the user’s manual.

Report No.: SA990126L04 Report Format Version 3.0.1 1 RF EXPOSURE REPORT REPORT NO.: SA990126L04 MODEL NO.: DSLR-2000N FCC ID: NHPDSLR2000N ACCORDING: FCC Guidelines for Human Exposure IEEE C95.1 APPLICANT: CAMEO COMMUNICATIONS, INC. ADDRESS: 5F ,No.42, Sec. 6, Mincyuan E. Rd., Neihu District, Taipei City 114, Taiwan ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. Report No.: SA990126L04 Report Format Version 3.0.1 2 1. RF EXPOSURE LIMIT LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) FREQUENCY RANGE (MHz) ELECTRIC FIELD STRENGTH (V/m) MAGNETIC FIELD STRENGTH (A/m) POWER DENSITY (mW/cm 2 ) AVERAGE TIME (minutes) LIMITS FOR GENERAL POPULATION / UNCONTROLLED EXPOSURE 300-1500 ... ... F/1500 30 1500-100,000 ... ... 1.0 30 F = Frequency in MHz 2. MPE CALCULATION FORMULA Pd = (Pout*G) / (4*pi*r2) where Pd = power density in mW/cm2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 R = distance between observation point and center of the radiator in cm 3. CLASSIFICATION The antenna of this product, under normal use condition, is at least 20cm away from the body of the user. So, this device is classified as Mobile Device. 4. CALCULATION RESULT OF MAXIMUM CONDUCTED POWER FREQUENCY BAND (MHz) MAX POWER (dBm) ANTENNA GAIN (dBi) DISTANCE (cm) POWER DENSITY (mW/ cm 2 ) LIMIT (mW/cm 2 ) 2412-2462 26.1 2 20 0.128 1.00

Report No.: RF990126L04 1 Report Format Version 3.0.1 FCC TEST REPORT REPORT NO.: RF990126L04 MODEL NO.: DSLR-2000N RECEIVED: Dec. 07, 2009 TESTED: Jan. 21 ~ Feb. 01, 2010 ISSUED: Feb. 04, 2010 APPLICANT: CAMEO COMMUNICATIONS, INC. ADDRESS: 5F ,No.42, Sec. 6, Mincyuan E. Rd., Neihu District, Taipei City 114, Taiwan ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan, R.O.C. TEST LOCATION: No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This test report consists of 68 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF or any government agencies. The test results in the report only apply to the tested sample. Report No.: RF990126L04 2 Report Format Version 3.0.1 TABLE OF CONTENTS 1. CERTIFICATION...................................................................................................... 4 2. SUMMARY OF TEST RESULTS ............................................................................. 5 2.1 MEASUREMENT UNCERTAINTY........................................................................... 5 3. GENERAL INFORMATION ...................................................................................... 6 3.1 GENERAL DESCRIPTION OF EUT ........................................................................ 6 3.2 DESCRIPTION OF TEST MODES .......................................................................... 7 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST ..................................................... 7 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL .......................... 8 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ....................................... 10 3.4 DESCRIPTION OF SUPPORT UNITS .................................................................. 10 4. TEST TYPES AND RESULTS ............................................................................... 11 4.1 RADIATED EMISSION MEASUREMENT ............................................................. 11 4.1.1 LIMITS OF RADIATED EMISSION MEASUREMENT........................................... 11 4.1.2 TEST INSTRUMENTS........................................................................................... 12 4.1.3 TEST PROCEDURES ........................................................................................... 13 4.1.4 DEVIATION FROM TEST STANDARD.................................................................. 13 4.1.5 TEST SETUP......................................................................................................... 14 4.1.6 EUT OPERATING CONDITIONS .......................................................................... 14 4.1.7 TEST RESULTS .................................................................................................... 15 4.2 CONDUCTED EMISSION MEASUREMENT ........................................................ 28 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT...................................... 28 4.2.2 TEST INSTRUMENTS........................................................................................... 28 4.2.3 TEST PROCEDURES ........................................................................................... 29 4.2.4 DEVIATION FROM TEST STANDARD.................................................................. 29 4.2.5 TEST SETUP......................................................................................................... 30 4.2.6 EUT OPERATING CONDITIONS .......................................................................... 30 4.2.7 TEST RESULTS .................................................................................................... 31 4.3 6dB BANDWIDTH MEASUREMENT..................................................................... 33 4.3.1 LIMITS OF 6dB BANDWIDTH MEASUREMENT .................................................. 33 4.3.2 TEST INSTRUMENTS........................................................................................... 33 4.3.3 TEST PROCEDURE.............................................................................................. 33 4.3.4 DEVIATION FROM TEST STANDARD.................................................................. 33 4.3.5 TEST SETUP......................................................................................................... 34 4.3.6 EUT OPERATING CONDITIONS .......................................................................... 34 4.3.7 TEST RESULTS .................................................................................................... 35 4.4 MAXIMUM OUTPUT POWER ............................................................................... 39 4.4.1 LIMITS OF MAXIMUM OUTPUT POWER MEASUREMENT................................ 39 4.4.2 INSTRUMENTS ..................................................................................................... 39 4.4.3 TEST PROCEDURE.............................................................................................. 39 4.4.4 DEVIATION FROM TEST STANDARD.................................................................. 40 4.4.5 TEST SETUP......................................................................................................... 40 4.4.6 EUT OPERATING CONDITIONS .......................................................................... 40 4.4.7 TEST RESULTS .................................................................................................... 41 4.5 POWER SPECTRAL DENSITY MEASUREMENT ................................................ 42 4.5.1 LIMITS OF POWER SPECTRAL DENSITY MEASUREMENT ............................. 42 4.5.2 TEST INSTRUMENTS............................................................…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST 2 RADIATED EMISSION TEST