O7J-GL245401-0T2.4 GHz 54 Mbps WirelessPC Card

IEEE 802.11g (draft) Wireless Network PC Card/ PCI Adapter User Manual Model: GL245401-0T GL2454VP-0T version 1.0 Manufacturer's Disclaimer Statement The information in this document is subject to change without notice and does not represent a commitment on the part of the vendor. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular purpose of this document. The manufacturer reserves the right to make changes to the content of this document and/or the products associated with it at any time without obligation to notify any person or organization of such changes. In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising out of the use or inability to use this product or documentation, even if advised of the possibility of such damages. This document contains materials protected by copyright. All rights are reserved. No part of this manual may be reproduced or transmitted in any form, by any means or for any purpose without expressed written consent of its authors. Product names appearing in this document are mentioned for identification purchases only. All trademarks, product names or brand names appearing in this document are registered property of their respective owners. FCC STATEMENT This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: l Reorient or relocate the receiving antenna l Increase the separation between the equipment or devices l Connect the equipment to an outlet other than the receiver’s l Consult a dealer or an experienced radio/TV technician for assistance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Driver Installation Step 1: Insert the 802.11g Wireless Network Adapter into your computer. Windows Found New Hardware Wizard will come up. Select the second option and click “Next” to continue. Step 2: Select the driver to install. Click “Browse” to select the folder where you store the driver files. Click “OK” to continue. Click “Next” to continue. Step 4: Driver Found Click “Continue Anyway” to continue Step 3: Driver Installation Driver files are being saved to your Windows system. Step 4: Driver Installation Complete Click “Finish” to complete the driver setup. The following message will appear as soon as you successfully installed the driver for your IEEE 802.11g wireless network adapter.

American Telecommunications Certification Body Inc. 6731 Whittier Ave, McLean, VA 22101 August 7, 2003 RE: Global Sun Technology FCC ID: O7J-GL245401-0T After a review of the submitted information, I have a few comments on the above referenced Application. 1) The test procedure for measuring power mentions a peak power meter in the procedure, but the diagram shows the substitution method. Please correct. 2) The SAR report provided is actually a copy of the EMC report with only 10 pages added to the back for a part of the SAR appendix. A SAR report has not been provided. Please provide. Timothy R. Johnson Examining Engineer mailto: [email protected] The items indicated above must be submitted before processing can continue on the above referenced application. Failure to provide the requested information may result in application termination. Correspondence should be considered part of the permanent submission and may be viewed from the Internet after a Grant of Equipment Authorization is issued. Please do not respond to this correspondence using the email reply button. In order for your response to be processed expeditiously, you must submit your documents through the AmericanTCB.com website. Also, please note that partial responses increase processing time and should not be submitted. Any questions about the content of this correspondence should be directed to the sender.

Page 1 CONSTRUCTION PHOTOS OF EUT

FCC ID Label Location

64 mm 4 1 m m Model: GL245401-0T FCC ID: O7J-GL245401-0T Tested To Comply With FCC Standards FOR HOME OR OFFICE USE Rating: 3.3V

Page 2 Page 3 Page 4

FCC ID: O7J-GL245401-0T ADT No.920617R03A Operational Description This device is an 2.4GHz/54Mbps Wireless PC Card which operates in the 2.4GHz band, the maximum data rate could be up to 54Mbps which OFDM technique will be applied. If the signal to noise radio is too poor which could not support 54Mbps, the 11Mbps data rate with CCK technique will be applied. The transmitter of the EUT is powered by host equipment via a PCMCIA interface. The antenna type used in this product is Patch antenna without antenna connector. The other instruction, please have a look at the users manual.

FCC ID: O7J-GL245401-0T Report No.: SA920617R03A 1Issued: July 26 2003 Reference No.: SA920617R03 SAR TEST REPORT REPORT NO.: SA920617R03A MODEL NO.: GL245401-0T RECEIVED: July 18 2003 TESTED: June 30 2003 APPLICANT: GLOBAL SUN TECHNOLOGY INC. ADDRESS: NO.13 Tung Yuan Rd., Jung Li Industrial Park Jung Li City, Tao Yuan Hsien, Taiwan ISSUED BY: Advance Data Technology Corporation LAB LOCATION: 47 14th Lin, Chiapau Tsun, Linko, Taipei, Taiwan, R.O.C. This test report consists of 31 pages in total except Appendix. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by CNLA, NVLAP or any government agencies. The test results in the report only apply to the tested sample. FCC ID: O7J-GL245401-0T Report No.: SA920617R03A 2Issued: July 26 2003 Reference No.: SA920617R03 Table of Contents 1.CERTIFICATION........................................................................................................................ 3 2.GENERAL INFORMATION........................................................................................................ 4 2.1GENERAL DESCRIPTION OF EUT.......................................................................................... 4 2.2GENERAL DESCRIPTION OF APPLIED STANDARDS ........................................................... 5 2.3GENERAL INOFRMATION OF THE SAR SYSTEM ................................................................. 5 2.4 GENERAL DESCRIPTION OF THE SPATIAL PEAK SAR EVALUATION AND PROBE SCAN.. 9 3.DESCRIPTION OF TEST MODES AND CONFIGURATIONS................................................ 13 4.DESCRIPTION OF SUPPORT UNITS .................................................................................... 14 5.TEST RESULTS ...................................................................................................................... 15 5.1TEST PROCEDURES .............................................................................................................15 5.2MEASURED SAR RESULT ..................................................................................................... 16 5.3SAR LIMITS ............................................................................................................................. 18 5.4RECIPES FOR TISSUE SIMULATING LIQUIDS .................................................................... 18 5.5TEST EQUIPMENT FOR TISSUE PROPERTY...................................................................... 20 6.SYSTEM VALIDATION ............................................................................................................21 6.1TEST EQUIPMENT ................................................................................................................. 21 6.2TEST PROCEDURE................................................................................................................ 21 6.3VALIDATION RESULT............................................................................................................. 23 6.4SYSTEM VALIDATION UNCERTAINTIES .............................................................................. 24 7.MEASUREMENT SAR PROCEDURE UNCERTAINTIES ...................................................... 25 7.1PROBE CALIBRATION UNCERTAINTY ................................................................................. 25 7.2ISOTROPY UNCERTAINTY .................................................................................................... 25 7.3BOUNDARY EFFECT UNCERTAINTY ................................................................................... 26 7.4PROBE LINEARITY UNCERTAINTY ...................................................................................... 26 7.5READOUT ELECTRONICS UNCERTAINTY .......................................................................... 26 7.6RESPONSE TIME UNCERTAINTY ......................................................................................... 27 7.7INTEGRATION TIME UNCERTAINTY .................................................................................... 28 7.8PROBE POSITIONER MECHANICAL TOLERANCE............................................................. 28 7.9PROBE POSITIONING............................................................................................................29 7.10 PHANTOM UNCERTAINTY..................................................................................................... 29 7.11 DASY4 UNCERTAINTY BUDGET........................................................................................... 30 8.INFORMATION ON THE TESTING LABORATORIES............................................................ 31 APPENDIX A: TEST CONFIGURATIONS AND TEST DATA APPENDIX B: ADT SAR MEASUREMENT SYSTEM APPENDIX C: PHOTOGRAPHS OF SYSTEM VALIDATION APPENDIX D: SYSTEM CERTIFICATE & CALIBRATION FCC ID: O7J-GL245401-0T Report No.: SA920617R03A 3Issued: July 26 2003 Reference No.: SA920617R03 1. CERTIFICATION PRODUCT : 2.4GHz/54Mbps Wireless PC Card MODEL NO. : GL245401-0T BRAND NAME : Global Sun OEM MODEL NO. : USR 5410 ( for 802.11g Wireless Turbo PC Card ) OEM BRAND NAME : U.S. Robotics APPLICANT : GLOBAL SUN TECHNOLOGY INC. STANDARDS : 47 CFR Part 2 (Section 2.1093), FCC OET Bulletin 65, Supplement C (01-01), RSS-102 We, Advance Data Technology Corporation, hereby certify that one sample of the designation has been tested in our facility on 30 th June 2003. The test record, data evaluation and Equipment Under Test (EUT) configurations represented herein are true and accurate, and it was tested according to the standards listed above. This device was found to be in compliance with the Specific Absorption Rate (SAR) requirement specified in FCC part 2.1093 under General Population / Uncontrolled Exposure condition. FCC ID: O7J-GL245401-0T Report No.: SA920617R03A 4Issued: July 26 2003…

Text truncated - open the document above for the full version.

FCC ID: O7J-GL245401-0T Report No.: RF920617R03A1Issued: July 28 , 2003 Reference No.: RF920617R03 FCC TEST REPORT REPORT NO.: RF920617R03A MODEL NO.: GL245401-0T OEM MODEL: USR 5410 RECEIVED: July 18, 2003 TESTED: June 19 ~ 26, 2003 APPLICANT: GLOBAL SUN TECHNOLOGY INC. ADDRESS: NO.13 Tung Yuan Rd., Jung Li Industrial Park Jung Li City, Tao Yuan Hsien, Taiwan ISSUED BY: Advance Data Technology Corporation LAB LOCATION: 47 14th Lin, Chiapau Tsun, Linko, Taipei, Taiwan, R.O.C. This test report consists of 62 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by CNLA, NVLAP or any government agencies. The test results in the report only apply to the tested sample. 0528 ILAC MRA Lab Code: 200102-0 FCC ID: O7J-GL245401-0T Report No.: RF920617R03A2Issued: July 28 , 2003 Reference No.: RF920617R03 Table of Contents 1CERTIFICATION ........................................................................................ 4 2SUMMARY OF TEST RESULTS................................................................ 5 3GENERAL INFORMATION ........................................................................ 6 3.1GENERAL DESCRIPTION OF EUT........................................................... 6 3.2DESCRIPTION OF TEST MODES............................................................. 7 3.3GENERAL DESCRIPTION OF APPLIED STANDARDS ............................ 7 3.4DESCRIPTION OF SUPPORT UNITS ....................................................... 8 4TEST TYPES AND RESULTS.................................................................... 9 4.1CONDUCTED EMISSION MEASUREMENT ............................................. 9 4.1.1LIMITS OF CONDUCTED EMISSION MEASUREMENT........................... 9 4.1.2TEST INSTRUMENTS ............................................................................... 9 4.1.3TEST PROCEDURES.............................................................................. 10 4.1.4DEVIATION FROM TEST STANDARD .................................................... 10 4.1.5TEST SETUP ........................................................................................... 11 4.1.6EUT OPERATING CONDITIONS............................................................. 11 4.1.7TEST RESULTS....................................................................................... 12 4.2RADIATED EMISSION MEASUREMENT ................................................ 18 4.2.1LIMITS OF RADIATED EMISSION MEASUREMENT.............................. 18 4.2.2TEST INSTRUMENTS ............................................................................. 19 4.2.3TEST PROCEDURES.............................................................................. 20 4.2.4DEVIATION FROM TEST STANDARD .................................................... 20 4.2.5TEST SETUP ........................................................................................... 21 4.2.6EUT OPERATING CONDITIONS............................................................. 21 4.2.7TEST RESULTS....................................................................................... 22 4.36DB BANDWIDTH MEASUREMENT....................................................... 29 4.3.1LIMITS OF 6dB BANDWIDTH MEASUREMENT ..................................... 29 4.3.2TEST INSTRUMENTS ............................................................................. 29 4.3.3TEST PROCEDURE ................................................................................ 30 4.3.4DEVIATION FROM TEST STANDARD .................................................... 30 4.3.5TEST SETUP ........................................................................................... 30 4.3.6EUT OPERATING CONDITIONS............................................................. 30 4.3.7TEST RESULTS....................................................................................... 31 4.4MAXIMUM PEAK OUTPUT POWER ....................................................... 39 4.4.1LIMITS OF MAXIMUM PEAK OUTPUT POWER MEASUREMENT ........ 39 4.4.2TEST INSTRUMENTS ............................................................................. 39 4.4.3TEST PROCEDURES.............................................................................. 40 4.4.4DEVIATION FROM TEST STANDARD .................................................... 40 FCC ID: O7J-GL245401-0T Report No.: RF920617R03A3Issued: July 28 , 2003 Reference No.: RF920617R03 4.4.5TEST SETUP ........................................................................................... 40 4.4.6EUT OPERATING CONDITIONS............................................................. 40 4.4.7TEST RESULTS....................................................................................... 41 4.5POWER SPECTRAL DENSITY MEASUREMENT................................... 43 4.5.1LIMITS OF POWER SPECTRAL DENSITY MEASUREMENT ................ 43 4.5.2TEST INSTRUMENTS ............................................................................. 43 4.5.3TEST PROCEDURE ................................................................................ 44 4.5.4DEVIATION FROM TEST STANDARD .................................................... 44 4.5.5TEST SETUP ........................................................................................... 44 4.5.6EUT OPERATING CONDITIONS............................................................. 44 4.5.7TEST RESULTS....................................................................................... 45 4.6BAND EDGES MEASUREMENT ............................................................. 53 4.6.1LIMITS OF BAND EDGES MEASUREMENT.......................................... 53 4.6.2TEST INSTRUMENTS ............................................................................. 53 4.6.3TEST PROCEDURE ..................…

Text truncated - open the document above for the full version.

FCC ID: O7J-GL245401-0T Report No.: RF920617R03A60Issued: July 28 , 2003 Reference No.: RF920617R03 5 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST FCC ID: O7J-GL245401-0T Report No.: RF920617R03A61Issued: July 28 , 2003 Reference No.: RF920617R03 RADIATED EMISSION TEST