O7X-ECLP-S-2Game Console Transceiver for Wireless Controller

CHANNEL 1 2 3 4 OFF ON RUMBLE OFF BACK START Instruction for Operation: LIMITED WARRANTY Pelican Accessories warrants to the original consumer purchaser that the product will be free from defects in materials and / or workmanship for a period of 120 days from the date of purchase. If a defect covered by this warranty occurs during this period, Pelican Accessories at its option will repair or replace, at no charge, any part that Pelican Accessories determines to be defective. To obtain warranty service during the warranty period, send the defective product postage pre-paid, with a money order for $4.00 to cover the return postage and handling, along with proof of purchase and the date of purchase to: PELICAN ACCESSORIES 1840 East 27th Street Vernon, CA 90058 This warranty shall not apply if the product has been damaged by abuse, misuses, negligence, accident, modification, tampering or by any other causes unrelated to defective materials and / or workmanship. Repair or replacement as provided under this warranty is Pelican Accessories' exclusive prerogative. ANY APPLICABLE IMPLIED WARRANTIES, INCLUDING WARRANTIES OR MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HERBY LIMITED TO 120 DAYS FROM THE DATE OF PURCHASE AN ARE SUBJECT TO THE CONDITIONS SET FORTH IN THIS LIMITED WARRANTY. IN NO EVENT SHALL PELICAN ACCESSORIES OR INCIDENTAL DAMAGES RESULT FROM THE BREACH OF ANY EXPRESS OR IMPLIED WARRANTIES. This warranty gives you specific legal rights, and you may also have other legal rights, Which vary from state to state. Instruction for Operation: PL-2006 A BAND White Botton Analog Stick D-Pad PRODUCT OVERVIEW: Eclipse Wireless Controller uses advance technology which gives you the ability to play without the limitations of a typical corded controller, hence there are a few switches and LED (lights) not found on your basic Xbox™ Controller. Channel Switch (Receiver and Controller): This switch selects the broadcast channel of the radio frequency. There are four positions; 1, 2, 3 and 4. There is a corresponding Channel Switch on the receiver Band Switch (Receiver and Controller): This switch selects the bandwidth. There are two positions; A and B. There is a corresponding Band Switch on the receiver Power Switch (Controller): This switch selects the power mode. There are 3 positions; Off, On, and Rumble Off INSTRUCTIONS: 1. Insert Batteries: Remove the battery lid and place the two AA batteries (included) into the Eclipse Wireless Controller. Make sure they are inserted as shown in the battery compartment. The batteries included are not long life. 2. Plug in the Receiver: With the Xbox™ turned off, plug the cable of receiver into controller port one (far left port.) 3. Check Band setting: Confirm that the Band Switch is set to A on both the controller and the receiver. Note:the only time you would ever change this switch is if you experienced a drop off in the signal, causing game play to be suspended. If this happens repeatedly we suggest you switch to Band B on both the Controller and Receiver. 4. Select a Channel on the Controller: You may select any channel you desire 1, 2, 3 or 4. 5. Select a Channel on the Receiver: This must match the channel selected on the Controller. Note:If using more then one controller you must use different channel settings, i.e., the first controller and receiver are set to Channel 1, the second controller and receiver are set to Channel 2. The channel position selected on the Eclipse Wireless Controller and Receiver have no relation to the Xbox™ controller ports. 6. Turn ON the Controller Turn the power switch located on the Controller to the ON position - You will see the following: On the Controller the LED will come on, lit green Note:If the LED on the pad comes on and goes to Red this is your low battery indicator meaning your battery has less then 20% power capacity. On the Receiver, the left LED will come on indicating there is a "Pad in". The right LED will flash continually indicating the signal is strong Note: If you wish to extend battery life select the rumble off position. This will turn off the rumble effect in game play, resulting in a doubling of your battery life. OTHER FEATURES: Multiple Players: You may play with up to four Eclipse Wireless controllers. Check to see that the channel switches are set as outlined above. Power Save Mode: When not in use the Eclipse Wireless controller automatically goes into a sleep mode to conserve batteries. A touch of any button puts the controller back into play mode. Note: Turn off the controller when not in use to extend your battery life. For technical questions please visit http://www.pelicanacc.com or call us directly at 1-800-331-3844 Action Buttons Analog Stick Black Button Channel Switch Power On/Off- Rumble Off Switch Start Button B Band Switch Black Button White Button Back Botton LED BAND A B 1 2 3 4 CHANNEL SIGNAL Link LED (Red) Channel Switch Band Switch Signal LED (Red) Memory Card Slots L BottonR Botton Changes or modifications not expressly approved by the manufacture could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Eclipse Wireless Controller Eclipse Wireless Receiver Pelican and its logo are registered trademarks. Xbox™ is a registered trademark of Microsoft Corporation. This product is not designed, manufactured, sponsored or endorsed by Microsoft Corporation. Up to 50 Feet of Range Over 100 Hours on Two AAs 8 Separate Channels Dual Rumble Motors Forward Positioned Black and White Buttons Low Battery Indicator

Request for Confidentiality 2-24-03 American Telecommunications Certification Body, Inc 6731 Whittier Avenue Suite C110 Mclean, VA 22101 RE: Certification Application For X-Box Wireless Controller PL-2006 FCC ID # 07X-ECLP-S-2 Please be advised that the following information is to be held confidential and behalf of Pelican Accessories. • Schematics • BOM information • Theory of Operation The application contains technical information which Pelican Accessories deems to be trade secrets and proprietary. If made public, the information might be used to the disadvantage of the applicant in the market place. Thanks for you attention to this matter. Jason Biheller Product Manager Pelican Accessories 1840 East 27 th Street Vernon, Ca 90058

Top Bottom Front Side

CONTROLLER DONGLE FCC-ID: O7X-ECLP-S-01 ECLIPES WIRELESS PL-2006 FCC-ID: O7X-ECLP-S-02 ECLIPES WIRELESS PL-2006

Cover Removed PCB Top PCB Bottom

Document 7357-01, Rev. 1 FCC ID: O7X-ECLP-S-02 FCC Certification Test Report Washington Laboratories, Ltd February 2003 FCC Certification Test Report for Pelican Accessories O7X-ECLP-S-02 February 28, 2003 Prepared for: Pelican Accessories 1840 East 27th Street Vernon, CA 90058 Prepared By: Washington Laboratories, Ltd. 7560 Lindbergh Drive Gaithersburg, Maryland 20879 FCC Certification Test Report Document 7357-01, Rev. 1 FCC ID: O7X-ECLP-S-02 FCC Certification Test Report Washington Laboratories, Ltd February 2003 FCC Certification Test Program FCC Certification Test Report for the Pelican Accessories D2027H (PL-2006) Microsoft X-Box Wireless Controller Host O7X-ECLP-S-02 February 30, 2003 WLL JOB# 7357 Prepared by: Brian J. Dettling Documentation Specialist Reviewed by: Gregory M. Snyder Wireless/Telco Services Manager & Chief EMC Engineer Document 7357-01, Rev. 1 FCC ID: O7X-ECLP-S-02 FCC Certification Test Report Washington Laboratories, Ltd February 2003 ii Abstract This report has been prepared on behalf of Pelican Accessories to support the attached Application for Equipment Authorization. The test report and application are submitted for a Intentional Radiator under Part 15.249 of the FCC Rules and Regulations. This Federal Communication Commission (FCC) Certification Test Report documents the test configuration and test results for a Pelican Accessories D2027H (PL-2006) Microsoft X- Box Wireless Controller Host. Testing was performed on an Open Area Test Site (OATS) of Washington Laboratories, Ltd, 7560 Lindbergh Drive, Gaithersburg, MD 20879. Site description and site attenuation data have been placed on file with the FCC's Sampling and Measurements Branch at the FCC laboratory in Columbia, MD. Washington Laboratories, Ltd. has been accepted by the FCC and approved by NIST NVLAP (NVLAP Lab Code: 200066-0) as an independent FCC test laboratory. The Pelican Accessories D2027H (PL-2006) Microsoft X-Box Wireless Controller Host complies with the limits for a Intentional Radiator device under Part 15.249 of the FCC Rules and Regulations. Document 7357-01, Rev. 1 FCC ID: O7X-ECLP-S-02 FCC Certification Test Report Washington Laboratories, Ltd February 2003 iii Table of Contents Abstract......................................................................................................ii 1 Introduction...................................................................................................................1 1.1 Compliance Statement............................................................................................1 1.2 Test Scope............................................................................................................1 1.3 Contract Information..............................................................................................1 1.4 Test Dates.............................................................................................................1 1.5 Test and Support Personnel....................................................................................1 1.6 Abbreviations.........................................................................................................2 2 Equipment Under Test....................................................................................................3 2.1 EUT Identification & Description............................................................................3 2.2 Test Configuration..................................................................................................3 2.3 Testing Algorithm...................................................................................................3 2.4 Test Location.........................................................................................................4 2.5 References.............................................................................................................4 2.6 Measurement Uncertainty.......................................................................................4 3 Test Equipment..............................................................................................................5 4 Test Results...................................................................................................................6 4.1 Duty Cycle Correction...........................................................................................6 4.2 Occupied Bandwidth: (FCC Part §2.1049)............................................................9 4.3 Radiated Spurious Emissions: (FCC Part §2.1053)...............................................13 4.3.1 Test Procedure..........................................................................................13 4.4 Conducted Emissions (AC Power Line)................................................................20 Document 7357-01, Rev. 1 FCC ID: O7X-ECLP-S-02 FCC Certification Test Report Washington Laboratories, Ltd February 2003 iv List of Tables Table 1. Device Summary....................................................................................................3 Table 2: Test Equipment List...............................................................................................5 Table 3. Occupied Bandwidth Results................................................................................13 Table 4. Radiated Emissions Limits.....................................................................................13 Table 5: Radiated Emissions Test Data..............................................................................15 Table 6. Radiated Emission Data, Average Data Above 1GHz............................................16 Table 7. Radiated Emission Data, Peak Data Above 1GHz.................................................18 Table 8: AC Power Line Conducted Emissions Test Data Sheet..................................21 List of Figures Figure 1. Duty Cycle Plot – Pulse Width.......................................................…

Text truncated - open the document above for the full version.

Radiated Emissions Test Setup Conducted Emissions Test Setup