O89WD1XWatch Type Display

Pinnacle Technology Corp All specifications are subject to change without notice Pinnacle © 2011, All Rights Reserved Service Calling System User Manual FCC Statement The devices comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that my cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. CONTENT 1 BRIEF INTRODUCTION ......................................................................................... - 1 - 1.1 What is Service Calling System? ........................................................................ - 1 - 1.2 How to Start the System? .................................................................................... - 2 - 2 CALLING DEVICE ................................................................................................... - 4 - 2.1 Service Caller Appearance .................................................................................. - 4 - 2.2 Specification ........................................................................................................ - 5 - 2.3 Dimension ........................................................................................................... - 5 - 2.4 Installation ........................................................................................................... - 6 - 2.4.1 Fix the Menu Sheet ................................................................................... - 6 - 2.4.2 How to Fix SC2X on the Table .............................................................. - 10 - 2.4.3 Print Table Number Label ....................................................................... - 11 - 2.4.4 How to install table number label .......................................................... - 12 - 2.5 Function Keys Description ................................................................................ - 14 - 3 DISPLAY DEVICE .................................................................................................. - 16 - 3.1 Wall Display (BD1X) ........................................................................................ - 16 - 3.1.1 Appearance ............................................................................................. - 16 - 3.1.2 Working Condition ................................................................................. - 16 - 3.1.3 Specification ........................................................................................... - 17 - 3.1.4 Interface .................................................................................................. - 18 - 3.1.5 Dimension .............................................................................................. - 18 - 3.1.6 Hang Style .............................................................................................. - 18 - 3.2 WD1X Watch Type Display/PD1X Waist Pager Type Display ........................ - 19 - 3.2.1 Appearance ............................................................................................. - 19 - 3.2.2 Cautions .................................................................................................. - 19 - 3.2.3 Specification ........................................................................................... - 20 - 3.2.4 Dimension .............................................................................................. - 20 - 3.2.5 Key Function .......................................................................................... - 21 - 3.2.6 Working Condition ................................................................................. - 22 - 3.2.7 Function Set ............................................................................................ - 23 - 4 SIGNAL REINFORCEMENT DEVICE ................................................................. - 31 - 4.1 RF Repeater ....................................................................................................... - 31 - 4.2 Dimension ......................................................................................................... - 31 - 4.3 Installation ............................................................................…

Text truncated - open the document above for the full version.

Inner RC8MHz Clock Oscillator 32.768 KHz Battery 433.92MHz Receive decode IC Antenna

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS EUT– All View EUT– Top View EUT– Bottom View EUT– Left Side View EUT– Right Side View EUT– Adapter Label View

EXHIBIT A - FCC ID LABELING AND LOCATION FCC ID Label Proposed FCC ID Location The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925) Label here

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS EUT –Cover off View EUT - Main Board Top View EUT – Main Board Bottom View EUT – Antenna View EUT – Battery View EUT– LED Display View

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP*, or any agency of the Federal Government. * This report contains data that are not covered by the NVLAP accreditation and are marked with an asterisk “★” (Rev.2) FCC PART 15 CLASS B MEASUREMENT AND TEST REPORT For Xiamen Pinnacle Electrical Co.,Ltd. 4F Guang Xia Building, Torch High-Tech Zone, Xiamen, China FCC ID: O89WD1X Report Type: Original Report Product Type: Watch Type Display Test Engineer: Leon Chen Report Number: R1XM120716056-00 Report Date: 2012-08-08 Reviewed By: Ivan Cao EMC Engineer Prepared By: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building, ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Shenzhen) Report No.: R1XM120716056-00 FCC Part 15 Class B Page 2 of 13 TABLE OF CONTENTS GENERAL INFORMATION.......................................................................................................................................3 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) .....................................................................................3 OBJECTIVE...................................................................................................................................................................3 RELATED SUBMITTAL(S)/GRANT(S).............................................................................................................................3 TEST FACILITY.............................................................................................................................................................3 SYSTEM TEST CONFIGURATION ..........................................................................................................................5 DESCRIPTION OF TEST CONFIGURATION......................................................................................................................5 EUT EXERCISE SOFTWARE..........................................................................................................................................5 EQUIPMENT MODIFICATIONS.......................................................................................................................................5 SUPPORT EQUIPMENT LIST AND DETAILS....................................................................................................................5 BLOCK DIAGRAM OF TEST SETUP................................................................................................................................5 SUMMARY OF TEST RESULTS...............................................................................................................................6 FCC §15.107 – AC LINE CONDUCTED EMISSIONS .............................................................................................7 MEASUREMENT UNCERTAINTY....................................................................................................................................7 EUT SETUP..................................................................................................................................................................7 EMI TEST RECEIVER SETUP.........................................................................................................................................8 TEST EQUIPMENT LIST AND DETAILS...........................................................................................................................8 TEST PROCEDURE........................................................................................................................................................8 TEST RESULTS SUMMARY............................................................................................................................................8 TEST DATA..................................................................................................................................................................8 FCC §15.109 - RADIATED EMISSIONS .................................................................................................................11 MEASUREMENT UNCERTAINTY..................................................................................................................................11 EUT SETUP................................................................................................................................................................11 EMI TEST RECEIVER SETUP.......................................................................................................................................11 TEST PROCEDURE......................................................................................................................................................12 TEST EQUIPMENT LIST AND DETAILS.........................................................................................................................12 CORRECTED AMPLITUDE & MARGIN CALCULATION.................................................................................................12 TEST RESULTS SUMMARY..........................................................................................................................................12 TEST DATA................................................................................................................................................................13 Bay Area Compliance Laboratories Corp. (Shenzhen) Report No.: R1XM120716056-00 FCC Part 15 Class B Page 3 of 13 GENERAL INFORMATION Product Description for Equipment under Test (EUT) The Xiamen Pinn…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Conducted Emissions - Front View Conducted Emissions – Side View Radiated Emission -Front View Radiated Emission - Rear View