OWDTR-0034-ELand Mobile Base Station

Installation Manual LBI-38636S MASTR ® III Conventional Base Station LBI-38636S 3 NOTE Repairs to this equipment should be made only by an authorized service technician or facility designated by the supplier. Any repairs, alterations or substitution of recommended parts made by the user to this equipment not approved by the manufacturer could void the user’s authority to operate the equipment in addition to the manufacturer’s warranty. NOTICE! The software contained in this device is copyrighted by M/A-COM Private Radio Systems, Inc. Unpublished rights are reserved under the copyright laws of the United States. This manual is published by M/A-COM Private Radio Systems, Inc., without any warranty. Improvements and changes to this manual necessitated by typographical errors, inaccuracies of current information, or improvements to programs and/or equipment, may be made by M/A-COM Private Radio Systems, Inc., at any time and without notice. Such changes will be incorporated into new editions of this manual. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose, without the express written permission of M/A-COM Private Radio Systems, Inc. Copyright  1992-2002 M/A-COM Private Radio Systems, Inc. All rights reserved. LBI-38636S 4 TABLE OF CONTENTS Page PRODUCT SPECIFICATION FOR CE MARKED EQUIPMENT ..................................................................................5 MAXIMUM PERMISSIBLE EXPOSURE (MPE) LIMITS .............................................................................................. 6 DETERMINING MPE RADIUS.................................................................................................................................... 6 SAFETY TRAINING INFORMATION ............................................................................................................................ 6 STATION SPECIFICATIONS (GENERAL)..................................................................................................................... 8 PUBLICATIONS INDEX .................................................................................................................................................. 9 SAFETY SUMMARY...................................................................................................................................................... 11 GROUND THE EQUIPMENT..................................................................................................................................... 11 REPLACEMENT OF PLUG-IN CIRCUIT MODULES ............................................................................................. 11 ELECTROSTATIC DISCHARGE - SENSITIVE COMPONENTS............................................................................ 11 DO NOT SUBSTITUTE PARTS OR MODIFY PRODUCT.......................................................................................12 INTRODUCTION ............................................................................................................................................................ 12 CABINET ..................................................................................................................................................................... 12 STATION POWER SUPPLY....................................................................................................................................... 12 TRANSMITTER/RECEIVER SHELF ......................................................................................................................... 12 TRANSMITTER POWER AMPLIFIER...................................................................................................................... 12 UNPACKING EQUIPMENT ........................................................................................................................................... 12 SITE PREPARATION AND INSTALLATION .............................................................................................................. 12 CABINET INSTALLATION ....................................................................................................................................... 12 Single 37-inch Cabinet Installation ........................................................................................................................... 12 Double Stacked 37-inch Cabinet installation ............................................................................................................ 13 ELECTRICAL CONNECTIONS ................................................................................................................................. 14 AC Power.................................................................................................................................................................. 14 Microphone ............................................................................................................................................................... 14 Antenna ..................................................................................................................................................................... 14 TELEPHONE LINE CHARACTERISTICS ................................................................................................................ 14 Telephone Lines........................................................................................................................................................ 14 Types Of Voice Grade Lines .................................................................................................................................... 14 Tone Remote Control Systems ................................................................................................................................. 17 Voting System Considerations....................................................…

Text truncated - open the document above for the full version.

M/A-COM, Inc. 221 Jefferson Ridge Parkway Lynchburg, VA 24501 Telephone: 434.455.9527 www.macom.com May 17, 2004 Subject: FCC ID: OWDTR-0034-E UHF (450-512 MHz) Mastr III base station Equipment Authorization Grant To: Whom it may concern. M/A-COM, Inc. wishes the filing information submitted for the subject equipment be treated as confidential information. By separate letter, agent authorization is granted to Mr. Denis Lalonde of Solectron regarding transmission of information on this subject. M/A-COM, Inc. requests that parts lists, circuit operational descriptions, block diagrams and schematic diagrams not be made routinely available for public inspection. M/A-COM, Inc. considers information in these exhibits to be classified as trade secrets, pursuant to 47 CFR Section 0.457 and Section 0.459 of the FCC rules. Thank you for your attention to this matter. Daryl Popowitch Regulatory Manager, Engineering Project Manager M/A-COM, Inc. – Lynchburg, VA

M/A-COM, Inc. 221 Jefferson Ridge Parkway Lynchburg, VA 24501 Telephone: 434.455.9527 www.macom.com May 17, 2004 To Whom It May Concern: The following organization is granted authority to act on M/A-COM’s behalf, to file technical reports, measurements, forms, and other various documents for M/A-COM equipment with FCC ID: OWDTR- 0034-E, UHF (450 - 512 MHz) Mastr III base station equipment as it applies to a new Equipment Authorization Grant. Denis Lalonde Radio Compliance Discipline Leader Solectron Technical Centre 21 Richardson Side Rd Kanata, ON K2K 2C1 · Canada We certify that we are not subject to denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse ACT of 1988, U.S.C.862. Further, no party, as defined in 47 CFR 1.2002(b), to the application is subject to denial of federal benefits, that includes FCC benefits. Sincerely, Daryl Popowitch Regulatory Manager, Engineering Project Manager

Figure 1: Base Station Front View Figure 2: Base Station Rear View with PA #1

0034-E B-0034 0034 xxxx

Page 1 Interior Photographs of Mastr III / SitePro Trunking Base Station Radio – RF Modules FCC ID: OWDTR-0033-E OWDTR-0034-E May 10, 2004 Page 2 Table of Figures Figure 1 - Tx Synthesizer overall..................................................................................... 3 Figure 2 - Tx Synthesizer - cover removed ..................................................................... 4 Figure 3 - Tx Synthesizer board top ................................................................................ 5 Figure 4 - Tx Synthesizer board bottom .......................................................................... 6 Figure 5 - Tx Synthesizer VCO top.................................................................................. 7 Figure 6 - Tx Synthesizer VCO bottom............................................................................ 8 Figure 7 - Tx Synthesizer disassembled ......................................................................... 9 Figure 8 - Rx Synthesizer overall .................................................................................. 10 Figure 9 - Rx Synthesizer cover removed ..................................................................... 11 Figure 10 - Rx Synthesizer board top............................................................................ 12 Figure 11 - Rx Synthesizer board bottom...................................................................... 13 Figure 12 - Rx Synthesizer frequency reference ........................................................... 14 Figure 13 - Rx IF overall................................................................................................ 15 Figure 14 - Rx IF board top ........................................................................................... 16 Figure 15 - Rx IF board bottom ..................................................................................... 17 Page 3 Figure 1 - Tx Synthesizer overall Page 4 Figure 2 - Tx Synthesizer - cover removed Page 5 Figure 3 - Tx Synthesizer board top Page 6 Figure 4 - Tx Synthesizer board bottom Page 7 Figure 5 - Tx Synthesizer VCO top Page 8 Figure 6 - Tx Synthesizer VCO bottom Page 9 Figure 7 - Tx Synthesizer disassembled Page 10 Figure 8 - Rx Synthesizer overall Page 11 Figure 9 - Rx Synthesizer cover removed Page 12 Figure 10 - Rx Synthesizer board top Page 13 Figure 11 - Rx Synthesizer board bottom Page 14 Figure 12 - Rx Synthesizer frequency reference Page 15 Figure 13 - Rx IF overall Page 16 Figure 14 - Rx IF board top Page 17 Figure 15 - Rx IF board bottom

Figure 1: Power Supply SN 31725960 Back View No Cover Figure 2: Power Supply Top View No Cover Figure 3: Power Supply Front View Cover On Figure 4: Power Supply Back View Cover On Figure 5: PA Front View Cover On Figure 6: PA Back View Cover On Figure 3: PA #1 SN 10325556 (Freq: 440-512 MHz) Figure 4: PA #1 Leftmost Section of Board Figure 5: PA #1 Middle section of Board Figure 6: PA #1 Rightmost Section of Board

Figure 1 Rx Front End module (top with cover) Figure 2 Rx Front End module (top without cover) Figure 3 Rx Front End module (bottom with cover) Figure 4 Rx Front End module (bottom without cover)

Figure 1: Top View of Module - Cover On Figure 2: Front View of Module, Cover On Figure 3: Bottom View of Module, Cover On Figure 4: Top View of Module, No Cover Figure 5: Stepro Analog Board CB101070V01 Rev 4A, Top View Figure 6: Stepro Analog Board CB101070V01 Rev 4A, Bottom View Figure 7: 02-35072-0001 Rev. C, Top View Figure 8: 02-35072-0001 Rev. C, Bottom View Figure 9: Stepro Interconnect Board, CB101073V1 Rev. R2A SLR 0228 1140, Top View Figure 10: Stepro Interconnect Board, CB101073V1 Rev. R2A SLR 0228 1140, Bottom View Figure 11: SLR 0214 0817 EA101419V2 R1A, with Daughterboard, Top View Figure 12: SLR 0214 0817 EA101419V2 R1A, without Daughterboard, Top View Figure 13: SLR 0214 0817 EA101419V2 R1A, Bottom View Figure 14: Daughterboard, SLR 0223 1249 T119 Jun 02, Top View Figure 15: Daughterboard, SLR 0223 1249 T119 Jun 02,

Page 1 Interior Photographs of Mastr III / SitePro Conventional Trunking Base Station Radio FCC ID: OWDTR-0033-E OWDTR-0034-E May 10, 2004 Page 2 Table of Figures Figure 1 - Backplane Top ................................................................................................ 3 Figure 2 - Backplane Board Bottom ................................................................................ 4 Figure 3 - Interface Board Top ........................................................................................ 5 Figure 4 - Interface Board Bottom ................................................................................... 6 Figure 5 - System Module Overall ................................................................................... 7 Figure 6 - System Module, cover removed...................................................................... 8 Figure 7 - System Module, main board top ..................................................................... 9 Figure 8 - System Module, main board bottom ............................................................. 10 Figure 9 - System Module - DSP Board top .................................................................. 11 Figure 10 - System Module - DSP Board bottom ..........................................................12 Figure 11 - DSP Module overall .................................................................................... 13 Figure 12 - DSP Module board top................................................................................ 14 Figure 13 - DSP Module board bottom.......................................................................... 15 Figure 15 - Power Module Board Top ........................................................................... 17 Figure 16 - Power Module Board Bottom ...................................................................... 18 Page 3 Figure 1 - Backplane Top Page 4 Figure 2 - Backplane Board Bottom Page 5 Figure 3 - Interface Board Top Page 6 Figure 4 - Interface Board Bottom Page 7 Figure 5 - System Module Overall Page 8 Figure 6 - System Module, cover removed Page 9 Figure 7 - System Module, main board top Page 10 Figure 8 - System Module, main board bottom Page 11 Figure 9 - System Module - DSP Board top Page 12 Figure 10 - System Module - DSP Board bottom Page 13 Figure 11 - DSP Module overall Page 14 Figure 12 - DSP Module board top Page 15 Figure 13 - DSP Module board bottom Page 16 Figure 14 - Power Module Overall Page 17 Figure 15 - Power Module Board Top Page 18 Figure 16 - Power Module Board Bottom

Certification Report for M/A-COM MASTRIII UHF Base Station FCC Part 22, 74, 80, 90, & RSS-119 Document Number: KP000882-CR-RAD-02-01 Release Date: May 26, 2004 Prepared for: M/A-COM, Inc. 221 Jefferson Ridge Parkway Lynchburg, Virginia U.S.A., 24501 Author: Denis Lalonde Radio Compliance Discipline Leader C-MAC Engineering Inc. A Solectron Company 21 Richardson Side Road, Kanata, Ontario, K2K 2C1 http://www.solectrontechnicalctr.com/ © Copyright C-MAC Engineering Inc. May 26, 2004 The master of this document is stored on an electronic database and is “write-protected” and may be altered only by authorized persons at C-MAC Engineering Inc. Viewing of the master document electronically ensures access to the current issue. Any hard copies must be regarded as uncontrolled copies. C-MAC Engineering Inc. accepts no liability for the content of this document except when it is reproduced in its entirety by a method acceptable to C-MAC Engineering Inc. Certification Report for M/A-COM MASTRIII UHF Base Station KP000882-CR-RAD-02-01 The master of this document is stored on an electronic database and is “write-protected” and may be altered only by authorized persons at C-MAC Engineering Inc.. Viewing of the master document electronically ensures access to the current issue. Any hard copies must be regarded as uncontrolled copies. Page 2 of 70 Release date: May 26, 2004 Release Control Record This document is based on CEI document template KG000347-TR-EMC-03. Release no. Reason for change Date released 01 Original Release May 26, 2004 Approvals Accreditations C-MAC Engineering test facilities are accredited by the Standards Council of Canada (SCC) in accordance with the scope of accreditation outlined at the following web site http://www.scc.ca/scopes/reg126-eng-s.pdf. [1] Through a Mutual Recognition Agreement (MRA) between the National Voluntary Laboratory Accreditation Program (NVLAP) and SCC, the accreditation status of this facility is valid for the U.S. C-MAC Engineering is ISO 9001:2000 and ISO-IEC 17025 certified and its processes are documented in the C-MAC Engineering Quality Manual [2] and Lab Operations Manual [3]. KP000882-CR-RAD-02-01 Certification Report for M/A-COM MASTRIII UHF Base Station The master of this document is stored on an electronic database and is “write-protected” and may be altered only by authorized persons at C-MAC Engineering Inc.. Viewing of the master document electronically ensures access to the current issue. Any hard copies must be regarded as uncontrolled copies. Release date: May 26, 2004 Page 3 of 70 Table of Contents RELEASE CONTROL RECORD...............................................................................................2 APPROVALS................................................................................................................................2 ACCREDITATIONS....................................................................................................................2 TABLE OF CONTENTS..............................................................................................................3 LIST OF FIGURES......................................................................................................................5 LIST OF TABLES........................................................................................................................7 1. EXECUTIVE SUMMARY.....................................................................................................9 2. COMPLIANCE SUMMARY...............................................................................................10 3. EQUIPMENT UNDER TEST (EUT)..................................................................................11 3.1 PRODUCT FUNCTIONAL DESCRIPTION.............................................................................11 3.2 MANUFACTURER INFORMATION......................................................................................11 3.3 TRANSMITTER SPECIFICATIONS.......................................................................................11 3.4 SYSTEM COMPONENTS....................................................................................................12 3.5 SUPPORT EQUIPMENT......................................................................................................13 3.6 SYSTEM SET-UP AND TEST CONFIGURATIONS.................................................................13 3.7 SYSTEM MODIFICATIONS................................................................................................14 4. GENERAL TEST CONDITIONS.......................................................................................15 4.1 TEST FACILITY................................................................................................................15 4.2 MEASUREMENT INSTRUMENTATION................................................................................15 5. DETAILED TEST RESULTS..............................................................................................16 5.1 RF POWER......................................................................................................................16 5.1.1 Test Specification................................................................................................16 5.1.1.1 Limits..............................................................................................................16 5.1.2 Test Facility Information.....................................................................................16 5.1.3 Test Procedure.....................................................................................................16 5.1.4 Test Results..........................................................................................................17 5.1.5 Test Conclusion...................................................................................................17 5.1.6 Test Equipment List...........................................…

Text truncated - open the document above for the full version.