OZ9USTC-TED-0001Response Transmitter Unit (RTU) under Part 95

FCC ID: OZ9USTC-TED-0001 SECTION 7 USER'S MANUAL FCC ID: OZ9USTC-TED-0001 At this time, U.S. Telemetry does not have a users manual and does not yet have plans to produce a manual for the EUT.

FCC ID: OZ9USTC-TED-0001 FCC ID: OZ9USTC-TED-0001

FCC ID: OZ9USTC-TED-0001 SECTION 5 PHOTOGRAPHS FCC ID: OZ9USTC-TED-0001 PHOTOS OF THE TESTED EUT The following photos are attached: Photo 1.EUT, Front View Photo 2.EUT, Rear View Photo 3.EUT, Bottom View Showing Connector Photo 4.EUT, Internal View Cover Removed Photo 5.EUT, Top View of Board Photo 6.EUT, Bottom View of Board Photo 7.EUT, Top View of Antenna Photo 8.EUT, Bottom View of Antenna FCC ID: OZ9USTC-TED-0001 Photo 1.EUT, Front View FCC ID: OZ9USTC-TED-0001 Photo 2.EUT, Rear View FCC ID: OZ9USTC-TED-0001 Photo 3.EUT, Bottom View Showing Connector

FCC ID: OZ9USTC-TED-0001 SECTION 3 LABELING INFORMATION FCC ID: OZ9USTC-TED-0001

FCC ID: OZ9USTC-TED-0001 Photo 4.EUT, Internal View Cover Removed FCC ID: OZ9USTC-TED-0001 Photo 5.EUT, Top View of Board FCC ID: OZ9USTC-TED-0001 Photo 6.EUT, Bottom View of Board FCC ID: OZ9USTC-TED-0001 Photo 7.EUT, Top View of Antenna FCC ID: OZ9USTC-TED-0001 Photo 8.EUT, Bottom View of Antenna

U. S. Telemetry Corporation FCC Part 95, Certification Application USTC-TED-0001 May 21, 2000 MEASUREMENT/TECHNICAL REPORT COMPANY NAME: U. S. Telemetry Corporation MODEL: USTC-TED-0001 FCC ID: OZ9USTC-TED-0001 DATE: May 21, 2000 This report concerns (check one): Original grant X Class II change_____ Equipment type: Deferred grant requested per 47 CFR 0.457(d)(1)(ii)? yes_____ No X If yes, defer until:_________________ date N.A. agrees to notify the Commission by N.A. date of the intended date of announcement of the product so that the grant can be issued on that date. Report prepared by: United States Technologies, Inc. 3505 Francis Circle Alpharetta, GA 30004 Phone Number: (770) 740-0717 Fax Number: (770) 740-1508 FCC ID: OZ9USTC-TED-0001 TABLE OF CONTENTS AGENCY AGREEMENT LETTER OF CONFIDENTIALITY SECTION 1 GENERAL INFORMATION 1.1 Product Description 1.2 Related Submittal(s) SECTION 2 TESTS AND MEASUREMENTS 2.1 Configuration of Tested EUT 2.2 Test Facility 2.3 Test Equipment 2.4 Modifications 2.5 Antenna Description 2.6 RF Power Output 2.7 Modulation Characteristics 2.8 Occupied Bandwidth 2.9 Spurious Emissions at Antenna Terminals 2.10 Field Strength of Spurious Radiation 2.11 Frequency Stability SECTION 3 LABELING INFORMATION SECTION 4 BLOCK DIAGRAM(S)/ SCHEMATIC(S) SECTION 5 PHOTOGRAPHS SECTION 6 DETAILED RF TECHNICAL INFORMATION SECTION 7 USER'S MANUAL FCC ID: OZ9USTC-TED-0001 LIST OF FIGURES AND TABLES FIGURES 1)Test Configuration 2) Photograph(s) for Spurious Emissions 3) RF Power Output 4) Modulation Characteristics 5) Occupied Bandwidth 6) Spurious Emissions at Antenna Terminals TABLES 1)EUT and Peripherals 2) Test Instruments 3) RF Power Output 4) Field Strength of Spurious Emissions FCC ID: OZ9USTC-TED-0001 SECTION 1 GENERAL INFORMATION FCC ID: OZ9USTC-TED-0001 GENERAL INFORMATION 1.1Product Description The Equipment Under Test (EUT) is a U. S. Telemetry Corporation, Model USTC-TED- 0001. The EUT is a 218.75 MHz Transmitter. The EUT operates as a Response Transmitter Unit (RTU) under the operating conditions set forth by the FCC for the 218-219 MHz service. The unit is a battery operated, one-way device, transmitting data generated by its internal microprocessor dependent on pre- programmed test data or external inputs to the device. The unit is manufactured by the following company: Axonn Corporation 101 West Robert E. Lee Blvd. Suite 202 New Orleans, LA 70124 FCC ID: OZ9USTC-TED-0001 1.2Related Submittal(s)/Grant(s) The EUT will be used with part of a system to send/receive data. The transmitter presented in this report will be used with a receiver which has been previously approved under a DoC authorization. The EUT is subject to the following authorizations: a) Certification as a transmitter as specified by Part 95.851. The information contained in this report is presented for the certification authorization(s) for the EUT. FCC ID: OZ9USTC-TED-0001 SECTION 2 TESTS AND MEASUREMENTS FCC ID: OZ9USTC-TED-0001 TEST AND MEASUREMENTS 2.1 Configuration of Tested System Prepared in accordance with the requirements of the FCC Rules and Regulations Part 95. All measurements are peak unless stated otherwise. The video filter associated with the spectrum analyzer was off throughout the evaluation process. Interconnecting cables were manipulated as necessary to maximize emissions. A block diagram of the tested system is shown in Figure 1. Test configuration photographs for spurious and fundamental emissions are shown in Figure 2. The sample used for testing was received by U.S. Technologies on April 12 in good condition. 2.2 Test Facility Testing was performed at US Tech's measurement facility at 3505 Francis Circle, Alpharetta, GA. This site has been fully described and submitted to the FCC, and accepted in their letter marked 31040/SIT. Additionally this site has also been fully described and submitted to Industry Canada (IC), and has been approved under file number IC2982. 2.3 Test Equipment Table 2 describes test equipment used to evaluate this product. 2.4 Modifications No modifications were made by US Tech, to bring the EUT into compliance with FCC Part 95 limits for the transmitter portion of the EUT. FCC ID: OZ9USTC-TED-0001 FIGURE 1 TEST CONFIGURATION 50Ω Termination Transmitter (EUT) 6 @ 1m u FCC ID: OZ9USTC-TED-0001 Test Date:April 22, 2000 UST Project:00-0141 Customer:U. S. Telemetry Corporation Model:USTC-TED-0001 FIGURE 2a Photograph(s) for Spurious Emissions (Front) FCC ID: OZ9USTC-TED-0001 Test Date:April 22, 2000 UST Project:00-0141 Customer:U. S. Telemetry Corporation Model:USTC-TED-0001 FIGURE 2b Photograph(s) for Spurious Emissions (Back) FCC ID: OZ9USTC-TED-0001 TABLE 1 EUT and Peripherals PERIPHERAL MANUFACTURER MODEL NUMBER SERIAL NUMBER FCC ID:CABLES P/D Transmitter (EUT) Axonn Corporation USTC-TED- 0001 FCC1OZ9USTC-TED-0001 (Pending) 6 @ 1m u Termination Component General, Inc. CFT-15 BMNoneNone FCC ID: OZ9USTC-TED-0001 TABLE 2 TEST INSTRUMENTS TYPEMANUFACTURERMODELSN. SPECTRUM ANALYZERHEWLETT-PACKARD8593E3205A00124 SPECTRUM ANALYZERHEWLETT-PACKARD8558B2332A09900 S A DISPLAYHEWLETT-PACKARD853A2404A02387 COMB GENERATORHEWLETT-PACKARD8406A1632A01519 RF PREAMPHEWLETT-PACKARD8447D1937A03355 RF PREAMPHEWLETT-PACKARD8449B3008A00480 HORN ANTENNAEMCO31153723 HORN ANTENNAEMCO31169505-2255 BICONICAL ANTENNAEMCO31109307-1431 LOG PERIODIC ANTENNA EMCO31469110-3600 TEMPERATURE CHAMBER THERMOTRONSM1617095 MULTIMETERFLUKE8553710469 PLOTTERHEWLETT-PACKARD7475A2325A65394 FCC ID: OZ9USTC-TED-0001 2.5 Antenna Description (FCC Section 95.859) Connectors that are used to connect RTU to external antenna shall not be of the types generally known as “F-type” or “BNC type”. The Model U. S. Telemetry Corporation USTC-TED-0001 incorporates an external antenna. Manufacturer:Axonn Corporation 101 West Robert E. Lee Blvd. Suite 202 New Orleans, LA 70124 Type: Printed Circuit Board Antenna Model Number:0656-137-AWO Rev. X2 Gain:-2 dBi Connector:SMA FCC ID: OZ9USTC-TED-0001 2.6 RF Power Outp…

Text truncated - open the document above for the full version.